• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.3
• /
• pp.1600-1604
• /
• 2015

As modern houses are constructed with high-density and high-insulation, there is benefit to reduce energy consumption, but there are many side effects raised from polluted air. To solve the problem, a ventilation system is used to improve a indoor air quality. In this research, we experimentally estimate ventilation performance of HRV(heat recovery ventilator) with heat-pipe according to working fluid filling quantity and ventilation. Heat-pipe used in this study was designated separately to be applied to a ventilation system. The working fluid was R22, which was filled from 40 to 55 (%vol.) by 5(%vol.). Ventilation based on the front velocity was measured from 0.3 m/s to 1.5 m/s by 0.3 m/s intervals. Refrigerant filling quantity with the highest efficiency was found to depend on the ventilation. From this study the optimal refrigerant filling quantity in accordance with the ventilation of the detachable heat pipes was found experimentally.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.11B
• /
• pp.1363-1372
• /
• 2011

Flooding based routing protocols are usually used to disseminate information in wireless sensor networks. Those approaches, however, require message retransmissions to all nodes and induce huge collision rate and high energy consumption. In this paper, HoGoP (Hop based Gossiping Protocol) in which all nodes consider the number of hops from sink node to them, and decide own gossiping probabilities, is introduced. A node can decide its gossiping probability according to the required average reception percentage and the number of parent nodes which is counted with the difference between its hop and neighbors' ones. Therefore the decision of gossiping probability for network topology is adaptive and this approach achieves higher message reception percentage with low message retransmission than the flooding scheme. Through simulation, we compare the proposed protocol with some previous ones and evaluate its performance in terms of average reception percentage, average forwarding percentage, and forwarding efficiency. In addition, average reception percentage is analyzed according to the application requirement.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.11 no.3
• /
• pp.1510-1532
• /
• 2017

In smart grid, privacy implications to individuals and their families are an important issue because of the fine-grained usage data collection. Wireless communications are utilized by many utility companies to obtain information. Network coding is exploited in smart grids, to enhance network performance in terms of throughput, delay, robustness, and energy consumption. However, random linear network coding introduces a new challenge for privacy preserving due to the encoding of data and updating of coefficients in forwarder nodes. We propose a distributed privacy preserving scheme for random linear network coding in smart grid that considers the converged flows character of the smart grid and exploits a homomorphic encryption function to decrease the complexities in the forwarder node. It offers a data confidentiality privacy preserving feature, which can efficiently thwart traffic analysis. The data of the packet is encrypted and the tag of the packet is encrypted by a homomorphic encryption function. The forwarder node random linearly codes the encrypted data and directly processes the cryptotext tags based on the homomorphism feature. Extensive security analysis and performance evaluations demonstrate the validity and efficiency of the proposed scheme.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.14 no.6
• /
• pp.207-213
• /
• 2014

In this paper, we propose Bluetooth based on efficient indoor-emotion-lighting control system. The proposed Bluetooth based on indoor-emotion-lighting control system was designed to be automatically controlled by the motion sensor light and using a Bluetooth module may be controlled to light up or mobile PC, wall pad. In addition, It was designed the LED lighting On/Off control the environment according to Humidity, the temperature, illumination, motion sensors. System based on the bluetooth is automatic control possible using the illumination sensor, and by selecting the desired lighting partial control can be designed. The experimental efficiency results of the proposed indoor-emotion-lighting control system were designed to provide an internal environment adapted to a resident, were able to maximize the energy savings, have reduced power consumption than the traditional simple On/Off control system.

