• Current Optics and Photonics
• /
• v.6 no.1
• /
• pp.32-38
• /
• 2022

Erbium-doped fiber amplifiers (EDFAs) have saturated the technological market but are still widely used in high-speed and long-distance communication systems. To overcome EDFA saturation and limitations, its erbium-doped fiber is co-doped with other materials such as zirconia and bismuth. This article demonstrates and compares the performance using three different fibers as the gain medium for zirconia-erbium-doped fibers (Zr-EDF), bismuth-erbium-doped fibers (Bi-EDF), and commercial silica-erbium-doped fibers (Si- EDF). The optical amplifier was configured with a double-pass amplification system, with a broadband mirror at the end of its configuration to allow double-pass operation in the system. The important parameters in amplifiers such as optical properties, optical amplification and noise values were also examined and discussed. All three fibers were 0.5 m long and entered with different input signals: 30 dBm for low input and 10 dBm for high input. Zr-EDF turned out to be the most relevant optical amplifier as it had the highest optical gain, longest transmission distance, highest average flatness gain with minimal jitter, and relevant noise figures suitable for the latest communication technology.

• Journal of the Optical Society of Korea
• /
• v.14 no.4
• /
• pp.298-304
• /
• 2010

The pair-induced quenching (PIQ) effect in a highly doped bismuth oxide-based erbium-doped fiber amplifier (EDFA) was theoretically and experimentally investigated. In the theoretical investigation, the bismuth oxide-based EDFA was modeled as a 6-level amplifier system that incorporated clustering-induced concentration quenching, cooperative up-conversion, pump excited state absorption (ESA), and signal ESA. The relative number of paired ions in a highly doped bismuth oxide EDF was estimated to be ~6.02%, determined by a comparison between the theoretical and the experimentally measured gain values. The impacts of the PIQ on the gain and the noise figure were also investigated.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.9 no.4
• /
• pp.377-380
• /
• 1999

Erbium (Er) doped $LiNbO_{3}(Er:LiNbO_{3})$ single crystal fibers were grown free of creacks along the c-axis by micro-pulling down method. The $Er^{3+}$ concentration was distributed homogeneously along the growth axis. The samples for optical characterization were cut from as-grown single crystal fibers and polished. When the 980nm light was incident on the sample, upconversion phenomena were observed at the green range of wavelength 510~570nm. In addition, the intensity of upconversion was remarkably increased by increasing the concentration of $Er_{2}O_{3}$ dopant in as-grown $Er:LiNbO_{3}$ crystals.

• Proceedings of the Korea Association of Crystal Growth Conference
• /
• 1999.06a
• /
• pp.321-335
• /
• 1999

Erbium(Er) doped LiNbO3(Er:LiNbO3) single crystal gibers were grown free of cracks along the c-axis by micro-pulling down method. the Er3+ concentration was distributed homogeneously along the growth axis. The samples for optical characterization were cut from as-grown single crystal fibers and polished. When the 980 nm light was incident on the sample, upconversion phenomena were observed at the green range of wavelength 510~570 nm. In addition, the intensity of upconversion was remarkably increased by increasing the concentration of Er2O3 dopant in as-grown Er:LiNbO3 crystals.

• Korean Journal of Optics and Photonics
• /
• v.21 no.4
• /
• pp.139-145
• /
• 2010

A complete modeling of erbium-doped Bismuth-oxide fibers with a high doping concentration is presented. A 6-level amplifier system that incorporated clustering-induced concentration quenching, cooperative upconversion, pump excited state absorption (ESA), and signal ESA, was adopted for the modeling. The accuracy of the modeling was verified by comparing the calculated gain and noise figure with experimentally obtained ones.

• Korean Journal of Optics and Photonics
• /
• v.8 no.4
• /
• pp.320-326
• /
• 1997

Broadband sources for fiber-optic gyroscope were constructed using erbium-doped fibers. Output power, linewidth, and mean wavelength were compared between four different source configurations. Among them, double pass configuration exhibited the highest output power, as high as 5.5 mW with 25 mW pumping at 1.48 ${\mu}{\textrm}{m}$ wavelength. It also showed nearly zero sensitivity of mean wavelength for the variation of pump power when a sufficient pumping was provided. Amplifier/Source configuration resulted in the highest detected power(power received by the gyro detector) that is more than 100 times larger than those of the other configurations, though it was the lowest of source output power. As the feedback level increased, the source power decreased while the linewidth increased, and mean wavelength varied significantly which would affect the scale factor of the gyroscope.

