• Journal of the Korean Society of Radiology
• /
• v.12 no.2
• /
• pp.179-184
• /
• 2018

In this study, we compared the measured values of the effective beam size of standard gamma irradiator with the simulation results to provide a useful means to the effective beam area determination. Results of the simulation and measured using ion chamber was distributed in a relative error of 4.5 ~ 7.3% of the case of air kerma rate. The size of the effective beam area is when the simulation was implemented in the horizontal direction 27cm, 21.6cm vertical direction, the measured result using a film was obtained similar results with the horizontal direction 26.5cm, 21.9cm vertical direction. The relative error in the horizontal direction is 1.85% and 1.38% vertical effective beam area was also similarly distributed around the field gamma rays. As a result of the study, it was confirmed that the effectiveness of the simulation was sufficient for the gamma irradiation system. In particular, it is small relative errors in the effective beam size than the air kerma rate is considered to be due to the size of the beam is determined by geometric factors rather than the capacity of the standard source. A further study is needed to improve the reliability of the photon energy distribution diagram using simulation.

• Journal of Korea Water Resources Association
• /
• v.49 no.8
• /
• pp.645-656
• /
• 2016

The study performed a regional flood frequency analysis and proposed a regression equation to estimate design floods corresponding to return periods for ungauged basins in Geum-river basin. Five preliminary tests were employed to investigate hydrological independence and homogeneity of streamflow data, i.e. the lag-one autocorrelation test, time homogeneity test, Grubbs-Beck outlier test, discordancy measure test ($D_i$), and regional homogeneity measure (H). The test results showed that streamflow data were time-independent, discordant and homogeneous within the basin. Using five probability distributions (generalized extreme value (GEV), three-parameter log-normal (LN-III), Pearson type 3 (P-III), generalized logistic (GLO), generalized Pareto (GPA)), comparative regional flood frequency analyses were carried out for the region. Based on the L-moment ratio diagram, average weighted distance (AWD) and goodness-of-fit statistics ($Z^{DIST}$), the GLO distribution was selected as the best fit model for Geum-river basin. Using the GLO, a regression equation was developed for estimating regional design floods, and validated by comparing the estimated and observed streamflows at the Ganggyeong station.

• Journal of the Mineralogical Society of Korea
• /
• v.26 no.3
• /
• pp.189-196
• /
• 2013

In this study, we tried to define the origin of fine-grained sediments in Southwestern Cheju Island Mud (SWCIM) using principal component analysis. We used relative clay mineral compositions using 138 marine surface sediments, 4 Huanghe sediments and 3 Changjiang river sediments by the semi-quantitative X-ray diffraction analysis. We made bioplot diagram using R program with principal component 1 and component 2 because they might contain more than 90% of all data. Although the distribution pattern of each clay minerals in SWCIM is so intricate, smectite and kaolinite contents are high in the west region, but illite and chlorite contents are rich in the east region. In the biplot, the east region of SWCIM distribute around Changjiang river, whereas west region of SWCIM disperse around Huanghe. Our results might reveal that west region of SWCIM is mainly originated by Huanghe, but east region of SWCIM by Changjiang River.

