• 한국신재생에너지학회:학술대회논문집
• /
• 2011.05a
• /
• pp.130.1-130.1
• /
• 2011

Nowadays, the number of PV module corporation is increasing due to demand growth of silicon solar module. However almost study of module is research about increasing of efficiency for it. This study is evaluation and development for process of module using the silicone encapsulation material instead of existing EVA sheet. We are changed adding material ratio on silicone and thickness of silicone. So we get better efficiency than EVA sheet through the evaluation for silicone liquid and modulation. Also, we are test after establishing manufacture system being able to quicker than existing modules line. The result of EVA sheet is average 207.47W and silicone material is 211.32W so we think that silicone is better than EVA sheet.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.15 no.5
• /
• pp.1683-1696
• /
• 1991

본 연구에서는 정4각단면덕트 입구영역에서 층류맥동유동(laminar pulsating flows)의 유동특성을 이론 및 실험적으로 규명하기 위하여, 이론적 방법으로 덕트 입 구영역에서의 층류맥동유동에 대한 운동량방정식을 유도한 후 비선형인 대류항을 선형 화 시켜서 라플라스변환으로 속도분포식의 해를 구하였고, 실험적인 방법으로는 시험 덕트 크기는 횡단면의 가로*세로가 40mm*40mm이고, 길이가 4000mm인 정4각단면덕트 입구영역에서 송풍기에 의한 공기흡입유동으로 층류진동유동을 발생하며 이들 두유동 을 합성시켜 발생한 층류맥동유동에 대하여 열선유속계의 열선신호로부터 얻어진 속도 파형을 고찰하여 덕트내의 맥동유동에 대한 임계레이놀즈수를 결정하고 속도분포를 측 정하였다. 그리고 이론적으로 얻어진 속도분포식과 열선유속계로 측정한 속도분포를 비교검토하여 정확성을 검증하고, 이들 해석결과로 부터 층류맥동유동의 입구길이(en- trance lenght)식을 결정하여 제안하였다.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.30A no.5
• /
• pp.1-15
• /
• 1993

In DQDB networks, the bandwidth can be increased considerably be using the EN(Erasure Node) algorithms and DR(Destination Release) algorithms. However, the important issue in implementing them is using method of extra capacity fairly. To improve it, this paper proposes AEN(Adaptive Erasure Node) algorithm which erasure function is activated by network traffic load. Its functional architecture consists of SESM, RCSM, LMSM in addition to the basic DQDB state machines (DQSM, RQM). The SESM and RCSM state machines are placed in front of the DQSM and RQM state machines in order for the node to take advantage of the newly cleared slots. This paper also presents some simulation results showing the effect of AEN algorithm on access delay, throughput and segment erasing ratio in the single and multiple priority networks. The results show that the AEN algorithm offer the better performance characteristics than existing algorithms under overload conditions.

• Environmental Analysis Health and Toxicology
• /
• v.23 no.4
• /
• pp.277-284
• /
• 2008

The ecotoxicological effects of 4-tert-octylphenol were observed on non-biting midge, Chironomus plumosus collected from Anyang stream in Seoul. The survival rate and adult emergence rate on C. plumosus exposed to octylphenol were not significantly affected. However, 4-tert-octylphenol induced developmental delay and disrupted sex ratio in high concentration of octylphenol. The mouth deformity such as tooth deletion or fusion in mentum, and tooth deletion in mandible were observed exposure to 4-tert-octylphenol. The deformity type of the mentum showed deletion (LT, 6.7%), and fusion (LT, 6.3%). Moreover, tooth deletion of mandible was observed in 4-tert-octylphenol treated groups (6.7%, 3 ppm).