• KIEAE Journal
• /
• v.16 no.3
• /
• pp.77-82
• /
• 2016

Purpose: The aim of this study is to calculate U-factor of the window using international standard methods and compare quantitative and tendency difference focused on ISO standard 15099 and ISO standard 10077. And the result of ISO standard calculation methods is verified using thermal performance experiment to evaluate applicability of domestic certification system. This study is utilized a basis for activation of domestic window certification system. Method: First, 16 cases are selected that is combined a variety of frame, Glazing, spacer, etc. The selected cases were simulated using WINDOW&THERM based on ISO 15099 and 10077 calculation method. Second, experiment was conducted based on Korean standard condition. Then, it was compared the error of experiment and simulation results. Through this process, ISO 15099 and 10077 calculation methods were evaluated accuracy and utilization. Result: The results show that the difference of ISO 15099 and ISO 10077-2 is maximum 5.4%. The results of comparing U-factor errors based on the Korea standard experiment test found 2.4%. Consequently, it will be possible to combination calculation methods of ISO 15099 and ISO 10077 for a single window.

• Journal of the Korean GEO-environmental Society
• /
• v.11 no.10
• /
• pp.49-55
• /
• 2010

The oil spill occurred frequently due to probably the increased consumption of oil as the energy source and the raw materials of various chemicals. For the treatment of oil contaminated groundwater, DAF(Dissolved Air Flotation) is being used but the removal efficiency is low. Therefore it is necessary to reduce the free phase oil, oil-in water type or water-in oil type emulsified oil, and soluble oil which are the main sources of contaminated groundwater. In this study, treatment of contaminated groundwater was performed using the Fenton oxidation process. The optimum conditions for the removal of THP(Total Petroleum Hydrocarbon) were 3 of pH, 25mM of $H_2O_2$ concentration and 25mM of $Fe^{2+}$ concentration. THP and COD(Chemical Oxygen Demand) concentrations decreased less than 1.5mg/L and 40.0mg/L in 7 minutes using DAF and Fenton oxidation process. However it is necessary to install the settling basin as the sludge concentration increased approximately 5 times.

• Smart Structures and Systems
• /
• v.18 no.5
• /
• pp.955-982
• /
• 2016

Recent studies integrating vibration control and structural health monitoring (SHM) use control devices and control algorithms to enable system identification and damage detection. In this study real-time SHM is used to enhance structural vibration control and reduce damage. A newly proposed control algorithm, including integrated real-time SHM and semi-active control strategy, is presented to mitigate both damage and seismic response of the main structure under strong seismic ground motion. The semi-active independently variable stiffness (SAIVS) device is used as semi-active control device in this investigation. The proper stiffness of SAIVS device is obtained using a new developed semi-active control algorithm based on real-time damage tracking of structure by damage detection algorithm based on identified system Markov parameters (DDA/ISMP) method. A three bay five story steel braced frame structure, which is equipped with one SAIVS device at each story, is employed to illustrate the efficiency of the proposed algorithm. The obtained results show that the proposed control algorithm could significantly decrease damage in most parts of the structure. Also, the dynamic response of the structure is effectively reduced by using the proposed control algorithm during four strong earthquakes. In comparison to passive on and off cases, the results demonstrate that the performance of the proposed control algorithm in decreasing both damage and dynamic responses of structure is significantly enhanced than the passive cases. Furthermore, from the energy consumption point of view the maximum and the cumulative control force in the proposed control algorithm is less than the passive-on case, considerably.

• Asian-Australasian Journal of Animal Sciences
• /
• v.4 no.4
• /
• pp.353-360
• /
• 1991

An experiment with completely randomized design was performed to investigate the effects of lysine and supplemented sodium on growth performance, nutrients utilization, acid-base balance and lysine arginine antagonism in broiler chicks. The experiment was carried out with 3 levels of dietary lysine (0.6, 1.2 and 1.8%) and 3 levels of sodium(0.4, 0.8 and 1.2%) for an experimental period of 7 weeks. Body weight gain of 1.2% lysine group was significantly (p<0.01) higher than that of low or high lysine group. The highest feed consumption was obtained at 1.2% lysine and 0.4% sodium supplemented level (ML-1.2) and the lowest at LL-1.2. The best feed efficiency was obtained at ML-0.8 level and the worst at LL-1.2 level. Mortalities of high (1.8%) and low (0.6%) lysine groups were significantly (p<0.05) higher than medium lysine (1.2%) group. Among the sodium levels, the mortality at 1.2% sodium supplemented level was significantly (p<0.01) different by the levels of dietary lysine. Lysine-arginine antagonism was observed in high lysine diet. Among the lysine levels, the lowest none weight and length were shown in low lysine group. Interactions between lysine and sodium were significantly (p<0.05) shown in femur weight. The levels of sodium and lysine affected significantly (p<0.01) the utilization of nitrogen, ether extract, total carbohydrate and energy.

