• 한국전기전자재료학회논문지
• /
• 제36권3호
• /
• pp.280-285
• /
• 2023

A breakdown voltage and breakdown electric field of the transformer insulating oil of liquid dielectric were studied in uniform electric field and non-uniform electric field and the transformer insulating oil was observed by the process reached breakdown. Insulation performance evaluation of the liquid dielectric was evaluated at the electrode spacing of 2.5 mm under the conditions of domestic and international standards (KS C IEC 60156), so a comparative review was conducted at the electrode spacing of 2.5 mm. When the electrode spacing is 2.5 mm, the average breakdown voltage is 38.5 kV for sphere-sphere electrodes, 26.6 kV for plate-plate electrodes, 22.9 kV for needle-needle electrodes, and 24.3 kV for sphere-needle electrodes. 23.7 kV for the sphere-plate electrode, and 20.7 kV for the needle-plate electrode. From these results, it can be seen that the average value of the breakdown voltage at the electrode spacing of 2.5 mm, in ascending order, is sphere-sphere, plate-plate, sphere-needle, sphere-plate, needle-needle and needle-plate. It was found that the breakdown voltage of the unequal field was lower than that of the equal field.

• 한국대기환경학회지
• /
• 제24권6호
• /
• pp.641-648
• /
• 2008

A plate-type dielectric barrier discharge (DBD) reactor was designed and tested for removal of gaseous toluene. The DBD reactor consisted of 9 parallel plate electrodes, four of which were grounded. An AC voltage of rectangular waveform ($5{\sim}8.5kV$, $60{\sim}1,000Hz$), was applied to the other five electrodes. The gaseous toluene passed through the DBD reactor and its concentration was measured by a real-time gas analyzer. The carbon monoxide (CO) and carbon dioxide ($CO_2$) which were produced by decomposition of toluene in the DBD reactor, were sampled and analyzed by a micro gas chromatography. The maximum toluene removal efficiency was 51.4%.

• Transactions on Electrical and Electronic Materials
• /
• 제4권4호
• /
• pp.30-35
• /
• 2003

In this paper, the $CF_4$ decomposition efficiency is investigated for three simulated plasma reactors that are needle plate reactor, metal particle reactor, and dielectric barrier reactor with hole (DBH). The$CF_4$ decomposition efficiency by DBH is much better than that by needle plate reactor or metal particle reactor. When applied voltage is increased up to the critical voltage for spark formation in the all reactors, the $CF_4$ decomposition efficiency is increased. The $CF_4$ decomposition efficiency in needle plate reactor and metal particle reactor is about $12\%$ and $22\%$ respectively at applied voltage of 23 kV (consumption power: 110 W) and $CF_4$ concentration of 500 ppm, however, the $CF_4$ decomposition efficiency is more than $95\%$ in case of DBH. DBH should be much better than two reactors investigated for $CF_4$ decomposition.

• 한국도로학회논문집
• /
• 제11권1호
• /
• pp.95-104
• /
• 2009

본 연구는 아스팔트 콘크리트의 유전율과 공극률의 상관성을 평가하기 위해 수행되었다. 이를 위해 다양한 범위 $(0%{\sim}20%)$의 공극률을 갖는 아스팔트 콘크리트 시편을 제작하였고, 저주파 유전율 측정법인 parallel plate법을 사용하여 아스팔트 콘크리트 시편의 유전율을 측정하였다. 아스팔트 콘크리트 시편의 경우 주파수가 증가함에 따라 유전율은 감소하는 경향을 나타내었고, 사용한 아스팔트 바인더의 종류에 따라 그 감소폭이 다르게 나타났다. 또한 공극률 $0%{\sim}20%$ 사이에서 공극률이 증가함에 따라 유전율 값은 선형적으로 감소하는 경향을 보였다. 더불어 아스팔트 콘크리트 시편의 유전율에 대한 온도 및 함수량 영향을 보정하여 유전율에 따른 공극률의 상관식을 제시하였다. 본 연구를 통해 제시된 아스팔트 콘크리트의 유전율과 공극률의 상관식은 현재 국내외에서 사용하고 있는 유전율을 활용한 비파괴 밀도 측정장비의 보정모델로 활용 가능하며, 향후 국내에서 개발하고자 하는 아스팔트 포장 비파괴 밀도 측정장비의 기본적인 알고리즘으로 활용이 가능할 것이다.

• Smart Structures and Systems
• /
• 제16권6호
• /
• pp.1091-1105
• /
• 2015

Piezoelectric coefficient and dielectric constant of PZT-5H vary with electric field. In this work, variations of these coefficients with electric field are included in finite element modelling of a cantilevered plate instrumented with piezoelectric patches. Finite element model is reduced using modal truncation and then converted into state-space. First three modal displacements and velocities are estimated using Kalman observer. Negative first modal velocity feedback is used to control the vibrations of the smart plate. Three cases are considered v.i.z case 1: in which variation of piezoelectric coefficient and dielectric constant with electric field is not considered in finite element model and not considered in Kalman observer, case 2: in which variation of piezoelectric coefficient and dielectric constant with electric field is considered in finite element model and not considered in Kalman observer and case 3: in which variation of piezoelectric coefficient and dielectric constant with electric field is considered in finite element model as well as in Kalman observer. Simulation results show that appreciable amount of change would appear if variation of piezoelectric coefficient and dielectric constant with r.m.s. value of electric field is considered.