• International Journal of Industrial Entomology and Biomaterials
• /
• v.12 no.1
• /
• pp.45-49
• /
• 2006

The present investigation was conducted to know the effects of host age on development and morphological characteristics of Nesolynx thymus, a gregarious ectopupal parasitoid of the uzi fly, Exorista bombycis, a serious en do-larval parasitoid of the silkworm, Bombyx mori L. For experimentation, 3 - 11 day-old pupae of E. bombycis were exposed to 2 day-old adults of N. thymus at $25{\pm}2^{\circ}C\;and\;60{\pm}10%$ RH. A highly significant negative correlation between host age and the following development and morphological characteristics of the parasitoid was observed: number of pupae parasitised, total adult recovery, sex ratio and recovery, longevity, body length, wing span, abdomen length, and abdomen width of females. The findings of the present study clearly demonstrate that various development and morphological parameters of N. thymus are influenced by the age of E. bombycis pupae.

• Bulletin of the Korean Chemical Society
• /
• v.15 no.8
• /
• pp.669-673
• /
• 1994

Coordination isomers of cis-(N-N)Pt(Glu) prepared by reaction of cis-(N-N)Pt($SO_4$) (N-N=2$NH_3$, ethylenediamine(en),(R,R)-1,2-diaminocyclohexane (DACH), N,N,N',N'-tetramethylethylenediamine (TMEDA)) with barium glutamate in water have been monitored and characterized by $^1H-NMR$, $^{13}C-NMR$, IR, and mass spectra. The reaction at room temperature affords the mixture of O,O'-and N, ${\alpha}$ O-chelated platinum(II) complexes. The O,O'-chelate initially formed isomerized to N,${\alpha}$O-chelate on standing for a long time or increasing temperature. The ratio of the two isomers at room temperature depends on the nature of the nitrogen donor coligand (N-N).

• International Journal of High-Rise Buildings
• /
• v.10 no.4
• /
• pp.285-297
• /
• 2021

Fire safety is one of the most significant issues for the design of mid-rise and high-rise timber structures. A large number of experimental tests were conducted during the last three decades to investigate the fire performance of the dowel-type timber connections. Many influenced parameters (e.g. the thickness of the side timber, the load ratio, the fasteners type etc.) were considered in those experiments. Relevant calculated models were proposed by previous researchers to estimate the fire resistance of the connections. In this study, a series of experimental programs of dowel-type connections in fire are collected. Then, empirical formulas proposed by EN 1995-1-2, Fire safety in timber buildings, and previous researchers are presented and analyzed. The accuracy of those formulas is checked by comparisons between the experimental data and estimated results. The collected experimental research and empirical formulas can be used as the reference for the fire design of dowel-type timber connections in the future.

• Asian-Australasian Journal of Animal Sciences
• /
• v.27 no.1
• /
• pp.55-61
• /
• 2014

Forty-eight Pelibuey${\times}$Katahdin male intact lambs ($23.87{\pm}2.84$ kg) were used in an 84-d feeding trial, with six pens per treatment in a $2{\times}2$ factorial design arrangement. The aim of the study was to evaluate the interaction of two dietary energy levels (3.05 and 2.83 Mcal/kg ME) and two dietary protein levels (17.5% and 14.5%) on growth performance, dietary energetics and carcass traits. The dietary treatments used were: i) High protein-high energy (HP-HE); ii) High protein-low energy (HP-LE); iii) Low protein-high energy (LP-HE), and iv) Low protein-low energy (LP-LE). With a high-energy level, dry matter intake (DMI) values were 6.1% lower in the low-protein diets, while with low-energy, the DMI values did not differ between the dietary protein levels. Energy levels did not influence the final weight and average daily gain (ADG), but resulted in lower DMI values and higher gain efficiencies. No effects of protein level were detected on growth performance. The observed dietary net energy (NE) ratio and observed DMI were closer than expected in all treatments and were not affected by the different treatments. There was an interaction (p<0.03) between energy and protein level for kidney-pelvic and heart fat (KPH), KPH was higher in lambs fed high energy and high protein diet but not in high energy and low protein diet. The KPH was increased (20.2%, p = 0.01) in high-energy diets, while fat thickness was increased (21.7%, p = 0.02) in high-protein diets. Therefore, it is concluded that dietary energy levels play a more important role in feed efficiency than protein levels in finishing lambs with a high-energy diet (>2.80 Mcal/kg ME). Providing a level of protein above 14.5% does not improves growth-performance, dietary energetics or carcass dressing percentage.

