• 대한용접접합학회:학술대회논문집
• /
• 대한용접접합학회 2003년도 춘계학술발표대회 개요집
• /
• pp.176-178
• /
• 2003

The weld zone of dissimilar formed Al alloy exhibited the complex structure of the two materials and mainly composed of the retreating side material. The mechanical properties were also depended on the dominant microstructure of the weld zone with welding conditions. The different mechanical properties of weld zone with welding conditions were related to the behavior of the precipitates of wrought Al alloy and Si particles of cast Al alloy. The higher mechanical properties of weld were acquired when relatively harder material, wrought Al alloy, was fixed at the retreating side.

• 자원환경지질
• /
• 제23권4호
• /
• pp.411-424
• /
• 1990

Mechanical, physical and petrographic properties of seventeen marble specimens collected from ten marble mines in Korea were investigated. Studied marbles were mainly composed of calcite, dolomite, and various amounts of serpentine, tremolite, olivine, quartz and opaque minerals. Complete and sutured textures were dominant. Compressive strength measured normal to the bedding plane is larger almost two times than that measured parallel to the bedding plane. From the results of Shore hardness test on marbles, water content was an important factor to decrease Shore hardness values. Engineering geological properties, especially, compressive strength, Young's modulus, wear resistance and water absorption could be controlled by the presence of quartz, and the type of marble texture. Water absorption-porosity, compressive strength-Young's modulus, and impact strength index-Los Angeles abrasion couples show good correlation. According to the comparative utility as commercial stone, it could be concluded that marbles from the Banglim mine, Songbo mine, Kwangdeok mine and Bongjeong mine were superior to that of other studied marbles.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 추계학술대회 논문집
• /
• pp.467-470
• /
• 2000

This paper present the result of the investigation, electric properties of outdoor insulators with the difference of contaminated condition. In general, the humidity and the amount of soluble salts such as NaCl, MgCl$_2$are the most dominant factor. A mini-fog chamber with transparent acryl and the standard contamination solution with kaoline was used. The kaoline was applied with sprayer to get the specific ESDD and NSDD value, then the specimen was dried and installed horizontally. And to measure the leakage current and the ambient condition, such as relative humidity and temperature, a DAS system was developed with LabView. From the result, we could know the influence of contaminated condition. Contaminated area and pattern has a close relationship with the electrical properties of outdoor insulator.

• 한국축산식품학회지
• /
• 제38권1호
• /
• pp.110-122
• /
• 2018

Akcakatik cheese (yogurt cheese) is produced by drying strained yogurt with or without adding cloves or black cumin. The main objective of this study was to detect the properties of both fresh and ripened Akcakatik cheeses and to compare them. For this purpose the biogenic amine content, volatile flavor compounds, protein degradation level, chemical properties and some microbiological properties of 15 Akcakatik cheese samples were investigated. Titratable acidity, total dry matter, NaCl, total nitrogen, water soluble nitrogen, ripened index, histamine, diacetyl and acetaldehyde levels were found to be higher in ripened cheese samples than in fresh cheese samples. On the other hand, the clove and black cumin ratios were found to be higher in the fresh cheese samples. Sodium dodecyl sulphate polyacrylamide gel electropherograms of cheese samples showed that protein degradation was higher in ripened cheese samples than in fresh samples, as expected. The dominant Lactic acid bacteria (LAB) flora of Akcakatik cheese samples were found to be Streptococcus salivarius subsp. thermophilus and Lactobacillus delbrueckii subsp. bulgaricus.

• 대한기계학회논문집A
• /
• 제32권12호
• /
• pp.1107-1114
• /
• 2008

This paper is aimed to understand the effect of different galvannealing temperatures on the frictional properties and Fe-Zn intermetallic phases of the galvannealed (GA) coatings on steel sheets. Their galvannealing treatments were conducted at 465, 505, 515 and $540^{\circ}C$ for about 10s in the additional heating furnace of an industrial continuous hot-dip galvanizing line. The mechanical and the frictional properties of the coatings were estimated using nanoindentation, nanoscratch, micro vickers hardness tests and flat friction tests, which were performed at contact pressures of 4, 20 and 80MPa. Also, the correlation between the microstructure and the frictional properties of the GA coatings were investigated by SEM observation for the cross-section of the GA coating after and before flat friction tests. The results showed that the mechanical and the frictional properties of the coatings are strongly dependent on their phase distributions and microstructure. Especially, in low contact pressure of 4MPa the frictional properties of the coatings were dependent on the surface phases and morphology, while in high contact pressure of 80MPa it was influenced by their mechanical properties based on the dominant phase distributions.

• Macromolecular Research
• /
• 제17권8호
• /
• pp.591-596
• /
• 2009

To trace the plasticizing effects of propylene glycol (PG) on poly(vinyl alcohol) (PVA), the rheological properties of PVA solutions in dimethyl sulfoxide (DMSO) and the physical properties of PVA films were discussed in terms of PG content. Both properties were closely related to the hydrogen bond breaking effects of PG The 6 and 12 wt% PVA solutions containing PG exhibited Bingham behavior, which was more noticeable at lower plasticizer content and higher polymer concentration. The 6 wt% PVA solutions containing more than 30 wt% PG showed a sudden decrease of viscosity over the frequency range of 0.08 and 0.2 rad/s. However, the 12 wt% PYA solutions showed no viscosity reduction even at a PG content up to 40 wt%. The glass transition temperature of the PVA/PG films was almost linearly decreased with increasing PG content but an abrupt reduction was observed at a plasticizer content 30 wt%, suggesting that the hydrogen bond breaking effects of PG on PVA became dominant between 20 and 30 wt%. This effect was further supported by the similar tendency of the tensile properties.

