• Nuclear Engineering and Technology
• /
• v.31 no.1
• /
• pp.17-28
• /
• 1999

A thermal-hydraulic analysis is conducted on the loss-of-coolant-accident (LOCA) during shutdown operation of YGN Units 3/4. Based on the review of plant-specific characteristics of YGN Units 3/4 in design and operation, a set of analysis cases is determined, and predicted by the RELAP5/MOD3.2 code during LOCA in the hot-standby mode. The evaluated thermal-hydraulic phenomena are blowdown, break flow, inventory distribution, natural circulation, and core thermal response. The difference in thermal-hydraulic behavior of LOCA at shutolown condition from that of LOCA at full power is identified as depressurization rate, the delay in peak natural circulation timing and the loop seal clearing (LSC) timing. In addition, the effect of high pressure safety injection (HPSI) on plant response is also evaluated. The break spectrum analysis shows that the critical break size can be between 1% to 2% of cold leg area, and that the available operator action time for the Sl actuation and the margin in the peak clad temperature (PCT) could be reduced when considering uncertainties of the present RELAP5 calculation.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.7 no.2
• /
• pp.44-53
• /
• 2003

A vertical hot-firing test facility was established to carry out the IPPT(Integrated Propulsion Performance Test) and SQT(Stage Qualification Test) of KSR-III(Korea Sounding Rocket-III). The components for actual launcher were mostly used, hence these tests were carried out under the condition of relatively lower safety margin. To perform hot-firing tests with the maximum safety, an engine emergency blockage system was investigated and applied. An emergency blockage system using combustion chamber pressures and acceleration signals was set up to monitor ignition delay and fail, flame out, propellant feeding status, unstable combustion and excessive structural vibration. With such a system, the test safety could be secured by rapid judgement and follow-up measures, which made IPPT and SQT be safely completed.

• Journal of Power Electronics
• /
• v.13 no.3
• /
• pp.349-361
• /
• 2013

As a result of the advantages such as high efficiency, continuous current and high stability margin, push-pull converter with continuous current (PPCWCC) is competitive for battery discharge regulator (BDR) which plays an important role in power conditioning unit (PCU). Leakage inductance yields current spike in low-ripple current of PPCWCCs. The operating modes are added due to leakage inductance. Therefore the steady state performance is affected, which is embodied in the spike of low-ripple current. PPCWCCs which are suitable for BDR can be separated into three types by current spike characteristics. Three representative topologies IIs1, IIcb2 and Is3 are analyzed in order to investigate the factors on the magnitude and duration of spike. Equivalent current sampling method (ECSM) which eliminates the sampling time delay and achieves excellent dynamic performance is adopted to prevent the spike disturbance on current sampling. However, ECSM reduces the sampling accuracy and telemetry accuracy due to neglecting the spike. In this paper, ECSM used in PPCWCCs is summarized. The current sampling error is analyzed in quality and quantity, which provides the foundation for offsetting and enhancing the telemetry accuracy. Finally, current sampling error rate of three topologies is compared by experiment results, which verify the theoretical analysis.

• Korean Journal of Applied Biomechanics
• /
• v.31 no.1
• /
• pp.37-43
• /
• 2021

Objective: The purpose of this study was to investigate the effect of mobile phone text messaging on the collision avoidance strategy for an approaching and stationary pedestrian. Method: Eighteen healthy young adults participated in this study. Each participant was asked to perform a task to walking with/without mobile phone text messaging and a task to avoid collisions with another pedestrian who was approaching or stationary during walking. Results: When text messaging with avoidance collision, it showed an early onset time, a larger mediolateral COM trajectory, trunk rotation angle and trunk rotation velocity (p<.05). Also, compared to an approaching pedestrian, when avoiding collision with a stationary pedestrian, it showed a later onset time, a lager avoidance displacement, mediolateral COM trajectory, trunk rotation angle (p<.05). Conclusion: Results suggest that mobile phone text messaging while collision avoidance leads to delay the perception stage and alters the adaptation stage. Consequently, pedestrian executed in an exaggerated avoidance action to create a greater safety margin when attending to mobile phone test messages while avoiding another pedestrian.

