• Journal of ILASS-Korea
• /
• v.20 no.4
• /
• pp.207-216
• /
• 2015

Recently, the researches for air pollutant control technologies have been performing in Korea, while considering an one of the latest main topics as problems on air pollutant control. However, it is difficult to investigate emission amount of air pollutant by passenger cars, because of lack of the domestic information about mobile source; the number of research institutes are less in the whole. Especially, the informations on registered numbers and emissions of motorcycles are less. Thus, in this study, the analysis that is based on experimental results was conducted for finding out source profiling and emission characteristics on motorcycles exhaust. For these experiments, the domestic motorcycles were chosen and evaluated by EURO III standard. From the result, controlled pollutants (CO, HC, NOx) were met to EURO III, but low displacement motorcycles showed a higher incomplete combustion reaction than that of 250 cc motorcycles. Additionally, uncontrolled pollutants (BTEX and 1,3-butadiene) were decreased with increasing a displacement of motorcycles. However, the emission trend of aldehydes was not followed that of those; the formaldehyde ratio increased upto approximately 33%, with increasing a displacement of motorcycles. In the future, it would be used to support the CAPSS as basic data of Korea.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.11 no.2
• /
• pp.69-74
• /
• 2003

An experimental feasibility study of the E3.9 engine with CP3.3 and EDC7C was conducted to understand the initial performance and the possibility for EURO-III regulation. ID cycle simulation for concept study was conducted using the BOOST. Also, some basic investigations through such various parameters as injection timing and rail pressure have been carried out to find the feasibility on EURO-III ESC mode. Based on the results, the feasibility of the E3.9 engine for EURO-III characteristics such as performance, emissions, and fuel economy was demonstrated.

• Advances in Automotive Engineering
• /
• v.1 no.1
• /
• pp.61-77
• /
• 2018

In this study, the effects of sitting position of the driver on the whiplash neck injury have been analyzed experimentally by using hybrid III series 50 percentile male crash test dummy. A testing platform consisting of vehicle ground, driver foot rest, driver seat and a 3-point seatbelt has been prepared. This testing platform and the instrumented crash test dummy are prepared for tests according to the Euro NCAP whiplash testing protocol. The prepared test set-up has been exposed to 3 different acceleration-time loading curves defined in the Euro NCAP whiplash testing protocol by performing sled tests. 9 different sled tests have been performed with the combinations of 3 different seating positions of the crash test dummy and 3 different acceleration-time loading curves. The sensor data obtained from the crash test dummy and high-speed videos taken are analyzed according to the injury assessments criteria defined in the Euro NCAP whiplash testing protocol and the criticality of the whiplash injury is defined. It is seen that the backset distance of the driver head with the headrest and the height difference of the top of the head of the driver with the headrest have a great importance on whiplash injuries.

• International Journal of Automotive Technology
• /
• v.2 no.4
• /
• pp.135-145
• /
• 2001

DEUTZ AG, co-founded in 1864 by Nicolaus August Otto, the inventor of the four-stroke cycle engine, has developed the new 2013 engine for commercial vehicles on the basis of the tried and tested 1012 and 1013 series. With 4 and 6 cylinder models, the engine covers the power range between 100 and 190 kW. At the time of their introduction to the market, the engines will meet the exhaust emission legislation of EURO IV and incorporate the potential for EURO IV, Further engineering targets were. (Compactness, Favourable power/cost relation, Low weight, Low fuel consumption and Low noise level). All targets could be accomplished in a relatively short development period via the application of modem simulation tools and test methods. In this paper, the design configuration of the engines is described with particular emphasis on measures for noise emission reduction and the combustion system including injection and turbo charging. Furthermore, we demonstrate the engine's potential to fullfill the European emission legislation EU4, which comes into force in 2005.

• Journal of Auto-vehicle Safety Association
• /
• v.9 no.1
• /
• pp.13-18
• /
• 2017

In recent years, NCAP regulations of many countries have induced automaker to improve the vehicle crashworthiness. But, the current NCAP regulations don't cover all types of traffic accidents. And rapid-increasing market share of compact cars and SUVs has brought for both consumer and automaker to pay more attention on crash compatibility. So, many countries have tried to develop the new crash test mode and update the present crash test mode. Especially, Euro NCAP has been developing a new impact protocol of the car-to-car frontal offset impact including the crash compatibility assessment. There are plans to introduce this new protocol in 2020, and it will be replaced the current Euro NCAP frontal offset impact. The test dummy in the front seats of this new test mode will be changed from 50% Hybrid-III male to 50% THOR male. This paper will address the vehicle responses, the occupant responses and the vehicle compatibility performance from a full vehicle crash test using the new car-to-car frontal offset test protocol of Euro NCAP.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.15 no.6
• /
• pp.128-136
• /
• 2007

It is well known that two representative methods satisfy EURO-IV regulation from EURO-III. The first method is to achieve the regulation through the reduction of NOx in an engine by utilizing relatively high EGR rate and the elimination of subsequently increased PM by DPF. However, it results in the deterioration of fuel economy due to relatively high EGR rate. The second is to use the high combustion strategy to reduce PM emission by high oxidation rate and trap the high NOx emissions with DeNOx catalysts such as Urea-SCR. While it has good fuel economy relative to the first method mentioned above, its infrastructure is demanded. In this paper, the number distribution of nano PM has been evaluated by Electrical Low Pressure Impactor(ELPI) and CPC in case of Urea-SCR system in second method. From the results, the particle number was increased slightly in proportion to the amount of urea injection on Fine Particle Region, whether AOC is used or not. Especially, in case of different urea injection pressure, the trends of increasing was distinguished from low and high injection pressure. As low injection pressure, the particle number was increased largely in accordance with the amount of injected urea solution on Fine Particle Region. But Nano Particle Region was not. The other side, in case of high pressure, increasing rate of particle number was larger than low pressure injection on Nano Particle Region. From the results, the reason of particle number increase due to urea injection is supposed that new products are composited from HCNO, sulfate, NH3 on urea decomposition process.

