• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 하계학술대회 논문집 C
• /
• pp.1500-1502
• /
• 2001

Plate-type ${\beta}-FeSi_2$ single crystals were grown using $FeSi_2$, Fe, and Si as starting materials by the chemical transport reaction method. The ${\beta}-FeSi_2$ single crystal was an orthorhombic structure. The direct optical energy gap was found to be 0.87eV at 300K. Hall effect shows a n-type conductivity in the ${\beta}-FeSi_2$ single crystal. The electrical resistivity values was 1.608$\Omega$cm and electron mobility was $3{\times}10^{-1}cm^2/V{\cdot}sec$ at room temperature.

• 소성∙가공
• /
• 제18권6호
• /
• pp.476-481
• /
• 2009

The present work demonstrates the mechanical and electrical responses of submicrocrystalline Cu-3%Ag alloy as a function of strain imposed by equal channel angular pressing(ECAP). From transmission electron microscope observation, the resulting microstructures of Cu-3%Ag alloy deformed by ECAP for 8-pass or more consist of reasonably fine, equiaxed grains without having a strong preferred orientation, suggesting that microstructure evolution is slower than that of pure-Al and its alloys owing to low stacking fault energy. The results of room temperature tension tests reveal that, as the amount of applied strain increases, the tensile strength of submicrocrystalline Cu-3%Ag alloy increases whereas losing both the ductility and the electrical conductivity. Such phenomenon can be explained based on microstructure featured by the non-equilibrium grain boundaries.

• 대한금속재료학회지
• /
• 제49권4호
• /
• pp.304-312
• /
• 2011

In this study, MOSFET type micro hydrogen gas sensors with platinum catalytic metal gates were designed, fabricated, and their electrical characteristics were analyzed. The devised MOSFET Hydrogen Sensors, called MHS-1 and -2, were designed with a platinum gate for hydrogen gas adsorption, and an additional sensing part for higher gas sensitivity and with a micro heater for operation temperature control. In the electrical characterization of the fabricated Pt-gate MOSFET (MHS-1), the saturated drain current was 3.07 mA at 3.0 V of gate voltage, which value in calculation was most similar to measurement data. The amount of threshold voltage shift and saturated drain current increase to variation of hydrogen gas concentration were calculated and the hydrogen gas sensing properties were anticipated and analyzed.

• 전자공학회논문지SC
• /
• 제49권4호
• /
• pp.36-44
• /
• 2012

전기 임피던스 단층촬영법은 대상물의 경계면에 부착된 여러 개의 전극들을 통해 전류를 주입하고 이에 유기되는 전압을 측정한 후, 이를 바탕으로 대상물 내부의 도전율(또는 저항률) 분포를 영상으로 복원하는 비교적 새로운 영상복원 기법이다. 본 논문에서는, 대상물 내부의 저항률 분포를 추정하기 위해서 전극사이의 전기저항과 저항률 분포와의 관계를 선형으로 가정하고, 이 선형 관계로부터 가중행렬을 계산한 후, 수정된 반복 Landweber 알고리즘을 적용하였다. 그리고 제안한 방법의 수렴시간을 줄이고 영상 복원의 정확도를 향상시키고자 목적 함수를 최소화하는 최적의 step length를 찾아 제안한 방법에 적용하였다. 몇 가지 시나리오를 설정하고 모의실험을 통해 제안된 방법의 영상 복원 성능을 평가한 결과, 비교적 양호한 복원 성능을 나타내었다.

• 한국결정성장학회지
• /
• 제14권4호
• /
• pp.145-150
• /
• 2004

We have investigated the structural, electrical and optical properties of Al-doped ZnO (AZO) thin films grown on glass substrate by pulsed DC magnetron sputtering as functions of pulse frequency and substrate temperature. A highly c-axis oriented AZO thin film is grown in perpendicular to the substrate when pulse frequency of 30 kHz and substrate temperature of $400^{\circ}C$ was applied. Under this optimized growth condition, the resistivity of AZO thin films exhibited $7.40\times 10^{-4}\Omega \textrm{cm}$. This indicated that the decrease of film resistivity resulted from the improvement of film crystallinity. The optical transmittance spectra of the films showed a very high transmittance of 85∼90 % in the visible wavelength region and exhibited the absorption edge of about 350 nm. The results show the potential application for transparent conductivity oxide (TCO) thin films.

