• Proceedings of the KIEE Conference
• /
• 1998.07d
• /
• pp.1261-1263
• /
• 1998

In this paper, we obtained that the monodomain alignment of nematic liquid crystal (NLC) increases with increasing irradiation time with linearly polarized ultraviolet (LPUV) light irradiation on polyimide (PI) surfaces. It was found that the monodomain alignment of NLC is obtained in a cell with normally LPUV light irradiated on PI surface at 30 min. and then oblique LPUV is secondly irradiated on PI surfaces rotated by $90^{\circ}$. The pretilt angle of NLC is generated about $2.5^{\circ}$ with oblique angle of $60^{\circ}$ and then decreased with increasing the oblique angle of IN light irradiation. It is considered that the pretilt angle of NLC is attributed to the photo-depolymerization of polymer with the oblique angle of UV light. The voltage-transmittance and response time characteristics of photo-aligned twisted nematic (TN)-LCD with UV light irradiation time of 60 min. were almost same in comparison with rubbing treated TN-LCD.

• Fashion & Textile Research Journal
• /
• v.5 no.5
• /
• pp.529-538
• /
• 2003

Chitosan should be satisfied a certain Mw range for the final application, Low molecular weight chitosan(LMWC) can be acquired by depolymerizing high molecular weight starting chitosan. Using $H_2O_2$ in depolymerizing chitosan is very effective and reproducible in controlling Mw of resulting LMWC. However, $H_2O_2$ can break glycoside linkage of chitosan and oxidize some $-NH_2$ groups in chitosan. It has been reported that decrease in DA(degree of deacetylation) of LMWC prepared by $H_2O_2$. However, any quantitative data of decrease in DA has not been reported yet. In this study, DA of initial chitosan and DA of $H_2O_2$ treated chitosan were measured and the change in DA of chitosan upon $H_2O_2$ treatment were investigated. Change in DA was very different upon $H_2O_2$ treatment condition. LMWC also showed DA change upon time passage. Pre-swelling treatment of initial chitosan and low ratio of $H_2O_2$/chitosan prevented a decrease in DA significantly. Yellowing of LMWC was detected upon time passage, however, decrease in DA was minimal (around 1%).

• Archives of Pharmacal Research
• /
• v.21 no.2
• /
• pp.179-186
• /
• 1998

Dextran-5-aminosalicylic acid ester (dextran-5-ASA) was synthesized as a colon-specific prodrug of 5-aminosalicylic acid (5-ASA) which is active against inflammatory bowel diseases. Chemical stability of dextran-5-ASA in the bath of pH 1.2 or 6.8 was investigated at $37^{\circ}C$ for 6 hrs, and 5-ASA was not released on such conditions. Depolymerization (%) of dextran-5-ASA by dextranase with the degree of substitution (DS) of 18, 23, or 30 was 92, 62 or 45 in 8 hrs respectively, but was not affected by the MW of dextran (9,000, 40,600, 80,200 or 580,000). Distribution of 5-ASA in dextran, determined by gel filtration chromatography, appeared to be relatively uniform. Incubation of dextran-5-ASA (DS 18) in cecal contents of rats released 20% (28 g) and 35% (49 g) of 5-ASA in 8 hrs and 24 hrs, respectively, but no 5-ASA was liberated from small intestinal contents.

• Korean Journal of Food Science and Technology
• /
• v.9 no.3
• /
• pp.194-198
• /
• 1977

A seaweed Ecklonia cava from Jeju island was irradiated with $0.1{\sim}6\;Mrad$ of gamma-rays and the yield and viscosity characteristics of alginates from it were examined. Irradiation below 1 Mrad dose brought about a 70% increase in the yield while higher doses caused slight decreases. Viscosity behavior of alginates below 0.5 Mrad dose was not altered while the viscosity decreased markedly above 1 Mrad dose, likely due to the depolymerization.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.11a
• /
• pp.537-540
• /
• 1999

Effect of alignment layers on pretilt angle generation and electrical characteristics in nematic liquid crystal(NLC) by using photo-alignment techniques on polyimide (PI) surface with side chain were studied. The generated pretilt angle of the NLC on rubbed PI surface with 1-layer is almost the same as that of the 2-layers. However, the generated pretilt angle of the NLC on photo-induced PI surface with 2-layers is larger than that of the 1-layer. Therefore, the pretilt angle of the NLC on photo-induced PI surface is attributed to surface roughness due to photo-depolymerization of the polymer with UV light irradiation on PI surface. Next we observed the same characteristics of voltage-transmittance (V-T) and response time for 1- and 2-layers on PI surface. We also observed the same voltage holding ratio (VHR) characteristics for 1- and 2-layers on photo-aligned PI surface. Consequently, we suggest that the VHR of photo-aligned TN-LCD is higher than that of the rubbing-aligned TN-LCD.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.7
• /
• pp.636-641
• /
• 2000

