• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.10 no.3
• /
• pp.43-50
• /
• 2010

DDC(Digital Down Converter) is a conversion technology to decimate to a lower sampling rate and DDC for the future development of communications technology has the necessary skills. So, it has been recognized in the wireless and the SDR(Software Defined Radio) system as essential components. In addition, research is underway on spectrum sensing for efficient communications environment due to the shortage of frequency resources. In this paper, the DDC systems were analyzed for CIC(Cascaded Integrator Comb) Filter, WDF(Wave Digital Filter), SRC(Sample Rate Conversion) each module. Moreover, we proposed a linkage effectively between DDC system and Spectrum Sensing for improve the efficiency of use of frequency by computer simulations. The simulation results of the DDC system was applied to the spectrum sensing capabilities. Also, performance and complexity of the results were derived and proposed system was the result of the check.

• ALGAE
• /
• v.24 no.3
• /
• pp.149-161
• /
• 2009

Characteristics of benthic microalgae and sediment properties were investigated for the intertidal flats of Kwangyang Bay, Korea. Sampling stations were selected every 100 m in the intertidal flats from land-side to open ocean at two different sampling sites. Samples were collected in June 2004, July, September, November, February and May 2005. Sediments properties were measured including temperature, water contents, sediment bulk density, nutrient concentrations in porewater. Chlorophyll a concentrations in surface sediment (0.5 cm) were measured and relationships between the chlorophyll a and various sediment properties were analyzed to identify major mechanisms regulating biomass of benthic microalgae in the intertidal flats using simple linear regression analysis. Sediment chlorophyll a concentrations were maximum during winter and minimum during warm seasons ranging from 4.4 mg $m^{-2}\;to\;81.2\;mg\;m^{-2}$. No clear spatial variations were observed for the sediment chlorophyll a in the study sites. Results from regression analysis suggested that benthic microalgae biomass was affected by sediment temperature and nutrients especially ammonium and silicate. Grazing effect was estimated using chlorophyll: pheopigments ratio, indirect indicator of grazing activity, and the positive correlation of the ratio and chlorophyll a implied that microalgae biomass is affected by grazing of zoobenthos although direct measurement of grazing activity is required to determine the importance of top-down controls in the benthic microalgae dynamics.

• Nuclear Engineering and Technology
• /
• v.48 no.4
• /
• pp.982-996
• /
• 2016

In this paper, new tethered aerial robots including roaming tethered aerial robots (RTARs) for radioactive material sampling and stationary tethered aerial robots (STARs) for environment monitoring are proposed to meet extremely-long-endurance missions of nuclear power plants. The flight of the proposed tethered aerial robots may last for a few days or even a few months as long as the tethered cable provides continuous power. A high voltage AC or DC power system was newly adopted to reduce the mass of the tethered cable. The RTAR uses a tethered cable spooled from the aerial robot and an aerial tension control system. The aerial tension control system provides the appropriate tension to the tethered cable, which is accordingly laid down on the ground as the RTAR roams. The STAR includes a tethered cable spooled from the ground and a ground tension control system, which enables the STAR to reach high altitudes. Prototypes of the RTAR and STAR were designed and successfully demonstrated in outdoor environments, where the load power, power type, operating frequency, and flight attitude of the RTAR and STAR were: 180 W, AC 100 kHz, and 20 m; and 300 W, AC or DC 100 kHz, and 80 m, respectively.

• Advances in environmental research
• /
• v.2 no.2
• /
• pp.119-129
• /
• 2013

The study examined the effect of urbanization on the water quality of Nwaorie and Otamiri Rivers in Owerri metropolis, Imo State, South-East Nigeria. Water samples were collected from Nwaorie and Otamiri Rivers from four sampling stations up and down stream. Water parameters analyzed using standard procedures were: color, turbidity, temperature, pH, total hardness, total solids, metals (Iron and magnesium), anions (nitrate and ammonia) and Fecal coliform. Results showed increased levels of coloration, iron, ammonia, turbidity and fecal coliform which exceeded the World Health Organization (WHO) permissible limits for drinking water. Increase in these parameters indicated influx of industrial effluent from the nearby industries and indiscriminate disposal of wastes at the bank of the rivers. Application of ANOVA showed various degree of variation in pollutants levels between the two rivers and at different sampling points. River Nwaorie was observed to be more impacted than River Otamiri. High values of iron observed from the study could be deleterious to human health if the river water is consumed without treatment. The study, therefore, recommended proper waste management and disposal as well as effluent treatments in Owerri municipal against pollution of surface water.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2005.11a
• /
• pp.513-517
• /
• 2005

The condition monitoring of rotating machinery such as turbines, pumps and compressors, determine what repairs are needed to avoid shutdown and disassembly of the machine in an industrial plant Many diagnosis methods have been developed for use when the machine is running at steady state, the stationary condition. But much information can be gained about a rotor's condition during non-stationary conditions such as run-up and run-down. Order tracking analysis is a powerful tool for analyzing the condition of a rotating machine when its speed changes over time. Powerful OTA using digital signal processing has some advantages(cheap hardware, the powerful methods, the accurate post processing) and also some disadvantages(calculation time, high speed sampling). New OTA tool based on the chirplet transform is similar to the short time Fourier transform. But, it has good resolution at high speed like other OTA methods based STFT and more resolution for constant frequency components than re-sampling OTA.

