• Korean Journal of Optics and Photonics
• /
• v.12 no.1
• /
• pp.17-24
• /
• 2001

Two-dimensional binary-phase diffraction gratings which can be employed to fabricate two- and three-dimensional periodic structures are designed and analyzed using rigorous coupled-wave analysis. These gratings serve as phase-masks which generate several diffracted waves from a normally incident beam and thus can produce a periodic interference pattern in space via nearfield holography. The properties of the diffracted beams can be controlled by varying the polarization and wavelength of the incident beam, surface-profile, groove depth and duty cycle of the mask. For the two-dimensional structure, optimum results can be obtained when the diffraction efficiency of the zero-order beam is minimized while that of the first-order maximized. On the other hand, when the diffraction efficiency of the zero-order is appreciable or even greater than other orders, we can obtain a variety of three-dimensional interference patterns which may be used to fabricate photonic crystals of tetragonal-body-centered and hexagonal structures in a submicron scale. scale.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.23 no.6
• /
• pp.1592-1601
• /
• 1998

The growing use of unlicensed wireless systems has spurred interest in the 2.4 Ghz ISM band. In order to facilitate the efficient design of such systems, understandings of the propserties of radio wave propagation in buildings is necessary. Many authors have reported about statistical propagation models based on the extensive measurements in buildings. However, measurement based statistical analysis will not be enough for the optimum deployment of the communication systems in the specific building. Aviding expensive measurements in the individual buildings prior to installation, or adjustments afterwards, theoretical prediction models have been developed to predict the path loss and delay spread from the building floor plane. Predictions shows good agreements with measurements except for a few environments which was surrounded by heavy scatterers.

• Journal of electromagnetic engineering and science
• /
• v.15 no.2
• /
• pp.120-122
• /
• 2015

This study presents a new, simple method for improving the front-to-back (F/B) ratio of a microstrip patch antenna (MSA) based on surface wave suppression. The back radiation of the MSA is significantly reduced by using the meandered ground plane edges and placing split-ring resonators (SRRs) in the middle of the meandered slots. By loading SRRs near the center of the meandered ground plane edges, some parts of the diffracted back-lobe power density can be reduced further. Compared to the F/B ratio of a conventional MSA with a full ground plane of the same size, an improved F/B ratio of 18 dB has been achieved experimentally for our proposed MSA.

• Bulletin of the Society of Naval Architects of Korea
• /
• v.20 no.2
• /
• pp.37-42
• /
• 1983

This paper presents a procedure within the framework of linear potential theory for predicting the lateral drifting forces on a cylinder floating on the free surface of a finite depth water. The disturbance of a regular incident wave caused by the presence of the floating body is represented by the sum of the diffracted and radiated wave potentials, which are determined by using Green's theorem. The lateral drifting forces are calculated by use of momentum theorem, and the scattered waves are expressed in their asymptotic forms. The computed lateral drifting forces on a Lewis form cylinder(b/T=1.25, $\sigma$=0.95) for water depth to draft ratio of 5.0 are compared with the Kyozuka's experimental results for a deep water, and found to be in good agreement. The water depth effects on drifting forces of the same model are also calculated.

• Journal of the Optical Society of Korea
• /
• v.15 no.4
• /
• pp.362-367
• /
• 2011

Organic ($Alq_3$) film, which was coated on a donor plate, was transferred to an organic light emitting diode (OLED) substrate with help of heat generated by a dithering laser beam. The laser beam was diffracted in an acousto-optic modulator (AOM), then focused on the laser-to-heat converting layer of the donor plate; the focused spot followed trajectories guided by rotation of a Galvano-mirror. Three different functional waveforms, sine wave, square wave, and saw tooth wave were applied to the AOM as modulation signal to generate the dithering beam. The fluorescence microscope images of the donor plate showed that the patterns of removed $Alq_3$ film were affected considerably by the modulation waveforms and the phase difference between adjacent dithering beams. Further, the printed images of Alq3 film on the OLED substrate were different from the patterns of removed Alq3 film. Atomic force microscope images indicated that not only direct transfer but also deposition by sublimated vapor of Alq3 contributed to the pattern formation. Printed patterns affected considerably the electricity-to-light conversion characteristics of OLEDs. For uniform transfer, not only the phase relation of dithering beam lines but also adequate waveform were important.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.19 no.5
• /
• pp.502-510
• /
• 2007

