• 대한공업교육학회지
• /
• 제37권2호
• /
• pp.161-179
• /
• 2012

이 연구의 목적은 중학교 창의적 체험활동을 위한 '에너지 교육' 수업 자료를 개발하는 데에 있다. 연구의 대상은 대구의 H 중학교 2학년 남학생 38명을 대상으로 하였다. 중학교 창의적 체험활동을 위한 '에너지 교육' 수업 자료 개발은 준비, 개발, 개선 단계의 세 단계로 이루어진다. 각 단계별 내용은 다음과 같다. 준비 단계는 수업 자료의 개발을 위해 에너지 교육 프로그램 및 관련 문헌을 연구하고 자료를 수집하였다. 개발 단계는 목표 설정, 학습지도안 설계, 수업 자료 제작, 평가 자료 개발의 구성 단계에 따라 수업 자료를 개발하였다. 개선 단계에서는 (1) 전문가에 의한 타당도 검증, (2) 학생들에 의한 예비 시험과 현장 시험을 실행하여 '에너지 교육' 수업 자료를 수정 보완하였다. 개발한 '에너지 교육' 수업 자료를 H중학교 창의적 체험활동 시간에 적용한 결과 학생들은 창의적 체험활동 시간에 '에너지 교육'을 하는 것에 대해 65% 이상의 학생이 긍정적인 대답을 하였다.

• 한국가축번식학회지
• /
• 제20권2호
• /
• pp.143-153
• /
• 1996

To improve the efficiency of nuclear transplantation in the rabbit, this study were evaluated the influence of celly cycle of donor nuclei on the in vitro developmental potential in the nuclear transplant embryos. The embryos of 16-cell stage were collected from the mated does at 48h post-hCG injection and they were synchronized to G1 phase of 32-cell stage. Synchronization of the cell cylce of blastomeres were induced, first, using an microtubules polymerization inhibitor, 0.5$\mu\textrm{g}$/ml colcemid for 10h to arrest blastomeres in metaphase, and secondly, using a DNA synthesis inhibitor, 0.1$\mu\textrm{g}$/ml aphidicolin for 1.5 to 2h to cleave to 32-cell stage and arrest them in G1 phase. The separated G1 phase blastomeres of 32-cell stage were injectied into enucleated recipient cytoplasms by micromanipulation. After culture until 20h post-hCG injection, the nuclear transplant oocytes were electrofused and activated by electrical stimulation. The nuclear transplant embryos were co-cultured for 120h. In vitro cultured embryos were monitored every 24h to assess for development rate. After in vitro cultue for 120h, the nuclear transplant embryos developed to blastocyst stage were stained with Hoechst 33342 dye for counting the number of blastomeres under a fluorescence microscopy. The cleavage rate of blastomeres from 16-cell stage stage rabbit embryos treated with colcemid for 10h or aphidicolin for 6h following colcemid for 10h were not significantly different. The electrofusion rate was similar by high in S and G1 phase donor nuclei as 80.6 and 79.1%, respectively. However, the nuclear transplant embryos using G1 phase donor nuclei were developed to blastocyst at high rate(60.3%) than those using S phase donor nuclei(26.0%). Moreover, the mean blastocyst stage were increased significantly(P<0.05) with the G1 phase donor nuclei(176.6 cells and 1.50 cycles), as compared with the S phase donor nuclei(136.6 cells and 1.42 cycles). These results show that the blastomeres of G1 phase were more successful as donor nuclei in the nuclear transplant procedure, compared with S phase.

• Educational Technology International
• /
• 제20권1호
• /
• pp.25-55
• /
• 2019

The core purpose of the study is to develop and validate an ADDIE model based instructional model for English Language Teaching (ELT) in early childhood classroom in Bangladesh as an aid to teachers to reconstruct their knowledge and experience more strategically, and for them to design and implement their instruction more structurally. This study is developmental in nature which has been divided in five phases as follows. Phase I: Existing methods and instructional strategy review, Phase II: Instructional model development, Phase III: Delphi 1st round, Phase IV: Delphi 2nd round and Phase V: Model validation. After reviewing relevant literature and existing strategy in phase I, the 1st version of instructional model is made phase II. Next in phase III and phase IV, two rounds of Delphi have been conducted where experts related to different concerning areas of this study reviewed the 1st version and gradually the final version of the instructional model is made. Finally, the instructional model for English teachers of early childhood classroom in Bangladesh got validated by the same Delphi panelists in Phase V. In respect with each phases of ADDIE, the instructional model elaborates the 1) representative key points, 2) instructors' activities prescribed for the instructors, 3) supporting strategies. Both the conceptual and procedural models are included in this study for clearer identification of the whole process. Lastly the study provides some recommendations for instructors and practitioners on choosing the instructional model like doing prior need analysis, incorporating teacher training programs, training students, keeping on researching for finding effective teaching technique and tools and being open to changes etc. In addition, the study also acknowledges its limitations like not being able to consider the psychological factors due to time limitation. Finally, at the end the study points out the areas that welcome further research.

• 센서학회지
• /
• 제17권4호
• /
• pp.289-294
• /
• 2008

The purpose of this study is to materialize the viscosity sensor by using the SH-SAW sensor of which the center frequency is operated at higher than 50 MHz. In order to measure the viscosity, SAW sensor of which the center frequency is operated at 100 MHz is developed. By using the developed sensor, phase shift, delay time, insertion loss, and frequency variation are measured at different viscosity. The result shows that the phase shift difference between the viscosity variations is such that the difference between the distilled water and the 100 % glycerol solution is approximately $45^{\circ}$, the change of the insertion loss is approximately 9 dB, and the difference of frequency variation is approximately 5.9 MHz. Therefore, it is shown that viscosity of unknown solution can be measured with the surface acoustic wave sensor.

