• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.22 no.6
• /
• pp.734-749
• /
• 1998

A numerical study t predict the characteristics on transient operation of the heat pipe cooling system with multiple heaters for electronic system has been performed. The heat pipe cooling system of 45 cm length and 16 mm diameter was composed of evaporator section with four heaters which simulate electronic components, insulated transport section, and condenser section with a conductor which was cooled under the constant heat flux boundary condition. Two test cases were investigated in present study; Case 1 indicated that the 1st and 2nd heaters among four heaters were heated off, while the 3rd and the 4th heaters were heated on. Case 2 was the inverse situation switched from heating locations of Case 1. Case 3 indicated that the 1st and 4th heaters among four heaters were heated off, while the 2nd and 3rd heaters were heated on. The results showed that the transient time to reach the steady state is shorter for Case 1 than for Case 2. Especially, the maximum temperature among the heaters which simulate electronic components during switching operation is relatively small compared to the maximum allowable operating temperature in electronic system. It is concluded that the heat pipe cooling system in present study operate with the good thermal reliability even for sudden switching situation of the heaters.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.37 no.5
• /
• pp.619-624
• /
• 2013

A bendable electronic module is developed. In this module, thin silicon electronic chips are embedded in a polymer-based encapsulating adhesive between flexible copper-clad polyimide layers. During the qualification test of a harshly thermal-hygroscopic complex loading condition, delaminations occur inside the module layers. A finite element model is developed for the module. To investigate the effect of hygroscopic stress on delamination, the results of the thermal and thermal-hygroscopic loads are compared. The analysis results reveal that the hygroscopic effect more strongly affects delamination than does the thermal effect. The potential failure mechanisms of the module are investigated based on the stress analysis.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.26 no.12
• /
• pp.863-866
• /
• 2013

SiC crystal ingots were grown on 6H-SiC dual-seed crystals with different surface roughness and different seed orientation by a PVT (Physical Vapor Transport) method. 4H and 15R-SiC were grown on seed crystal with high root-mean-square (rms) value. The polytype of grown crystal on the seed crystal with lower rms value was confirmed to be 6H-SiC. On the other hand, all SiC crystals grown on seed crystals with different seed orientation were proven to be 6H-SiC. The surface roughness of seed crystals had no effect on the crystal structure of the grown crystals. However, the crystal quality of 6H-SiC single crystals grown on the on-axis seed were revealed to be slightly better than that of 6H-SiC crystal grown on the off-axis seed.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.8 no.12
• /
• pp.1971-1978
• /
• 2013

The aim was to be utilized as basic data in arranging efficient plan for removing halitosis by surveying correlation with halitosis components by each factor after measuring halitosis and analyzing components by subject of adults on halitosis. It targeted totally 160 people by 80 outpatients of 1 dental hospital, respectively, where is located in Daejeon and Chungnam, for 12 months from February 1, 2011 to January 30, 2012. As a result of analysis, in the halitosis measurement value of Oral chroma, it was shown to be 9.4% in case of being more than 112ppb in the measurement value of hydrogen sulfide, 20.6% in case of being more than 26ppb in the measurement value of methyl mercaptan, and 44.0% in case of being more than 8ppb in the measurement value of dimethyl sulfide, which was indicated to be the highest value among three components. Only the methyl mercaptan component and the dimethyl sulfide component, which were measured with oral chroma, stood at 0.578, thereby having been shown to have high positive correlation. Accordingly, a multilateral research is considered to be likely necessity as for diverse components of causing halitosis.

• Korean journal of food and cookery science
• /
• v.14 no.5
• /
• pp.541-546
• /
• 1998

Volatile flavor components in leaf and petiole of fresh Pleurospermum kamtschaticum H$\_$OFFM/ were extracted by SDE (simultaneous steam distillation and extraction) method using diethyl ether as solvent. Essential oils were analyzed by gas chromatography (GC) and combined gas chromatography-mass spectrometry (GC-MS). Identification of volatile flavor components was based on the Rl of GC and mass spectrum of GC-MS. A total of 31 components, including 15 hydrocarbons, 4 aldehydes, 1 ketone, 5 alcohols, 2 esters, 3 acids and 1 oxide were identified in the essential oils. (Z)-${\beta}$-Farnesene, (Z, E)-${\alpha}$-farnesene and farnesene were the major volatile flavor components in fresh Pleurospermum kamtschaticum. Volatile flavor patterns of Pleurospermum kamtschaticum were analyzed using electronic nose. Sensor T30/1 and PA2 that were sensitive to alcohols had the highest resistance for fresh Pleurospermum kamtschaticum. Resistance of six metal oxide sensors was decreased in dried sample compared with fresh one.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.232.1-232.1
• /
• 2014