• Economic and Environmental Geology
• /
• v.20 no.2
• /
• pp.85-95
• /
• 1987

The host rocks of titaniferous magnetite deposits in Gonamsan are alkaline gabbros, which are typical of undersaturated alkaline rocks in terms of the lack of normative quartz. According to field occurrences and petrographic features, these alkaline gabbros are divided into 3 rock types: coarse-grained and pegmatitic rock, medium-grained rock with equigranular texture, and layered cumulate rock. All these rocks mainly contain clinopyroxene(salite), plagioclase(An 43-66), pargasite, and ilmenite. The accessory minerals are apatite, sphene, quartz, and sometimes titaniferous magnetite. Pargasite, sphene, and quartz are considered to be secondary minerals formed by the reaction among clinopyroxene, plagioclase and Fe-Ti oxide at deuteric stage. Fe-Ti oxides generally occur as ilmenite in the alkaline rocks, and titaniferous magnetite in the ore deposits. Layered cumulate rocks are characterized by a recurrence of discontinuous thin mesolayer of clinopyroxene-pargasite within leucolayer mainly composed of plagioclase. Clinopyroxene is cumulus mineral whereas plagioclase, ilmenite and apatite occur as intercumulus minerals. According to the variation diagrams of oxide and trace element contents against the differentiation index, incompatible elements, such as Na, Ba and Sr, show positive correlations whereas compatible elements, such as Mg and Cr, show negative correlations. However some compatible elements, such as Co, Ni and V show irregular variations, reflecting relative cumulate status of cumulus and intercumulus minerals. On the de la Roche multicationic diagram, these alkaline gabbros are distributed along the differentiation curve of undersaturated alkaline series from alkaline basaltic composition through basanitic composition to tephritic composition. Layered cumulate rocks, which are distributed between basanitic composition and tephritic composition, reflect their cumulate character, slightly scattering away from the curve. The medium-grained rock shows higher contents in Ba, Sr and light rare earch elements than the coarse-grained and pegmatitic rock. The former shows two times higher contents of total rare earth elements than the latter, $while(La/Lu)_{cn}$ ratios maintain fairly constant values of 5.08~5.06 in these two rocks. This means that coarse-grained and pegmatitic rock, as compared with the medium-grained rock, was formed by the earlier differentiated magma but rare-earth element distribution pattern remained almost parallel during differentiation. From the data the above mentioned, these alkaline gabbros are considered to be comagmatic and to be formed by intrusions of differentiated magmas in its reservoir.

• Geotechnical Engineering
• /
• v.10 no.2
• /
• pp.25-40
• /
• 1994

In order to investigate behavior of lateral flow by plasticity of soils and construction control due to it, in the case of unsymmetrical surcharge load on the soft soils, we examine the existing theoretical background, and compared and analysed the experimental results by model test. After model test fabricated by model test apparatus, which made full remolding samples of soft soils, we observed the state of behavior for deformation with increasing load step to constant time interval. The critical surcharge and ultimate capacity showed tendency to approach to the proposed value of Jaky and Meyerhof, and the lateral flow pressure of which the maximum value was acted on the depth calculated by z/H=0.26+1.71cu and one third value of the maximum lateral flow pressure acted on the ground surface, approach the trapezoid distribution And maximum lateral flow pressure will be calculated by proposed equation of Hong or simple equation which($\alpha=0.4$) the flow pressure coefficient . of proposed equation by Tschebotarioff exchanged to($\alpha=K_0$) . Basides, the failure surcharge by [(q/$y_m$)-q] and [$S_y-(y_m/S_y)$] showed the smaller than ultimate bearing capacity, especially failure criteria line of control diagram of [$S_y(y_m/S_y)$] will be calculated by following equation. $S_y.=3.15exp[-0.58(y_m/S_y)$

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.21 no.5
• /
• pp.474-483
• /
• 2015

In order to understand the seasonal change of phytoplankton as well as the effect of water physico-chemical parameters, we investigated 18 stations in coastal areas of the East Sea in February, May, August and November in 2009. The taxa of phytoplankton observed in this study were classified as 37 Bacillariophyceae, 22 Dinophyceae, 1 Euglenophyceae, 3 Dictyophyceae and 1 Cryptophyceae. Phytoplankton abundance ranged from $1.2{\times}10^3cells/L$ to $246.6{\times}10^3cells/L$(with a mean value of $24.8{\times}10^3cells/L$), the highest biomass was observed in May. The dominant species were Leptocylindrus danicus, Chaetoceros affinis, Pseudo-nitzschia pungens, Thalassionema nitzschioides and etc. Pearson's correlation co-efficient between phytoplankton abundance and other water parameters showed the positive relationships with pH, DO, Secchi-disk depth, and SS, the negative relationships with $SiO_2-Si$. Seasonal patterns of phytoplankton dominant species were affected by the characteristics of water masses based on T-S diagram analysis. In particular, phytoplankton distributional patterns were related with water temperature in May and salinity in August, respectively. According to the result of MDS(Multi-dimensional scaling) using the phytoplankton abundance and species composition, the spatial distribution of phytoplankton were characterized with Ganwon(Group A) and Gyeongbuk(Group B) at the coastal areas of Jukbyeon or Uljin.

