• 한국환경복원기술학회지
• /
• 제5권6호
• /
• pp.30-36
• /
• 2002

A 0.19 hectare natural-type wetland for stream water treatment demonstration was constructed and planted with cattails from April 2001 to May 2001. Part of its bottom surfaces adjacent to levees have a variety of slope of 1 : 4~1 : 15. Two small open water areas were installed, in which emergent plants could not grow. Removal of nutrients from stream waters was a major objective of the wetland. Waters of Sinyang Stream flowing into Kohung Estuarine Lake were pumped and funneled into the wetland. The lake had been formed by a salt marsh reclamation project and was located southern coastal region of Korean Peninsula. Volumes and water quality of inflow and outflow were analyzed from July 2001 through December 2001. Inflow and outflow averaged $120.4m^3/day$ and $112.1m^3/day$, respectively. Hydraulic retention time was about 3.1 days. Average total phosphorous concentration of influent and effluent was $0.19mg/{\ell}$ and $0.075mg/{\ell}$, respectively. Total phosphorous loading rate of inflow and outflow averaged $12.05mg\;m^{-2}\;day^{-1}$ and $4.44mg\;m^{-2}\;day^{-1}$, respectively. Average total phosphorous removal rate in the wetland was $7.61mg\;m^{-2}\;day^{-1}$. Seasonal changes of phosphorous retention rates were observed. The wetland acted as effective phosphorous sinks in the initial stage of the constructed wetland.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2016년도 제50회 동계 정기학술대회 초록집
• /
• pp.267.2-267.2
• /
• 2016

Semiconductor photo-catalysis offers the potential for complete removal of toxic chemicals through its effective and broad potential applications. Various new compounds and materials for chemical catalysts were synthesized in the past few decades. As one of the most important II-VI group semiconductors, zinc sulfide (ZnS) with a wide direct band gap of 3.8 eV has been extensively investigated and used as a catalyst in photochemistry, environmental protection and in optoelectronic devices. In this work, the ZnS films and nanostructures have been successfully prepared by wet chemical method. We show that the agglomerates with four successive scales are always observed in the case of the homogeneous precipitation of zinc sulfide. Hydrodynamics plays a crucial role to determine the size of the largest agglomerates; however, other factors should be invoked to interpret the complete structure. In addition, studies of the photocatalytic properties by exposure to UV light irradiation demonstrated that ZnS nanocrystals (NCs) are good photo-catalysts as a result of the rapid generation of electron-hole pairs by photo-excitation and the highly negative reduction potentials of excited electrons. A combination of their unique features of high surface-to volume ratios, carrier dynamics and rich photo-catalytic suggests that these ZnS NCs will find many interesting applications in semiconductor photo-catalysis, solar cells, environmental remediation, and nano-devices.

• 열처리공학회지
• /
• 제7권4호
• /
• pp.270-276
• /
• 1994

The effects of thermomechanical and duplex aging treatment on precipitation behavior were investigated for the 8090 aluminium alloy by tensile test, hardness test, plane-strain fracture toughness test and electron microscope. Both pre-aging stretch and duplex aging with pre-aging stretch were effective to homogenize the distribution of S' phase in this alloys. The latter makes more homogeneous distribution of S' phase than that of the former, but the sizes of S' phase in both specimens are almost same. The size and distribution of 0' phase were not changed by thermomechanical or duplex aging treatment. The strength was increased by thermomechanical treatment, but the elongation was decreased. Duplex aging treatment couldn't change the strength and elongation. Pre-aging stretch and duplex aging with pre-aging stretch have same effect on the strength and elongation. The increase of strength by thermomechanical treatment in 8090 alumunium alloy was caused by homogeneously precipitated S' phase.

