• Journal of Auto-vehicle Safety Association
• /
• v.14 no.2
• /
• pp.57-69
• /
• 2022

Recently, as interest in self-driving cars has increased worldwide, research and development on the Advanced Driver Assist System is actively underway. Among them, the purpose of Adaptive Cruise Control (ACC) is to minimize the driver's driving fatigue through the control of the vehicle's longitudinal speed and relative distance. In this study, for the research of the ACC test in the real environment, the real-road test was conducted based on domestic-road test scenario proposed in preceding study, considering ISO 15622 test method. In this case, the distance measurement method using the dual camera was verified by comparing and analyzing the result of using the dual camera and the result of using the measurement equipment. As a result of the comparison, two results could be derived. First, the relative distance after stabilizing the ACC was compared. As a result of the comparison, it was found that the minimum error rate was 0.251% in the first test of scenario 8 and the maximum error rate was 4.202% in the third test of scenario 9. Second, the result of the same time was compared. As a result of the comparison, it was found that the minimum error rate was 0.000% in the second test of scenario 10 and the maximum error rate was 9.945% in the second test of scenario 1. However, the average error rate for all scenarios was within 3%. It was determined that the representative cause of the maximum error occurred in the dual camera installed in the test vehicle. There were problems such as shaking caused by road surface vibration and air resistance during driving, changes in ambient brightness, and the process of focusing the video. Accordingly, it was determined that the result of calculating the distance to the preceding vehicle in the image where the problem occurred was incorrect. In the development stage of ADAS such as ACC, it is judged that only dual cameras can reduce the cost burden according to the above derivation of test results.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.16 no.6
• /
• pp.465-471
• /
• 2023

This paper proposes a comparator structure that improves the noise and output delay of a single-slope ADC(SS-ADC) used in CMOS Image Sensor (CIS). To improve the noise and delay characteristics of the output, a comparator structure using the miller effect is designed by inserting a capacitor between the output node of the first stage and the output node of the second stage of the comparator. The proposed comparator structure improves the noise, delay of the output, and layout area by using a small capacitor. The CDS counter used in the single slop ADC is designed using a T-filp flop and bitwise inversion circuit, which improves power consumption and speed. The single-slope ADC also performs dual CDS, which combines analog correlated double sampling (CDS) and digital CDS. By performing dual CDS, image quality is improved by reducing fixed pattern noise (FPN), reset noise, and ADC error. The single-slope ADC with the proposed comparator structure is designed in a 0.18-㎛ CMOS process.

• Journal of the Korean Institute of Gas
• /
• v.20 no.1
• /
• pp.62-67
• /
• 2016

Natural gas, one of the cleanest fossil fuel, is liquefied to reduce its volume for the long distance transportation. Small size floating liquefied natural gas plant has small area that safe issue is highly considered. However, Dual Mixed Refrigerants (DMR) process has fire potential by using flammable refrigerants and N2 Expander process has low compressed energy efficiency which has high inherent process safety. Therefore, safe process with high compressed energy efficiency is constantly needed. This study suggested an alternative refrigerants to existing DMR process by using Hydrofluorocarbon which has high safety due to its non-flammable properties. As a result, it showed 34.8% lower compressed energy efficiency than DMR process that contains fire potential whereas 42.6% improved compressed energy efficiency than Single N2 Expander process. In conclusion, this research proposed safe process for small size floating liquefied natural gas plant while having high efficiency.

• Journal of the Korean Institute of Gas
• /
• v.22 no.4
• /
• pp.63-73
• /
• 2018

Innovative technical process for Energy Storage System (ESS), Liquid Air Energy Storage system (LAES) is mature technologies based on the gas liquefaction process. In spite of many advantages such as high energy density, no geographical constraints, low investment costs and long useful life, the system has not yet widely commercialized due to low round trip efficiency. To improve RTE and acquire high yield of liquid air, various configurations of LAES process have been considered. In this research, dual refrigerants cycle (R-600a and methanol) for air liquefaction and thermal oil circulation for power generation via liquid air gasification have been applied to improve cycle performance significantly using Aspen HYSYS simulator.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.25 no.11
• /
• pp.1350-1357
• /
• 1988

The dual dielectric films have been grown on single-crystalline silicon substrates with the thickness ranging from 125A to 180A at various gas and temperature conditions by using rapid thermal process that included independent nitridation step. The film characteristics and their dependence on the contents of the hydrochloric gas and the processing time have been studied. By the addition of the hydrochloric gas, the initial oxide thickness was significantly changed, but after sequential nitridation processes the thickness of the films was nevertheless a little bit varied within 10A. All the samples of the dual dielectric films show the increased breakdown voltages in proportion to the additive contents of the hydrochloric gas and also show the higher breakdown strengths than the thermal oxide and nitrided oxide films grown by the conventional furnance process or the rapid thermal nitridation process that was composed of the dependent nitridation cycles.

