• 한국광학회:학술대회논문집
• /
• 한국광학회 2001년도 제12회 정기총회 및 01년도 동계학술발표회
• /
• pp.124-125
• /
• 2001

The electro-magnetic vector equation(F=$qv{\times}B$ ; F：force, B：magnetic field, q：plus charge, v ：velocity of the charge) explains well about the rotations of electron and positron under the magnetic field[Ref.1], as in Fig.1(a). Because the electro-magnetic wave is also a motion of the alternating charge and magnetic field as in Fig.2, the force vector has all the time inwarding direction and then the wave has a rotating motion. The positron in the proton has constant charge and alternating one at the same time[Ref.2] and then the alternating charge makes the absorbing force with the alternating charge of the rotating wave ($\pi$-ray) around the nucleus[Ref.2]. (omitted)

• 한국해양공학회지
• /
• 제20권2호
• /
• pp.59-65
• /
• 2006

Steel, as a reinforcing mechanism in concrete, provides the tensile strength that is lacking in concrete, alone, and the high alkaline environment (pH 12.5) in concrete offers satisfactory protection against most corrosion of the steel. However, the corrosion of reinforcing steel in concrete can occur by chloride attack or carbonation, and it can cause a loss of integrity a section and concrete failure through cracking and spalling. In this study, a transient electro magnetic method (TEM) of a nondestructive technique is adapted to study the measuring method of steel corrosion in mortar. The sensor was made of an enameled wire, with a diameter of 0.25mm and anacril. He sensor configuration used was a coincident loop type. The secondary electro motive force (2nd EMF) was measured with SIROTEMIII, which equipped the accelerator. The accelerator allowsthe transmitter to turn off approximately $10\sim15$ times faster than normal. The high-resolution time series, used for very shallow or a high resistivity investigation was selected. After steels were corroded by the salt spray, during 4, 8, 15 and 25 days, they were embedded in mortar. The content results acquired in this study are as follows. The variation of the secondary electro motive force (2nd EMF) was shown by the change of steel surface with different corrosion time steel. It was confirmed that measurement of steel corrosion in mortar by a transient electro-magnetic method (TEM) can be possible.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1995년도 봄 학술발표회 논문집
• /
• pp.355-359
• /
• 1995

In this paper, the possibility of interferometric shows very good linearity to the strain. Fiber optic sensors have various merits for health monitoring systems. They are very small in diamerter. So, they don't give any disturbance in strength to the structures, Optical fiber sensors are innert to the electro-magnetic field. Therefore, fiber optic sensors give us a good solution to the electro-magnetic field. Therefore, fiber optic sensors give us a good solution to the maintainance systems of the structures, which are exposed to the electric fields, such as bridges, dams and buildings.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2010년도 춘계학술대회 논문집
• /
• pp.1263-1264
• /
• 2010

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 1995년도 추계학술대회 논문집
• /
• pp.474-477
• /
• 1995

In this paper, the nonlinear model of axial electro-magnetic suspension(EMS) system is presented. The characteristic of attracyion force is analyzed by FEM. Some simulation is given to compare the sliding mode control based on the input-output linearization with the classical linear control using Taylor approximation. Real result of regulating control, transient response comparison, and robustness control with disturbance using the sliding mode method is presented.

• 연구논문집
• /
• 통권23호
• /
• pp.81-92
• /
• 1993

In this study, quarter vehicle model is used to analyse vibration control effects for ride comfort and handling safety according to this three kinds of control methods, which are the modal control, the sky-hook control and the linear viscous damping control. We performed theoretical analysis and experiments and compared two results. In experiments, electro-magnetic actuator was employed as a force actuator. It is shown that all three methods can effectively control the vehicle model. The modal control method gives similar control results using gain less than the viscous damping control.

• 대한디지털의료영상학회논문지
• /
• 제7권1호
• /
• pp.39-44
• /
• 2005

Purpose of this research is that if Radiographer has focused on Radiation exposure research until now, he should realize that always exposed by Electro Magnetic Wave at given working environment And also, another purpose is that to minimize damage with measuring Electro Magnetic Wave which is happened area and distance of Radiation Control System and High Voltage Equipment, check occurrence rate and minimize damage from it.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1987년도 정기총회 및 창립40주년기념 학술대회 학회본부
• /
• pp.37-40
• /
• 1987

In transverse flux linear induction motors(TFLIM), The loops of the working flux lie in planes transverse to the direction of motion. With a poly-phase primary winding, The TFLIMs has both electro-magnetic propulsion and levitation force. Thus, TFLIM a will be useful in high speed ground transportation systems. In this paper, The characteristics of a single aide TFLIM are analysed by using electromagnetic field theory.

• Structural Engineering and Mechanics
• /
• 제53권6호
• /
• pp.1201-1214
• /
• 2015

This paper introduces the combined effect of electric field, magnetic field and thermal field on edge wave propagating in a homogeneous isotropic prestressed plate of finite thickness and infinite length. The dispersion relation of edge wave has been obtained by using classical dynamical theory of thermoelasticity. The phase velocity has been computed and shown graphically for various initial stress parameter, electro-magneto parameter, electric parameter and thermoelastic coupling parameter.

• 한국군사과학기술학회지
• /
• 제15권4호
• /
• pp.366-373
• /
• 2012

In this paper, serious changes in the electromagnetic environment with increasing power and energy capabilities for electric driving and military mission are discussed. Design and control strategies on the Electro-Magnetic Compatibility(EMC) for the series hybrid electric vehicle are proposed to minimize the effects of electromagnetic interferences.