• Proceedings of the KSME Conference
• /
• 2001.06a
• /
• pp.842-847
• /
• 2001

In order to reinforce the plate in bending spot-welding method is usually used. To analyze the effect of the reinforcement of the plates spot-welded, finite element method was employed to take advantage of the deflection obtained with respect to the change of the aspect ratio and area ratio. The reinforcement effect represented by the equivalent thickness. Was maximum when the aspect ratio was around $1.2{\sim}1.6$ and the area ratio was 0.05.

• Korean Journal of Cognitive Science
• /
• v.20 no.2
• /
• pp.125-154
• /
• 2009

This paper describes the possibility of human physiological data, especially brain-wave activity, to detect cognitive overload, a phenomenon that may occur while learner uses an e-learning system. If it is found that cognitive overload to be detectable, providing appropriate feedback to learners may be possible. To illustrate the possibility, while engaging in cognitive activities, cognitive load levels were measured by EEG (electroencephalogram) to seek detection of cognitive overload. The task given to learner was a computerized listening and recall test designed to measure working memory capacity, and the test had four progressively increasing degrees of difficulty. Eight male, right-handed, university students were asked to answer 4 sets of tests and each test took from 61 seconds to 198 seconds. A correction ratio was then calculated and EEG results analyzed. The correction ratio of listening and recall tests were 84.5%, 90.6%, 62.5% and 56.3% respectively, and the degree of difficulty had statistical significance. The data highlighted learner cognitive overload on test level of 3 and 4, the higher level tests. Second, the SEF-95% value was greater on test3 and 4 than on tests 1 and 2 indicating that tests 3 and 4 imposed greater cognitive load on participants. Third, the relative power of EEG gamma wave rapidly increased on the 3rd and $4^{th}$ test, and signals from channel F3, F4, C4, F7, and F8 showed statistically significance. These five channels are surrounding the brain's Broca area, and from a brain mapping analysis it was found that F8, right-half of the brain area, was activated relative to the degree of difficulty. Lastly, cross relation analysis showed greater increasing in synchronization at test3 and $4^{th}$ at test1 and 2. From these findings, it is possible to measure brain cognitive load level and cognitive over load via brain activity, which may provide atimely feedback scheme for e-learning systems.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.6
• /
• pp.4185-4191
• /
• 2015

The demand for improved rail transportation safety is growing due to the increased speeds of current railways. In addition, freight trains with heavier axle loads are required to run on conventional railways. In order to meet these requirements, increased rail weights and the application of a CWR system have been introduced on conventional railways. The H type sleeper, which has higher lateral resistance than the existing mono sleepers, has been recently developed to increase track stiffness and reduce track irregularities. In this paper, the effects of a H-type sleeper on track behavior were investigated by 3-Dimensional F.E. analysis.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.28 no.4
• /
• pp.409-415
• /
• 2015

For the design of Concrete-Filled Steel Tube(CFST) columns, the outside diameter D to the steel tube thickness t ratio(D/t ratio) is limited to prevent the local buckling of steel tubes. Each design code proposes the respective model to compute the maximum D/t ratio using the yield strength of steel $f_y$ or $f_y$ and the elastic modulus of steel E. Considering the uncertainty in $f_y$ and E, the reliability index ${beta}$ for the local buckling of a CFST section can be calculated by formulating the limit state function including the maximum D/t models. The resulted ${beta}$ depends on the maximum D/t model used for the reliability analysis. This variability in reliability analysis is due to ambiguity in choosing computational models and it is called as "modelling uncertainty." This uncertainty can be considered as "non-specificity" of an epistemic uncertainty and modelled by constructing possibility distribution functions. In this study, three different computation models for the maximum D/t ratio are used to conduct reliability analyses for the local buckling of a CFST section and the reliability index ${beta}$ will be computed respectively. The "non-specific ${beta}s$" will be modelled by possibility distribution function and a metric, degree of confirmation, is measured from the possibility distribution function. It is shown that the degree of confirmation increases when ${beta}$ decreases. Conclusively, a new set of reliability indices associated with a degree of confirmation is determined and it is allowed to decide reliability index for the local buckling of a CFST section with an acceptable confirmation level.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2010.09a
• /
• pp.951-954
• /
• 2010