• 상하수도학회지
• /
• 제21권3호
• /
• pp.273-278
• /
• 2007

Modern society has moved from a phosphorus recycling loop, where animal manure and human wastes were spread on farming land to recycle nutrients, to a once-through system, where phosphates are extracted from mined, non-renewable phosphate rock and end up either in landfill(sewage sludge, incinerator ash) or in surface waters. In this research, crystallization of nitrogen and phosphate with natural sources of $Mg^{2+}$ in synthetic water was tested. The operational parameters of pH, mixing time, and the magnesium molar ratio were investigated to find optimal conditions of the MAP precipitation using synthetic wastewater. The removal efficiency of phosphate increased with pH up to 11. By MAP precipitaiton of the synthetic waste water, 94% of the phosphate were eliminated at pH 11. It was found that at least 10 minutes mixing time was required and 20 minutes mixing time was recommended for efficient phosphate removal. High efficiency removal of phosphate was possible when the magnesium molar ratio was 1.0~2.0. The comparative study of different magnesium sources showed that coagulants (PAC) was the more efficient sources than only magnesium. The result showed that 97% of phosphate removal. In conclusion, coagulants (PAC) induced crystallization of struvite and hydroxyapatite was shown to be a technically viable process that could prove cost effective for removing phosphate in wastewater.

• 한국분말재료학회지
• /
• 제23권5호
• /
• pp.372-378
• /
• 2016

This study focuses on the development of an alkaline leaching hydrometallurgy process for the recovery of tungsten from WC/Co hardmetal sludge, and an examination of the effect of the process parameters on tungsten recovery. The alkaline leaching hydrometallurgy process has four stages, i.e., oxidation of the sludge, leaching of tungsten by NaOH, refinement of the leaching solution, and precipitation of tungsten. The WC/Co hardmetal sludge oxide consists of $WO_3$ and $CoWO_4$. The leaching of tungsten is most affected by the leaching temperature, followed by the NaOH concentration and the leaching time. About 99% of tungsten in the WC/Co hardmetal sludge is leached at temperatures above $90^{\circ}C$ and a NaOH concentration above 15%. For refinement of the leaching solution, pH control of the solution using HCl is more effective than the addition of $Na_2S{\cdot}9H_2O$. The tungsten is precipitated as high-purity $H_2WO_4{\cdot}H_2O$ by pH control using HCl. With decreasing pH of the solution, the tungsten recovery rate increases and then decrease. About 93% of tungsten in the WC/Co hardmetal sludge is recovered by the alkaline leaching hydrometallurgy process.

• 열처리공학회지
• /
• 제3권4호
• /
• pp.10-22
• /
• 1990

A study has been investigated on the effect of mechanical properties (tension strength, rotary bending fatigue strength, wear resistance, hardness) according to the carbide particle size variation by the treatment of 1) quenching tempering, and 2) quenching, subzero treatment and tempering. The material used in this investigation was a typical bearing steel, high C high Cr, AISI E 52100. The result obtained in this study were as follows : (1) Finer the carbide particle size increasing the hardness and retained austenite in same quenching condition. (2) Finer the carbide particle size reduced the tension and rotary bending fatigue which were resulted from austenite grain growth and carbide precipitation on grain boundry that induced by carbide refine heat treatment. (3) Finer the carbide particel size increasing the wear resistance which were resulted by uniform distribution of carbide and increased hardness induced by microstructural uniform hardenability of matrix. (4) When the carbide particles were refinded, subzero treatment is effective only wear resistance and hardness.

• Journal of Pharmaceutical Investigation
• /
• 제24권3호spc1호
• /
• pp.11-18
• /
• 1994

We have studied the iron uptake by the purified brush-border membrane vesicles (BBMVs) to determine the effect of fructose on the absorption of iron. BBMVs were prepared by the modified calcium precipitation method, The degree of purification was routinely assessed by the marker enzyme, alkaline phosphatase, and the functional integrity was tested by $D-[1-^3H]glucose$ uptake. The appearance of membrane vesicles was shown by transmission electron microscopy (TEM). The uptakes of complexes of labeled iron $[^{59}Fe]$ with fructose and ascorbate were measured with a rapid filtration technique, The uptake rate and pattern of the two iron-complexes, Fe(III)-fructose and Fe(III)-ascorbate, were also observed. A typical overshooting uptake of D-glucose was observed with peak value of $2{\sim}3$ times higher concentration than that at equilibrium. This result was similar to other studies with BBMVs. TEM showed that the size of BBMVs was uniform and we can hardly find any contaminants, Fe(III)-fructose has the higher value of $V_{max}$ and the lower value of Km than those of Fe(III)-ascorbate, respectively. It may be concluded that D-fructose is more effective in promoting the iron absorption than ascorbate.

