• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.3
• /
• pp.1288-1295
• /
• 2012

Korea Ministry of Knowledge Economy has estimated that wind power (WP) will be occupied 37% in 2020 and 42% in 2030 of the new energy sources, and also green energies such as photovoltaic (PV) and WP are expected to be interconnected with the distribution system because of Renewable Portfolio Standard (RPS) starting from 2012. However, when a large scale wind power plant (over 3[MW]) is connected to the traditional distribution system, protective devices (mainly OCR and OCGR of re-closer) will be occurred mal-function problems due to changed fault currents it be caused by Wye-grounded/Delta winding of interconnection transformer and %impedance of WP's turbine. Therefore, when Double-Fed Induction Generator (DFIG) of typical WP's Generator is connected into distribution system, this paper deals with analysis three-phase short, line to line short and a single line ground faults current by using the symmetrical components of fault analysis and PSCAD/EMTDC modeling.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.16 no.1
• /
• pp.51-61
• /
• 2014

It is necessary to perform a dynamic analysis to numerically evaluate the effect of blasting on nearby facilities. The blast load time history, which cannot be directly measured, is most often determined from empirical equation. The load has to be adjusted to account for various factors influencing the load and the frequency, but there is not a clear guideline on how to adjust the load. In this study, a series of 2D dynamic numerical analyses that simulates a closely monitored test blasting is performed, from which the blast load that matches the measured vibrations are derived. In the analyses, it is assumed that the hole generated by the blasting is in the form of a circle, and the load was applied normally to the wall of the opening. Special attention was given in selecting the damping ratio for the ground, since it has important influence on the wave propagation and attenuation characteristics of the blast induce waves. The damping ratio was selected such that it matches favorably with the attenuation curve of the measurement. The analyses demonstrate that the empirical blast load widely used in practice highly overstimates the vibration since it does not account for the energy loss due to rock fragmentation. If the empirical load is used without proper adjustment, the numerical analysis may seriously overstimate the predicted vibration, and thus has to be reduced in the analysis.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.8
• /
• pp.417-428
• /
• 2020

Housekeeping genes are expressed in cells of all organisms and perform basic cellular functions such as energy generation, substance synthesis, cell death, and cell defense. Accordingly, the expression levels of housekeeping genes are relatively constant, and thus they are used as reference genes in gene expression studies, such as protein expression and mRNA expression analysis of target genes. However, the levels of expression of these genes may be different among various tissues or cells and may change under certain circumstances. Therefore, it is important to select the best reference gene for specific gene expression research by exploring the stability of housekeeping gene expression. This review summarizes housekeeping genes found in humans, chickens, pigs, and rats in the literature and estimates expression stability using geNorm, NormFinder, and BestKeeper software. The most suitable reference housekeeping gene can selected based on expression stability according to the experimental conditions of the gene expression study and can thus be applied to data normalization.

• Journal of Nutrition and Health
• /
• v.40 no.1
• /
• pp.78-88
• /
• 2007

The purpose of this study was to investigate dietary fat and individual fatty acids intake pattern of 174 college women living in Seoul and Gyong-gi province through internet nutritional assessment system. Each of the subjects was required to input their own food intake for three days, which included two days during the week and one day of the weekend, on the web program directly and all of the data collected were used for statistical analysis. The mean daily caloric intake of the subjects was 1,500.9 kcal which was at 71.5% of Estimated Energy Requirement (EER). Dietary fat contributed 27.6% of the total caloric intake which was slightly higher than the recommended limit of 25%. Daily cholesterol intake was 310.0 mg, which was also high to some degree. Mean daily N6 and N3 fatty acid intake was 6.1 g and 0.9 g, respectively, and calory % calculated from each were 3.63% and 0.53%. This result showed the intake of N3 fatty acid fell in Acceptable Macronutrient Distribution Ranges (AMR) $0.5\sim1.0%$ but that of N6 fatty acid was somewhat lower than the AMDR $4\sim8%$. N6/N3 ratio 8.5/l, however, was within the desirable range $4\sim10/1$. Considering overall dietary fatty acids intake, oleic acid was the most abundant, followed by linoleic and palmitic acid. And among polyunsaturated fatty acids intake, linoleic acid was exclusively high, accounting for 97.4% of total N6 fatty acid intake. On the contrary, three fatty acids, linolenic (67.3%), DHA (21.1%) and EPA (10.0%), together supplied 98.4% of total N3 fatty acid intake. Mean P/M/S was 0.9/l.1/1.0. The subjects' intake of fat, many fatty acids and cholesterol came from diverse food groups including meats, fats and oils, milk and milk products, eggs, fish, and soybean products. Nevertheless, the subjects tended to show unfavorable fat and fatty acids intake pattern in terms of quantity and quality. Based on these results, it is important to monitor dietary fat intake pattern of the general population continuously and an internet program such as the one used for this study would be valuable, especially for assessing dietary patterns in the younger generation.