The green displays are the human friendly displays, the nature friendly displays, and the economical displays. Electrochromic displays are low cost and environmental devices because they do have more choice of colours and use much less power. The elements of the electrochromic devices consist of at least two conductors, an electrochromic material and an electrolyte. The optical properties were obtained using the optical contrast between the transparency of the substrate and the coloured state of the electrochromic materials. These devices can be fully flexible and printable. Due to the characteristics of the high coloration efficiency and memory effects, the electrochromic devices have been used in various applications such as information displays, smart windows, light shutters and electronic papers. Among these technical fields switchable mirrors have been received much attention in the applicative point of view of various electronic devices production. We have developed a novel silver (Ag) deposition-based electrochromic device for the reversible electrodeposition (RED) system. The electrochromic device can switch between transparent states and mirror states in response to a change in the applied voltage. The dynamic range of transmittance percent (%) for the fabricated device is about 90% at 550 nm wavelength. Also, we successfully fabricated the large area RED display system using the parted electrochromic cells of the honey comb structure.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.327-327
• /
• 2008

Lead-free $(K_{0.5}Na_{0.5})NbO_3$ 압전 세라믹스는 다양한 광소자로의 응용과 압전 특성, 초전 특성을 이용한 압전 소자로의 응용이 가능한 재료로 보고되고 있다. 그러나 KNN계 압전소재 특성상 판상 형태의 결정립으로 인해 낮은 소결 밀도를 갖게 되고, 그로인해 압전물성의 저하를 초래하는 문제점을 가지고 있다. 따라서, 본연구에서는 다양한 밀링 방법을 적용하여 입자 사이즈를 작게 하고 소성체의 결정립을 구형화 함으로써 저온소결에서의 압전물성을 개선시키고자 한다. $(K_{0.5}Na_{0.5})NbO_3$를 기계적 분쇄법에 의해 입자사이즈에 따라 변화되는 상의 분석과 압전체로서의 특성을 관찰하였다. 결정학적 상분석 및 미세 조직은 XRD, SEM을 이용하여 관찰하였고, Capacitance는 Impedance analyzer(HP4192A)로 측정하였으며, Impedance 주파수 특성은 Network Analyzer로 측정하여 Kp, Kt와 Qm을 측정하였다.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2006.06a
• /
• pp.346-347
• /
• 2006

기계적 품질계수(Qm)를 향상시키기 위해 $Y_2O_3$와 $MnO_2$를 첨가함에 따른 $SrBi_2Nb_2O_9$ 세라믹스의 강유전 특성을 알아보았다. 합성분말의 입도를 분석 한 결과 $SrBi_2Nb_2O_9$의 경우 781.27nm였고, $Y_2O_3$와 $MnO_2$를 첨가한 경우 각 각 830.4nm와 981.1nm로 particle size는 증가하였고, 소결 후 소결밀도는 차이가 거의 없었으며, grain size는 $SrBi_2Nb_2O_9$과 $Y_2O_3$를 첨가했을 경우 $1{\mu}m$이하이며 반면, $MnO_2$를 첨가하였을 때 결정립이 성장하여 $3{\sim}4{\mu}m$로 나타났다. 또한, 모두가 $450^{\circ}C$ 이상의 상전이온도를 갖았다.

• Proceedings of the IEEK Conference
• /
• 2004.06a
• /
• pp.155-158
• /
• 2004

This paper presents a CPW patch antenna with $\lambda/2$ CPW transmission lines. Through the full-wave simulation and the equations of gap capacitance, the dimensions of the CPW transmission lines and resonance circuit components are extracted. Using extracted dimensions, we designed and implemented CPW patch antennas in the range of frequency of 5GHz.

• Transactions on Electrical and Electronic Materials
• /
• v.4 no.1
• /
• pp.11-14
• /
• 2003

The regularities of immobilization of natural medicinal substances - alchidine on gels of poly(vinyl alcohol) - are investigated. It is shown that the polymer components of alchidine interact with nonionic polymer with formation of interpolymer complexes. The influence of the different factors on the properties of complexes is considered and the constants of alchidine distribution in the system gel - water are calculated.