• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 하계학술대회 논문집 Vol.3 No.2
• /
• pp.743-745
• /
• 2002

Pyroelectric and dielectric properties of modified PZT thin film and bulk ceramics were studied. In case of bulk specimens were prepared by conventional ceramic process and thin films with same composition and (111) preferred orientation were prepared by the sol-gel process. Their crystal structure, pyroelectric and dielectric properties were investigated after poling at $150^{\circ}C$ for 30 min for bulk ceramics and no poling treatment, respectively. Dielectric constants and losses of bulk and thin film were 600, 875 and 0.028, 0.025, respectively. Pyroelectric coefficients obtained were $50nC/cm^2K$ and $30nC/cm^2K$, respectively.

• 한국세라믹학회지
• /
• 제31권8호
• /
• pp.841-848
• /
• 1994

The sintering behavior of La-modified PbTiO3 ceramics was investigated in order to improve the poor sinterability of PbTiO3. Addition of La improved the sinterability. It was confirmed that this improvement was due to the decrease in tetragonality ratio c/a of crystal lattice. The variations of dielectric constant and pyroelectric coefficient were measured with temperature. It was observed that with the increase of La content, Curie temperature decreased and dielectric constant at room temperature increased. La-modified PbTiO3 ceramics had smaller pyroelectric figure of merits than those of pyroelectric materials in use. The effects of grain size on dielectric and pyroelectric properties were also investigated. The change of grain size had effect on maximum dielectric constant and pyroelectric coefficient, but is had little effect on pyroelectric figure of merit at room temperature. The closer examination near ferro-paraelectric phase transition temperature revealed that the behavior of phase transition approached a more relaxor character with the increase of La content and the decrease of grain size.

• 한국세라믹학회지
• /
• 제33권8호
• /
• pp.863-870
• /
• 1996

Fabricated modified PZT system for pyroelectric IR sensor were analyzed and characterized for dielectric piezoelectric and pyroelectric properties. Particle size and distribution of source powders were controlled by attrition milling process. 0.05PSS+yPT+(0.95-y)PZ+0.4 wt%MnO2 system was fabricated and investigated sintering density crystal structure and micro-structure through sintering conditions sintering temperature and sintering atmosphere. The poled sintered system of y=0.11 showed the lowest dielectric constant. The dielectric constants were increased with increasing y-mole ratio. The pyroelectric properties of modified PZT systems which were assembled to TO-5 package were measured by IR measurement system average out-voltage of 0.05PSS+0.1PT+0.84PZ+ wt%MnO2 was 3V.

• 한국표면공학회지
• /
• 제36권5호
• /
• pp.413-417
• /
• 2003

The effect of 0-0.7 ㏖% addition of $Cr_2$$O_3$on the dielectric, pyroelectric, and piezoelectric properties were studied in the (Mg$0.7Pb_{1}$$3/Nb_{2}$3/)$O_3$-$0.3PbTiO_3$(0.7PMN-0.3PT) ceramics with composition near the morphotropic phase boundary. The dielectric constant and loss of the ceramics samples were measured as a function of temperature at various frequencies (0.1-100 KHz). The pyroelectric coefficient was measured by using the Byer-Roundy method as a function of temperature. Dielectric, pyroelectric, and piezoelectric constant achieved the maximum values of 0.4 ㏖% $Cr_2$$O_3$The transition temperature is continuously shifted to lower temperature with an increase of a small amount of $Cr_2$$O_3$.

• 한국세라믹학회지
• /
• 제35권7호
• /
• pp.679-684
• /
• 1998

Dielectricand pyroelectric properties of {{{{ { { {Ba }_{0.67 }Sr }_{0.33 } }`TiO_{3 } ^{ } }} (BST) thin plates and films were investigated. For BST thin plates maximum dielectric constant and pyrolelectric coefficient were observed at around 24$^{\circ}C$ and pyroelectric characteristics were improved as applied bias field was increased. When the electric field of 4kV/cm was applied to the thin plates sintered at 140$0^{\circ}C$ the pyroelectric coefficients over 4$\times$10-7C/{{{{ { cm}^{2 }K }} were obtained in the range of 0-4$0^{\circ}C$ BST thin films deposited using rf magnetron sputtering showed [001] preferred orientation at substrate temperatures above 50$0^{\circ}C$ On the contrary to the thin plates the dielectric constants of the thin films gradually increased above 15$^{\circ}C$ and decreased as applied bias field in-creased. The pyroelectric coefficients of thin films were lower than 1/10 those of thin plates.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 하계학술대회 논문집 Vol.3 No.2
• /
• pp.746-748
• /
• 2002