• Journal of Korean Society of Environmental Engineers
• /
• v.32 no.1
• /
• pp.79-86
• /
• 2010

Effects of operating parameters such as applied voltage, solution conductivity, ferrous ion concentration, electrode material on phenol degradation by pulsed corona discharges were investigated in laboratory scale experiments. The increase of applied voltage enhanced the phenol degradation by generating more energetic electrons. The solution conductivity inversely affected phenol removal rate in the tested ranges because the increase of conductivity decreased the electric field strength through the liquid phase. The addition of ferrous sulfate promoted the phenol degradation through the OH radical production by the Fentonlike reactions between ferrous ion and hydrogen peroxide generated by pulsed corona discharges. Catechol and hydroquinone were detected as primary intermediates of phenol degradation and the decrease of pH and the increase of conductivity were observed probably due to the generation of organic acids. Almost all of the initial phenol was disappeared and 29% of total organic corbon (TOC) was removed in the condition of 0.5 mM of ferrous sulfate after approximately 230 kJ of discharge energy transferred to the reactor.

• Journal of Korean Society of Environmental Engineers
• /
• v.38 no.3
• /
• pp.101-109
• /
• 2016

This research is to explore food waste management across local governments. In particular, pubic administration on food waste, food waste management (from generation to disposal) and civil complaints in jurisdiction are examined. In doing so, a self-administered questionnaire survey was conducted among civil officers in charge of food waste management, and all the collected responses were statistically analyzed. The main results were as follows: public spending on food waste management was a little larger in metropolises than in provincial cities, and the largest food waste source was identified as households (in housing). While regular collection of food waste by trucks was the most common transport method adopted by local governments, resource recovery for compost/fertilizer production was widely used. Also, most of the respondents agreed that the current approach to food waste handling practices are necessarily replaced with more advanced technology converting waste into energy or fuel. Further, it's found that the civil complaints on food waste management were largely categorized into 3 groups - food waste handling, civil service and food waste retrieval. Therefore, the findings indicate that the development and application of no-food waste or waste-to-resource systems are effective in housing estates where large amount of food waste is generated and eliminated.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.10 no.4
• /
• pp.63-68
• /
• 2010

Utility-Pipe Conduit is, Housing and city effectively accommodate what they absolutely need power, communications, gas, pipeline, water supply, drainage, energy facilities etc, according to expansion of urban infrastructure are derived, several ways to solve problems in, collection facilities in place are maintained and managed facility. If Utility-Pipe Conduit is damaged, as well as national security, because their impact on society as a whole, by introducing large vulnerability in the fire prevention activities and suppression measures and disaster for our situation by introducing measures, comprehensive analysis of the fire risk, it shall establish fire prevention activities and suppression through analysis of Utility-Pipe Conduit design, institutional issues, the problem of fire protection facilities, fire spread phenomenon etc. Because of Utility-Pipe Conduit is an enclosed place, so incomplete combustion due to lack of oxygen supply that there are problem such dark smoke, carbon monoxide etc, toxic combustion products and heat generation and visual impairment is an issue difficult to enter. As well as fire prevention activities, the fire In light of the particularity of the under ground than above ground fire, so this phenomenon is weak fire fighting that fire to become effective fire fighting tactics, basically it is necessary difficulty softening, non-burn softening and prevent combustion expansion of the cable is installed on the Utility-Pipe Conduit, having to considering the specificity of the response command system and relevant organizations to establish an on-site, Structural identification and other information gathering required to record of Response agencies, keep air conditioning system 24 hours and strengthening Virtual Total Training of Response agen

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.8C
• /
• pp.633-641
• /
• 2008

Since WSNs encounter attacks, such as jamming or eavesdropping without physical access occurs, security is one of the important requirements for WSNs. The key pre-distribution scheme that was recently researched for advance of security in WSNs distributes the keys and probability with the use of q-composite random key pre-distribution method, but there is a high probability that no key shared between sensor nodes, and it takes a lot of time and energy to find out the shared key. Therefore, it is not suitable for WSNs. In order to enhance stability of a node that plays a role of gateway without depending on probabilistic key, this paper proposesa key pre-distribution scheme combined with random key pre-distribution scheme and double hash chain. Since the proposed scheme can maintain a small storage place and strong security strengths, it is more efficient than the existing schemes with the same security strengths. In addition, since it uses a small size of key generation key set, it can reduce a great deal of storage overhead.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.4
• /
• pp.143-153
• /
• 2018

Environmental regulations, which are discussed through the International Maritime Organization, focus on two aspects: the economic supply of fuel oil and, ultimately, securing next-generation energy sources. At present, there are limitations in relation to the basic quality of fuel oil and the direct relation through basic quality when applied to ships and traps in relation to environmental regulations, and the standard for the basic quality of fuel oil is generally used. There are many cases where the composition is very complicated, and the interpretation and analysis of basic quality deviate from the range of the basic standard. In other words, it is difficult to classify and apply the problem when analyzing it in connection with fuel quality and ship operations. In this paper are various factors for the basic quality of fuel oil, and a proposed possibility for the scope of the standard.

• Korean Journal of Microbiology
• /
• v.52 no.4
• /
• pp.391-397
• /
• 2016

Clostridium is a genus of Gram-positive, rod shape, spore-forming obligate anaerobe. Recently, Clostridium has been attracted as a host for bio-based chemical production, due to its diversity of substrate utilization and the production ability for metabolites which can be used as a building block for chemical production. Especially, butanol produced from Clostridium has been considered as an alternative fuel. As a transportation fuel, butanol has a higher energy density and lower hygroscopicity compared to ethanol, the first generation biofuel. Recently, metabolic engineering of Clostridium has been massively conducted for butanol production. In this study, the metabolic engineering strategy of Clostridium for butanol production has been reviewed with a brief perspective.