There are lots of soft ground improvement methods which is consist of different materials. In the analysis and design, composite ground method is usually regarded. Composite ground method considers the area replacement ratio as a key parameter to combine the physical and mechanical characteristics of tow different material. In this study, using composite material consist of three different materials which have different diameters, series of specific gravity test were performed according to KS F 2308, to investigate the applicability of composite ground method. As a result, it is found that composite material which is consist of fine grained soil and granular soil has a high applicability of composite ground method. This result means that, in estimating of ground properties of composite material which is consist of similar fine grained material such as cement mixing etc., composite ground method has a less applicability.

• Journal of Gastric Cancer
• /
• v.18 no.3
• /
• pp.218-229
• /
• 2018

Purpose: This study investigated whether the metabolic avidity of primary tumors and/or metastatic lymph nodes (LNs) measured by $^{18}F$-fluorodeoxyglucose ($^{18}F-FDG$) positron emission tomography/computed tomography (PET/CT) was related to survival after surgery in patients with advanced gastric cancer (AGC). Materials and Methods: One hundred sixty-eight patients with AGC who underwent preoperative $^{18}F-FDG$ PET/CT and curative resection were included. The $^{18}F-FDG$ avidity of the primary gastric tumor and LNs was determined quantitatively and qualitatively. The diagnostic performance of $^{18}F-FDG$ PET/CT was calculated, and the prognostic significance of $^{18}F-FDG$ avidity for recurrence-free survival (RFS) and overall survival (OS) was assessed. Results: In all, 51 (30.4%) patients experienced recurrence, and 32 (19.0%) died during follow-up (median follow-up duration, 35 months; range, 3-81 months); 119 (70.8%) and 33 (19.6%) patients showed $^{18}F-FDG$-avid primary tumors and LNs, respectively. $^{18}F-FDG$ PET/CT showed high sensitivity (73.8%) for the detection of advanced pathologic T ($pT{\geq}3$) stage and high specificity (92.2%) for the detection of advanced pN (${\geq}2$) stage. $^{18}F-FDG$ avidity of LNs was significantly associated with RFS (P=0.012), whereas that of primary tumors did not show significance (P=0.532). Univariate and multivariate analyses revealed that $^{18}F-FDG$ avidity of LNs was an independent prognostic factor for RFS (hazard ratio=2.068; P=0.029). Conclusions: $^{18}F-FDG$ avidity of LNs is an independent prognostic factor for predicting RFS. Preoperative $^{18}F-FDG$ PET/CT can be used to determine the risk and prognosis of patients with AGC after curative resection.

• Journal of the Korea Institute of Building Construction
• /
• v.8 no.5
• /
• pp.59-65
• /
• 2008

In the evaluation method of KS on the activity factor of fly ash, same amount of cement should be replaced with fly ash. Therefore, contradictory effects on concrete strength exist, i. e. strength decease due to low content of cement and strength increase of strength due to filling-pore-function of fly ash. European Committee for Standardization (CEN) specifies the method 1 to 4. adding fly ash without reducing the content of cement, for the evaluation method on activity factor of fly ash. This study investigates the applicability of the method 2 of CEN to mix design of concrete. The followings are derived ; There is a key ratio of f)y ash mixing which enhances the incremental ratio of mixing water to improve fluidity of mortar. The incremental ratio of mixing water is maximized about 11% ratio of fly ash mixing. Compressive strength most slightly increases at that ratio of fly ash mixing. Activity factor of fly ash increases as water-cement ratio becomes low and contents of fly ash becomes high. Moreover, quality of fly ash and condition of mix design affect the applicable amount of fly ash and available range of water-cement ratio. However, this method has some problems for practical purpose because activity factors of fly ash for some cases are over 1.0. Further research should be conducted to develop more useful method of evaluating activity factor of fly ash.

