• Asia-pacific Journal of Multimedia Services Convergent with Art, Humanities, and Sociology
• /
• v.7 no.1
• /
• pp.219-227
• /
• 2017

Current military command information system uses electronic equipment a lot on which semiconductor chip is attached. It seems its' importance will increase more with latest information communication technology developing. Electronic equipment which uses electricity contains regular tolerance to high output electric signal. And EMC specification is the standardized of this electronic equipment's tolerance. On the other hand, the Institute of Atomic Energy Research has ever declared that high output electromagnetic pulse(EMP) will be broken out within the radius of 170Km when 10kt nuclear explosion occurs at an altitude of 40Km above Seoul. Then, the region suffer from the damage of most electronic equipments. Therefore, the norm to protect the influences in that case is defined by EMP protection specification. Most common electronic equipments meet the EMC norm, but there is no way to check whether they meet the EMP norm or not. That is because it is difficult to check whether they meet EMP protection norm and is on the matter of cost. Except inevitable cases, there is no review of checking whether they meet the norm or not. Considering the above, in this research, we speculate about the measures to improve military EMP protection ability by analyzing the EMC-EMP correlation and checking the EMP protection ability of general electronic equipment through the analysis.

• Korean Chemical Engineering Research
• /
• v.61 no.3
• /
• pp.362-367
• /
• 2023

Recently, research and development of proton exchange membrane fuel cells (PEMFC) membranes are progressing in the direction of thinning to reduce prices and improve performance. Demand for hydrogen-powered vehicles for commercial vehicles is also increasing, and their durability should be five times greater than those for passenger vehicles. Despite the thinning of the membranes, the durability of the membranes must be increased five times, so the improvement of the durability of the membranes has become more important. Since the acceleration durability evaluation time also needs to be shortened, the protocol using oxygen instead of air in the existing protocol was applied to a 10 ㎛ thin membrane to evaluate durability. The accelerated durability test (Open circuit voltage holding) was terminated at 720 hours. If the air-based department of energy (DOE) protocol was used, a lifespan of 450,000 km of driving hours would be expected, with a durability of about 1,500 hours. During the chemical durability evaluation, the active area of the electrode decreased by 51%, suggesting that catalyst degradation had an effect on membrane durability. Reducing the catalyst degradation rate is expected to increase membrane durability.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.30 no.3B
• /
• pp.285-293
• /
• 2010

Soil moisture is a key factor to control the exchange of water and energy between the surface and the atmosphere. In recent, many researches for spatial and temporal variability analyses of soil moisture have been conducted. In this study, we analyzed the spatio-temporal variability of soil moisture in Walnut Gulch Experimental Watershed, Arizona, U.S. during the Soil Moisture Experiment 2004 (SMEX04). The spatio-temporal variability analyses were performed to understand sensitivity of five observation sites with precipitation and relationship between mean soil moisture, and its standard deviation and coefficient of variation at the sites, respectively. It was identified that log-normal distribution was superior to replicate soil moisture spatial patterns. In addition, precipitation was identified as a key physical factor to understand spatio-temporal variability of soil moisure based on the temporal stability analysis. Based on current results, higher spatial variability was also observed which was agreed with the results of previous studies. The results from this study should be essential for improvement of the remotely sensed soil moisture retrieval algorithm.

• Journal of Wetlands Research
• /
• v.25 no.4
• /
• pp.394-407
• /
• 2023

Ecological restoration is an ecological technology that diagnoses problematic ecological spaces and restores the damaged ecosystem to a healthy appearance similar to its original appearance based on reference information obtained by analyzing intact nature. To achieve successful restoration, the project must be carried out in respect of a series of procedures. However, in Korea, restoration projects are usually actively promoted regardless of diagnostic evaluation, which wastes cost and energy, and the effect is not significant. As the reference information is not utilized, ecological restoration to return the damaged nature makes features different greatly from the appearance of nature, causing another damage. As the restoration effect is not evaluated, it is impossible to determine whether it is successful or not, and as a result, even if the project continues, there is no development and no effect. However, advanced societies have not only made academic progress by respecting these procedures but also have great economic effects along with the improvement of environmental conditions as ecological restoration has become an industry. Therefore, the international society recognizes ecological restoration as an important means of solving environmental problems at the global level, including climate change, and international organizations are actively promoting projects to treat the injured planet. However, most of the restoration projects promoted in Korea were evaluated below the level as a result of the evaluation of the effect. Nevertheless, those who have led low-quality projects are blocking plans to establish ecological restoration as a new industry that can contribute significantly to improving these levels, and thus the problem is expected to worsen. To solve this problem, it is necessary to filter out defective businesses by introducing a strict and correct project evaluation system by dividing it into before and after. Furthermore, it is necessary to establish ecological restoration as an industry and leave the process in the principles of the market.

