• Membrane and Water Treatment
• /
• v.14 no.4
• /
• pp.163-173
• /
• 2023

The presence of high amounts of organic and inorganic contaminants in textile wastewater is a major environmental concern. Therefore, the treatment of textile wastewater is an urgent issue to save the aquatic environment. The disposal of large quantities of untreated textile wastewater into inland water bodies can cause serious water pollution. In this study, synthetic dye wastewater samples were prepared using orange dye in the laboratory. The synthetic samples were then treated by a batch adsorption process using the prepared activated carbon (AC) from date pits. The wastewater parameters studied were the pH, total dissolved solids (TDS), total suspended solids (TSS), electrical conductivity (EC) and salinity. The activated adsorption process showed that the maximum removal efficiencies of electric conductivity (EC), salinity, TDS and TSS were 65%, 92%, 89% and 90%, respectively. The removal efficiencies were proportional to the increase in contact time (30-120 min) and AC adsorbent dose (1, 3 and 5 g/L). The adsorption profile indicates that 5 g/L of adsorbent delivers better results for TDS, EC, TSS and salinity at contact time of 120 min. The adsorption characteristics are better suited to the pseudo-second-order kinetic model than to the pseudo-first-order kinetic model. The Langmuir and Freundlich isotherms were well suited for describing the adsorption or contact behavior of EC and TSS within the studied system.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.24 no.3
• /
• pp.385-392
• /
• 2000

The adsorption ability of dyes on chitin, a natural polymer was investigated for decolorization of dye wastewater. Chitin was manufactured in lab by decalcification in dilute aqueous HCI solution and deproteination in dilute aqueous NaOH solution with shrimp shells. Absorbance of residue solution of dyebaths after dye adsorptions of chitin were measured in varieties of dye concentration and dipping periods. Four kinds of dyestuffs were used, C.I.Acid Blue 29. C.I.Direct Blue 6, C.I.Reactive Orange 12 and C.I.Basic Red 18. When chtin 1g was dipped in 0.05% of dyebath with stirring, maximum adsorption ratio of each kind of dyes was exhibited as 91.6% for C.I.Acid Blue 29, 95% for C.I.Direct Blue 6, 58.2% for C.I.Reactive Orange 13 and 75.8% for C.I.Basic Red 19. It shows that chitin has better adsorption abilities of ionic dyes of acid, direct and basic dye than non-ionic reactive dye. And chitin has better adsorption abilities of anionic acid direct dyes than cationic basic dye because of the presence of nitrogen atoms. All kinds of dyestuffs used showed speedy absorption effects by chitin, so chitin can absorb much amount of dyes in 5 mimutes reach to equilibrium of adsorption in 2 hours after dipping. Basic dye was absorbed the most speedily in 5 minutes, although maximum adsorption ratio is not high. That reason can be thought that chitin surface is essentially negatively charged due to polar funtional groups.

• Membrane Journal
• /
• v.18 no.1
• /
• pp.94-102
• /
• 2008

For the treatment of the dye wastewater, a polyamide nano-composite membrane and reverse osmosis (RO) membranes were prepared using interfacial polymerization technique, in which piperazine, meta-phenylene diamine, and trimesoyl chloride were used as monomers, Their permselective properties were characterized with aqueous solutions of PEG 600, $Na_2SO_4$, and NaCl, and their performance was compared with that of Osmonics Co, They were found to be a typical nano-composite membrane and a low pressure RO membrane. Using them, a real dye wastewater supplied from the Kyungin Corporation, one of the domestic dye producer, was treated, studying the separation performances of the membranes, Also, during the wastewater treatment, cleaning in place (CIP) of the membranes was carried out regularly to recover the flux of the membranes. Three different chemical cleaners were employed for the CIP process and their performance were compared in this study.

• Journal of Korean Society on Water Environment
• /
• v.23 no.1
• /
• pp.27-32
• /
• 2007

This study focused on estimating the feasibility of a strong basic anion exchanger (PA312OH) as a sorbent for the removal of residual reactive dye and saving chemicals and water. Cellulose reactive dye C.I.RB49 was tested because reactive dye is the largest single group of dyes and that dye needs larger amount of inorganic salts as dyeing agent but nearly 50% of reactive dyes may be lost to the effluent. The adsorption characteristics of PA312OH for C.I.RB49 were as follows. Ion-selectivity among the dye and inorganic salts was Dye > ${SO_4}^{2-}$ > ${CO_3}^{2-}$ > $Cl^-$. C.I.RB49 was exchanged more than 3 times ${SO_4}^{2-}$ and ${CO_3}^{2-}$ and $Cl^-$ was not exchanged absolutely. The exchanging velocity was increased exponentially with increasing temperature. This result is positive effect on treating the high temperature dyeing process wastewater. The exchanged dye percents to initial were 96.8% and 99% at flow rate 20.5 mL/min. and 3.7 mL/min.. The exchanging capacity of PA312OH for C.I.RB49 was 215.2 mg/g at conc.=369.2 mg/L, Temp.=$25^{\circ}C$. 74% inorganic salts were recrystallized from real dark reactive color dyeing wastewater treated with PA312OH.