• 한국환경생태학회지
• /
• 제25권1호
• /
• pp.10-16
• /
• 2011

본 연구는 제주도 용수저수지 주변 호랑가시나무개체군을 식물사회학적 방법으로 분류하고, 식생과 토양과의 상관관계를 밝히고자 분포서열법에 의한 분석을 실시하였다. 호랑가시나무개체군은 꾸지뽕나무우점개체군, 상동나무우점개체군, 예덕나무우점개체군으로 분류되었다. 토양분석 결과 유기물함량 14.62~17.35%, 전질소함량 0.39~0.51%, 유효인산함량 8.83~20.15mg/kg, 치환성 K 0.44~0.64cmol+/kg, Ca 5.79~6.87cmol+/kg, Mg 3.43~4.19cmol+/kg이며, 토양 pH는 5.41~5.80인 것으로 조사되었다. 예덕나무우점개체군은 유효인산과 유기물함량이 많고 치환성 K, Mg의 양료가 적은 입지에 분포하는 것으로 분석되었다. 상동나무우점개체군과 꾸지뽕나무우점개체군은 유효인산과 유기물함량이 적고 치환성 K, Mg의 양료가 많은 입지에 분포하는 것으로 조사되었다. 호랑가시나무 자생지 보호를 위해 수관층을 피압하고 있는 덩굴식물 제거작업이 이루어져야 하며, 지속적인 생태모니터링과 자생지 보존을 위한 관리방안이 수립되어야 한다.

• Journal of Forest and Environmental Science
• /
• 제36권2호
• /
• pp.133-142
• /
• 2020

Soil physical and chemical properties at three layers such as top (0-10 cm), middle (10-20 cm) and bottom (20-30 cm) layers under three different vegetation types were studied. Soil samples were collected from Acacia forest, vegetable and fallow lands of Chittagong university campus, Chittagong, Bangladesh. Results showed that sand was the dominant soil particle followed by clay and silt fractions in all soil depths under different vegetation types. Soils of fallow land showed the highest values of bulk density while forest soils had the lowest values at three depths. Acacia forest soil having lowest values of dispersion ratio (DR) is less vulnerable while fallow soil with highest DR values is more vulnerable to soil erosion. The lower pH value at all soil layers in three ecosystems represented that soils under study are acidic in nature. Contents of organic matter, total nitrogen, exchangeable cations (Ca²⁺, Mg²⁺, K⁺ and Na⁺) and cation exchange capacity (CEC) were observed higher in Acacia forest soils compared to vegetable and fallow soils. Only soils of vegetable land had higher level of available phosphorus in three layers than that of other two land covers. The study also revealed that different soil properties were observed in three different vegetation types might be due to variation in vegetation and agronomic practices.

• Journal of the Korean Wood Science and Technology
• /
• 제34권5호
• /
• pp.19-28
• /
• 2006

There has been considerable research in recent times in light-timber med structures in fires. These structures have included horizontal (floor-like) panels in bending and walls under eccentric and approximately concentric vertical loading. It has been shown that compression properties are the most dominant mechanical properties in affecting structural response of these structures in fire. Compression properties have been obtained by various means as functions of one variable only, temperature. It has always been expected that compression properties would be significantly affected by moisture and stress, as well. However, these variables have been largely ignored to simplify the complex problem of predicting the response of light-timber framed structures in fire. Full-scale experiments on both the panels and walls have demonstrated the high level of significance of moisture and stress for a limited range of conditions. Described in this paper is an overview of these conditions and experiments undertaken to obtain compression properties as a functions of moisture, stress and temperature. The experiments limited temperatures to $20{\sim}100^{\circ}C$. At higher temperatures moisture vaporizes and moisture and stress are less significant. Described also is a creep model for wood at high temperatures.

• Nuclear Engineering and Technology
• /
• 제54권9호
• /
• pp.3470-3477
• /
• 2022

Soils are porous materials with high shielding capability to attenuate gamma and X-rays. The disposal of radionuclides throughout the soil profile can expose the living organisms to ionizing radiation. Thus, studies aiming to analyze the shielding properties of the soils are of particular interest for radiation shielding. Investigations on evaluating the shielding capabilities of highly weathered soils are still scarce, meaning that additional research is necessary to check their efficiency to attenuate radiation. In this study, the radiation shielding properties of contrasting soils were evaluated. The radiation interaction parameters assessed were attenuation coefficients, mean free path, and half- and tenth-value layers. At low photon energies, the photoelectric absorption contribution to the attenuation coefficient predominated, while at intermediate and high photon energies, the incoherent scattering and pair production were the dominant effects. Soils with the highest densities presented the best shielding properties, regardless of their chemical compositions. Increases in the attenuation coefficient and decreases in shielding parameters of the soils were associated with increases in clay, Fe₂O₃, Al₂O₃, and TiO₂ amounts. In addition, this paper provides a comprehensive description of the shielding properties of weathered soils showing the importance of their granulometric fractions and oxides to the attenuation of the radiation.