The purpose of this study is assessing the characteristics of surface aging and recovery of hydrophobicity for silicone rubber which takes a great interest as outdoor insulation recently subjected to the combined stressed of salt fog and AC power. The methods for assessing are contact angle ATR-FRIR, AFM and XRD. In addition salt fog method is adopted as the artificial contamination experiment and AC power is applied 24 hour on and 24 hour off repeatedly for 5 cycles. The results suggest that degraded surface was more rough than virgin but was restored water repellency through the off cycle. It was due to not only the formation of fractal surface but also maintenance of hydrophobic surface by diffusion of low molecular oil. Although surface recovers initial hydropohbicity there are possibilities of decreasing electrical performance due to irreversable changes such as depolymerization of surface and loss of filler particles. This fact is confirmed by surface conductivity measurement showing that the degradation is significant and the recovery of hydrophobicity is imperfect as the energized cycle increases.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.05b
• /
• pp.7-10
• /
• 2004

This paper presents the electrical properties of PTFE nozzle for a electrical apparatus. In the arcing environment in a electrical apparatus, radiation is considered to be the major energy transport mechanism from the arc to the wall. The fraction of the radiation power is emitted out of the arc and reaches the nozzle wall, causing ablation at the surface and in the depth of the wall. The energy concentration in the material leads to the depolymerization and eventually leads to the generation of decomposed gas as well as some isolated carbon particles. Adding some fillers into PTFE is expected to be efficient for improving the endurability against radiation. In this experiment, three kinds of fillers that have endurance in the high temperature environment were added into PTFE. Light reflectance of fillers was investigated. Dielectric constan and dissipation factor of PTFE composites were investigated. Dielectric constant and dissipation factor of the PTFE composites increased with increasing contents of the fillers.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.62 no.4
• /
• pp.223-226
• /
• 2013

In this study, we investigated the electro-optical(EO) characteristic of fringe-field switching(FFS) mode cell by the two kinds of ultraviolet(UV) alignment method on the organic thin film(polyimide: PI). The suitable organic layersfor FFS cell and the aligning capabilities of nematic liquid crystal(NLC) using the in-situ photoalignment method were studied Disclination is observed after conventional photoalignment method for 1h, and in-situ photoalignment method for 1h. Monodomain alignment of the NLC can be observed via in-situ photoalignment method for 2h and 3h. It is considered that NLC alignment is due to photo-depolymerization of the polymer with oblique non-polarized UV irradiation on PI surface. An unstable V-T curve of UV-aligned FFS-LCD with conventional photoalignment method can be achieved. However, a stable V-T curve of UV-aligned FFS-LCD with in-situ photoalignment method(1h), and V-T curve of UV-aligned FFS-LCD with in-situphotoalignment method was much stable comparing with that of other UV-aligned FFS-LCD's. As a result, more stable EO performanceof UV-aligned FFS-LCD with in-situphotoalignment method for 3h is obtained than that of the other UV-aligned FFS-LCD's.

• Resources Recycling
• /
• v.23 no.4
• /
• pp.3-11
• /
• 2014

Large scale generation of plastic waste has generated considerable interest it seeking innovative solutions to waste recycling and reuse. Plastic solid waste(PSW) treatment and recycling processes could be allocated to four major categories, re-extrusion(primary), mechanical recycling(secondary), chemical recycling(tertiary) and energy recovery(quaternary). This review considers the various aspects of the PSW recycling such as recycling methods of PSW, special problems about some proposed process, separation techniques, and recycling of mixed PSW.

• Journal of Plant Biology
• /
• v.39 no.4
• /
• pp.287-293
• /
• 1996

The effect of taxol and ethyl-N-phenylcarbamate (EPC) on the growth and gravitropism of maize roots and coleoptiles was studied. Taxol is known to promote the assembly of microtubules (MTs) and stabilizes MTs by preventing depolymerization. EPC, on the contrary, is an anti-microtubule drug that promotes disassembly of MTs. Taxol, at 1 $\mu$M, inhibited gravitropic response of maize roots to about 40%, but did not inhibit growth; at 10 $\mu$M, it inhibited the gravitropic response of coleoptile segments of maize by approximately 50%, but did not inhibit growth, while 0.5 mM EPC inhibited both the gravitropic response and growth of maize roots by approximately 50%. Taxol, which inhibited the gravitropic response of maize roots and coleoptile segments, had no effect on either the polar or the bilateral transport of auxin. These results indicated that MT polymerization could not occur normally with taxol or EPC, so that if there was any abnormal rearrangement of MT, the gravitropic response was inhibited, which resulted from the inhibition of neither growth nor auxin transport. This results suggested that gravitropic response was related to the MT arrangement, and that both straight growth and the differential growth in gravitropic response could be regulated by different mechanisms.