• Bulletin of the Korean Chemical Society
• /
• 제18권6호
• /
• pp.608-612
• /
• 1997

The preparation and photoluminescence properties of $ZnGa_2O_4$ : Mn phosphor are presented. Under 254 nm excitation $Zn_1-_xMn_xGa_2O_4$ exhibits the green emission band at 506 nm wavelength and maximum intensity where x=0.005. The manganese activated $ZnGa_2O_4$ phosphor prepared by the polymerized complex method shows a remarkable increase in the emission intensity and is smaller particle size than that prepared by conventional method. Also, electron paramagnetic resonance study on $ZnGa_2O_4$ : Mn powders indicates that the increase in emission intensity after firing treatment in mild hydrogen reducing atmosphere is due to the conversion of the higher valent manganese to $Mn^{2+}$.

• 대한기계학회논문집
• /
• 제14권1호
• /
• pp.130-137
• /
• 1990

본 연구에서는 Bueckner의 가중함수법을 열충격 문제에 도입하여 열충격 응력 세기계수를 구하고, 평면변형을 파괴인성치와 비교하여 재료가 열충격을 받은 후 파괴 되는 시간을 이론적으로 계산한다. 또한 음향 방출법을 이용하여 파괴시간을 측정하 고 이론치와 비교한다.

• 한국재료학회지
• /
• 제25권2호
• /
• pp.100-106
• /
• 2015

Plasma properties of dielectric barrier discharges (DBDs) at atmospheric pressure were measured and characterized using optical emission spectroscopy. Optical emissions were measured from argon, nitrogen, or air discharges generated at 5-9 kV using 20 kHz power supply. Emissions from nitrogen molecules were markedly measured, irrespective of discharge gases. The intensity of emission peaks was increased with applied voltage and electrode gap. The short wavelength peaks (315.9 nm and 337.1 nm) measured at the middle of DBDs were significantly increased with applied voltage. The optical emission from DBDs decreased with the addition of oxygen gas, which was especially significant in argon discharge. Emission from oxygen molecules cannot be measured from air discharge and argon discharge with 4.8% oxygen. The emission intensity at 337.1 nm and 357.7 nm related with nitrogen molecule was sensitively changed with electrode types and discharge voltages. However, the pattern of argon emission spectrum was nearly the same, irrespective of electrode type, oxygen content, and discharge voltage.

• 한국재료학회지
• /
• 제21권9호
• /
• pp.509-514
• /
• 2011

In this study, optical emission spectroscopy was used to monitor the plasma produced during the RF magnetron sputtering of a $BaTiO_3$ target. The intensities of chemical species were measured by real time monitoring with various discharge parameters such as RF power, pressure, and discharge gas. The emission lines of elemental and ionized species from $BaTiO_3$ and Ti targets were analyzed to evaluate the film composition and the optimized growth conditions for $BaTiO_3$ films. The emissions from Ar(I, II), Ba(I, II) and Ti(I) were found during sputtering of the $BaTiO_3$ target in Ar atmosphere. With increasing RF power, all the line intensities increased because the electron density increased with increasing RF power. When the Ar pressure increased, the Ba(II) and Ti(I) line intensity increased, but the $Ar^+$ line intensity decreased with increasing pressure. This result shows that high pressure is of greater benefit for the ionization of Ba than for that of Ar. Oxygen depressed the intensity of the plasma more than Ar did. When the Ar/$O_2$ ratio decreased, the intensity of Ba decreased more sharply than that of Ti. This result indicates that the plasma composition strongly depends on the discharge gas atmosphere. When the oxygen increased, the Ba/Ti ratio and the thickness of the films decreased. The emission spectra showed consistent variation with applied power to the Ti target during co-sputtering of the $BaTiO_3$ and Ti targets. The co-sputtered films showed a Ba/Ti ratio of 1.05 to 0.73 with applied power to the Ti target. The films with different Ba/Ti ratios showed changes in grain size. Ti excess films annealed at $600^{\circ}C$ did not show the second phase such as $BaTi_2O_5$ and $TiO_2$.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 하계학술대회 논문집 Vol.7
• /
• pp.521-522
• /
• 2006

In this paper, hybrid air-water discharges were used to develop an optimal condition for providing a high level of water decomposition for hydrogen yield. Electrical and optical phenomena accompanying the discharges were investigated along with feeding gases, flow rates, and point-to-plane electrode gap distance. The primary focus of this experiment was put on the optical emission of the near UV range, with the energy threshold sufficient for water dissociation and excitation. The $OH(A^{2+},'=0\;X^2,"=0$) band's optical emission intensity indicated the presence of plasma chemical reactions involving hydrogen formation. In the gaseous atmosphere saturated with water vapor the OH(A-X) band intensity was relatively high compared to the liquid and transient phases although the optical emission strongly depended on the flow rate and type of feeding gas. In the gaseous phase discharge phenomenon for Ar carrier gas transformed into a gliding arc via the flow rate growth. OH(A-X) band's intensity increased according to the flow rate or residence time of He feeding gas. Reciprocal tendency was acquired for $N_2$ and Ar carrier gases. The peak value of OH(A-X) intensity was observed in the proximity of the water surface, however in the cases of Ar and $N_2$ with 0.5 SLM flow rate peaks shifted to the region below the water surface. Rotational temperature ($T_{rot}$) was estimated to be in the range of 900-3600 K, according to the carrier gas and flow rate, which corresponds to the arc-like-streamer discharge.