• Journal of ILASS-Korea
• /
• v.20 no.1
• /
• pp.28-34
• /
• 2015

Recently, some researchers have been carried out risk assessment of vehicles exhaust on human health. Especially, some of VOCs which is non-controlled, was classified to hazardous pollutant, such as 1,3-Butadiene and BTEX(Benzene, Toluene, Ethylbenzene and Xylene). Therefore, the profile on non-controlled pollutant may be needed in the future, because it would be critical data or information to control them. Additionally, with increasing amount of motorcycle, the source profiling is essential for estimating emission factor and amount on motorcycle exhaust. For these, in this study, imported motorcycles (8 vehicles) were selected as a test model while considering the increasing ratio on sales volume between 2013 and 2014; it was also compared with domestic motorcycles on those. The experiment was conducted by driving mode, UDC and ECE+EUDC that made from EURO III. In addition, it was performed at cold start driving mode without effect by displacement, for evaluating only correlation of BTEX with HC. In order to apply the ratio (m,p-Xylene/o-Xylene) as a marker, the ratio was compared with those of tunnel, road side and residential area. As a result, it showed best correlation ($R^2=0.98$) among those. In the future, it has to be considered as a marker for effect evaluation to atmospheric environment by exhaust emission.

• Journal of Auto-vehicle Safety Association
• /
• v.9 no.2
• /
• pp.20-25
• /
• 2017

KNCAP is a program to evaluate the automobile safety, providing consumer vehicle safety assessment results. The safety evaluation tests are Frontal Impact, Offset Frontal Crash, Side Crash, Side Pole Crash, Rear Impact. This is the study of the offset frontal impact safety evaluation. Currently, IIHS is performing a small overlap test. NHTSA plans to implement the oblique moving deformable barrier test. Euro-NCAP plans to implement a mobile frontal impact test. Simulation is used to compare occupant behavior and injury. We have investigated whether the introduction of the test at KNCAP is necessary. The dummy model used in the simulation was the 50th percentile male Hybrid III dummy.

• The Journal of Korean Medicine Ophthalmology and Otolaryngology and Dermatology
• /
• v.24 no.3
• /
• pp.27-36
• /
• 2011

Objective : The purpose of this clinical research was to analyze the correlation between disease severity and disease specific quality of life adjusted by general quality of life measure in adult patients with atopic dermatitis attending Wonkwang Univ. Sanbon Oriental Medical Center. Methods : A total of 35 patients participated in atopic dermatitis clinical trial from June 1st, 2010 to June 30th, 2011 were included in this study. SCORing Atopic Dermatitis(SCORAD) index, Dermatologic Life Quality Index(DLQI), Health Utility Index III(HUI-III) and EuroQoL 5-Dimension(EQ-5D) have been estimatied. Baseline statistical analysis and normality test were done by using Student t-test, Shapiro-Wilk test and ladder test. Pearson analysis and Spearman analysis were conducted to examined the correlation of each variables. Hierachial regression analysis was performed using related variables. Statistical significance was achieved if the probability was less than 5%. Results : There were statistically significance between DLQI and SCORAD index, and also between DLQI and EQ-5D. However there was no significant between DLQI and HUI-III. In the hierachial regression analysis, after adjusting for demographic variables (gender, age) and general quality of life (EQ-5D), SCORAD index significantly predict the intensity of disease specific quality of life (DLQI). Conclusions : We confirmed the correlation between SCORAD index and DLQI, and developed the inference for regression equation of DLQI using SCORAD index, EQ-5D and demographic variables.

• Journal of muscle and joint health
• /
• v.19 no.2
• /
• pp.152-160
• /
• 2012

Purpose: The purpose of this study was to test the effects of the Tai Chi exercise on metabolic syndrome and health-related quality of life in middle-aged women. Methods: A quasi-experimental design was used. Subjects were sixty middle-aged women with metabolic syndrome. All of the subjects were met the criteria of the National Cholesterol Education Program-Adult Treatment Panel III (NCEP-ATP III). The subjects were divided into the experiment group (n=33) trained the Tai Chi for 12 weeks and the control group (n=27). Metabolic syndrome risk factors including blood pressure, waist circumference, glucose, triglyceride (TG), and high density lipoprotein cholesterol (HDL-C) were measured before and after the 12-week period. Euro Quality of Life Questionnaire 5-Dimensional Classification (EQ-5D) was used to evaluate the health-related quality of life. Results: The experiment group showed significant decreases in diastolic blood pressure, waist circumference, glucose, and TG; and increase in HDL-C compared to the control group. For the health-related quality of life evaluation, the experiment group showed significant improvement more than the control group. Conclusion: The Tai Chi exercise may be effective intervention in preventing cardiovascular disease caused by metabolic syndrome in middle-aged women.