• Science of Emotion and Sensibility
• /
• v.17 no.4
• /
• pp.3-18
• /
• 2014

In this study, drivers' longitudinal car control, subjective fatigue, and perceived fidelity were compared between 2D and 3D display driving simulation. The results can be summarized as followings. First, in all target speed conditions, the drivers tended to drove faster in 2D display condition than 3D display condition. Second, speed deviation from target speed increased as target speed decreased. Third, distances between the lead vehicle and the driver's vehicle were significantly reduced in the 3D display condition when the speeds of the lead vehicle were relatively fast(i. e., over 80km/h). Fourth, although the perceived fidelity was not significantly different between the two display conditions, subjective fatigue was higher in the 3D display condition than in the 2D display condition.

• Proceedings of the KSR Conference
• /
• 2011.05a
• /
• pp.690-696
• /
• 2011

A number of conventional railway bridge is more than 2600. Non-ballast plate girder bridge is about 700 and this is 27% of all bridge numbers. Non-ballast plate girder has advantages that self load is more lighter than moving load and construction cost is more inexpensive than concrete bridge. But non-ballast plate girder has disadvantages that vibration and noise is bigger than concrete bridge. This study had analyzed behavior of non-ballast plate girder according to the arrangement of supports and driving conditions to review the proper arrangement of support. Measurements were performed in single line and disel locomotive of 7400type were used as test vehicle. The vehicle's driving conditions are as follows; Change of driving direction, Constant speed driving, Deceleration driving, Acceleration driving. Main measurement contents were horizontal displacement and vertical vibration acceleration in girder of vicinity support. Results of measurement are as follows; In case that a vehicle drives from fixed support to movable support, vertical vibration acceleration of the girder was smaller than opposition case.

• Journal of the Korean Society of Safety
• /
• v.24 no.4
• /
• pp.104-110
• /
• 2009

In this driving simulation study, the impairing effects of various types of electronic devices usage(i. e., destination search by using in-vehicle navigation system, TV watching and dialing cellular phone) during driving on front-to-rear-end collision avoidance were investigated. Percentage of collisions, driving speeds when the drivers collided, and initial reaction time for collision avoidance were analyzed and compared as the dependent measures. The results indicated that (1) any types of electronic devices usage during driving induced more serious collision-related impairment than control condition where no additional task was required, and (2) in general, destination search task appeared to impair drivers collision avoidance performance more than the other task requirements in terms of percentage of collisions and initial reaction time for collision avoidance, but TV watching induced most serious collision impact. These results suggested that any types of electronic device usage could distract drivers attention from the primary task of driving, and be resulted in serious outcome in potentially risky situation of front-to-rear-end collision. In particular, mandatory use of eye-hand coordination and receiving feedback seemed to one of essential factor leading the drivers visual attentional distraction.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.6
• /
• pp.3708-3713
• /
• 2015

The objective of this study is to numerically investigate the heat transfer rate for evaluating the thermal performances of the stack thermal system using the commercial software. In order to perform this, the cooling performances of the stack system for fuel cell electric vehicle were tested under both driving road conditions including the general driving road and uphill driving road and operating conditions with and without of the air conditioning system. The heat transfer rate of the stack radiator for the stack system was increased with the increase of the inlet air flow velocity. The heat transfer rate of the stack radiator increased by 105.3% at the coolant flow rate of 20 l/min and 221.3% at the coolant flow rate of 120 l/min with the increase of the air flow velocity from 2 m/s to 10 m/s. $9.45^{\circ}C$ of inlet coolant temperature of the stack radiator at the severe driving condition of the slope of 8% and velocity of 50 km/h showed higher 85.3% than $5.1^{\circ}C$ of inlet coolant temperature at the general driving condition of the slope of 0% and velocity of 120 km/h. In addition, as the fuel cell electric vehicle with the air conditioning system operation was driving under severe uphill driving condition, the radiator coolant temperature for a stable stack operation could be exceeded over $70^{\circ}C$.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.22 no.1
• /
• pp.59-64
• /
• 2014

Integrated Starter Generator (ISG) system improves the fuel economy of hybrid electric vehicles by using idle stop and go function, and regenerative braking system. To obtain the high performance and durability of ISG motor under continuously high load condition, the motor needs to properly design the cooling system (cooling fan and cooling structure). In this study, we suggested the enhanced design by modifying the thermal design of the ISG motor and then analyzed the improvement of the cooling performance under high-speed condition and generating mode by CFD simulation. The temperatures at the coil and the magnet of the enhanced model were decreased by about $4^{\circ}C$ and $6^{\circ}C$, respectively, compared to those of the conventional model. Therefore, we verified the cooling performance enhancement of the novel thermal design in the case of core loss increment due to the higher speed condition.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.10
• /
• pp.739-744
• /
• 2017