• Proceedings of the Optical Society of Korea Conference
• /
• 2000.02a
• /
• pp.96-97
• /
• 2000

Incoherent broadband optical sources have been applied in various areas such as a light source for optical device characterization, fiber-optic gyroscopes$^{(1)}$ , and spectrum sliced light source in wavelength division multiplexing (WDM) system$^{(2)}$ . To utilize the inherent low loss in silica optical fibers, various types of incoherent light sources are being developed. Among the light sources, the amplified spontaneous emission (ASE) from a rare earth doped fiber has benefits in temperature stability, high output power, low polarization dependence over semiconductor diodes$^{(3)}$ . Recently erbium doped fibers (EDF) have been intensively researched for ASE sources as well as optical amplifiers$^{(4)}$ . The spectrum of ASE from an EDF, however, is limited in the 1520~1560 nm range in conventional configurations. In this letter we described a new broadband ASE source which included both the conventional ASE band of Er$^{3+}$ ion, 1520nm~1560nm and ASE band from Tm$^{3+}$ ions that extends the bandwidth further. For the first time, to the best knowledge of authors, a fiber ASE source based on the energy transfer between Er$^{3+}$ and Tm$^{3+}$ ions in the range of 1460~1550 nm, has been demonstrated using a single 980nm pump laser diode. (omitted)omitted)

• Korean Journal of Optics and Photonics
• /
• v.10 no.1
• /
• pp.47-52
• /
• 1999

This study describes a simple and effective experimental determination of pump-power dependence of refractive indices and dispersions of erbium-doped fibers (EDFs) of various doping concentrations. Systermatical analysis on light-induced change of the refractive indices and dispersion for a signal wavelength range of 1510 nm-1560 nm with a pump of 980 nm wavelength has been made by measuring the pump-induced phase changes of the signal beam in Mach-Zehnder type interferometer, which has an optically pumped EDF and a reference EDF in each of the two arms, respectively. The measured pump-induced refractive indices match well with the theoritically predicted ones. The results show that pump-induced refractivity and dispersion changes of the EDF increase with the increasing pump power and $Er^{3+}$-doping concentration as expected from theory.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.12
• /
• pp.83-91
• /
• 1998

Fiber Bragg grating which has a blazed ang1e to the plane of incident wave generates a side-mode as well as main-mode. The side-mode has an identical characteristics with a long period grating that couples with a cladding mode, so rejects the special wavelength. We experimented on the side-mode characteristics with two fibers which Ge doped depressed index fiber and very high photosensitive H$_2$ loaded step index fiber according to the tilted angle. Also, using a phase mask equipped with rotation plate which has 0.02$^{\circ}$ resolution, we can control the bandwidth and the peak value of a total loss spectrum by aligned tilted grating in a fiber and using this, tried to compose the ASE band rejection filter of the Erbium doped fiber amplifier.

• Information and Communications Magazine
• /
• v.11 no.2
• /
• pp.77-89
• /
• 1994

High speed optical fiber transmission technology has been remarkably improved during the past 20 years. This paper presents recent research status and future technological issues for the future information society, that is, the Tb/s transmission by frequency division multiplexing and the ultra long-distance by optical soliton transmission. Erbium-doped fiber amplifier and recent optical technology have brought optical transmission system of up to 10 Gb/s to the point of commercialization. Taking into account the future super information highway, that is, B-ISDN network, ultra wide-band picture-based information can be provided for many subscribers via existing optical fiber cables. However, to achieve the high speed transmission, the technologies must be developed not only for transmission lines but also for transmission nodes. Since the conventional signal transmission/processing technique using electronics has the limit in its speed, novel photonic technology is being developed for this purpose. On the other hand, optical solitons propagate stably through optical fibers, without pulse broadening effect of the fiber dispersion. Since the pulse broadening effect becomes serious as the transmission speed increases, optical solitons is the important technologies to realize the high speed, long distance transmission.