• 한국가스학회:학술대회논문집
• /
• 한국가스학회 1998년도 추계학술발표회 논문집
• /
• pp.255-260
• /
• 1998

This study describes the results of Coefficient Of Performance(COP) analysis by cycle simulation for two types of absorption-compression hybride cycle using the water/Lithium Bromide solution pair, These types are basic hybride systems introducing a mechanical compression process into the refrigerant vapor phase of the single effect absorption cycle. In absorption-compression hybrid cycles, coefficient of performance is improved compared with absorption cycle. Hybride cycle Type ll is considered as a key technology to support energy utilization system, given its capability of utilizing waste heat to drive system with a high level of efficiency.

• 한국진공학회지
• /
• 제8권2호
• /
• pp.153-157
• /
• 1999

The dependence of the absorption edge of wurtzite $Al_xGa_{1-x}N$ on alN mole fraction has been studied. The AlN mole fraction was varied from 0 to 1. The absorption coefficients at room temperature were determined by transmission and photothermal deflection spectroscopy. Photothermal deflection spectroscopy can be applied to determine the low absorbance values. From the results, the effective bandgaps of $Al_xGa_{1-x}N$ alloys were determined by choosing corresponding photon energies of the positions of the absorption coefficient of $6.3\times10^4\textrm{cm}^{-1}$ at the absorption curves of the $Al_xGa_{1-x}N$ alloys. From the energy position of the absorption coefficient versus AlN mole fraction, a bowing parameter of 1.3eV was determined. The bowing parameter agreed quite well with the measured effective bandgaps of AlGaN alloys.

• 한국전기전자재료학회논문지
• /
• 제30권12호
• /
• pp.817-821
• /
• 2017

As a ZnO varistor is subjected to electrical and environmental stresses, it degrades gradually, which may result in power interruption by short circuit. This study investigates changes in the electrical characteristics of ZnO varistors due to deterioration owing to energy absorption, and determines the optimal parameters for on-line diagnosis of the varistor. Two types of varistors were used for an accelerated aging experiment involving the application of the $8/20{\mu}s$ standard lightning impulse current. The electrical characteristics in terms of the reference voltage, total leakage current, resistive leakage current, and third-harmonic component of the total leakage current were measured, and their change rates were analyzed. The results revealed that the total leakage current increased slightly with an increase in the varistor absorbed energy, while the resistive leakage current and the third-harmonic component increased apparently. Therefore, the third-harmonic component of the total leakage current was proposed as the optimal parameter for on-line monitoring of ZnO varistor conditions.

• 한국환경과학회지
• /
• 제6권4호
• /
• pp.391-397
• /
• 1997

The study was carried out to demonstrate the superiority of used packing in view of energy saving and efficiency of mass transfer, comparing with conventional packing. The results are as follows : 1. Owing to low Pressure drop under high load. 25mm NSW-ring, pp. can cause energy saving 2. The unique magnitudes of used packing are as follows $C_G$=5.78, m=0.67, n=0.46 3. Used packing can make high efficiency including energy saving because of low pres sure drop per the number of transfer unit. To rate the characteristic of packing, It should be carried out that the measurement of pressure drop per packing height and per the number of transfer unfit. This study demonstrated the superiority of used packing by carring out above experiment and could be used as basic reference for design and predicting efficiency of packing tower which is tilled with same packing.

• 에너지공학
• /
• 제7권2호
• /
• pp.231-240
• /
• 1998

CFC계 냉매에 의한 지구환경문제 야기, 여름철 피크전력의 증가뿐만 아니라 열회수 시스템에서의 손실로 인하여 고성능 흡수냉동시스템의 개발은 이 문제를 해결할 수 있는 유망한 방법중의 하나이다. 하수처리수를 이용한 흡수식 냉동시스템은 환경보호와 에너지 보존의 측면에서 유용하다. 본 연구에서는 2중효용 병렬 및 직렬방식에 대한 사이클 시뮬레이션 해석을 수행하였다. 신작동매체로 LiBr+LiI+LiCl+LiNO3 용액을 선택하였다. 이 연구의 주된 목적은 흡수기와 응축기의 냉각수로써 하수처리수를 효과적으로 이용할 수 있는 가능성을 평가하는 것과 2중효용 병렬과 직렬방식에 영향을 미치는 신작동매체의 특성을 파악하고 최적설계조건을 찾고자 하는 것이다. 본 연구에서 사이클 시뮬레이션을 통하여 신작동매체를 사용하는 흡수식 냉동기의 특성을 파악했으며 이를 기존의 LiBr 수용액을 사용하는 흡수식 냉동기와 비교평가하였다. 신작동매체를 이용한 흡수식 냉동기는 LiBr 수용액을 사용하는 경우보다 COP의 향상과 시스템의 소형화가 가능하다는 것을 알 수 있었다.