• 분석과학
• /
• 제22권4호
• /
• pp.307-312
• /
• 2009

수용액 중의 carbaryl을 형광분광법을 이용하여 정량하기 위한 분석방법에 대하여 연구하였다. 분석의 최적 조건을 구하기 위해서 들뜸 파장, 계면활성제의 농도, 보조계면활성제인 ethanol의 농도 및 방출 파장의 방출 세기에 대한 영향을 조사하였다. Carbaryl 용액에 계면활성제인 sodium dodecyl sulfate (SDS)을 첨가하였을 때 방출세기가 조금 증가하였으며 보조계면활성제인 ethanol을 첨가하였을 때 방출 세기가 현저히 증가함을 관찰하였다. 최적 분석 조건의 들뜸 파장, 계면활성제의 농도, 보조계면활성제인 ethanol의 농도 및 방출 파장은 각각 281 nm, $1.0{\times}10^{-2}mol/L$, 20% (v/v), 349 nm 이었다. 최적 분석조건에서 carbaryl의 검정곡선의 감응범위와 검출한계($3{\sigma}$)는 각각 $5{\times}10^{-7}$에서 $1.0{\times}10^{-4}mol/L$ 및 $1.1{\times}10^{-8}mol/L$이었다. 검정곡선에서 직선성이 성립하는 농도 범위에서 상관계수(S/N=3)는 0.9996이었다.

• 한국분말재료학회지
• /
• 제16권3호
• /
• pp.203-208
• /
• 2009

$Y_2O_3$:Eu red phosphor was prepared by microwave synthesis. The crystal phase, particle morphology, and luminescent properties were characterized by XRD, SEM, and spectrofluorometer, respectively. The prepared $Y_2O_3$:Eu particles had good crystallinity and strong red emission under ultravioletet excitation. The crystallite size increased with calcination temperature and satuarated at $1200^{\circ}C$. The primary particle size initially formed was varied from 30 to 450 nm with microwave-irradiation (MI) time. It was found that the emission intensity of $Y_2O_3$:Eu phosphor strongly depends on the MI time. In terms of the emission intensity, it was recommended that the MI time should be less than 15 min. The emission intensity of $Y_2O_3$:Eu phosphor prepared by microwave syntehsis strongly depended on the crystallite size of which an optimal size range was 50-60 nm.

• 대한기계학회논문집B
• /
• 제33권11호
• /
• pp.849-857
• /
• 2009

The experimental study was performed to investigate the effects of partial premixing, varying the equivalence ratio, mixing degree, swirl intensity, mixing length on the characteristics of flame structure and NOx emission. Experiments were conducted in a dump combustor at 1 bar using methane as fuel. Inlet air temperature was 570K. OH chemiluminescence images were acquired with an ICCD camera. As a result of the experimental investigation of characteristics of flame and NOx emission in partial premixed combustor, we can conclude the results as below. With the increase of swirl number, The flame length decreases and the flame width increases and it helps flame stabilization. It means that lean flammability limit is extended. With the increase of mixing of fuel-air length ratio, Flame goes to be stabilized and NOx emission and $OH^{\ast}$ intensity decrease. Through the comparison of preceding results, It is possible that the exhausted NOx emission from a gas turbine combustor will be able to predict through the $OH^{\ast}$ intensity.

• Journal of the Optical Society of Korea
• /
• 제16권4호
• /
• pp.414-417
• /
• 2012

The effect of cerium concentration and the addition of $Sb_2O_3$ on the light emission of cerium-contained glass were investigated. The glass matrix composition was $20Y_2O_3-25Al_2O_3-55SiO_2$, the $CeO_2$ concentration ranged from 0.05 to 0.5 mol%, and $Sb_2O_3$ was added at concentrations of 0.02 to 0.1 mol%. The $Ce^{3+}$ and $Ce^{4+}$ absorption bands were observed at approximately 330 nm and 240 nm, respectively. A broad emission band at 400 nm, due to the 4f-5d transition of the $Ce^{3+}$ ion, was observed under illumination by a UV light at 330 nm. The photoluminescence intensity of $Ce^{3+}$ had a maximum value at a $CeO_2$ concentration of 0.1 mol%. Adding $Sb_2O_3$ decreased the $Ce^{4+}$ absorption intensity and enhanced the light emission intensity of $Ce^{3+}$ by about 45%.

• 한국분말재료학회지
• /
• 제15권5호
• /
• pp.399-404
• /
• 2008

Spray pyrolysis was applied to prepare $M_{3}MgSi_{2}O_{8}:Eu^{2+}$ (M=Ca, Sr, Ba) blue phosphor powder. The library of a Ca-Sr-Ba ternary system was obtained by a combinatorial method combined with the spray pyrolysis in order to optimize the luminescent property under vacuum ultraviolet (VUV) excitation. 10 potential compositions were chosen from the first screening. The emission shifted to longer wavelength as Ca became a dominant element and the emission intensity was greatly reduced in the composition region at which Ba is dominant element. On the base of the first screening result, the second fine tuning was carried out in order to optimize the luminescence intensity under VUV excitation. The optimal composition for the highest luminescence intensity was $(Ca_{1.7},\;Sr_{0.3},\;Ba_{1.0})Si_{2}O_{8}:Eu^{2+}$ which had the color coordinate of (0.152, 0.072) and about 64% emission intensity of $BaMgAl_{10}O_{17}$ (BAM) phosphor.