• Investigative Magnetic Resonance Imaging
• /
• v.1 no.1
• /
• pp.130-134
• /
• 1997

Purpose: To analyze contrast-enhancement pattern of stomach cancer on dynamic MRI and to verify the efficacy of intravenous contrast agent in the evaluation of stomach cancer. Materials and Methods: Twelve patients with proven stomach cancer underwent dynamic MRI. By using l.OT scanner, we obtained precontrast FLASH images, and 30, 60, 90 second delay FLASH images after intravenous contrast injection. All patients ingested one liter of water and had intramuscular injection of Buscopan just before MR study. For quantitative analysis we measured signal to noise ratio (SiN) of stomach cancer on each image, and signal difference to noise ratio (SD/N) between cancer and intraluminal fluid, cancer and the pancreas. For qualitative analysis two radiologists evaluated lesion conspicuity on each image by grading system(grade 0, 1, 2, 3: poor, fair, good, excellent). Results: SiN of stomach cancer increased gradually by time(precontrast, 30, 60, 90 second delay: 38.7, 42.5, 57.4, 65.7). SD/N between cancer and intraluminal fluid significantly increased after contrast enhancement(l.24, 25.01, 39.30, 45.89). SD/Ns between cancer and the pancreas were 10.5, 9.33, 9.99, 10.66, respectively. In qualitative analysis, precontrast images were better than postcontrast images for delineation of stomach cancer. Postcontrast images showed clear endo-Iuminal side of stomach cancer, but outer margin of stomach cancer was more distinct on precontrast images. Conclusion: Precontrast MR images are better than postcontrast MR images in the depiction of stomach cancer. Intravenous contrast agent is not imperative in the evaluation of stomach cancer.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.26 no.12A
• /
• pp.2000-2011
• /
• 2001

In this Paper, we convert conventional low speed(1x, 6x) DVD systems designed by analog PLL(Phase Locked Loop) into digital PLL to operate at high speed systems flexibly, and present optimal DPLL model in high speed(20x) DVD systems. Especially, we focused on the design of DPLL that can overcome channel effects such as bulk delay, sampling clock frequency offset and asymmetry phenomenon in high speed DVD systems. First, the modified Early-Late timing error detector as digital timing recovery scheme is proposed. And the four-sampled compensation algorithm using zero crossing point as asymmetry compensator is designed to achieve high speed operation and strong reliability. We show that the proposed timing recovery algorithm provides enhanced performances in jitter valiance and SNR margin by 4 times and 3dB respectively. Also, the new four-sampled zero crossing asymmetry compensation algorithm provides 34% improvement of jitter performance, 50% reduction of compensation time and 2.0dB gain of SNR compared with other algorithms. Finally, the proposed systems combined with asymmetry compensator and DPLL are shown to provide improved performance of about 0.4dB, 2dB over the existing schemes by BER evaluation.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.10
• /
• pp.39-50
• /
• 1998

Wide-band sharp-transition filters are widely used in applications such as wireless CODEC design or medical systems. Since these filters suffer from large sensitivity and roundoff noise, large word-length is required for the VLSI implementation, which increases the hardware size and the power consumption of the chip. In this paper, a low-power implementation technique for digital filters with wide-band sharp-transition characteristics is proposed using CPL (Complementary Pass-Transistor Logic), LWDF (Lattice Wave Digital Filter) and a modified DIFIR (Decomposed & Interpolated FIR) algorithm. To reduce the short-circuit current component in CPL circuits due to threshold voltage reduction through the pass transistor, three different approaches can be used: cross-coupled PMOS latch, PMOS body biasing and weak PMOS latch. Of the three, the cross-coupled PMOS latch approach is the most realistic solution when the noise margin as well as the energy-delay product is considered. To optimize CPL transistor size with insight, the empirical formulas for the delay and energy consumption in the basic structure of CPL circuits were derived from the simulation results. In addition, the filter coefficients are encoded using CSD (Canonic Signed Digit) format and optimized by a coefficient quantization program. The hardware cost is minimized further by a modified DIFIR algorithm. Simulation result shows that the proposed method can achieve about 38% reductions in power consumption compared with the conventional method.