• Animal Bioscience
• /
• v.36 no.11
• /
• pp.1666-1684
• /
• 2023

Objective: Our objective was to examine the relationships of supplemental rumen-protected lysine (RPL) or lysine + methionine (RPLM) on lactational performance, plasma amino acids (AA) concentration, and nitrogen use efficiency of lactating dairy cows by using a meta-analysis approach. Methods: A total of 56 articles comprising 77 experiments with either RPL or RPLM supplementation were selected and analyzed using a mixed model methodology by considering the treatments and other potential covariates as fixed effects and different experiments as random effects. Results: In early lactating cows, milk yield was linearly increased by RPL (β₁ = 0.013; p<0.001) and RPLM (β₁ = 0.014; p<0.028) but 3.5% fat-corrected milk (FCM) and energy-corrected milk (ECM) (kg/d) was increased by only RPL. RPL and RPLM did not affect dry matter intake (DMI) but positively increased (p<0.05) dairy efficiency (Milk yield/DMI and ECM/DMI). As a percentage, milk fat, protein, and lactose were unchanged by RPL or RPLM but the yield of all components was increased (p<0.05) by feeding RPL while only milk protein was increased by feeding RPLM. Plasma Lys concentration was linearly increased (p<0.05) with increasing supplemental RPL while plasma Met increased (p<0.05) by RPLM supplementation. The increase in plasma Lys had a strong linear relationship (R² = 0.693 in the RPL dataset and R² = 0.769 in the RPLM dataset) on milk protein synthesis (g/d) during early lactation. Nitrogen metabolism parameters were not affected by feeding RPL or RPLM, either top-dress or when supplemented to deficient diets. Lactation performance did not differ between AA-deficient or AA-adequate diets in response to RPL or RPLM supplementation. Conclusion: RPL or RPLM showed a positive linear relationship on the lactational performance of dairy cows whereas greater improvement effects were observed during early lactation. Supplementing RPL or RPLM is recommended on deficient-AA diet but not on adequate-AA diet.

• Tunnel and Underground Space
• /
• v.33 no.6
• /
• pp.519-533
• /
• 2023

In this study, the linear cutting tests of pick cutters were carried out on a granitic rock with the average compressive strength over 100 MPa. From the tests, the correlation between the cutter acting force and the temperature measured by infrared thermal imaging camera during rock cutting was analyzed. In every experimental condition, the maximum temperature was measured at the rock surface where the chipping occurred, and the temperature generated in the rock was closely correlated with the cutter acting force. On the other hand, the temperature of a pick cutter increased up to only 36℃ above the ambient temperature, and the correlation with the cutter force was not obvious. This can be attributed to the short cutting distance under laboratory conditions and the high thermal conductivity of the tungsten carbide inserts. However, the relatively high temperature of the tungsten carbide inserts was found to be maintained. Therefore, it is recommended that a reinforcement between the insert and the head of a pick cutter or the quality improvement of silvering brazing in the production of a cutter is necessary to maintain the high cutting performance of a pick cutter.

• Journal of Advanced Navigation Technology
• /
• v.27 no.6
• /
• pp.835-840
• /
• 2023

RFID(Radio Frequency Identification) systems are attracting attention as a key component of Internet of Things technology due to the cost and energy efficiency of application services. In order to use RFID technology in the IoT application service field, it is necessary to be able to store and manage various information for a long period of time as well as simple recognition between the reader and tag of the RFID system. And in order to read and write information to tags, a performance improvement technology that is strong and reliable in poor wireless channels is needed. In particular, in the UHF(Ultra High Frequency) RFID system, since multiple tags communicate passively in a crowded environment, it is essential to improve the recognition rate and transmission speed of individual tags. In this paper, Middleton's Class A impulsive noise model was selected to analyze the performance of the RFID system in an impulsive noise environment, and FM0 encoding and Miller encoding were applied to the tag to analyze the error rate performance of the RFID system. As a result of analyzing the performance of the RFID system in Middleton's Class A impulsive noise channel, it was found that the larger the Gaussian noise to impulsive noise power ratio and the impulsive noise index, the more similar the characteristics to the Gaussian noise channel.