• Membrane and Water Treatment
• /
• v.11 no.2
• /
• pp.111-121
• /
• 2020

The fouling of Nanofiltration membrane (NF) was examined using wastewater containing reactive black dye RB5 of 1500 Pt/Co color concentrations with 16890 mg/l TDS collected from El-alamia Company for Dying and Weaving in Egypt. The NF-unit was operated at constant pressure of 10 bars, temperature of 25℃, and flowrate of 420 L/min. SEM, EDX, and FTIR were used for fouling characterization. Using the ROIFA-4 program, the total inorganic fouling load was 1.07 mM/kg present as 49.3% Carbonates, 10.1% Sulfates, 37.2% Silicates, 37.2% Phosphates, and 0.93% Iron oxides. The permeate flux, recovery, salt rejection and mass transfer coefficients of the dye molecules were reduced significantly after fouling. The results clearly demonstrate that the fouling had detrimental effect on membrane performance in dye removal, as indicated by a sharp decrease in permeate flux and dye recovery 68%. The dye mass transfer coefficient was dropped dramatically by 34%, and the salt permeability increased by 14%. In this study, all the properties of the membrane used and the fouling that caused its poor condition are identified. Another study was conducted to regeneration fouled membrane again by chemical methods in another article (Abdel-Fatah et al. 2017).

• Journal of Environmental Science International
• /
• v.7 no.2
• /
• pp.209-216
• /
• 1998

Nanofiltration[NF45] and reverse osmosis membrane(HR98PP) separation treatment of dyestuff wastewater was carried out In order to separate relatively pure water from synthetic dyestuff wastewater, which consists of reactive dye, acid dye, basic dye, direct dye, and disperse dye. The experiments were performed by using the plate and frame membrane module. In the nanofiltration and reverse osmosis membrane separation, When the NaCl concentration was 0.1, 5.0, and 20.091, retention was 63.0, 46.0, 0.9%, respectively. When permeate flux was 125.0, 67.5, and 45.0 L/$m^2$ h, the osmotic pressure increased with Increasing the NaCl concentration. Permeate flux of two membranes Increased as temperature Increased due to segmental movement of polymer of the membrane and the rejection rate of dyestuff was decreased gradually. It was found that the rejection rate was about 95% in the nanofiltratlon, while the reverse osmosis membrane showed a high rejection rate of 99% under all temperature and pressures conditions.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.12
• /
• pp.2135-2139
• /
• 2000

The coagulation of anionic colloidal particles by the cyanoguanidine(CG)-formaldehyde resin has been reported to be caused by an electrostatic interaction of the diaminomethylene urea (DU) cation with an anionic surface charge of particles. In this research, 100~500 nm sized cationic cyanoguanidine-formaldehyde resin was synthesized to coagulate anionic dye wastewater, and the results showed that the less pH of aqueous cyanoguanidine-formaldehyde resin solution was, the higher Zeta potential of that was. In case of coagulating 0.4 g/L reactive dye by cyanoguanidine-formaldehyde resin at pH 3, 5, 7, 9, and 11, COD removal and the percent decolorization of synthetic dye wastewater at pH 3 are higher than those of other pH conditions. The COD removal and the percent decolorization of synthetic dye wastewater were 74% and 90% at 400 ppm, pH 3.

• Journal of Korean Society on Water Environment
• /
• v.25 no.3
• /
• pp.370-374
• /
• 2009

Adsorption characteristics of glass fibers, obtained from the spent lithium primary batteries recycling process, were investigated for the removal of Acid Red 27 dye from aqueous solution. The batch data clearly showed that increasing the initial sorptive concentration apparently enhanced the amount adsorbed and the uptake process followed the pseudo-second order rate model. The equilibrium adsorption data at different initial sorptive concentrations were fitted well to Freundlich and Langmuir adsorption isotherms. Moreover, the increase in temperature, favored the uptake of dye on this solid, indicated the process was endothermic in nature. Further, using the temperature dependence sorption data obtained at different temperatures was used to estimate various thermodynamic parameters.

• Carbon letters
• /
• v.11 no.1
• /
• pp.1-8
• /
• 2010

The adsorption of Acid Blue 92 onto three low cost and ecofriendly biosorbents viz., cow dung ash, mango stone ash and parthenium leaves ash and commercial activated carbon have discussed in this work. The ash of all the mentioned bio-wastes was prepared in the muffle furnace at $500^{\circ}C$ and all the adsorbents were stored in an air thermostat. Experiments at total dye concentrations of 10~100 mg/L were carried out with a synthetic effluent prepared in the laboratory. The parameters such as pH and dye concentration were varied. Equilibrium adsorption data followed both Langmuir and Freundlich isotherms. The results indicate that cow dung ash, mango stone ash and parthenium leaves ash could be employed as low-cost alternatives to commercial activated carbon in wastewater treatment for the removal of dye.

• Membrane and Water Treatment
• /
• v.9 no.2
• /
• pp.87-94
• /
• 2018

The interactions of water soluble polymers with dye are studied by ultrafiltration using a molecular weight cut off of 10 KDa regenerated cellulose ultrafiltration membrane. Two water-soluble polymers, namely Poly (Sodium-4 Styrenesulfonate) (PSS) and Poly (Vinyl Alcohol) (PVA) were selected for this study. The effects of process parameters, such as, polyelectrolyte concentrations, transmembrane pressure, ionic strength and pH of solution on dye retention and permeation flux were examined. PSS enhanced ultrafiltration achieved dye retention as high as 99% as a result of complexation between polyanion containing aromatic groups and cationic dye. This result was confirmed by the red shift. The retention of dye decreases as the salt concentration increases, a high retention was obtained at pH above 4. However, in case of PVA, relatively low retention (50%) was observed. Ionic strength and pH has no significant effect on the removal of MB. The permeate flux depended slightly on polyelectrolytes concentrations, transmembrane pressure, salt concentration and pH.