• JSTS:Journal of Semiconductor Technology and Science
• /
• v.14 no.5
• /
• pp.594-600
• /
• 2014

A threshold voltage compensation pixel circuit was developed for active-matrix organic light emitting diodes (AMOLEDs) using amorphous indium-gallium-zinc-oxide thin-film transistors (a-IGZO-TFTs). Oxide TFTs are n-channel TFTs; therefore, we developed a circuit for the n-channel TFT characteristics. The proposed pixel circuit was verified and proved by circuit analysis and circuit simulations. The proposed circuit was able to compensate for the threshold voltage variations of the drive TFT in AMOLEDs. The error rate of the OLED current for a threshold voltage change of 3 V was as low as 1.5%.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2009.10a
• /
• pp.677-680
• /
• 2009

DC influence between pixel electrode and alignment layer (AL) in in-plane switching mode LCD was analyzed through DC equivalence-circuit equation induction, DC charge-discharge simulation, luminance and residual-DC measurement systems using test patterned (TP) cell. DC discharging rate (DDR) of single layer electrode was faster than that of double layer electrode and DDR of low resistance AL was faster than that of high resistance AL. DC discharging characteristics had a close relation to layer number and resistance between two electrodes.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.473-476
• /
• 2008

A simple voltage compensation pixel circuit for AMOLED is produced using low temperature polycrystalline silicon (LTPS) technology. Its operation is verified by AIM-SPICE. Simulation results show that the pixel circuit has high immunity to variation of LTPS-TFT and reduces the drop in luminance due to the degradation of the OLED.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.98-102
• /
• 2006

Historically, LCD monitors have not been able to be used for frame-sequential stereoscopic 3D visualisation due to their slow pixel response rate. With LCD pixel response rates now in the single-digit millisecond range it is natural to ask whether it is now possible to achieve frame-sequential stereoscopic 3D viewing on LCDs.

• Journal of Information Display
• /
• v.5 no.3
• /
• pp.1-7
• /
• 2004

We developed a novel frame interpolation method to interpolate a frame between two successive original frames. Using this method, we are able to apply a double-rate driving method instead of an impulse driving method where a black frame is inserted between two successive original frames. The double-rate driving method enables amelioration of the motion blur of LCDs caused by the characteristics of human vision without reducing the luminosity of the whole screen. The image quality of the double-rate driving method was also found to be better than that of an impulse driving method using our motion picture simulator and an actual panel. Our initial model of our frame interpolation method consists of motion estimation with a maximum matching pixel count estimation function, an area segmentation technique, and motion compensation with variable segmentation threshold. Although salt and pepper noise remained in a portion of an object mainly due to inaccuracy of motion estimation, we verified the validity of our method and the possibility of improvement in hold-type motion blurring.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.54 no.6
• /
• pp.123-133
• /
• 2017

In this paper, we developed an optimal flicker-free control algorithm operating within 16 luminance implementation bits and 512 brightness implementation pulses irrespective of LPM(LED Pixel Matrix) module configuration on dynamic driving method of LED display system. As an implementation method, we turned the refresh rate up by increasing the number of scans through multiple shift-latches which were devised from conventional shift-latch scheme for full color representation. As a result, the LED display system of this method has no flicker phenomenon because of the novel refresh rate higher than 2,040[Hz] incomparable to 240~480[Hz] of conventional system.

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.32B no.10
• /
• pp.1280-1285
• /
• 1995

In this paper the optimized overlap driving scheme for improving the reduction problem of the operating voltage range occured by the overlap driving scheme proposed precedently and increasing the contrast ratio of screen image in the simple matrix LCDs is proposed. The characteristic estimation of the proposed method was performed in a condition that the number of scan electrodes was 120 and the threshold voltage of LC pixel was 2V and the overlap rate of scan signal was varied from 0% to 40% . As a result of estimation compared with the overlap driving scheme proposed precedently, this new method was certified as a method which it could increase the operating voltage range of the LC pixel by 16% in 20% overlap condition and it's operating voltage range was also increased very much with the increase of the overlap rate. Consequently this newly proposed method was certified as a method which it could maintain the improvement effect of the operating characteristics obtained by the overlap driving scheme proposed precedently with the big improvement in the contrast ratio of screen image.

• Journal of the Korea Society of Computer and Information
• /
• v.11 no.1 s.39
• /
• pp.63-69
• /
• 2006

There are many new studies on the contents for mobile devices that are all connected to networks in a seemingly ubiquitous environment. The purpose of this paper is to propose a framework for obtaining Internet content intended for computers on mobile devices. In other words, the primary concern of this paper is to select the best images for optimal performance and convert them into images that can be effectively reproduced on mobile devices. For this, the performance of the server is to be optimized through selecting high-priority images among the many available images and converting them while considering the display pixel rates (DPR) and the image distribution areas.

• Journal of IKEEE
• /
• v.13 no.4
• /
• pp.50-56
• /
• 2009

This paper describes the design of image data transmitter for portable media device for Mobile Display Digital Interface standard. The transmitter uses connection lines to 6 to transmit QVGA image data. In this paper, the transmitter is using only 9 packets for image processing and a state-machine based design is adapted for packet processing. The design was verified using FPGA Xilinx virtex4-LX60. Data rate of the transmitter is 363Mbps with six connection lines. The transferring capability is 30 frame of 24bit RGB 500,000 pixel image data per second.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.9 no.3
• /
• pp.279-284
• /
• 2014

This paper proposes a novel OLED pixel circuit to compensate the threshold voltage variation of p-channel low temperature polycrystalline silicon thin-film transistors (LTPS TFTs). The proposed 5-TFT OLED pixel circuit consists of 4 switching TFTs, 1 OLED driving TFT and 1 capacitor. One frame of the proposed pixel circuit is divided into initialization period, threshold voltage sensing and data programming period, data holding period and emission period. SmartSpice simulation results show that the maximum error rate of OLED current is -4.06% when the threshold voltage of driving TFT varies by ${\pm}0.25V$ and that of OLED current is 9.74% when the threshold voltage of driving TFT varies by ${\pm}0.50V$. Thus, the proposed 5T1C pixel circuit can realize uniform OLED current with high immunity to the threshold voltage variation of p-channel poly-Si TFT.