• Journal of Biosystems Engineering
• /
• 제32권5호
• /
• pp.279-283
• /
• 2007

In this study, the potential possibility of oxygenates on di-ether group (DBE, dibutyl ether) was investigated as an additives for an agricultural direct injection diesel engine. It tested to estimate change of engine performance and exhaust emission characteristics for the commercial diesel fuel and oxygenates additives blending fuel which has four kinds of mixed ratio. The smoke emission of blending fuel (diesel fuel 80 vol-% + DBE 20 vol-%) was reduced in comparison with diesel fuel, that is, it was reduced approximately 26% at 2500 rpm, full load. And, power, torque and brake specific energy consumption didn't have large differences. But, NOx emission of blended fuel was increased compared with commercial diesel fuel.

• Journal of Advanced Marine Engineering and Technology
• /
• 제26권5호
• /
• pp.554-564
• /
• 2002

A newly designed combustion chamber of diesel engine with a modified piston crown was prepared for the purpose of investigation for reduction of NO emission. It was intended to realize 2-stage combustion that is to keep fuel rich condition during early stage of combustion and fuel lean condition during next stage. The engine was tested on various conditions concerning exhaust gas emissions especially about NO emission and simultaneously fuel consumption rate. It was found that the engine with 2-stage combustion type piston emits significantly low NO at various speed and torque compared with conventional engines, but it raised points at issue in CO and smoke emissions with fuel consumption rate. The increasing of injection pressure on 2 stage combustion type diesel engine affects on CO and smoke emission considerably to reduce but slightly on NO to increase. The effect of 2-stage combustion was better at low speed than at high speed.

• 한국자동차공학회논문집
• /
• 제5권2호
• /
• pp.127-135
• /
• 1997

Experiments have been conducted to investigate emission characteristics of compressed natural gas fueled vehicle(CNGV) by the FTP 75 mode test. Its purification technologies were also investigated. It was found that CNGV was operated on the rich A/F condition by comparison with gasoline vehicle. The Pd catalyst was higher in methane purification performance than Pt and Pd/Pt/Rh catalysts. Up to 60% portion of the accumulative HC emissions(that contains above 80% methane) form CNGV occurs during the first phase of the FTP 75 mode. CO that is exhausted at rich conditions of the air-fuel ratio more than lean conditions should be used for the catalytic reduction of NOX, because the methane is not the effective reduction for NOX in the CNGV with 3-way catalyst system.

• 품질경영학회지
• /
• 제19권2호
• /
• pp.63-77
• /
• 1991

Currently the problem of air pollution caused by the motor vehicle emission is one of the most serious problems to be solved. Thus we needed the inspection method and technical innovation constraining the motor vehicle emission. In order to establish the more reasonable certified test, the multivariate sequential rectifying inspection plan designed in this paper has been applied to the domestic vehicles by analyzing the statistic characteristics of the emission distribution. This inspection method is designed to satisfy the evaluation measure constraining domestic vehicle emission, and it serves the defect rectifying system and performance certification of catalytic converts. As the prior parameter for the domestic vehicles, we used the data for the catalytic converts which passed the certified test excuted by the EPK. For the case of engine test, we used those data which passed the certified test of domestic vehicles. The multivariate sequential rectifying inspection plan of the vector parameter is able to minimize the average sample number and increase the pass probability of operating characteristic curve.

• 한국연소학회지
• /
• 제20권4호
• /
• pp.42-48
• /
• 2015

This study was investigated the estimation of VOCs (Volatile Organic Compounds) emission from a gas station tank. To improve the atmosphere environmental quality near the gas station, the installation of vapor recovery system has been expanded recently. Therefore, it was necessary to calculate VOCs emissions from the gas station tank with vapor recovery systems for evaluation of their performance. The VOCs emissions are difficult to measure directly because of various sources and irregularly emission by pressure rise. In this study, VOCs emissions were estimated by simple calculation based on the equation of state for measured pressure, temperature and volume of a gasoline tank at a gas station. The result confirmed that the present national emission factor did not have significant discrepancy with the calculated value.

