• ETRI Journal
• /
• v.25 no.5
• /
• pp.356-368
• /
• 2003

This paper analyzes the characteristics of packet losses in mobile computing environments based on the Gilbert model and then describes a mechanism that can recover the lost audio packets using redundant data. Using information periodically reported by a receiver, the sender dynamically adjusts the amount and offset values of redundant data with the constraint of minimizing the bandwidth consumption of wireless links. Since mobile computing environments can be often characterized by frequent and consecutive packet losses, loss recovery mechanism need to deal efficiently with both random and consecutive packet losses. To achieve this, the suggested mechanism uses relatively large, discontinuous exponential offset values. That gives the same effect as using both the sequential and interleaving redundant information. To verify the effectiveness of the mechanism, we extended and implemented RTP/RTCP and applications. The experimental results show that our mechanism, with an exponential offset, achieves a remarkably low complete packet loss rate and adapts dynamically to the fluctuation of the packet loss pattern in mobile computing environments.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.24 no.10
• /
• pp.705-710
• /
• 2012

This study aims to analyse changes of inner temperature of PVS(Passive ventilation skin) and heat recovery when it has ventilation of air through PVS using numerical simulation in the winter condition. Results are as follows. 1) In case of the air inflows through PVS, change of inner temperature of PVS is lower than in case of the air flows inner space to out space, by dynamic insulation. 2) It was identified that the temperature gradient of PVS were bigger by increases of ventilation amount. To reduce ventilation load, heat transfer efficiency at the inner side of PVS is important and what performance of insulation at the inner side of PVS secure helps to improve heat performance of all PVS.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.14 no.2
• /
• pp.430-439
• /
• 1990

Steady state turbulent airflow and unsteady characteristics of generation, transportation, and recovery behavior of contaminate particles in the simplified 2 dimensional Vertical Laminar Flow (VLF) type clean room was numerically simulated using the low Reynolds number k-over bar.epsilon- turbulent model. Characteristics of airflow in VLF type clean room are greatly affected by the recirculation zone around working surface. The recirculation zone must be considered at the time of clean room design because the recirculation zone whose area increases with increment of inlet velocity exerts bad influence upon the performance of clean room in terms of particle contamination. The location of maximum particle concentration changes from the location of particle source to the recirculation zone, while averaged particle concentration is reduced exponentially with time. Recovery time of clean room with spontaneous particle generation source is inversely proportional to inlet velocity. We introduce nondimensionalized recovery time through the dimensional analysis, which can indicates the general performance of clean room with design structure change. It was identified that .tau. is independent of inlet velocity and background concentration. Therefore .tau. can be the simple factor to compare the different structure of clean room in terms of dynamic response to contamination and becomes larger with better structure of clean room.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.7
• /
• pp.2936-2951
• /
• 2016

An emerging satellite technology, Operationally Responsive Space (ORS) is expected to provide a fast and flexible solution for emergency response, such as target tracking, dense earth observation, communicate relaying and so on. To realize large distance transmission, we propose the use of available relay satellites as relay nodes. Accordingly, we apply software defined network (SDN) technology to ORS networks. We additionally propose a satellite network architecture refered to as the SDN-based ORS-Satellite (Sat) networking scheme (SDOS). To overcome the issures of node failures and dynamic topology changes of satellite networks, we combine centralized and distributed routing mechanisms and propose a fast recovery routing algorithm (FRA) for SDOS. In this routing method, we use centralized routing as the base mode.The distributed opportunistic routing starts when node failures or congestion occur. The performance of the proposed routing method was validated through extensive computer simulations.The results demonstrate that the method is effective in terms of resoving low end-to-end delay, jitter and packet drops.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2016.04a
• /
• pp.124-126
• /
• 2016

Successful deployment of the Software Defined Network (SDN) depends on its ability to cope up with network failures. There are various types of failures that may occur in an SDN. The most common are switch and link failures. It is necessary to recover the network from failures for a continuous service availability. But for the real-time services fast recovery from the failure is required to minimize the service disruption time. In the proposed work, we focused on minimizing the recovery time after the failure is detected. Once the failure is detected, the controller involvement is needed to dynamically reroute the failure disrupted flows from the failed component to an alternate path. The aim of the proposed scheme is to provide a traffic management scheme which can react to the dynamic network events by rapidly modifying the forwarding behavior of the switches for faster in-band network adaptability. The proposed scheme (1) Considers the shared data and control path delay (2) Optimally utilize the network resources (3) Eliminates the need of constant monitoring overhead at the controller which results into faster detouring and ultimately rapid recovery.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.6 no.12
• /
• pp.3081-3099
• /
• 2012

