• 전기학회논문지P
• /
• 제62권1호
• /
• pp.36-44
• /
• 2013

This paper is written for the development and application of boiler fuel control algorithm and distributed control system of coal-fired power plant by the steps of design, coding, simulation test, site installation and site commissioning test. Fuel control algorithm has the upper algorithm and it is boiler master control algorithm that controls the fuel, feed water, air by generation output demand. Generation output demand by power load influences fuel control. Because fuel can not be supplied fast to the furnace of boiler, fuel control algorithm was designed adequately to control the steam temperature and to prevent the explosion of boiler. This control algorithms were coded to the control programs of distributed control systems which were developed domestically for the first time. Simulator for coal-fired power plant was used in the test step. After all of distributed control systems were connected to the simulator, the tests of the actual power plant were performed successfully. The reliability was obtained enough to be installed at the actual power plant and all of distributed control systems had been installed at power plant and all signals were connected mutually. Tests for reliability and safety of plant operation were completed successfully and power plant is being operated commercially. It is expected that the project result will contribute to the safe operation of domestic new and retrofit power plants, the self-reliance of coal-fired power plant control technique and overseas business for power plant.

• Journal of Communications and Networks
• /
• 제5권3호
• /
• pp.197-201
• /
• 2003

We study in this paper both distributed power control and removal algorithms for multimedia CDMA wireless networks. In our study, users can have different data rates as well as different quality of service (QoS) requirements. We derive a necessary and sufficient condition for the fully distributed power control (FDPC) algorithm to find a feasible power set. We also prove that, if the maximal power level is used at the start, then the distributed constrained power control (DCPC) algorithm is equivalent to the FDPC algorithm. For the connection removal algorithm, we prove that the non-reinitialized removal algorithm finds a feasible power set faster and employs smaller power levels than the reinitialized one does. Performances of some connection removal criteria are also studied. Our simulation results reveal that the smallest normalized CIR (SNC) and largest CIR requirement (LCR) criteria result in smaller outage probability than the smallest CIR (SC) criterion in a multimedia environment.

• 전기학회논문지
• /
• 제59권2호
• /
• pp.298-305
• /
• 2010

In this paper, a new algorithm of optimal Volt/Var Control is proposed using Volt/Var control for the Distribution Automation System (DAS) with Distributed Generation (DG) based on the modeling of the distributed load and the distributed current. In the proposed, algorithm based on the modeling of the distributed load and the distributed current are estimated from constants of four terminals using the measurement of the current and power factor from a Feeder Remote Terminal Unit (FRTU) and DG data from RTU for DG. For the optimal Volt/Var Control, the gradient method is applied to find optimal solution for tap, capacity and power control of OLTC (On-Load Tap Changers), SVR (Step Voltage Regulator), PC (Power Condenser) and DG (Distributed Generation). In the case studies, the estimation and control of the voltages have been testified in a radial distribution system with DG using matlab program.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2003년도 ICCAS
• /
• pp.1982-1985
• /
• 2003

Future cellular networks will mainly be driven by, high quality channels, high band with utilization, low power consumption and efficient network management. For a given channel allocation, the capacity and quality of communication of cellular radio systems using CDMA(Code Division Multiple Access) can be increased by using a transmitter power control scheme to combat the near-far problem. Centralized power control schemes or distributed ones to maximize the minimum signal-to-interference in each user of CDMA wireless network have been investigated. This paper has proposed a distributed power control algorithm, which employs an adaptive search scheme, in order to solve quickly the linear systems of equations for power update in CDMA cellular radio systems. The simulation results show that the proposed scheme has faster convergence rate than the typical bang-bang type of distributed power control algorithm, which has been much used as a reference algorithm in IS-95A and W-CDMA communication network.

