• Transactions of the Korean Society of Automotive Engineers
• /
• v.5 no.3
• /
• pp.54-65
• /
• 1997

To quantify the LII signals from soot particle of flames in diesel engine cylinder, a new method has been proposed for correcting LII signal attenuated by soot particles between the measuring point and the detector. It has been verified by an experiment on a laminar jet ethylene-air diffusion flame. Being proportional to the attenuation, the ratio of LII signal at two different detection wavelengths can be used to correct the measured LIIsignal and obtain the unattenuated LII signal, from which the soot volume fraction in the flame can be estimated. Both the 1064-nm and frequency-doubled 532-nm beams from the Nd : YAG laser are used. Single-shot, one-dimensional(1-D) line images are recorded on the intensified CCD camera, with the rectangular-profile laser beam using 1-mm-diameter pinhole. Two broadband optical interference filters having the center wavelengths of 647 nm and 400 nm respectively and a bandwidth of 10 nm are used. This two-wavelength correction has been applied to the ethylene-air coannular laminar diffusion flame, previously studied on soot formation by the laser extinction method in this laboratory. The results by the LII measurement technique and the conventional laser extinction method at the height of 40 nm above the jet exit agreed well with each other except around outside of the peaks of soot concentration, where the soot concentration was relatively high and resulting attenuation of the LII signal was large. The radial profile shape of soot concentration was not changed a lot, but the absolute value of the soot volume fraction around outside edge changed from 4ppm to 6.5 ppm at r=2.8mm after correction. This means that the attenuation of LII signal was approximately 40% at this point, which is higher than the average attenuation rate of this flame, 10~15%.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.20 no.6
• /
• pp.76-82
• /
• 2016

Recently, environmental sustainability of the transitional explosives and propellants is an issue of growing importance in energetic materials. For examples, ammonium perchlorate(AP) as an solid propellants oxidizer could create a poisonous gas and atmospheric pollutions, such as HCl. Among the several oxidizers, hydrazinium nitroformate(HNF) is an effective candidate substance for eco-friendly oxidizer, which has high density, pressure index, and less smog generating property during combustion for the thrust control system. This study was controlled the size distribution and shapes through various conditions. Length and diameter ratio(L/D) of crystals has below 1 : 3, and the particle size was two types of $200{\mu}m$ and $50{\mu}m$.

• Membrane Journal
• /
• v.24 no.6
• /
• pp.438-447
• /
• 2014

The amorphous and porous borosilicate without any cracks was obtained under the following condition : 0.01~ 0.10 mole ratio of trimethylborate (TMB)/ tetraethylorthosilicate (TEOS) and the temperature of $700{\sim}800^{\circ}C$. According to the BET and SEM measurements, borosilicate heat-treated in between 700 and $800^{\circ}C$ showed the surface area of $251.12{\sim}355.62m^2/g$, the pore diameter of 3.5~4.9 nm, and the particle size of 30~60 nm. According to the TGA measurements, the thermal stability of poly[1-(trimethylsilyl)propyne](PTMSP) membrane was enhanced by inserting borosilicate. SEM observation showed that the size of dispersed borosilicate in the composite membrane was $1{\mu}m$. The results showed that the permeability of $H_2$ and $N_2$ increased and the selectivity of $H_2/N_2$ decreased upon the addition of borosilicate into PTMSP membranes. Addition of borosilicate may possibly increase the free volume, cavity and porosity of membranes indicating that permeation occurred by molecular sieving, surface and Knudsen diffusion rather than solution diffusion of gases.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.4
• /
• pp.639-650
• /
• 2000

The main object of this study was to investigate experimentally the characteristics of cyclone-bag filter with bottom inlet to decrease the high pressure drop which was one of main problems of fabric bag filter. The experiment was executed for the analysis of collection efficiency and pressure drop(specially, pressure drop of fabric filter) characteristics of the cyclone-bag filter in comparison with those of general fabric bag filter with various experimental parameters such as the inlet velocity, dust loading and variation of vortex region, etc. In the results, the tangential inlet type showed higher collection efficiency for submicron particles below $1{\mu}m$ in diameter than of center inlet, and over 99% for overall collection efficiency. For the inlet particle concentration $100mg/m^3$, pressure drop reduction ratios were shown as 15~38% with the inlet velocity in case of large bag, while 30~48% for small bag due to the increase of vortex region.

• Korean Chemical Engineering Research
• /
• v.53 no.6
• /
• pp.783-791
• /
• 2015

A fluidized-bed reactor with an inside diameter of 0.1 m and a height of 1.2 m was used to study the effect of steam and catalyst additions to air-blown biomass gasification on the production of producer gas. The equipment consisted of a fluidized bed reactor, a fuel supply system, a cyclone, a condenser, two receivers, steam generator and gas analyzer. Silica sand with a mean particle diameter of $380{\mu}m$ was used as a bed material and calcined dolomite ($356{\mu}m$), which is effective in tar reduction and producer gas purification, was used as the catalyst. Both of Korea wood pellet (KWP) and a pellet form of EFB (empty fruit bunch) which is the byproduct of Southeast Asia palm oil extraction were examined as biomass feeds. In all the experiments, the feeding rates were 50 g/min for EFB and 38 g/min for KWP, respectively at the reaction temperature of $800^{\circ}C$ and an ER (equivalence ratio) of 0.25. The mixing ratio (0~100 wt%) of catalyst was applied to the bed material. Air or an air-steam mixture was used as the injection gas. The SBR (steam to biomass ratio) was 0.3. The composition, tar content, and lower heating value of the generated producer gas were measured. The addition of calcined dolomite decreased tar content in the producer gas with maximum reduction of 67.3 wt%. The addition of calcined dolomite in the air gasification reduced lower heating value of the producer gas. However The addition of calcined dolomite in the air-steam gasification slightly increased its lower heating value.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.30 no.4
• /
• pp.652-659
• /
• 1997