• Asian-Australasian Journal of Animal Sciences
• /
• v.16 no.9
• /
• pp.1348-1354
• /
• 2003

The feeding value of high-oil corn fed to Taiwan Country (TC) chicken was examined by measuring apparent metabolizable energy (AME), growth performance, sexual maturity, carcass characteristics, and plasma pigmentation. In a completely randomized design, 870 sex-intermingled one-wk-old chicks were assigned to one of 30 floor pens, 29 birds per pen, and each pen randomly assigned to one of five dietary treatments. The experiment was ended when birds were 16 wk of age. The five dietary treatments varied in main fat sources, which were corn oil (CO), high-oil corn (HOC), lard (LRD), whole soybean (WSB) and yellow corn (YC), respectively. All the diets were formulated isonitrogenously, isocalorically, and of equal lysine and methionine contents except YC, in which equal amounts of YC replaced HOC. The results indicated that feed conversion in HOC was 8% higher (p<0.05) than YC whereas the calculated AME of HOC was only 3.5% to 4.0% higher than that of YC. No significant differences were observed in body weight, body weight gain, feed consumption, feed conversion ratio and ME efficiency for body weight gain among CO, HOC, LRD, and WSB. No significant differences existed in both skin and muscle pigmentation of breast among the five dietary treatments. No significance differences existed in plasma carotenoid content measured at various ages among the five dietary treatments except that birds fed with HOC had less (p<0.05) plasma carotenoids at 16 wk-old. The results indicate that if the price of high-oil corn is no more than 1.05 times that of yellow corn, the dietary cost per kg of body weight gain for TC chickens fed diets containing high-oil corn will be less, although their body weight may be lighter compared to chickens fed diets formulated with other fat sources.

• Fashion & Textile Research Journal
• /
• v.13 no.5
• /
• pp.752-758
• /
• 2011

In this paper, experiments to develop working clothes and evaluated, including the current and material-improved working clothes in relation to physiological functionality measurement. Experiments were conducted on subjects after wearing working clothes in an climate chamber, and the thermo-physiological response, such as human body temperature, micro-climate within the clothes, blood pressure, heart rate were measured. In this manner, the physiological functionality of improved working clothes was compared with that of current working clothes and evaluated. The summary of obtained results is as follows: For physiological functionality evaluation through material-improved working clothes, P working clothes showed significantly lower rectal temperature than C working clothes. For mean skin temperature, P's skin temperature was significantly higher than C's in the second half of the experiment. P working clothes's temperature around the thighs in Micro climate was significantly lower than that of the C working clothes. Also, humidity within the clothes showed similar trends. During the exercise period, C working clothes showed higher blood pressure than P, but P showed higher heart rates than C. Also, the oxygen uptake amount was higher in C than P during the exercise period, it explains that the energy consumption amount of P working clothes was smaller than that of C working clothes. Of the subjective evaluation, for temperature sensation, workers wearing P working clothes felt cooler. For humidity, C working clothes showed more humidity. For comfort, P working clothes were better, and for sense of fatigue, workers felt less tired wearing P working clothes. From results above, we can see that physiological functionality improved in the material-improved working clothes in the working clothes for construction site workers. The improvement of working clothes through functionality improvements not only will provide personal pleasantness to constriction site workers, but will also generate efficiency and productivity improvements at construction sites. All in all, the continuous study of functionality improvements in working clothes taking into consideration the human body's physiological responses is required.