Elastic deformation and fatigue damage can cause the permanent deformation of a kart's frame during turning, affecting the kart's driving performance. A kart's frame does not contain any suspension or differential devices and, therefore, the dynamic behavior caused by torsional deformation when driving along a curve can strongly affect these two kinds of deformations. To analyze the dynamic behavior of a kart along a curved section, the GPS trajectory of the kart is obtained and the torsional stress acting on the kart-frame is measured in real time. The mechanical properties of leisure and racing karts are investigated by analyzing their material properties and conducting a tensile test. The torsional stress concentration and frame distortion are investigated through a stress analysis of the frame on the basis of the obtained results. Leisure and racing karts are tested in each driving condition using driving analysis equipment. The behavior of a kart when being driven along a curved section is investigated through this test. Because load movement occurs owing to centrifugal force when driving along a curve, torsional stress acts on the kart's steel frame. In the case of a leisure kart, the maximum torsional stress derived from the torsional fatigue limit was found to be 230 MPa, and the torsional fatigue limit coefficient was 0.65 when driving at a speed of 40 km/h. Furthermore, the driving elements during the cornering of a kart were measured based on an actual auto-test after installing a driving measurement system, and the driving behavior of the kart was analyzed by measuring its vertical displacement.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.32 no.1
• /
• pp.26-33
• /
• 2009

The directions of the road are divided into two, the right-hand side and left-hand side of the road, by the convention and specific native method in the world. This paper deals with the characteristics and behaviors of drivers who are accustomed to driving on right-hand side of the road, drive with a handle on the left-hand side, and comparing with left-hand side drivers. The driver's eye movements were measured by eye camera and questionnaires were used for measuring subjective evaluation such as driving mental workload. The experimental results indicated even if the experts who had much experience on right-hand side driving, they had lower driving skill than novice driver, accustomed to driving on left-hand side. In terms of mental workload, MCH rating scale and MNASA-TLX, the right-hand side drivers were in lower stress condition than the left-hand side drivers because of having much driving experience. However, they conducted a few mistakes by confusing the position of turn signal and windshield wiper because of their driving habit or traits and it lead to operation mistakes. These results can be applied effectively to develop the driving support information with changed environments.

• Korean Journal of Culture and Social Issue
• /
• v.12 no.1
• /
• pp.35-54
• /
• 2006

This study analysed the effect of music tempo on young drivers' driving speed. 23 male college students under age 26 were randomly assigned to one of three music conditions as follows; No Music, Slow Music and Fast Music. Every subject's travel time(sec) and driving speed(Km/h) was recorded while they were driving a computer-based driving simulator. As the results of this study, we found that 1) the fast music group's mean of travel time was the shortest and also, 2) their mean of driving speed was the fastest. The effect of music tempo on driving speed can be explained as a biological mechanism, same as the effect on our heart-beat rate or intensity of physical exercising. This result shows us that listening musics while driving can affect the driving speed instead of the driver's physical condition.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.25 no.2
• /
• pp.79-86
• /
• 2020

This study examines the power generation characteristics of a vehicle rooftop photovoltaic module with urban driving conditions. Actual test data with an illuminometer and a thermometer were used to analyze the power generation characteristics of the vehicle rooftop photovoltaic module. In addition, the power generation characteristics were analyzed in terms of urban driving conditions, irradiance, ambient temperature, and photovoltaic module temperature. This study also analyzes the power generation characteristics of the vehicle rooftop photovoltaic module with urban driving conditions through a wavelet transform filtering method. The power generation characteristics of the vehicle rooftop photovoltaic module with urban driving conditions depend on the change in irradiance rather than that in photovoltaic module temperature.

• Korean Journal of Culture and Social Issue
• /
• v.12 no.1
• /
• pp.81-102
• /
• 2006

This study focused on driver's carefulness and researched the relationship between driving confidence and driving behaviour in elderly and young drivers. In order to evaluate the driving confidence level, 'Driving Confidence Scale' was developed. 175 of young drivers(younger than 25) and 150 of elderly drivers(older than 65) conducted Driving Confidence Scale. They answered their driving patterns; driving history, annual mileage, the frequency of committing traffic violation, and experience of accident within 5 years. Elderly driver's data was collected by face to face interview. The factors of driving confidence were analyzed and the driving confidence level of young and elderly drivers was compared. Driving Confidence was consisted of 4 factors; environment of traffic condition, safe driving, driving ability, attention. Elderly driver's confidence was lower than young driver's. Elderly drivers in high driving confidence group, showed longer driving history and they were tend to commit violations more frequently than elerly drivers in low driving confidence group. Young drivers, whose driving confidence level was high answered more driving history, annual mileage, the frequency of committing traffic violation and experience of accident within 5 years.