• 한국수소및신에너지학회논문집
• /
• 제14권3호
• /
• pp.276-282
• /
• 2003

A hydrogen enriched CNG engine can be stably operated at ultra lean condition and reduce emission extremely. It also has advantage to increase gradually the use of hydrogen for the coming hydrogen-energy age. In this studies, the combustion and emission characteristics of heavy-duty hydrogen-CNG engine were investigated to verify the enhancement of performance by enriched hydrogen into natural gas. The results showed that a hydrogen-CNG engine could achieve ultra lean operation and low emission, while power was reduced by the decrease of intake air flow.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2007년도 7th International Meeting on Information Display 제7권1호
• /
• pp.937-939
• /
• 2007

Carbon nanotubes (CNTs) have used as an electron field emitter of the field emission display (FED) due to their characteristics of high-electron emission, rapid response and low power consumption. However, to commercialize the FED with CNT emitter, some fundamental problems regarding life time and emission efficiency have to be solved. In this study, we investigated the $TiO_2$ coated CNT as a field emitter. $TiO_2$ nanoparticles can coated on CNT surface by chemical solution method. $TiO_2$ nanoparticles had uniform size with the average size of about 2.4 nm to 3.1 nm. Field emission performance of CNT coated with $TiO_2$ nanoparticles was evaluated and discussed.

• 한국자동차공학회논문집
• /
• 제12권1호
• /
• pp.10-16
• /
• 2004

The Homogeneous Charge Compression Ignition (HCCI) engine has advantage for reducing the NOx and P.M. simultaneously. Therefore, HCCI engine is receiving attention as a low emission diesel engine concept. This study was carried out to investigate the characteristics of combustion and exhaust emission for operating conditions in a direct injection type of HCCI engines such as supercharged and naturally aspirated using diesel fuel and additive. From the experimental result, we found that cool flame was always appeared and also it was difficult to control combustion characteristics by changing the injection timing in HCCI. In addition, at the lean air-fuel ratio and high speed range, it was observed that charging air pressure, additive or increasing intake air temperature is effective to increase combustion performance and reduce exhaust emission. We concluded that chemical reaction by the increasing intake air temperature or additive without physical improvement has limitation for reduction of exhaust emission.

• 실천공학교육논문지
• /
• 제6권2호
• /
• pp.127-134
• /
• 2014

Analyzing test data of a vehicle for evaluating its emission performance is an essential process in automotive development field, yet it is intricate and tedious task. In addition, clear understanding and care are required when the analysis process is carried out. Computer software solutions significantly reduce the time and the effort for such analysis. Developing a computer routine to analyze the emission data in a vehicle test demands a complete understanding of the emissions analysis and its related details. In this paper, the principals to develop a LabVIEW analysis routine (VI) are introduced helping automotive engineers comprehend the emission analysis process of a vehicle test data and instruct them to develop similar routines for such analysis.

• Asian-Australasian Journal of Animal Sciences
• /
• 제28권7호
• /
• pp.999-1005
• /
• 2015

Bacillus-based feed additive was evaluated for its efficacy on growth performance, nutrient digestibility, fecal gas emission, and the consumption of time and amount of water for cleaning the pen of growing finishing pigs. A total of 120 growing pigs ($23.59{\pm}1.41kg$) were used in a 16-wk feeding trial. Pigs were randomly distributed into 1 of 2 treatments on the basis of body weight and sex. There were 12 replicate pens per treatment, with 5 pigs (3 barrows and 2 gilts) per pen. Dietary treatments were CON which was basal diet, and T1 which was CON+62.5 ppm microbial feed additive that provided $1.47{\times}10^8cfu$ of Bacillus organisms per gram of supplement. During the weeks 0 to 6, average daily gain (ADG) in T1 treatment was higher (p<0.05) than CON, but no improvement in average daily feed intake (ADFI) and feed efficiency (G:F) was noted. During 6 to 16 weeks, no difference (p>0.05) was noted in growth performance. However, ADG was improved (p<0.05) and overall ADFI tended (p = 0.06) to improve in T1 compared with CON. At week 6, the co-efficient of apparent total tract digestibility (CATTD) of dry matter (DM) nitrogen (N) was increased (p<0.05) in T1 compared with CON. Fecal $NH_3$ emission was decreased (p<0.05) in T1 compared with CON, at the end of 6th and 15th weeks. The time and water consumed for washing the pens were decreased (p<0.05) in T1 compared with CON. In conclusion, supplementation with Bacillus-based feed additive could improve the overall growth performances, increase the CATTD of DM and decrease the fecal $NH_3$ content and the time and water consumed in washing the pens for growing-finishing pigs.