• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.8
• /
• pp.79-85
• /
• 2004

In this paper, the RF-ID system for ubiquitous tagging applications has been designed, fabricated and analysed. The RF-ID System consists of passive RF-ID Tag and Reader. The passive RF-ID tag consists of rectifier using zero-bias schottky diode which converts RF power into DC power, ID chip, ASK modulator using bipolar transistor and slot loop antenna. We suggest an ASK undulation method using a bipolar transistor to compensate the disadvantage of the conventional PIN diode, which needs large current Also, the slot loop antenna with wider bandwidth than that of the conventional patch antenna is suggested The RF-ID reader consist of patch array antenna, Tx/Rx part and ASK demodulator. We have designed the RF-ID System using EM and circuit simulation tools. According to the measured results, The power level of modulation signal at 1 m from passive RF-ID Tag is -46.76 dBm and frequency of it is 57.2 KHz. The transmitting power of RF-ID reader was 500 mW

• The Journal of Korean Academy of Prosthodontics
• /
• v.25 no.1
• /
• pp.213-226
• /
• 1987

The purpose of this study was to standardize and classify the coordination pattern among the left and right masseter and anterior temporal muscles, in terms of integrated EMG values per stroke during gum chewing in normal subjects. In this study, 20 normal subjects were selected to chew a piece of gum and integrated EMG from middle portion of the masseter and anterior temporal muscles on both sides were recorded 20 times during each of the right and left chewing respectively. And the Bioelectric Processor Model EM2 (Myo-tronies Research, Inc., U.S.A.) with the surface electrodes was used to record the EMG activity during all experimental procedures. The results were as follows; 1. In all subjects, the chewing side masseter muscle was predominantly active among the four muscles examined. 2. The integrated EMG value of the middle of masseter muscle was significantly predominant than those of the anterior temporal muscle (p<0.0001) on the chewing side, but no significant predominant was observed on the nonchewing side (p<0.98). 3. In comparison with same muscles on the chewing and nonchewing side, low correlation coefficient was found between the middle of masseter muscles (R=0.317), but high correlation coefficient was found between the anterior temporal muscles (R=0.738). Between two muscles on the same side, there were significant correlation in the chewing (R=0.557) and nonchewing side (R=0.625). 4. In the coordination patterns among four muscles examined, distinct individual differences were found, but in an identical subject one fixed pattern appeared with significant reproducibility.

• Journal of Life Science
• /
• v.19 no.6
• /
• pp.693-697
• /
• 2009

The purpose of the present investigation was to investigate diversity patterns in Mt. Neungdong forested landscape. It was conducted on twelve sloping plots $(100{\times}100 m)$ in the east and west sides of Mt. Neungdong. A total of 2,157 specimins were identified as trees with a diameter at breast height (DBH) ${\geq}$10 em. There were a total of 135 species of 35 families present in both regions of Mt. Neungdong. Least significant differences (LSD) by post hoc analysis revealed that region A had significantly greater densities than region B. Shannon-Wiener functions differed significantly between forests (F=4.12, < 0.05), with region B forest having a significantly higher value (2.118) than region A (1.882). Pinus thunbergii and Quercus aliena were dominant on most plots of both regions, however, the P. densiflora forest of region A was distributed better in the middle plots exposures compared to the opposite ones. Q. aliena, Q. mongolica, and Carpinus laxiflora largely occupied the middle and lower exposures of region B. The spatial distribution in Neungdong's forest was very heterogeneous and reflected by most species as having micro-climate and patchy distributions.

• The Korean Journal of Applied Statistics
• /
• v.29 no.1
• /
• pp.113-122
• /
• 2016

Longitudinal data often occur in prospective follow-up studies. Joint model for longitudinal data and failure time has been applied on several works. In this paper, we extend it to the case where longitudinal data involve informative observation time process as well as competing risks survival times. We use a likelihood approach and derive an EM algorithm to obtain maximum likelihood estimate of parameters. A suggested joint model allows us to make inferences for three components: longitudinal outcome, observation time process and competing risk failure time. In addition, we can test the association among these components. In this paper, liver cirrhosis patients' data is analyzed. The relationship between prothrombin times measured at irregular visiting times and drop outs is investigated with a joint model.

• Journal of the Korean Society of Tobacco Science
• /
• v.23 no.2
• /
• pp.109-114
• /
• 2001

A CAB cDNA vector(pKGCAB), encoding the light harvesting chlorophyll a/b binding protein in Korean ginseng (Panax ginseng C. A. Meyer), was constructed with the CaMV35S promoter of plant expression vector. The chimeric vector was transformed into tobacco(Nicotiana tabacum cv. NC 82) using Agrobacterium tumefaciens LBA 4404 strain, and the transgenic tobacco plant CAB-TP2 was selected. Photosynthetic rates of the CAB-TP2 plant at before-flowering stage were increased about 20% under low irradiance conditions of quantum 100 and 500 $\mu$mol.m$^{-2}$ s$^{-1}$ , however, the rates were similar to those of NC 82 under quantum 1000 and 2000 $\mu$mol.m$^{-2}$ s$^{-1}$ conditions. The plants were germinating under low- or normal irradiance condition and the quantum yield of photosystem III were measured. The differences of the Fv/Em values between conditions were 0.07 and 0.01 in NC 82 and CAB-TP2, respectively. The mature leaves in the position 8-10 of the CAB-TP2 at before-flowering stage revealed l0% higher Fv/Fm values in range of 0.759 to 0.781 and 40% more chlorophyll contents of 70-93mg/$m\ell$ than those of normal NC 82. These data suggest the possibility that the increase in photosynthetic activity of leaves under low light intensity in the canopy of CAB-TP2 transgenic tobacco might lead to increase the quality of lower tobacco leaves.