• The Journal of the Convergence on Culture Technology
• /
• v.10 no.1
• /
• pp.403-409
• /
• 2024

In this paper, the guidelines for the design of an Artificial Intelligence(AI) based Integrated Process Safety Management(PSM) system to enhance workplace safety using data from process safety reports submitted by hazardous and risky facility operators in accordance with the Occupational Safety and Health Act is proposed. The system composed of the proposed guidelines is to be implemented separately by individual facility operators and specialized process safety management agencies for single or multiple workplaces. It is structured with key components and stages, including data collection and preprocessing, expansion and segmentation, labeling, and the construction of training datasets. It enables the collection of process operation data and change approval data from various processes, allowing potential fault prediction and maintenance planning through the analysis of all data generated in workplace operations, thereby supporting decision-making during process operation. Moreover, it offers utility and effectiveness in time and cost savings, detection and prediction of various risk factors, including human errors, and continuous model improvement through the use of accurate and reliable training data and specialized datasets. Through this approach, it becomes possible to enhance workplace safety and prevent accidents.

• Journal of Animal Science and Technology
• /
• v.66 no.2
• /
• pp.310-325
• /
• 2024

Glyconutrients help in the body's cell communication. Glyconutrients and synbiotics are promising options for improving immune function. Therefore, we hypothesized that combining synbiotics and glyconutrients will enhance pig nutrient utilization. 150 pigs (Landrace × Yorkshire × Duroc), initially weighing 58.85 ± 3.30 kg of live body weight (BW) were utilized to determine the effects of synbiotics-glyconutrients (SGN) on the pigs' performance, feed efficiency, gas emission, pork traits, and composition of fatty acids. The pigs were matched by BW and sex and chosen at random to 1 of 3 diet treatments: control = Basal diet; TRT1 = Basal diet + SGN 0.15%; TRT2 = Basal diet + SGN 0.30%%. The trials were conducted in two phases (weeks 1-5 and weeks 5-10). The average daily gain was increased in pigs fed a basal diet with SGN (p = 0.036) in weeks 5-10. However, the apparent total tract digestibility of dry matter, nitrogen, and gross energy did not differ among the treatments (p > 0.05). Dietary treatments had no effect on NH₃, H₂S, methyl mercaptans, acetic acids, and CO₂ emissions (p > 0.05). Improvement in drip loss on day 7 (p = 0.053) and tendency in the cooking loss were observed (p = 0.070) in a group fed basal diets and SGN at 0.30% inclusion level. The group supplemented with 0.30% of SGN had higher levels of palmitoleic acid (C16:1), margaric acid (C17:0), omega-3 fatty acid, omega-6 fatty acid, and ω-6: ω-3 ratio (p = 0.034, 0.020, 0.025, 0.007, and 0.003, respectively) in the fat of finishing pigs. Furthermore, group supplemented with 0.30% of SGN improved margaric acid (C17:0), linoleic acid (C18:2n6c), arachidic acid (C20:0), omega 6 fatty acid, omega-6 to omega-3 ratio, unsaturated fatty acid, and monounsaturated fatty acid (p = 0.037, 0.05, 0.0142, 0.036, 0.033, 0.020, and 0.045, respectively) in the lean tissues of finishing pigs compared to pigs fed with the control diets. In conclusion, the combination of probiotics, prebiotics, and glyconutrients led to higher average daily gain, improved the quality of pork, and more favorable fatty acid composition. Therefore, these results contributed to a better understanding of the potential of SGN combinations as a feed additive for pigs.

• The Korean Journal of Quaternary Research
• /
• v.31 no.2
• /
• pp.31-42
• /
• 2017

Oahu Island is the third largest island of the Hawaiian chain which located in the northern hemisphere close to the center of the Pacific Ocean and is affected by storms and tsunamis in the northern and southern hemispheres. High-wave and high-energy waves are concentrated in the winter and summer, and the Oahu Coast is always in an active erosion environment. These natural effects are likely to become more severe with global warming and sea level rise. In addition, as the anthropogenic factors, there was indiscreet flood of development on the coast until the 1972 coastal management law was enacted. However, the present coastal erosion phenomenon was not serious than thought. The cause can be found in the improvement of the coastal management of the provincial government. The Hawaiian government is no longer applying this method, which was built prior to the enactment of the Coastal Control Act, due to increased erosion and side effects at other sites. So, in Hawaii, it is mainly applied to soft revetment methods such as supplying sand or making artificial sand dunes as an erosion prevention method. In Korea, there are some places where the soft revetment method is applied partially, but it is mainly composed of hard revetment structure.