• International Journal of Naval Architecture and Ocean Engineering
• /
• 제10권2호
• /
• pp.188-200
• /
• 2018

This paper proposes a single control strategy to solve the problem of trans-media vehicle difficult control. The proposed control strategy is just to control the vehicle's air navigation, but not to control the underwater navigation. The hydrodynamic model of a vehicle when entering water obliquely at low speed has been founded to analyze the motion characteristics. Two methods have been used to simulate the vehicle entering water in the same condition: numerical simulation method and theoretical model solving method. And the results of the two methods can validate the hydrodynamic model founded in this paper. The entering water motion in the conditions of different velocity, different angle, and different attack angle has been simulated by this hydrodynamic model and the simulation has been analyzed. And the change rule of the vehicle's gestures and position when entering water has been obtained by analysis. This entering water rule will guide the follow-up of a series of research, such as the underwater navigation, the exiting water process and so on.

• 설비공학논문집
• /
• 제18권12호
• /
• pp.1039-1046
• /
• 2006

The numerical simulations on the train entering a tunnel are performed by solving unsteady axi-symmetric problems. To reduce the effects of the pressure wave generated by the train starting abruptly, several starting methods of the train are examined. The high order velocity increase gives better results than those for the linear velocity increase. The high order velocity increase gives good results for the pressure rise by the train entering a tunnel, too. The distance to the train reaches the highest running velocity from the start should be more than 60 m when the train speed is 350 km/h.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 1999년도 추계학술대회 논문집
• /
• pp.333-343
• /
• 1999

When a high speed train enters a tunnel, wind speed passing through the train in a tunnel section becomes higher due to the reverse flow to the direction of the train. The higher wind speed gives more aerodynamic forces to the pantograph on the train. Therefore, it is necessary to perform aerodynamic and dynamic analyses in order to check whether the current collection of the high speed train, entering the tunnel, still remain permissible or not. In this paper, the aerodynamic analysis has been performed under the assumption that a high speed train at 300 km/h enters a tunnel whose cross sectional area Is 107/㎡ and length is 1000m. In consideration of the aerodynamic analysis results, the dynamic analysis has been performed based on the catenary and pantograph dynamic models in SEOUL-PUSAN high speed rail, using the GASENDO developed by RTRI. In addition, the fatigue life of the contact wire has been reviewed using the Goodman diagram. Based on the analysis results, it is concluded that the increase of the aerodynamic forces on the pantograph in the tunnel section shall not affect characteristics of current collection adversely except that motions of the pantograph may be constrained by bump-stops.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2006년도 추계 학술대회논문집
• /
• pp.189-192
• /
• 2006

The numerical simulations on the train entrering a tunnel were performed by solving unsteady axi-symmetric problems. To reduce the effects of the pressure wave generated by the train starting abruptly, several starting method of the train were also examined. The pressure rise by the train entering a tunnel was compared with other results, and similar value was obtained compared with those of previous studies.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2000년도 춘계 학술대회논문집
• /
• pp.91-98
• /
• 2000

The three-dimensional unsteady compressible Full Navier-Stokes equation solver with sliding multi-block method has been applied to analyze three dimensional characteristics of the flow field and compression wave around the high speed train which Is entering into a tunnel. The numerical scheme of AF + ADI was used to efficiently solve Navier-Stokes equations in the curvilinear coordinate system. The vortex formation around the nose region was found and the generation of compression wave due to the blockage effects was observed ahead of the train in the form of plane wave. The three dimensional characteristics of the flow field compared to the analytic results were discussed in detail. The variation of pressure of tunnel wall surface and velocity profile of the train are identified as the train enters into a tunnel. The changes in aerodynamic forces and streamlines of each specific sections are also discussed and presented.

• 한국전산유체공학회지
• /
• 제5권3호
• /
• pp.23-31
• /
• 2000

The three-dimensional unsteady compressible Full Navier-Stokes equation solver with sliding multi-block method has been applied to analyze three dimensional characteristics of the viscous flow field and compression wave around the high speed train which is entering into a tunnel. The numerical scheme of AF + ADI was used to efficiently solve Navier-Stokes equations in the curvilinear coordinate system. The vortex formation owing to the viscous interaction around the train was found and the generation of compression wave due to the blockage effects was observed ahead of the train in the form of plane wave. The three dimensional characteristics of the flow field compared to the analytic results were discussed in detail. The variation of pressure of tunnel wall surface and velocity profile of the train are identified as the train enters into a tunnel. The changes in aerodynamic forces and streamlines of each specific sections are also discussed.