• Restorative Dentistry and Endodontics
• /
• v.22 no.1
• /
• pp.156-169
• /
• 1997

This study was designed to evaluate the influences of evaporation of liquid of dental cements by drying during long term using. Zinc phosphate cement, polycarboxylate cement, and glass ionomer cement were used, and evaluated the properties as follows; consistency, setting time, film thickness, solubility, and compressive strength according to the ADA specification. The specimens of control group were made by mixing the newly opened liquid using the powder-liquid ratio recommended by the manufacturer, and the specimens of ES groups were made by mixing the 10% evaporated liquid by drying with the powder-liquid ratio recommeded by the manufacturer, and the specimens of EM group were made by mixing the 10% evaporated liquid with the powder-liquid ratio modified for standard consistency. The following conclusions were drawn ; 1. The viscosity of mixture of all kinds of cements were increased by the evaporation of liquid, especially the viscosity of glass ionomer cement were influenced significantly. 2. The amount of liquid should be increased to get a standard consistency at the using of evaporated liquid of cement, the most significant increase of liquid amount was required on Ketac-Cem. 3. The setting times were increased at both cases of mixing of evaporated liquid with powder - liquid ratio recommended by manufacturer or modifided through consistency test. 4. At an experimental group of mixing of the evaporated liquid with powder-liquid ratio recommended by manufacturer, solubility was decreased and film thickness was increased. 5. By the result of evaporation of cement liquid, the compressive strength of polycarboxylate cement was increased slightly and it of glass ionomer cement was increased, however, by the increase of amount of liquid to be possible to manipulate the compressive strength were decreased.

• Textile Coloration and Finishing
• /
• v.18 no.6 s.91
• /
• pp.16-24
• /
• 2006

The purpose of this study is to improve the defects of chitosan crosslinked viscose rayon by ECH and to describe the change of hand of chitosan crosslinked viscose rayon fabrics. The chitosan crosslinked viscose rayon were manufactured by crosslinking process using ECH as crosslinking agent, 2 wt% aqueous acetic acid as a solvent of chitosan and ECH, and 20 wt% aqueous sodium hydroxide as crosslinking catalyst. Viscose rayon were first immersed in the pad bath of the mixed solution of chitosan and ECH, padded up to 100 wt% wet pick-up on weight of fiber(owf), precured on pin frames at $130^{\circ}C$ for 2 minutes, immersed in NaOH solution and finally wash and dry. Antimicrobial properties of the viscose rayon treated with chitosan were measured by the shake flask C.T.M. 0923 test method with staphylococcus aureus(ATCC 6538) as the microorganism. When the concentration of chitosan was increased chitosan crosslinked viscose rayon's LT, WT, B, 2HB and MIU were increased and G, 2HG, SMD, T and $T_m$ were decreased. On the other hand, WT, EM were decreased and RT was increased at $1{\times}10^{-2}M$ ECH. The optimum condition for crosslinking was that ECH concentration was between $1{\times}10^{-2}M\;and\;5{\times}10^{-2}M$. Antimicrobial effects of rayon fabric treated with chitosan was excellent.

• Journal of Life Science
• /
• v.21 no.3
• /
• pp.406-411
• /
• 2011

To investigate the effects of short-term treatment with tri-n-butyltin chloride (TBTCl) and bisphenol A (BPA) on the reproduction of striped field mice, the mice were intramuscularly injected with TBTCl or BPA immediately before the reproductive season and examined in the reproductive season after keeping them for 4 months. As a result, there were no differences between the control and the compound-treated groups regarding body weight in both sexes, the residual levels of the compounds in the adult males, and the gonadosomatic index (GSI) and the histological structures with LM and EM of the testes and epididymides in both the adult and young males. The infant mortality and abortion rate, however, were high in the TBTCl-treated groups and BPA-treated groups respectively, compared to the control group. Conclusively, it was suggested that short-term treatment with TBTCl or BPA in mice in the non-reproductive season might have inhibited the development of the uterine embryos or fetuses, although it did not induce accumulations of these compounds or affect the reproductive organs of adult and young (F1) males.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.6
• /
• pp.525-532
• /
• 2015

In this paper, we propose an equivalent model of array antennas that use open-ended waveguides for effective EM simulation. We first investigate an individual element that consists of an open-ended waveguide and square ground plane. The waveguide length, aperture size, and ground size of the individual element are adjusted to give a similar radiation pattern to that of the individual element of the original antenna. We then apply the designed equivalent model to two different types of array antennas, such as a microstrip patch array and a waveguide array antenna. Comparison of the simulation results using the equivalent model with the results obtained with the original antenna reveals a difference in gain of less than 0.2 dB and a difference in half power beam width(HPBW) of less than $1^{\circ}$. The designed equivalent model is then mounted on a simple aircraft, and the simulation results are again compared to results from the original antenna. We find a 60 % reduction in simulation resources and time when compared with the original antenna model.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.1
• /
• pp.30-38
• /
• 2015

In this paper, the design of a compact triple-mode bandpass filter using a high-Q cylindrical dielectric resonator is proposed. In detail, the triple $TE_{01{\delta}}$ modes along three orthogonal axes are used and novel coupling structure in the metallic enclosure is adopted to introduce the coupling between the resonant modes. Due to the cross coupling, the proposed bandpass filter has an asymmetric frequency response with flexible three transmission zeros, one of which can be located very close to the passband edge to provide an extremely sharp skirt characteristic with low insertion loss. The proposed filter is about 60 % miniaturized compared with conventional single-mode dielectric resonator filter. The proposed bandpass filter design is validated by the circuit and 3D EM simulations and measurements compared to the target specifications.