• Korean Journal of Social Welfare
• /
• v.62 no.3
• /
• pp.323-351
• /
• 2010

Through the biographical approach, the current research purports to reconstruct the Changeprocess of values and identities on the lives of the first-generation Korean-German females in Germany from the transnational perspective. Ten interviews were conducted, using Schutze's autobiographicalnarrative interview. Interview data were analyzed through the application of Schutze's autobiographical-narrative interview and Mayring's qualitative content analysis. Findings showed that on the onset of emigration, their values centered around hybrid collectivism. Their life in the process of emigration was characteristic of a shift to hybrid individualism. Furthermore, the life at beginning of emigration was found to be characterized by a singular regional identity. The process of emigration was shown to mark the conversion into dual identity, dual regional and dual national. Some theoretical and practical suggestions for the emigrants' welfare were finally offered that were associated with the process of values and identities changes in their life.

• Transactions of Materials Processing
• /
• v.19 no.6
• /
• pp.337-343
• /
• 2010

Current need of weight reduction in automotive part increases the application for high strength steel (HSS). The various types of high strength steels have been used to produce chassis part, control arms and trailing arms for weight reduction and increasing of fatigue durability such as dual phase steel (DP) and ferrite bainite steel (FB). But, DP and FB steels have proven to show inferiority in durability as well as press formability. Edge cracking occurred often in flange forming and hole expansion processes is the major failure encountered. This paper discussed the behavior of edge stretchability of high strength steel of DP and FB steels. Experimental works have been conducted to study the effect of punch clearance and burr direction on hole expansion ratio (HER). Also finite element simulation (FEM) has been preformed to clarify the mechanism of flange crack and support the experimental results on HER of DP and FB steels. It was simulated the whole process of blanking process following by hole expansion process and ductile fracture criterion named the modified Cockcroft-Latham model which was used to capture the fracture initiation. From the hole expansion tests and FEM simulation studies it was concluded that ferrite bainite steel showed better stretch-flangeability than dual phase steel. It was attributed to the lower work hardening rate of ferrite bainite steel than dual phase steel at the sheared edge.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.29 no.4
• /
• pp.99-106
• /
• 2021

The purpose of this study was to evaluate the performance of novel process with thermal hydrolysis and separation as pre-treatment of anaerobic digestion (AD). The dewatered sludge was pre-treated using THP, and then separated. The separated liquid used as substrate for AD and separated solid was returned on THP(Thermal Hydrolysis Process). The degree of disintegration (DD, based on COD) using only THP found 45.1-49.3%. The DD using THP+separation found 76.1-77.6%, which was higher than only THP. As result from dual-pool two-step model, the ratio of rapidly degradable substrate to total degradable substrate found 0.891-0.911 in separated liquid, which was higher than only THP. However, the rapidly degradable substrate reaction constant (kF) of only THP and THP+separation were similar. This results found that dewatered sludge was disintegrated by THP, and then rapidly degradable substrate of hydrolyzed sludge was sorted by separation.

• Journal of Arbitration Studies
• /
• v.26 no.3
• /
• pp.149-173
• /
• 2016

This study vindicates similarities and differences of hybrid process of arbitration and mediation between China and Malaysia. Both countries develop hybrid processes combining arbitration with mediation in their own cultural soils. The Chinese dispute resolver plays the dual role of arbitrator and mediator during the proceedings of hybrid process of arbitration and mediation. On the other hand, a different arbitrator plays the role of mediator, if conciliation fails in Malaysia. On the other hand, judges are allowed to act as mediator during the proceeding in China and Malaysia.

• Informatization Policy
• /
• v.26 no.2
• /
• pp.62-80
• /
• 2019

The purpose of this study is to investigate the direct effect of victimization experience on cyber security behavior and the indirect effect of information protection awareness through the Dual Process Theory. Baron & Kenny regression analysis was conducted and the results are as follows - first, victimization experience has a positive effect on cyber security behavior; second, the relationship between victimization experience and cyber security behavior is mediated by cyber security awareness; and third, the direct effect of victimization experience on cyber security behavior and the indirect mediating effect of cyber security awareness are both positive (+). The direct effect of victimization experience on cyber security behavior is analyzed to be relatively large compared to the indirect effect that cyber security awareness has on cyber security behavior. Based on these results, It is suggested that periodic cyber security education and campaign policies are needed to enhance cyber security behavior.