• Korean Journal of Agricultural Science
• /
• v.42 no.3
• /
• pp.201-205
• /
• 2015

The experiment was conducted to evaluate the effects of pathogenic Escherichia coli on diarrhea, growth performance, and blood profile of weaned pigs. A total of 48 pigs were used and housed in individual pens of disease containment chambers for 16 d (4 d before and 12 d after the first challenge [d0]). The treatments were with or without the pathogenic E. coli challenge (F-18 E. coli strain; heat-labile, heat-stable, and Shiga-like toxins). Pigs were orally inoculated with a dose of $10^{10}cfu$ E. coli per 3 mL PBS daily for 3 days. The common nursery diet and water were available at all times. The ADG, ADFI, G:F, diarrhea score, ratio of fecal ${\beta}$-hemolytic coliforms from total coliforms (RHT), and blood profile were measured. The pathogenic E. coli reduced (P < 0.05) ADG from d0 to 6 (117 vs. 297 g/d) and from d0 to 12 (377 vs. 238 g/d) compared with the control. Meanwhile, the pathogenic E. coli increased (P < 0.05) diarrhea score (average 3.4 vs. 1.4) and RHT (average 82 vs. 11%) on d3, 6, and 9 and the number of white blood cells (17.59 vs. $13.48{\times}10^3/{\mu}L$) on d6 compared with the control. No differences were found on ADFI and others in the blood profile (total protein and hematocrit). In conclusion, pathogenic E. coli used in this experiment successfully caused mild diarrhea, increased number of white blood cells, and adversely affected growth rate of weaned pigs.

• Journal of Nutrition and Health
• /
• v.3 no.2
• /
• pp.95-99
• /
• 1970

Korea is one of the typical rice eating countries where availability of animal protein is limited even for the growing generation. Nutritive food products for infants and children are not available commercially in large scale at the present time, although a limited amount of expensive milk products are produced. The present study deals with a pioneering attempt on a new food mixture to meet this demand. Several food mixtures, possibly produced in the country, consisting of rice, soybean, FPC, vitamin, minerals and other food additives are developed in this work Sixty female and male rats aged $30{\sim}40$ days were divided into five groups, twelve rats each. The rats had been maintained with the six different diets, as follow. Formulation of proposed infant food mixturesComposition F-R-1 F-S-2 F-F-3 F-P-4 S Rice 100% 40% 37% 46% 70% Sugar - 12 13 10 70 Casein - - - - 20 Bean - 40 37 24 - Yeast - 3 2 3 - Mineral Vitamain - 2 4 2 4.3 F.P.C - 3 4 7 - Fat - - 4 8 4 Cod liver Oil - - - - 3 The findings of this study presented in FER, PER, final organ weights, body weights growth, percentage of nitrogen retention in the body. F-P-4 group tended to remain the heaviest and F-R-1 the lightest in the body weight among three groups throughout the experimental period. In terms of FER (Feed Efficiency Ratio) and PER (Prortein E. R.) value, F-P-4 group kept the highest record throughout. F-P-4 group showed the highest value of nitrogen retention in the body. In comparision between F-P-4 groups and casein 20% group (standard) in all respects of this experiment, F-P-4 group which is the most superior among experimental group, revealed statisfically no significant inferior than that of standard group. This fact could be interpreted that most limiting a. a., methionine in the soy protein produced little inferiority of the experimental groups in the study.

• Steel and Composite Structures
• /
• v.46 no.4
• /
• pp.565-575
• /
• 2023

This study represents a numerical research in vibration and buckling of functionally graded material (FGM) beam comprising edge crack by using finite element method (FEM) and multilayer perceptron (MLP). It is assumed that the material properties change only according to the exponential distributions along the beam thickness. FEM and MLP solutions of the natural frequencies and critical buckling load are obtained of the cracked FGM beam for clamped-free (C-F), hinged-hinged (H-H), and clamped-clamped (C-C) boundary conditions. Numerical results are obtained to show the effects of crack location (c/L), material properties (E₂/E₁), slenderness ratio (L/h) and end supports on the bending vibration and buckling properties of cracked FGM beam. The FEM analysis used in this paper was verified with the literature, and the fundamental frequency ratio ($\overline{P_{cr}}$) and critical buckling load ratio ($\overline{{\omega}}$) results obtained were compared with FEM and MLP. The results obtained are quite compatible with each other.