• KIPS Transactions on Computer and Communication Systems
• /
• v.4 no.2
• /
• pp.57-64
• /
• 2015

At the case of peak threshold algorithm, 3-axes data should sample step data over 20 Hz to get sufficient accuracy. But most of the digital sensors like 3-axes accelerometer have very low sampling rate caused by low data communication speed on limited SPI or $I^2C$ bandwidth of the low-cost MPU for ubiquitous devices. If the data transfer rate of the 3-axes accelerometer is getting slow, the sampling rate also slows down and it finally degrades the data accuracy. In this study, we proved there is a distinct functional relation between the sampling rate and threshold on the peak threshold step detection algorithm under the 20Hz frequency, and made a threshold function through the experiments. As a result of experiments, when we apply threshold value from the threshold function instead of fixed threshold value, the step detection error rate can be lessen about 1.2% or under. Therefore, we can suggest a peak threshold based new step detection algorithm with threshold function and it can enhance the accuracy of step detection and step count. This algorithm not only can be applied on a digital step counter design, but also can be adopted any other low-cost ubiquitous sensor devices subjected on low sampling rate.

• Journal of Environmental Impact Assessment
• /
• v.21 no.6
• /
• pp.859-877
• /
• 2012

In this study, Echo-sounder($E_s$) monitoring methodology was applied to test environmental impacts of artificial weirs(SCW and JSW) in the Yeongsan River on fish community and habitat structures at first time, and was compared with conventional fish sampling methodologies($C_s$). For the Es monitoring in the fields, parallel transect methods was employed in determining the survey distance interval with every 125 m within the upper-lower 2 km of the weirs. Four different fish sampling gears such as casting nets, kick nets, fyke nets, and gill nets were used for applications of $C_s$ monitoring methodology. According to the Echo-sounder monitoring, fish density, expressed as a number of individuals per square meter, along the longitudinal axis of the weir was significantly greater(JSW, t = 3.506, n = 30, p < 0.001) in the down-river reach of the weir than in the up-river reach. Also, fish density along the vertical water column was highest at mid-depths of Seungchon weir, which has simple habitat substrates, while fish density was highest at hypolimnetic depth of Juksan weir. According to fish sampling by the $C_s$ methodology, the fish compositions decreased as the river goes upward, and significant differences(JSW, t = 0.248, n = 30, p < 0.05) in the compositions of fish species occurred between up-reach and down-reach of the weirs. The dominant species near the two weirs were Opsarichthys uncirostris amurensis, Hemiculter eigenmanni and Coilia nasus. Overall, our fish and habitat data, based on $E_s$ and $C_s$ monitoring methodologies, suggest that the weirs disturbed the rivers due to initial habitat disturbances by the weir constructions as well as the barrier roles of weirs on fish passage and migrations. More long-term scientific and systematic fish impact monitoring and assessments($E_s$ and $C_s$) are required in the future to predict changes of ecological structures and functions on the constructions of the weirs.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.22 no.5
• /
• pp.185-191
• /
• 2022

In this study, we propose a novel super-resolution neural network based on U-Net, residual neural network, and sub-pixel convolution. To prevent the loss of detailed information due to the max pooling of U-Net, we propose down-sampling and connection using sub-pixel convolution. This uses all pixels in the filter, unlike the max pooling that creates a new feature map with only the max value in the filter. As a 2×2 size filter passes, it creates a feature map consisting only of pixels in the upper left, upper right, lower left, and lower right. This makes it half the size and quadruple the number of feature maps. And we propose two methods to reduce the computation. The first uses sub-pixel convolution, which has no computation, and has better performance, instead of up-convolution. The second uses a layer that adds two feature maps instead of the connection layer of the U-Net. Experiments with a banchmark dataset show better PSNR values on all scale and benchmark datasets except for set5 data on scale 2, and well represent local area patterns.

• Journal of Astronomy and Space Sciences
• /
• v.27 no.2
• /
• pp.173-180
• /
• 2010

As a preparatory study for Global Positioning System-Very Long Baseline Interferometry (GPS-VLBI) hybrid system, we examined if VLBI type observation of the GPS signal is realizable through a test experiment. The test experiment was performed between Kashima and Koganei, Japan, with 110 km baseline. The GPS L1 and L2 signals were received by commercial GPS antennas, down-converted to video-band signals by specially developed GPS down converters, and then sampled by VLBI samplers. The sampled GPS data were recorded as ordinary VLBI data by VLBI recorders. The sampling frequency was 64 MHz and the observation time was 1 minute. The recorded data were correlated by a VLBI correlator. From correlation results, we simultaneously obtained correlation fringes from all 8 satellites above a cut-off elevation which was set to 15 degree. 87.5% of L1 fringes and 12.5% of L2 fringes acquired the Signal to Noise Ratios which are sufficient to achieve the group delay precision of 0.1nsec that is typical in current geodetic VLBI. This result shows that VLBI type observation of GPS satellites will be readily realized in future GPS-VLBI hybrid system.

• Journal of the Microelectronics and Packaging Society
• /
• v.6 no.3
• /
• pp.1-7
• /
• 1999

A single RF transceiver evaluation board have been developed for the purpose of application to the 900MHz band transceiver contained RF-IC chip And environment test was evaluated. The RF-IC chipset includes LNA(Low Noise Amplifier), down-conversion mixer, AGC(Automatic Gain Controller), switched capacitor filter and down sampling mixer. The RF evaluation board for the testing of chipset contained various external matching circuits, filters such as RF/IF SAW(Surface Acoustic Wave) filter and duplexer and power supply circuits. With the range of 2.7~3.3V the operated chip revealed moderate power consumption of 42mA. The chip was well operated at the receiving frequency of 925~960MHz. Measurement result is similar to general RF receiving specification of the 900MHz digital mobile phone.