• 전기학회논문지
• /
• 제58권8호
• /
• pp.1463-1471
• /
• 2009

In this paper, a new algorithm of Integrated Volt/Var Control (IVVC) is proposed using Volt/Var control for the Distribution Automation System (DAS) based on the modeling of the distributed load and the distributed current. In the proposed, the load flow based on the modeling of the distributed load and the distributed current are estimated from constants of four terminals using the measurement of the current and power factor from a Feeder Remote Terminal Unit (FRTU). For Integrated Volt/Var Control (IVVC), the gradient method is applied to find optimal solution for tap and capacity control of OLTC (On-Load Tap Changers), SVR (Step Voltage Regulator), and SC (Shunt Condenser). What is more Volt/Var control method is proposed using moving the tie switch as well as IVVC algorithm using power utility control. In the case studies, the estimation and simulation network have been testified in Matlab Simulink.

• 제어로봇시스템학회논문지
• /
• 제14권7호
• /
• pp.624-628
• /
• 2008

This paper is concerned with multiple motor control using a distributed network control method. Speed and position of multiple motors are synchronized using clock synchronized distributed controllers. CAN (controller area network) is used and a new clock synchronization algorithm is proposed and implemented. To verify the proposed control algorithm, two disks which are attached on two motor shafts are controlled to rotate at the same speed and phase angle with the same time base using network clocks.

• 한국콘텐츠학회논문지
• /
• 제8권2호
• /
• pp.9-17
• /
• 2008

본 논문에서는 동기적인 분산시스템에서 불리 알고리즘에 기초하여 하나의 새로운 선출(election) 알고리즘을 설계하고 이를 분석하고자 한다. 동기적인 분산시스템에서 기존의 불리 알고리즘은 고장 추적 장치를 이용하여 더욱 효율적으로 설계되고 구현 될 수 있음을 보인다.

• 대한기계학회논문집
• /
• 제19권1호
• /
• pp.111-121
• /
• 1995

A fuzzy control algorithm of bell-type membership functions and 9 rules is constructed for narrow range level control of steam generators in nuclear power plants. It is implemented at a field digital distributed controller, a Westinghouse-made controller called Westinghouse Distributed Processing Family(WDPF). Performance for level control of the developed fuzzy controller is compared with that of conventional controller, both at the field controller. For these comparisons, both the fuzzy control algorithm and the conventional PI control algorithm were carefully tuned. Also the sampling time for optimal performance was investigated. The results show that the fuzzy control algorithm is not only better in performance than the conventional algorithm but also much easier to be tuned by operators in the field.

• 대한전기학회논문지:시스템및제어부문D
• /
• 제53권7호
• /
• pp.501-508
• /
• 2004

In this paper, a coordinated scheduling algorithm is proposed to reduce end-to-end delay in distributed control of systems. For the algorithm, the analysis of practical end-to-end delay in the worst case is performed priory with considering implementation of the systems. The end-to-end delay is composed of the delay caused by multi-task scheduling of operating systems, the delay caused by network communications, and the delay caused by asynchronous timing between operating systems and network communications. Through some simulation tests based on CAN(Controller Area Network), the proposed worst case end-to-end delay analysis is validated. Through the simulation tests, it is also shown that a real-time distributed control system designed to existing worst case delay cannot guarantee end-to-end time constraints. With the analysis, a coordinated scheduling algorithm is proposed here. The coordinated scheduling algorithm is focused on the reduction of the delay caused by asynchronous timing between operating systems and network communications. Online deadline assignment strategy is proposed for the scheduling. The performance enhancement of the distributed control systems by the scheduling algorithm is shown through simulation tests.

• 한국통신학회논문지
• /
• 제25권9A호
• /
• pp.1405-1412
• /
• 2000

In this paper, we propose an efficient dynamic wavelength assignment algorithm in distributed WDM (Wavelength-Division Multiplexing) networks without wavelength conversion. The algorithm tries to assign a locally-most-used wavelength distributedly on a fixed routing path. We first formulate our algorithm by using the concept of a sample space which consists of optical fibers connected to nodes on a routing path of a lightpath to be assigned a wavelength. In particular, we analyze the blocking performance mathematically as compared with that of the most-used (MU) wavelength assignment algorithm previously proposed for WDM networks under centralized control. We also obtain numerical results by simulation on the blocking performance of other centralized/distributed wavelength assignment algorithms as well as our algorithm using the M/M/c/c dynamic traffic model. Consequently, we show that analytical results match simulation results and that our algorithm is efficient in distributed WDM networks in terms of blocking performance, control traffic overhead and computation complexity.