• 대한기계학회논문집A
• /
• 제22권4호
• /
• pp.826-833
• /
• 1998

The energy-absorbing characteristic of impact limiters affects the cask design so significantly that it should be evaluated as accurate as possible. The objective of this study is to find the influence of the impact limiter's steel case and gusset plates which enclose the shock absorbing cellular material on the impact energy absorption. The influence of impact limiter's steel case and gusset plate stiffeners on the impact energy absorption behavior under horizontal drop impact was evaluated for a radioactive isotope transport cask. Though the impact limiters mitigate the impact damage of the cask, the impact limiter's steel case and gusset plate stiffeners increase the impact force so significantly that should be designed as soft as possible. The impact analysis without considering impact limiter's steel case and gusset plates stiffener gives non-conservative results, so the stiffness of the steel case and gusset plates should be considered in impact analysis.

• 한국안전학회지
• /
• 제30권6호
• /
• pp.12-17
• /
• 2015

In this study, the collapse characteristic of CFRP/Al compound square tube was investigated experimentally. The conclusions are as follows; The impact collapse characteristic of CFRP/Al compound square tube was found to be the most superior stacking conditions $[90^{\circ}]_8$. It showed that a very stable collapse mode was crushing. In the member with $[0_2{^{\circ}}/90_2{^{\circ}}]_s$ and $[90_2{^{\circ}}/0_2{^{\circ}}]_s$, stacking conditions, $0^{\circ}$ fibers were splayed to the external by laminar bending, while the $90^{\circ}$ fibers were held between the folds of the aluminum member by laminar bending, local buckling and transverse crack. In the member with $[45_2{^{\circ}}/45_2{^{\circ}}]_s$ stacking conditions, fibers were held between the folds of the aluminum member by local buckling and transverse crack.

• 한국가스학회지
• /
• 제3권1호
• /
• pp.14-20
• /
• 1999

[ $H_2O/LiBr$ ]계 흡수식 사이클에 압축기를 조합한 흡수압축사이클을 도입하여 증기를 단열압축시켜 그 증기의 응축열을 재생열로 이용하는 사이클에 대해서 시뮬레이션을 통하여 횹수압축사이클의 특성을 밝힌 연구이다. 기존의 흡수사이클에 압축기를 도입함에 따라 고효율 사이클을 실현할 수 있음을 제시하였으며, 흡수$\cdot$압축사이클의 구체적인 가능성을 제시하였다. 재생기에서 발생한 냉매증기를 단열압축시킨 TYPE 2는 단열압축 증기의 응축열만으로는 재생이 어려우므로 외부로부터 별도의 열량을 투입해야 하며 투입하는 외부열량에 폐열이나 2차 에너지를 이용할 수 있다면 높은 COP를 얻을 수 있어 실현가능성이 높다.

• 한국해양환경ㆍ에너지학회지
• /
• 제10권3호
• /
• pp.173-180
• /
• 2007

파력에너지 변환을 위해 설계된 착저식 진동수주형 공기실 내의 파진폭 변화를 우리나라 연안의 특징적인 파랑 조건을 적용하여 조사하였다. 진동수주형 공기실의 형상인자가 파력에너지 변환에 미치는 영향을 파력에너지의 흡수 효율 관점에서 분석하였다. 실험적 및 수치적 접근법을 함께 사용하여 그 결과들을 상호 비교하였으며, 주어진 파랑 분포 하에서 파력에너지 흡수가 최대가 되는 형상인자들의 최적화를 목적으로 연구가 수행되었다. 실험은 공기실의 이차적원 형상을 가정하여 이차원 조파수조에서 실시되었으며, 수치적 해석은 공기실 내에서는 변동하는 공기압을 고려할 수 있도록 Rankine Green 함수를 적용하고 공기실 밖에서는 Kelvin Green 함수를 적용하는 합성 적분방정식에 기초하여 수행되었다. 공기실 상부의 덕트 직경, 공기실 폭, 공기실 전면벽 및 후면벽의 깊이는 흡수되는 파력에너지의 크기와 정점 주기를 민감하게 변화시키는 주요한 형상인자들임을 확인하였다.

• 대한기계학회논문집A
• /
• 제30권3호
• /
• pp.241-248
• /
• 2006

Shoe cushioning systems are important to prevent body injuries. This study developed and evaluated a cushioning system to reduce impact force on the heel. The cushioning system suggested consist of a polyurethane pocket, which contains water and porous grains of open cell to dissipate the energy effectively. Load-displacement curves fer the shoe cushioning system were obtained from an instrumented testing machine and the results were compared with various pockets with air, water or grains. Mechanical testings showed that the pocket with 5g porous grain was the best for the cushioning system. This system can be applied to the design of various kind of sport shoes.