• Journal of the Korean GEO-environmental Society
• /
• v.21 no.1
• /
• pp.5-12
• /
• 2020

Vibration propagated from seismic sources has damping according to distance and amplification and reduction characteristic in different regions according to topography and geological structure. The vibration propagated from the seismic source to the bedrock is largely affected by the damping according to the separation distance, which can be simply estimated through the damping equation. However, it is important to grasp geological information by location because vibration estimation transmitted to the surface are affected by the natural period of the soil located above the bedrock. Geotechnical investigation data are needed to estimate the seismic intensity based on geological information. If there is no Vs profile, the standard penetration tests are mainly used to determine the soil parameters. The Integrated DB Center of National Geotechnical Information manages the geotechnical survey data performed on the domestic ground, and there is the standard penetration test information of 400,000 holes. In this study, the possibility of quantitation the amplification coefficient for each region was examined to calculated the physical interactive seismic intensity based on geotechnical information. At this time, the shear wave column diagram was generated from the SPT-N value and ground response analysis was performed in the target area. The site coefficients for each zone and the seismic intensity distribution for the seismic motion present a significant difference according to the analysis method and the regional setting.

• Archives of design research
• /
• v.17 no.4
• /
• pp.141-148
• /
• 2004

The purpose of this study is to define the emotion that expressed in step animation and to quantify the intuitional expression of emotion that related step for using extract, measure, analysis the stimulate element about step. The survey of relation with 27 word of emotional expressions and 36 moving pictures of step sample is used for method of this test. The emotional mental structure is transferred to 2 dimensional planes as applying the results of analysis of integrated data using Quantification Method 3, which the integrated data is composed two axial - confidential axial and stabling axial. Analysis of distribution of 2 dimensional diagram shows that the second of the plane and the third of the plane have much data. However, the first of the plane and the forth of the plane have a little data. Through this kind of analysis of graph, it is difficult to express a different emotion between unstable the timidity mind and stable feel the timidity mind using only step analysis. Six difference types about physical elements affecting to emotion are selected and analyzed such as the paces of step, the rate of step, the movement angle of pelvis, the swing range of arm, angle of backbone and the lean angle of body. The result is that the rate of stop and the lean angle of body are the major element that effects to emotional stimulate of stop. This thesis argues about methods transforming subjective expression to objective and quantitative expression with the state of delicate emotion of character apply to step animation naturally. Those data to apply to multi-contents in future are the main target in this study.

• Korean Journal of Soil Science and Fertilizer
• /
• v.36 no.5
• /
• pp.263-271
• /
• 2003

Effects of the existence of $CO_2$ gas and pH on the silica surface characteristics at silica/Pb(II) and sodium dodecyl sulfonate (SDS, $C_{12}H_{25}SO_3Na$) solution interface were studied. The hydrophobic characteristics of silica surface was delineated by contact angle measurement and surface force measurement using atomic force microscopy (AFM). In $CO_2$ free condition provided by purging $N_2$ gas, the contact angle of fused silica surface in $10^{-4}M$ Pb(II) and SDS solution increased greatly up to $90^{\circ}$ compared with $40^{\circ}$ in atmospheric condition. It was due to the precipitation of $PbCO_3$ in atmospheric condition. In $CO_2$ free condition the change of contact angle and adhesion force ($F_{ad}$) in AFM, affected by pH change, was similar to the distribution of $PbOH^+$ ion in speciation diagram corresponding to $10^{-4}M$ total Pb(II). Therefore, it was convinced that the $PbOH^+$ ion among Pb(II) species would be the main adsorbing type on silica surface. Both of contact angle measurement and surface force measurement using AFM showed that the Pb only treatment made the silica surface hydrophobic. However, it could not be explained theoretically by current knowledge, and required further study in atomic level to solve the problem.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.37 no.1
• /
• pp.47-54
• /
• 2013

This study investigates the crack growth behavior due to primary water stress corrosion cracking (PWSCC) in the dissimilar metal butt weld of a reactor piping using Alloy 82/182. First, detailed finite element stress analyses were performed to predict the stress distribution of the dissimilar metal butt weld in which the hydrostatic and the normal operating loads as well as the weld residual stresses were considered to evaluate the stress redistribution due to mechanical loadings. Based on the stress distributions along the wall thickness of the dissimilar metal butt weld, the crack growth behavior of the postulated axial and circumferential cracks were predicted, from which the crack growth diagram due to PWSCC was proposed. The present results can be applied to predict the crack growth rate in the dissimilar metal butt weld of reactor piping due to PWSCC.