• Reproductive and Developmental Biology
• /
• 제34권3호
• /
• pp.263-270
• /
• 2010

Luteal cells produce progesterone that supports pregnancy. Steroidogenesis requires coordination of the anabolic and catabolic pathways of lipid metabolism. In the present study, the corpus luteum (CL) in early pregnancy established from luteal phase and pregnant phase was analyzed. The first study determined progesterone changes in the bovine CL at day 19 (early maternal recognition period) and day 90 in mid-pregnancy and compared them to the CL from day 12 of the estrous cycle. CL alternation was tested using two-dimensional polyacrylamide gel electrophoresis (2-DE) and matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOF). Comparing CL from luteal phase to those from pregnant phase counterparts, significant changes in expression level were found in 23 proteins. Of these proteins 17 were not expressed in pregnant phase CL but expressed in luteal phase counterpart, whereas, the expression of the other 6 proteins was limited only in pregnant phase CL. Among these proteins, vimentin is considered to be involved in regulation of post-implantation development. In particular, vimentin may be used as marker for CL development during pregnancy because the expression level changed considerably in pregnant phase CL tissue compared with its luteal phase counterpart. Data from 2-DE suggest that protein expression was disorientated in mid pregnancy from luteal phase, but these changes was regulated with progression of pregnancy. These findings demonstrate CL development during mid-pregnancy from luteal phase and suggest that alternations of specific CL protein expression may be involved in maintenance of pregnancy.

• 전기학회논문지
• /
• 제64권1호
• /
• pp.182-187
• /
• 2015

In the three-phase power system, when any one-phase or two-phases is open-phase, the unbalanced current flows and the single-phase power supplies to three-phase loads. Specially, motor coil and transformer coil receive over-current. As a result, great damage as well as electrical fire can occur to the power system. In order to improve these problems, this paper proposes that an open-phase detection device is designed by a new algorithm using electric potential difference between the resultant voltage of neutral point and ground, and a control circuit topology of open-phase protector is composed of highly efficient semiconductor devices. It improves response speed and reliability. The control algorithm circuit also operates the cut-off of a conventional residual current protective device (RCD) which flows an enforced leakage current to ground wire at open-phase accident. Furthermore, time delay circuit is added to prevent the incapable operation of open-phase protector about instantaneous open-phase not open-phase fault. The time delay circuit improves more reliability.

• 한국전자파학회논문지
• /
• 제23권3호
• /
• pp.410-413
• /
• 2012

2차원 레이다 간섭계에서 표적의 공간 도달 각도를 추정하는 방법 중에서 1차원 알고리즘과 디지털 빔 포밍알고리즘, 위상차의 최소 자승 오차 알고리즘들의 각도 모호성 해소 성능을 비교한다. 위상 비교 모노 펄스 알고리즘의 경우, 2차원 레이다 간섭계에 적용하기 위해 방위각 방향과 고각 방향으로 각각 적용하였다. 성능 비교를 위해 Monte carlo 시뮬레이션 방법을 이용하여 2차원 레이다 간섭계에서 각도 추정 알고리즘 별 각도 모호성 해소 확률과 수행 시간을 비교하였다. 각도 모호성 해소 확률과 수행 시간을 고려할 때 위 여러 방법 중에서 위상 비교 모노 펄스 알고리즘이 실시간 신호 처리 분야에 가장 효율적임을 보여준다.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2010년도 춘계학술대회 논문집
• /
• pp.1059-1060
• /
• 2010

• 수산해양기술연구
• /
• 제41권2호
• /
• pp.107-112
• /
• 2005

In order to investigate influence of moon light to the fishing of Pacific saury stick-held dip net fishery in the northwestern Pacific Ocean, casting number, catch and CPUE were analyzed between the full moon and the new moon phases. Based on analyses of data taken from 8 vessels during 1992~2002, casting numbers at the full moon phase and the new moon phase were 110.3 and 121.0 times, respectively, and the first was lower than the latter by 8.8%. Catches of the full moon phase were higher than the new moon phase by 12.5% and CPUE expressed in ton/day and ton/haul were also higher by 31.5%, 26.1% respectively.

• 시스템엔지니어링학술지
• /
• 제14권2호
• /
• pp.41-48
• /
• 2018

This paper describes the systems engineering development process for the Departure from Nucleate Boiling Ratio (DNBR) algorithm using FPGA. Current Core Protection Calculator System (CPCS) requirement and DNBR logic are analyzed in the reverse engineering phase and the new FPGA based DNBR algorithm is designed in the re-engineering phase. FPGA based DNBR algorithm is developed by VHSIC Hardware Description Language (VHDL) in the implementation phase and VHDL DNBR software is verified in the software Verification & Validation phase. Test cases are developed to perform the software module test for VHDL software modules. The APR 1400 simulator is used to collect the inputs data in 100%, 75%, and 50% reactor power condition. Test input signals are injected to the software modules following test case tables and output signals are compared with the expected test value. Minimum DNBR value from developed DNBR algorithm is validated by KEPCO E&C CPCS development facility. This paper summarizes the process to develop the FPGA-based DNBR calculation algorithm using systems engineering approach.