The present study is to estimate the effect of diffracted wave fields inside a harbor, around harbor entrance and outer breakwater, when a navigation channel is dredged in the vicinity of the a harbor entrance. The wave field of the problem is considered to be two-dimensional plane and the configuration of the submarine pit on the sea bed is designated by a single rectangular type. The numerical simulation is performed by using the solution of the Greet function based on the boundary integral equation. The results of this study is illustrated by applying the normal incidence and partially reflecting boundaries.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.28 no.6
• /
• pp.397-407
• /
• 2016

The traveling waves of the left and right of the detached breakwater are bent behind the detached breakwater by diffraction, causing phase interference, superimposed and propagated. If the direction of the waves becomes same and they head to the entrance of a port due to the geographical conditions, superimposed wave energy could influence inside of a port. In this study, we investigated the influence of the phase difference of the left and right diffraction waves generated according to the length of the detached breakwater on the wave heights in a port through numerical experiments when the detached breakwater at a port entrance is installed. From this result, it was confirmed that the wave heights in a port is increased or decreased by the influence of superimposed caused by the phase difference of the left and right diffraction waves due to the length of the detached breakwater.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.26 no.4
• /
• pp.16-26
• /
• 1989

Diffraction patterns of electromagnetic fields for the incidence of E-polarized plane wave on both interfaces of an arbitrary-angle dielect wedge are obtained by sum of geometric optics term and the edge diffracted fields. The diffraction coefficients of the edge diffracted fields are evaluated by employing the physical optics approximation and then correcting its error with the multipole line source at the dielectric edge. For the wedge angle $120^{circ}$, the incident angle $60^{circ}$, the relative dielectric constant of the dielectric wedge, 2, 5, and 10, and the observation distance from the tip of the wedge, 5 and 10 wavelength, the diffraction coefficients and the diffraction patterns corresponding to geometric optics, physical optics, and the solution corrected by the multipole line source are plotted, respectively. While the corrected solutions presented in this paper are valid only in the far-field region, these asymptotic solutions show to satisfy the boundary condition on the dielectric interfaces.

• Korean Journal of Optics and Photonics
• /
• v.7 no.2
• /
• pp.89-95
• /
• 1996

Superresolution optics, employing Gaussian apodization, is rigorously treated at the soft X-ray wave-length(λ=0.013 ${\mu}{\textrm}{m}$) region. In the diffraction integral, the line integral along the imaginary axis is found small, and it is ignored, so that the diffraction integral consists of the integration along the real axis. The resolution of the diffracted image is not effected by the pupil angular frequency bandwidth $2{\omega}_0$, which is one of the most important the characteristic features of Gaussian apodization ($e^{-o^2x^2}$ optics. The superresolution optics has resolution ($\frac{1}{2}{\times}FWHM)$=$\Delta$x=0.008 $\mu$m which is smaller than the Rayleigh criterion of 2λ=0.026 ${\mu}{\textrm}{m}$ for NA=0.25. The optical system has ${\omega}_0{\ge}\frac{1}{2}{\sigma}$, which gives the peak intensity of the diffracted image larger than $e^{-2}$ times intensity obtainable by the infinite sperture.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.3 no.4
• /
• pp.223-234
• /
• 1991

In this paper, the harbor tranquility problem is analysed by an improved boundary integral equation method. The effect of the diffracted wave transformation induced by the breakwater and structures located at a harbor mouth is considered. Partial reflection concept is also used to consider energy dissipation effects. The present model is verified by comparing the results of the model for rectangular and semi-circular harbors with the analytic solutions. they show a reasonable agreement. Also the wave height distribution of the HUPO harbor computed using the present model agree well to those from the previous hydraulic model tests. It also shows a good agreement with the results from the time-dependent mild slope equation model.