We propose a new multipath-based reliable routing protocol on MANETs, Multipath-based Reliable routing protocol with Fast-Recovery of failures (MRFR). For reliable message transmission, MRFR tries to find the most reliable path between a source and a destination considering the end-to-end packet reception reliability of the routes. The established path consists of a primary path that is used to transmit messages, and the secondary paths that are used to recover the path when detecting failures on the primary path. After establishing the path, the source transmits messages through the primary path. If a node detects a link failure during message transmission, it can recover the path locally by switching from the primary to the secondary path. By allowing the intermediate nodes to locally recover the route failure, the proposed protocol can handle the dynamic topological change of the MANETs efficiently. The simulation result using the QualNet simulator shows that the MRFR protocol performs better than other protocols in terms of the end-to-end message delivery ratio and fault-tolerance capability.

• Journal of Korea Multimedia Society
• /
• v.25 no.3
• /
• pp.461-467
• /
• 2022

This research is to raise awareness of food safety by designing and supporting a hazard food information notification platform for consumers. To this end, the design was carried out by dividing the process into a data extraction process, an application screen design process, and a CNN-based food inference process. Data was collected through public data APIs and crawling, and it was sent to each activity screen designed for Android studios so that it could be output. As a result, when the platform is executed, information on hazardous food names, registration dates, food classification, manufacturing dates, recovery grades, recovery reasons, recovery methods, company names, barcode numbers, and packaging units can be intuitively and conveniently checked. In addition, CNN-based food inference processes allowed mobile cameras to infer harmful food and applied various quantization techniques such as Dynamic Range, Integer, and Float16 to compare the degree of improvement in inference performance. As a result, the group that applied basic quantization and treated device resources with GPU showed the greatest improvement in inference performance. Through this platform, it is expected that the reliability of food safety will be improved by making it more convenient for consumers to recognize food risks.

• Elastomers and Composites
• /
• v.52 no.4
• /
• pp.280-286
• /
• 2017

The mechanical and dynamic properties according to the content of filler, plasticizer, and crosslinking agent of rubber composites for Lipseal were measured in this study. The mechanical properties of the composite including the silane coupling agent and silica were found to be superior to those of the composite containing carbon black. It was found that the rebound resilience characteristics were influenced by the crosslink density of sulfur rather than the filler or plasticizer. In the case of recovery, it was confirmed that the elastic restoring force improved in the compression deformation condition and recovery increased as the crosslinking density increased. The rubber composite for Lipseal of this study is expected to improve the manufacturing technology of the rubber composite which can implement the optimum function for recognizing the performance such as oil resistance, durability and compression set.

• International Journal of Highway Engineering
• /
• v.14 no.5
• /
• pp.47-55
• /
• 2012

PURPOSES: SUPERPAVE binder grade tests including Multiple Stress Creep and Recovery(MSCR) test are applied to evaluate rheological properties of four polymer modified binders. METHODS: To evaluate grade of four modified binders, PG testing protocols, such as DSR, BBR and MSCR are employed. RESULTS: It is observed that MSCR test shows different performance grades especially on modified binders. Both DMP and EG binder show similar high temperature performance to SBS 5% modified binder. CONCLUSIONS: Binder Grading system in Korea need to be reviewed to properly reflect the performnace of modified binders. The binders modified with DMP and EG can be possible alternatives SBS 5% modified binder considering its performance and cost.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.15 no.6
• /
• pp.615-628
• /
• 2015

CGRA (Coarse-Grained Reconfigurable Architecture) based multi-core architecture can be considered as a suitable solution for the fault-tolerant computing. However, there have been a few research projects based on fault-tolerant CGRA without exploiting the strengths of CGRA as well as their works are limited to single CGRA. Therefore, in this paper, we propose two approaches to enable exploiting the inherent redundancy and reconfigurability of the multi-CGRA for fault-recovery. One is a resilient inter-CGRA fabric that is ring-based sharing fabric (RSF) with minimal interconnection overhead. Another is a novel intra/inter-CGRA reconfiguration technique on RSF for maximizing utilization of the resources when faults occur. Experimental results show that the proposed approaches achieve up to 94% faulty recoverability with reducing area/delay/power by up to 15%/28.6%/31% when compared with completely connected fabric (CCF).