• Journal of Korean Institute of Industrial Engineers
• /
• v.41 no.2
• /
• pp.121-127
• /
• 2015

A reduction of motor performance due to brain disorders can be screened by evaluating force tracking capabilities (FTCs). Existing studies have examined FTCs mainly using simple sinusoidal waves, of which repeated profiles have a critical limitation due to a learning effect in force tracking. The present study examined the effects of personal factors (age and gender) and sinusoidal wave factors (central force and complexity) on FTCs of healthy adults using composite sinusoidal wave profiles (CSWPs). FTCs were measured using Finger $Touch^{TM}$ for 30 seconds and quantified in terms of time within the target range (TWR, accuracy measure) and relative RMSE (RRMSE, variability measure). A total of 90 healthy adults in 20s to 70s with the equal gender ratio participated in the experiment consisting of combinations of 2 central force levels (6 N and 10 N) and 2 complexity levels (approximate entropy, ApEn = 0.03 and 0.06) of CSWPs. Significantly decreased FTCs (lower TWR and higher RRMSE) were found in aged adults, females, the low central force, and the high complexity. The detailed FTC decrements include a 43% reduced TWR and a 85% increased RRMSE of older adults in 70s as compared to those in 20s, a 17% reduced TWR and a 17% increased RRMSE of female as compared to those of male, a 30% reduced TWR and a 108% increased RRMSE at central force = 6N when compared to those at central force = 10N, and a 19% reduced TWR and a 30% increased RRMSE at ApEn = 0.06 as compared to those at ApEn = 0.03. The characteristics of FTCs for CSWPs can be of use in establishing an assessment protocol of motor performance for screening brain disorders.

• Asian-Australasian Journal of Animal Sciences
• /
• v.30 no.11
• /
• pp.1563-1567
• /
• 2017

Objective: The influence of substituting steam-flaked corn (SFC) for dry rolled corn (DRC) on feedlot cattle growth performance and dietary net energy when cattle are allowed either ad libitum or 2-h restricted access to the finishing diet was evaluated. Methods: Treatment effects were tested using 96 crossbred steers ($251{\pm}2kg$) during the initial 56 d of the finishing phase. Cattle were blocked by weight and randomly assigned within blocks to 16 pens (4 pens/treatment). Bunk space was sufficient (41 cm/head) to allow all steers access to the feed bunk at the same time. Treatments consisted of two finishing diets containing (dry matter basis) 77.1% corn grain processed by dry rolling (density = 0.50 kg/L) or steam flaking (density = 0.36 kg/L). Cattle were fed twice daily at 06:00 and 14:00 h, allowing for approximately 5% residual. In the case of restricted feeding, steers were allowed access to feeders for 1 h following each feeding, after which residual feed was withdrawn. Results: There were no treatment interactions on dry matter intake (DMI), average daily gain (ADG), gain efficiency (G:F), or dietary net energy (NE). Restricting feed access time reduced (p<0.01) feed intake, and hence, ADG. Substitution of SFC for DRC increased (p<0.01) ADG, feed efficiency (G:F), and estimated dietary NE, without affecting DMI. Based on tabular net energy of maintenance ($NE_m$) value (2.18 Mcal/kg) for DRC, the estimated $NE_m$ value for SFC using the replacement technique, averaged 2.44 Mcal/kg; an improvement of 10.7%. The ratio of observed-to-expected dietary NE was not affected by feed access time. Conclusion: Substitution of SFC for DRC in finishing diets for feedlot cattle enhanced ADG, gain efficiency, and the NE value of the diet. Although restriction of feed access time depressed DMI and ADG, it did not affect the comparative benefit of steam flaking toward enhancement of ADG, G:F, and dietary NE.