• 한국의학물리학회지:의학물리
• /
• 제15권2호
• /
• pp.105-111
• /
• 2004

본 연구에서는 의료용 선형가속기로부터 발생되는 명목상 가속전압 6 MV선의 검출특성을 확인하기 위하여 유전체 물질을 사용한 평행판 검출기를 제작하였다. 제작한 검출기의 전극은 단면이 크롬으로 코팅되어 있는 FEP유전체 필름(두께: 100 $\mu\textrm{m}$)을 사용하였고 두 전극 사이에 PTFE유전체 필름(두께 : 100 $\mu\textrm{m}$)을 삽입하였다. 측정을 위하여 선원-팬텀 표면간의 거리 100 cm, 그리고 팬텀의 표면으로부터 깊이 5 cm되는 지점에 방사선 유도전하를 획득하기 위한 제작검출기를 놓았다. 방사선 조사시 제작검출기의 유용성을 알아보기 위하여, 영점 변동, 누설 전류, 인가전압에 따른 검출기의 반응, 재현성, 선형성, 조직최대선량비 등을 측정하였다. 측정결과 검출기의 영점 변동 전류 (I$_{Z}$ )는 8.3 pA, 누설 전류(I$_{I}$)는 10 pA 이었다. 제작 검출기는 인가전압에 대한 선형성을 보였으며, 또한 재현성실험에서는 조사된 선량에 대하여 1% 오차 범위 내에서 일치하였다. 검출기의 선량에 대한 선형성은 3% 이내의 오차범위에서 일치하면서 선량율 의존성이 있음을 확인하였다. 조직최대선량비분포에 대한 제작 평행판 검출기와 비교검출기간의 선량오차는 팬텀내의 최대 선량점으로부터 7.5 cm까지 3% 이내에서 일치하였다. 본 연구결과 유전체 필름을 이용한 평행판 검출기는 선량계로서의 기본적인 특성들을 허용 가능한 범위에서 만족스러워 상대선량측정을 위한 검출기로 사용할 수 있음을 확인할 수 있었다.

• 전기학회논문지
• /
• 제56권3호
• /
• pp.583-587
• /
• 2007

Corona discharge and ozone generation characteristics of a slit dielectric barrier discharge type wire-plate plasma reactor with a third electrode have been investigated. When a third electrode is installed on a slit of the slit barrier, where an intense corona discharge occurs, it is found that a significantly increased ozone output could be obtained. This, however, indicates that the third electrode can activate the corona discharges both of the discharge wire and the slit of the slit barrier in the plasma reactor. As a result, a thin stainless wire, used as the third electrode has a strong effect to influence the corona discharge of the slit and corona wire, especially to the negative corona discharge. Higher amounts of the output ozone and ozone yield, about 1.27 and 1.29 times for the negative corona discharge, can be obtained with the third electrode, which reveals the effectiveness of the third electrode.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 제38회 하계학술대회
• /
• pp.1287-1288
• /
• 2007

The cross capacitor electrode system applied Thompson-Lampard theorem for precise and accurate measurement of dielectric constants is studied in this study. The capacitance derived from cross capacitor is calculated by the equation of ($C=\frac{{\epsilon}ln2}{\pi}{\cdot}$ effectivelength of electrode) which is very different from the equation of capacitance derived from parallel plate capacitor. From above mentioned reason, the capacitance measurement uncertainty of cross capacitor can be reduced then that of the parallel plate capacitor. the measurement dielectric constant measured by cross capacitor electrode method is one order more accurate and precise than that of 3-electrode method.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2003년도 하계학술대회 논문집 Vol.4 No.2
• /
• pp.1119-1122
• /
• 2003

In this paper, the electric field distribution in dielectric tube with one layer and spherical dielectric in water was simulated. The reactor was made up of the spherical dielectric that is diameter 2.5[mm], ${\epsilon}_r$ : 5, 100, 1000, 5000 respectively and one glass plate being 2[mm] thickness, ${\epsilon}_r$ : 5 as electrode. The discharge gap was 7[mm]. As a result of the simulation, in case of being about the same value between the dielectric constant of spherical dielectric and water, when the reactor was applied to high voltage dielectric polarization characteristic was trending toward disappearance. To get more strong electric field, the dielectric constant should be higher comparatively, Increasing the spherical dielectric constant, the location of equippotential line was shifting from the interior to the exterior.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2003년도 하계학술대회 논문집 Vol.4 No.2
• /
• pp.1143-1146
• /
• 2003

This paper was simulated the electric field distribution in dielectric tube with two layers and spherical dielectric in water. The reactor was made up of the spherical dielectric that is diameter : 2.5[mm], ${\epsilon}_r$ : 5, 25, 100, 1000, 5000 respectively and two glass plate being 2[mm] thickness, ${\epsilon}_r$ : 5 as electrode. The discharge gap was 9[mm]. As a result of the simulation, in case of being about the same value between the dielectric constant of spherical dielectric and water, when the reactor was applied to high voltage, dielectric polarization characteristic was trending toward disappearance. To get more strong electric field, the dielectric constant should be higher comparatively, Increasing the spherical dielectric constant, the location of equippotential line was shifting from the interior to the exterior.