• 대한기계학회논문집
• /
• 제18권12호
• /
• pp.3357-3368
• /
• 1994

Total pressure losses required to calculate the total-to-total efficiency are estimated by integrating empirical loss coefficients of four loss mechanisms along the mean-line of blades as follows; blade profile loss, secondary flow loss, end wall loss and tip clearance loss. The off-design points are obtained on the basis of Howell's off-design performance of a compressor cascade. Also, inlet-outlet air angles and camber angle are obtained from semi-empirical relations of transonic airfoils' minimum loss incidence and deviation angles. And nominal point is replaced by the design point. It is concluded that relatively simple loss models and Howell's off-design data permit us to calculate the off-design performance with satisfactory accuracy. And this method can be easily extended for off-design performance prediction of multi-stage compressors.

• 한국전산유체공학회지
• /
• 제14권1호
• /
• pp.35-44
• /
• 2009

To adequately analyze flows in pipe or duct network system, traditional node-based junction coupling methods require the junction loss which is specified by empirical or analytic correlations. In this paper, a new finite volume junction coupling method using a ghost junction cell is developed by considering the interchange of linear momentum as well as the important wall-effect at junction without requiring any correlation on the junction loss. Also, boundary treatment is modified to preserve the stagnation enthalpy across boundaries, such as pipe-end and the interface between junction and branch. Also, the computational accuracy and efficiency of the Godunov-type finite volume schemes are investigated by tracing the total mechanical energy of rapid transients due to sudden closure of valve at downstream end.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2007년도 제29회 추계학술대회논문집
• /
• pp.215-218
• /
• 2007

고체추진제를 사용한 초소형 추력기의 내탄도 모델링과 성능예측에 관하여 기술하였으며, 특히 초소형화 되면서 고려해야하는 연소실 내의 열손실을 고려하였다. 추진제는 일반 HTPB-AP계열을 선택하였으며, 계산 모델은 간단한 1차원 축대칭 end-burner 모델로 정하였다. 연소실내의 화염에 노출되는 표면과 체적에 대한 비율을 변화시키면서 연소실 가스 온도, 압력, 추력을 계산하여 본 논문의 경우 열손실효과로 약 3%의 총역적 감소가 있음을 확인하였다.

• 한국추진공학회지
• /
• 제12권2호
• /
• pp.33-39
• /
• 2008

초음속 연소에서 혼합 효율을 높이면서 전압력 손실을 줄일 수 있는 혼합기에 관한 연구가 수십 년동안 진행되어 왔으며, 본 논문에서는 이를 만족할 수 있는 새로운 개념의 혼합기를 고안하여 그 성능을 수치해석을 통하여 분석하였다. 후면 계단 혼합기를 비교 대상으로 압력과 등밀도선, 유선구조를 분석하였다. 공동이나 탭에서 발생하는 충격파가 후류로 전파되는 것과 달리, 벤트 혼합기의 구멍에서 발생하는 충격파는 벤트 혼합기 끝단에서 형성되는 팽창파에 의해 전파되지 못하며, 후류부의 재순환 영역으로 인해 경계층이 증가하며 이로 인해 후면 계단 방식에 비해 약한 충격파가 형성된다. 따라서 충격파로 인한 전압력 손실을 줄일 수 있으며, 구멍을 통한 공기 유입은 다수의 재순환 영역을 형성하여 혼합 효율을 증대시킨다. 또한 후류부에서 유동 흐름이 전반적으로 안정화되는 것을 볼 수 있다.

• 대한기계학회논문집
• /
• 제13권5호
• /
• pp.1044-1051
• /
• 1989

본 연구에서는 Wu가 제시한 수학적 모델에 기초를 둔 비점성 준3차원 유동해 석에 실제 유체의 점성효과 및 2차유동 등에 의해 발생하는 손실들을 손실모델로 반영하여 그 타당성 유무를 검토하는 데 목적을 두었다.