• Journal of Microbiology and Biotechnology
• /
• 제9권1호
• /
• pp.56-61
• /
• 1999

Pseudomonas sp. SW1 grew and produced biosurfactants on 3% hexadecane as the energy and carbon source. As a result of biosurfactant synthesis, the surface tension of the medium was reduced from 72 dyne/cm to 30 dyne/cm. The properties of biosurfactants that were purified from Pseudomonas sp. SW1 were investigated. The purification procedure included acid precipitation from culture supernatant, silica gel G60 column chromatography, and Sephadex G-150 gel filtration. The biosurfactants were separated into two different types, viz., types I and II. Biosurfactant type Isignificantly reduced the surface tension of water from 72 to 27 dyne/cm at concentration levels above 30 mg/l. The surface tension of water was reduced to a minimum of approximately 30 dyne/cm by biosurfactant type II at concentration levels over 80 mg/l. The biosurfactants were effective in a wide range of pHs, at NaCl concentrations of up to 4%, at $CaCl_2$ concentration up to 100 mM, and at temperatures up to $200^{\circ}C$ for 8 h.

• Environmental Engineering Research
• /
• 제22권1호
• /
• pp.12-18
• /
• 2017

Struvite precipitation has been proven to be an effective method in removing and recovering ammonia nitrogen (N) and phosphate phosphorus (P) from wastewater. In this study, effects of pH, molar ratios and pre-treatment of effluent of anaerobically digested swine wastewater were investigated to improve struvite crystallization. The magnesium : ammonium : phosphate ratio of 1.2 : 1.0 : 1.0 was found to be optimal, yet the molar ratio in the wastewater was 1 : 74.9 : 1.8. From the analysis, the optimum pH was between 8.0 and 9.0 for maximal phosphate P release and from 8.0 to 10.0 for maximal ammonia N and phosphate P removal from real wastewater. Analysis from Visual MINTEQ predicted the pH range of 7-11 for ammonia N and phosphate P removal and recovery as struvite. For pre-treatment, microwave pre-treatment was ineffective for phosphate P release but ultrasound pre-treatment showed up to 77.4% phosphate P release at 1,000 kJ/L of energy dose. Precipitates analysis showed that phosphorus and magnesium in the collected precipitate had almost same values as theoretical values, but the ammonia content was less than the theoretical value.

• Journal of Microbiology and Biotechnology
• /
• 제13권5호
• /
• pp.680-686
• /
• 2003

This study was carried out to characterize the antilisterial substances produced by Leuconostoc sp. W65 and to evaluate the effects of pH, temperature, and time on inhibitory activity using response surface methodology. Leucocin W65, an antilisterial substance produced by Leuconostoc sp. W65, markedly inhibited the growth of Listeria monocytogenes, L. innocua, and L. ivanovii, whereas other pathogens including Gram-negative bacteria were not susceptible. The pH was the most effective factor with regard to bacteriocin activity, while temperature and time of heat treatment had no significant effect. Fifty percent of inhibitory activity remained after 22.8 min at pH 4.2 and $121^{\circ}C$. Leucocin W65 was purified by ammonium sulfate precipitation, hydrophobic interaction chromatography, and tricine-SDS-PAGE. Compositional analysis originally estimated the peptide to be 56 amino acids in length without asparagine, glutamine, and tryptophane. The sequence of partial N-terminal amino acid residues of purified bacteriocin was identified as follows: $NH_{2}-XGXAGVXPXGGQQPXVPLXYP$.