For the effective utilization of the fish bone waste from seafood industry, the physical properties of the isolated hydroxyapatite from tuna bon have been investigated. On X-ray measurements, the chemical formula and phase of the bone calcined by various temperature were detected as $Ca_{10}\;(PO_4)_6\;(OH)_2$, and hydroxyapatite, respectively. It was shown that the chemical properties of apatite separated from tuna bone were controlled by Ca/P ratio. The mean agglomerate particle diameter was changed as a function of temperature. However, the particle shape has a geometrically non-regular types. These trends are consistent with SEM images. The composition of the glass-ceramic batch by calcined tuna bone was not perfectly agreed with the suggested data, but the partially substituted composition possibly shows the application of it as a bioceramic material.

• Korean Journal of Ichthyology
• /
• v.28 no.4
• /
• pp.239-248
• /
• 2016

The habitat, age and spawning characteristics of the Korean eastern spined loach, Iksookimia yongdokensis, were investigated to obtain baseline data for its ecological characteristics in the Chuksancheon (stream), Yeongdeok-gun, Gyeongsangbuk-do, Korea. The difference between the habitats of juveniles (0+) and 1~4 year old loaches was that juveniles mainly inhabited sandy bottoms (substratum particle size $0.6{\pm}1.44\;cm$) with very slow velocities of water current ($2.4{\pm}2.09\;cm/sec$) and low depths ($29.2{\pm}7.57\;cm$), whereas 1~4 year old loaches inhabited pebble and cobble bottoms (substratum particle size 5.5~6.1 cm) with relatively fast velocities of water current (3.8~4.6 cm/sec) and deep depths (50~70 cm). The age groups for I. yongdokensis (female) estimated by the frequency distribution of total length in the spawning season (July) indicated that the 35~64 mm is 1-year old, the 65~94 mm group is 2-year old, the 95~119 mm is 3-year old, and the 120~145 mm is more than 4-year old. The sex ratio (♂/♀) was 0.69, and females were 10~30 mm larger than males. The lamina circularis at the base of the pectoral fins in males, a secondary sexual characteristic, formed at the 13th month after hatching. The spawning season according to the gonadosomatic index (GSI) was June to July with water temperatures of $20{\sim}25^{\circ}C$. The average number of eggs was $2,292{\pm}618$, with a diameter of $1.46{\pm}0.02\;mm$ for mature eggs.

• Resources Recycling
• /
• v.19 no.6
• /
• pp.43-50
• /
• 2010

The crisis of energy gives rise to the growing concerns over continuing uncertainty in the energy market. Under these circumstances, there are also increasing interests on coals. In particular, Low Rank Coal (LRC) is receiving gradual attentions from green industry. But due to is high moisture content range from 30 - 60%, drying process has to be preceded before being utilized as power plant. In this study drying kinetics of LRC is induced by using a fixed-bed reactor. The drying kinetics was evaluated in from of the particle size, the inlet gas temperature, the drying time, the gas velocity, and the LID ratio. The consideration of the reynold's number was taken for correction of gas velocity, particle size and LID was taken for correction of reactor diameter, packing height of coal. As being seen as characteristic of drying coal, it can be found that fixed-bed reactor can contributed to active drying of free water. In this sense, it could be considered that phase boundary reaction is appropriate mechanism.

• Journal of the Korean Chemical Society
• /
• v.50 no.6
• /
• pp.464-470
• /
• 2006

the coricosteroid drug dexamethasone is an efficacious antiinflammatory drug, it is difficult to formulate in an injectable formulation due to its poor aqueous solubility. A lipid-based nanosphere formulation containing dexamethasone was designed for solubilization of the drug in aqueous solution and sustained release of the drug from the nanosphere. The lipid nanospheres, composed of phospholipid, cholesterol and cationic lipid, were prepared by self emulsification-solvent diffusion method followed by diafiltration. Physicochemical characteristics such as mean particle diameter, zeta potential and drug loading efficiency of the lipid nanospheres were investigated according to the variation of either the kind of lipid or the lipid composition. The lipid nanospheres had a mean diameter 80-120 nm and dexamethasone loading efficiency of greater than 80%. The drug loading efficiency increased with the increase of the length of aliphatic chain attached to the phospholipid. However, the drug loading efficiency was inversely proportional to the increase of cholesterol content in the lipid composition. The lipid nanosphere could not be prepared without the use of cationic lipid and the drug loading efficiency was proportional to the increase of cationic lipid content. The lipid nanospheres containing dexamethasone are a promising novel drug carrier for an injectable formulation of the poorly water-soluble drugs.

• Resources Recycling
• /
• v.12 no.5
• /
• pp.42-49
• /
• 2003

Characteristics of reduction and carbidization for hematite ore with a wide size range have been investigated at high temperature(590∼64$0^{\circ}C$) under $H_2$ and $H_2$-CO gas mixtures. The apparent activation energy for reduction of hematite ore with H2 gas was found to be 20 kJ/mol. The weight loss by reduction was about 28% md the weight gain by carbidization was about 5%. The measured values of weight change were compared with those calculated from equation (3) & (5) and fairly good agreement was obtained. The rate of carbidization was increased with an decrease in temperature, particle diameter and gas ratio($H_2$/ CO). The free carbon was increased with decrease in gas ratio($H_2$/ CO). The rate of carbidization was increased with mixing of $H_2$ gas but this effect was not proportional to fraction of $H_2$ gas. It was also found that the rate of carbidization was the maximum in the $H_2$ gas fraction of 0.5. It is considered that $H_2$ plays a part as a catalyst for formation of iron carbide($Fe_3$C).