• 한국결정성장학회지
• /
• 제8권4호
• /
• pp.587-591
• /
• 1998

마이크로 웨이브를 보조 여기원으로 사용한 직류 magnetron 스퍼터링법으로 Aluminum이 2wt% 포함되어 있는 Zn:Al 합금타겟을 사용하여 AZO(Aluminum doped zinc oxide) 투명 전도막을 제막하였고 그 영향을 조사하였다. 타겟인가 전압이 420V에서 증착된 막의 투과율, 비저항 그리고 증착속도는 각각 50~70%, $5.5{\times}10^{-3}{\Omega}$cm 그리고 6,000$\AA\textrm{mm}^2$/J 이었다. 이 막을 40$0^{\circ}C$에서 30분간의 열처리하면 광투과율은 80% 이상으로 열처리전에 비해 향상되었으며 전도도는 2배 이상 향상되어 비저항값이 $2.0{\times}10^{-3}{\Omega}$cm인 막을 얻을 수 있었다.

• 센서학회지
• /
• 제24권4호
• /
• pp.219-223
• /
• 2015

Indium free consisting of three alternating layers GTO/Ag/GTO has been fabricated by radio-frequency (RF) sputtering for the applications as transparent conducting electrodes and the structural, electrical and optical properties of the gallium tin oxide (GTO) films were carefully studied. The gallium tin oxide thin films deposited at room temperature are found to have an amorphous structure. Hall Effect measurements show a strong influence on the conductivity type where it changed from n-type to p-type at $700^{\circ}C$. GTO/Ag/GTO multilayer structured electrode with a few nm of Ag layer embedded is fabricated and show the optical transmittance of 86.48% in the visible range (${\lambda}$ = 380~770 nm) and quite low electrical resistivity of ${\sim}10^{-5}{\Omega}cm$. The resultant power conversion efficiency of 2.60% of the multilayer based OPV (GAG) is lower than that of the reference commercial ITO. GTO/Ag/GTO multilayer is a promising transparent conducting electrode material due to its low resistivity, high transmittance, low temperature deposition and low cost components.

• Carbon letters
• /
• 제13권4호
• /
• pp.230-235
• /
• 2012

In this study, reduced graphene oxide/polyimide (r-GO/PI) composite films, which showed significant enhancement in their electrical conductivity, were successfully fabricated. GO was prepared from graphite using a modified Hummers method. The GO was used as a nanofiller material for the preparation of r-GO/PI composites by in-situ polymerization. An addition of 20 wt% of GO led to a significant decrease in the volume resistivity of composite films by less than nine orders of magnitude compared to that of pure PI films due to the electrical percolation networks of reduced GO created during imidization within the films. A tensile test indicated that the Young's modulus of the r-GO/PI composite film containing 20 wt% GO increased drastically from 2.3 GPa to 4.4 GPa, which was an improvement of approximately 84% compared to that of pure PI film. In addition, the corresponding tensile strength was found to have decreased only by 12%, from 113 MPa to 99 MPa.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 1992년도 폐기물 매립지의 공학적 특성과 개량기술
• /
• pp.33-66
• /
• 1992

Recently, waste landfills built on seashores have been increased because of the easy availability of broad area near the urban communities. To evaluate the performance of the marine clay landfill liner numerical contaminant transport analyses are performed by selecting the typical section of a waste landfill built on seashores and using hydraulic conductivity data obtained from the site. Also, the laboratory electrical resistivity test and the in-situ corrosion test are performed in order to analyze the influence of the soil and leachates composing the landfills on the construct ion materials. From the results of contaminant transport analyses, it is shown that the leachates can be migrated faster through narrow pervious channels than the wide homogeneous pervious tedium and the importance of good quality barriers to prevent the contaminant migration is recognized. In the laboratory electrical resistivity test all the earth materials except the cover soils saturated with distilled water have small resistivities, which shows a high potential of corrosivity of soils composing landfills. However, the degree of corrosion of specimens buried in the landfills was not so severe except the zinc and carbon steel specimens. This apparently conflict results present the necessity of the investigation of other major factors and the long term in-situ corrosion test.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2008년도 추계 학술발표회
• /
• pp.1693-1706
• /
• 2008

It is of importance to determine the zero effective stress void ratio($e_{00}$), which is the void ratio at effective stress equal to zero, and the relationships of void ratio-effective stress and of void ratio-hydraulic conductivity for characterizing non-liner finite strain consolidation behavior for ultra-soft dredged materials. The zero effective stress void ratio means a transitional status from sedimentation to self-weight consolidation of very soft soil deposits, and acts as a starting point for self-weight consolidation in the non-linear finite strain numerical analysis such as PSDDF. In this paper, a new method for determining the zero effective stress void ratio has been introduced with the aid of measuring electrical resistivity of the specimen. A correlation between the zero effective stress void ratio and the initial slurry void ratio has been proposed, which can be used in PSDDF analysis as an input parameter. Combining all of the accessible experimental data, the consolidation characteristics of a dredged soil from the Incheon area has been studied in detail.