• 한국윤활학회:학술대회논문집
• /
• 한국윤활학회 2002년도 proceedings of the second asia international conference on tribology
• /
• pp.411-412
• /
• 2002

Piston-cylinder system are widely used in power engineering applications. In reciprocating refrigeration compressors, where extremely low friction losses are required, ringless pistons are being used to diminish the friction between piston rings and cylinder wall. Since the ringless piston has the freedom of lateral motion there is a potential danger that it will occasionally hit the cylinder wall while moving up and down along it's axis. A good design must therefore provide a smooth and stable reciprocating motion of the piston and ensure that the fluid film separating the piston from the cylinder wall is maintained all times. And the compromise between refrigerant gas leakage through the piston-cylinder clearance and the friction losses is required utilizing a dynamic analysis of the secondary motion for the high efficiency compressor. To this end, the computer program is developed for calculating the entire piston trajectory and the lubrication characteristics as functions of crank angle under compressor running conditions. The results explored the effects of some design parameters and operating conditions on the stability of the piston, the oil leakage, and friction losses.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2008년도 추계학술대회 논문집
• /
• pp.1420-1425
• /
• 2008

This study is to examine the sound transmission loss of a railway vehicle floor. To this end, a semi-reverberation room was constructed. The semi-reverberation room was made of a railway vehicle floor between the sound radiating chamber and the sound receiving chamber. To block the sound, the wall was made of acryl, urethane foam, wood, and glass fiber. The test followed the KS F 2808 standard, and a typical reverberation room was used to verify the performance of the semi-reverberation room. As a result, comparison of the measurements showed that the test results of the semi-reverberation room had the same tendency as those of the reverberation room. Consequently it was possible to measure the sound transmission loss of railway vehicle structures using the semi-reverberation room.

• Journal of the Korean Wood Science and Technology
• /
• 제21권1호
• /
• pp.39-50
• /
• 1993

The purpose of this study was to describe the micromorphological changes in Korean red pine (Pinus densiflora S. et Z.) wood decayed by a major brown-rot fungus, Lentinus lepideus, using scanning electron microscope and transmission electron microscope. At the end of the 12-week exposure to the fungus in soil block procedure(ASTM 1971), test blocks sustained 5.02% weight loss. The formation of bore hole by hyphae and penetration of hyphae through bordered pit were not observed. Instead, fungal hyphae appeared to penetrate axially tracheid luminar from the the ray cells via cross field pits. Hyphae were mainly found in lignin rich cell corner regions of tracheids, and also extensive degradation of tracheid wall occurred in this region. Extensive degradation of $S_2$ layer occurred without noticeable alteration of the $S_3$ layer, but warty layer and compound middle lamella remained relatively intact. Localized erosion, the characteristic of white rot, was observed in some cell wall and wall components including lignin were found to be decomposed.

• 치과방사선
• /
• 제13권1호
• /
• pp.97-105
• /
• 1983

For the assessment of changes in the bone architecture of the maxilla and mandible in renal osteodystrophy, 31 chronic renal failure patients who were undergoing hemodialysis therapy were selected. They were evaluated through clinical oral examination, radiographic and biochemical examination. The results were as follows: 1. In 17 cases (54.8%), there were evidences of bony change in jawbone. 2. The most common dental radiographic finding was decreased bone density (14 cases, 45.2%). 3. The second most common dental radiographic finding was total or partial loss of lamina alveolar dura (11 cases, 35.5%). 4. The third most common dental radiographic finding was total or partial loss of inferior canal wall (8 cases, 25.8%). 5 cases showed evidences of bony change only in jawbone, and 5 cases only in hand, and 12 cases in both. 6. Serum creatinine, urea nitrogen and alkaline phosphatase values in hemodialysis group were much higher than in control group. 7. There were statistically significant correlation between bone density and lamina dura, and inferior alveolar canal wall.

• International Journal of Fluid Machinery and Systems
• /
• 제2권1호
• /
• pp.13-20
• /
• 2009

The effects of positively bowed blade on the aerodynamic performance of annular compressor cascades with large camber angle were experimentally investigated under different incidences. The distributions of the exit total pressure loss and secondary flow vectors of compressor cascades were analyzed. The static pressure was measured by tapping on the cascade surfaces, and the ink-trace flow visualizations were conducted. The results show that the value of the optimum bowed angle and optimum bowed height decrease because of the increased losses at the mid-span with the increase of the caber angle. The C-shape static pressure distribution along the radial direction exists on the suction surface of the straight cascade with large r camber angles. When bowed blade is applied, the larger bowed angle and larger bowed height will further enhance the accumulation of the low-energy fluid at the mid-span, thus deteriorate the flow behavior. Under $60^{\circ}$ camber angle, flow behavior near the end-wall region of some bowed cascades even deteriorates instead of improving because the blockage of the separated flow near the mid-span keeps the low-energy fluid near the end-walls from moving towards the mid-span region, and as a result, a rapid augmentation of the total loss is easy to take place under large bowed angle. With the increase of camber angle, the choice range of bowed angle corresponding to the best performance in different incidences become narrower.