• 한국유체기계학회 논문집
• /
• 제9권6호
• /
• pp.17-21
• /
• 2006

The numerical simulations on the train entering a tunnel were performed by solving unsteady axi-symmetric problems. In the case that 5th order velocity profile is used to reduce the effects of the pressure wave generated by the train starting abruptly, the effect of the initial distance between the train and the tunnel were examined. The impulsive start gives undesired pressure disturbances to the flow field including inside the tunnel. But 5th order velocity profile with initial distance more than 80 m gives much stable pressure variance in time, and pressure distribution inside the tunnel in space. The distance to the train reaches the highest running velocity from the start should be more than 80 m when the train speed is 350 km/h.

• 한국산학기술학회논문지
• /
• 제16권6호
• /
• pp.3672-3679
• /
• 2015

열차 운행에 따른 전장품들의 발열을 예측하기 위해 동력차 내 벽면온도 및 외부 유출 온도 및 풍속, 외부로부터 유입되는 유입 공기의 유입 온도 및 속도를 측정하였다. 이를 위하여 적외선카메라를 이용하여 고속열차 내부의 전장품 및 벽 표면의 온도를 측정하였다. 또한 전장품에서 발생하는 열은 고속열차 천장에 설치된 덕트를 통하여 외부로 배출된다. 배출되는 공기의 온도 및 속도를 측정하였고, 외부에서 동력차 내부로 들어오는 유입공기의 온도 및 속도도 측정하였다. 또한 부착형 온도센서를 이용하여 동력차 내부의 벽 및 전장품 표면에서의 온도를 측정하였다. 측정된 결과를 이용하여 열차 주행에 따른 전장품의 발열 특성을 분석하였다.

• 대한교통학회지
• /
• 제33권1호
• /
• pp.14-28
• /
• 2015

2000년대 중반부터 인터넷 검색 트래픽을 활용한 다양한 연구가 진행되었다. 대표적으로 구글은 미국의 독감 발병 상황을 인터넷 유저의 검색 패턴을 통해 예측하는 서비스를 만들기도 하였다. 교통지표 역시 인터넷 검색 패턴과 유사할 수 있다는 가설을 확인하기 위하여, 검색 트래픽 데이터를 활용하여 고속도로의 진입 교통량과 구간 속도를 추정하는 모형을 구축하고 적합도 등을 확인하는 것이 본 연구의 목적이다. 그 결과, 첫째, 출퇴근의 상시적 통행이 이루어지는 지점의 TCS 진입 교통량 모형은 구글 검색 트래픽이 입력변수로 우수하였고, 검색 트래픽과는 음의 상관관계를 보였다. 둘째, 여가 통행이 집중적으로 나타났던 지점의 TCS 진입 교통량 모형은 네이버의 검색 트래픽이 입력변수로 선정되었으며, 검색 트래픽과는 양의 상관관계가 나타났다. 셋째, VDS 속도의 경우 시계열 도표상 검색 트래픽과 음의 상관관계를 보였다. 넷째, 검색 트래픽을 입력변수로 활용한 전이함수 잡음 시계열 모형은 그렇지 않은 시계열 모형에 비해 비교적 적합도가 우수하다는 결과를 도출하였다. 다만, VDS 속도 모형의 경우 다수의 입력변수가 포함되고 모형 계수의 부호가 상이함에 따른 한계가 존재하였다. 향후 검색 트래픽의 출처나 검색어, 혹은 시차 및 집계 단위에 대한 추가적 연구가 진행된다면, 교통 분야의 빅 데이터 연구시 활용 폭이 넓어질 것으로 판단된다.

• 소음진동
• /
• 제7권6호
• /
• pp.959-966
• /
• 1997

In general, the booming noise intensity at tunnel exit is strongly related to the gradient of the compression wave front created by high speed train entering the tunnel. This paper presents some results in relation with the compression wave front produced when the high speed train enters a tunnel. Four kinds of tunnel entrance shape with real dimensions were studied to investigate the formation of compression wave front inside tunnel by train entering tunnel. Computations were carried out using three-dimensional compressible Euler equation with vanishing viscosity and conductivity of fluid. According to the results, the flow disturbances occured at tunnel entrance were eliminated by tunnel hood with same cross sectional area. The compression wave front is formed completely at 30-40m from tunnel entrance. The maximum pressure gradient of compression wave front is reduced by 29.8% for the inclined tunnel hood and reduced by 21.5% for the tunnel hood with holes at the top face with tunnel without hood. The length of the inclined hood is 15m and the length of the hood with holes is 20m.