The effect of $MnO_2$ addition in $0.05Pb(Sn_{0.5}Sb_{0.5})O_3-0.8PbZrO_3-0.15PbTiO_3$(0.05PSS-0.8PZ-0.15PT) ceramics on crystal structure and electrical properties were studied. The sintering temperature and time were $1230^{\circ}C{\sim}1270^{\circ}C$ and 2hr, respectively. Then crystal structure, dielectric and pyroelectric properties were investigated. All the poled specimens showed the lower dielectric constant and $tan{\delta}$ than the unpoled specimens. Dielectric constant at 1kHz of the 0.05PSS-0.8PZ-0.15PT(MnO2 0.3wt%) system specimen sintered at $1250^{\circ}C$ for 2hr were 270 and showed the lowest $tan{\delta}$ of 0.2% after poling of $2kV_{DC}/mm$ at $150^{\circ}C$ for 30 minutes. Pyroelectric coefficient was maximum value of $50nC/cm^2K$ and Curie temperature was $224^{\circ}C$.

• 마이크로전자및패키징학회지
• /
• 제20권4호
• /
• pp.25-30
• /
• 2013

Pb-free ferroelectric $(Na_{0.5}Bi_{0.5})TiO_3$ (NBT) thin films were prepared by a modified sol-gel process. Their structural, dielectric and pyroelectric properties were investigated as a function of the excess Na/Bi ratio and the annealing temperature. In the case of thin films containing no excess Na and Bi, only partial amounts of the perovskite NBT were crystallized, where the films consisted mainly of the pyrochlore phase of $Bi_2Ti_2O_7$ for annealing conditions of $600{\sim}800^{\circ}C$. With increasing excess Na/Bi ratio, the proportion of the perovskite phase effectively increased due to the compensation of the volatile Na and Bi components. For a Na/Bi ratio of 2.0, the thin film with single NBT perovskite phase was obtained within XRD detection limit after annealing at $700^{\circ}C$ for 10 min and it showed the excellent dielectric properties, ${\varepsilon}r$ of ~550 and tan ${\delta}$ of 0.03. While these properties were degraded for Na/Bi ratio of 2.5 despite the existence of pure perovskite phase. The NBT thin film with Na/Bi ratio of 2.0 are also promising candidates for applications requiring pyroelectric devices because it was found to have pyroelectric coefficients of $1.3{\sim}7nC/cm^2K$ in the temperature range of $30{\sim}100^{\circ}C$.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1993년도 하계학술대회 논문집 B
• /
• pp.1119-1121
• /
• 1993

The PSN-PT-PZ ceramics doped with the Mn-oxide(0.5wt%) were fabricated by the mixed oxide method at 1250($^{\circ}C$) for 2(hr) and then the dielectric and pyroelectric properties were investigated with the compositions. In the 0.05PSN-0.4PT-0.55PZ specimen with 0.5(wt%) $MnO_2$, the pyroelectric coefficient was $6.6{\times}10^{-8}(C/Cm^2^{\circ}C)$, and the figure of merits for pyroelectric current and voltage were $27{\times}10^{-9},\;45{\times}10^{-12}$(C.Cm/J), respectibly.

• Applied Science and Convergence Technology
• /
• 제25권4호
• /
• pp.77-80
• /
• 2016

The $PbSc_{1/2}Nb_{1/2}O_3$ ceramics at a relatively low temperature of $1300^{\circ}C$ was successful synthesized. Solid state reaction of two-step process is not necessary. The dielectric constant, dielectric loss and admittance of ceramic samples were determined. The pyroelectric characteristics are in good agreement with the dielectric properties. Ferroelectric properties of well-formed the $PbSc_{1/2}Nb_{1/2}O_3$ ceramics are in agreement with broad distribution of relaxation phenomenon. Relatively strong frequency dependent of dielectric constant is observed at about $110^{\circ}C$. The distinct thermal hysteresis was observed in the measurement of the dielectric constant and dielectric loss. The critical exponents of during cooling and heating measurements in the $PbSc_{1/2}Nb_{1/2}O_3$ ceramics were 1.14 and 1.59 at 1 kHz, respectively.

• 한국세라믹학회지
• /
• 제26권6호
• /
• pp.755-762
• /
• 1989

A pyroelectric ceramic material based on Pb(Sn1/2Sb1/2)O3 modified PZT system is studied as a function of the amount of Pb(Sn1/2Sb1/2)O3 and PbTiO3. With increasing the Pb(Sn1/2Sb1/2)O3 amount the dielectric constant increases up to 10mol% and then decreases, but the pyroelectric coefficient decreases and as the PbTiO3 contents increase in the 10mol% added PZT system, the dielectric constant increases but the infrared sensitivity decreases. The good pyroelectric material has low dielectric constant and no pyrochlore phase, but does not depend in the amount of remanent dipole, and its composition sites around ferroelectric-to-antiferroelectric phase boundary.