• Journal of the Korean Academy of Esthetic Dentistry
• /
• v.26 no.1
• /
• pp.17-23
• /
• 2017

Purpose: This retrospective study is to evaluate whether the timing of implant placement and the result of esthetic outcomes are related. Materials and Methods: Among the patients who had undergone single implant surgery on anterior area from 2010 to 2013 in Veterans Health Service Medical Center, 34 implants in 27 patients (24 male and 3 female) were selected and categorized into 3 groups according to the timing of placement, which are group D (Delay), group E (Early) and group I (Immediate). Aesthetic indices used included the Pink Esthetic Score (PES). It has 7 variables scores, such as mesial papilla, distal papilla, a level of soft-tissue margin, soft-tissue contour, alveolar process, soft-tissue color, and soft-tissue texture. Each variable ranges from 0 to 2, therefore total 14 points are highest. All patients were received by regular follow-up at least 1-year. One examiner measured PES on the intraoral photos. Each patient was considered as a statistical unit for statistical analysis. Statistical analyses were performed using a commercially available statistical software (SPSS Statistics 21.0, IBM Corp., Armonk, NY, USA). Kruskal-Wallis test was used for inter-group comparisons. Statistical significance was set at P<0.05. Result: Mean score in Group D, Group I, and Group E were $11.5{\pm}1.5$, $11.4{\pm}1.8$, and $11.3{\pm}1.8$ respectively. In Kruskal-Wallis test, there are no differences (P=0.989). Conclusion: In this limited study suggests that clinical aesthetic results can be achieved with all treatment protocols. Finally, various factors can be considered to produce the esthetic results.

• Korean Journal of Radiology
• /
• v.2 no.3
• /
• pp.138-144
• /
• 2001

Objective: Bronchogenic carcinoma can mimic or be masked by pulmonary tuberculosis (TB), and the aim of this study was to describe the radiologic findings and clinical significance of bronchogenic carcinoma and pulmonary TB which coexist in the same lobe. Materials and Methods: The findings of 51 patients (48 males and three females, aged 48-79 years) in whom pulmonary TB and bronchogenic carcinoma coexisted in the same lobe were analyzed. The morphologic characteristics of a tumor, such as its diameter and margin, the presence of calcification or cavitation, and mediastinal lymphadenopathy, as seen at CT, were retrospectively assessed, and the clinical stage of the lung cancer was also determined. Using the serial chest radiographs available for 21 patients, the possible causes of delay in the diagnosis of lung cancer were analyzed. Results: Lung cancers with coexisting pulmonary TB were located predominantly in the upper lobes (82.4%). The mean diameter of the mass was 5.3 cm, and most tumors (n=42, 82.4%) had a lobulated border. Calcification within the tumor was seen in 20 patients (39.2%), and cavitation in five (9.8%). Forty-two (82.4%) had mediastinal lymphadenopathy, and more than half the tumors (60.8%) were at an advanced stage [IIIB (n=11) or IV (n=20)]. The average delay in diagnosing lung cancer was 11.7 (range, 1-24) months, and the causes of this were failure to observe new nodules masked by coexisting stable TB lesions (n=8), misinterpretation of new lesions as aggravation of TB (n=5), misinterpretation of lung cancer as tuberculoma at initial radiography (n=4), masking of the nodule by an active TB lesion (n=3), and subtleness of the lesion (n=1). Conclusion: Most cancers concurrent with TB are large, lobulated masses with mediastinal lymphadenopathy, indicating that the morphologic characteristics of lung cancer with coexisting pulmonary TB are similar to those of lung cancer without TB. The diagnosis of lung cancer is delayed mainly because of masking by a tuberculous lesion, and this suggests that in patients in whom a predominant or growing nodule is present and who show little improvement of symptoms despite antituberculous or other medical therapy, coexisting cancer should be suspected.

• Journal of Information Technology Services
• /
• v.18 no.5
• /
• pp.209-224
• /
• 2019

When evaluating the performance of a NPD(New Product Development) project, it is common to evaluate the project performance according to the achievement of the planned goal in terms of time, quality and cost management, which are usually three main constraints of the project. The evaluation of the financial factors by which sales contributed to the return of the company is more influential. This is why companies need to increase sales and raise profits. Therefore, it is more reasonable to evaluate the sales performance of NPD projects over a certain period of time against the input costs. At this time, we can analyze the causes of inefficient projects and compare them with other projects and find out how to improve the sales performance to help the company increase its competitiveness. In this paper, we analyze the relative efficiency of the sales performance on the input of the projects by using the actual sales in the period of one year after mass production of the NPD projects of 'S' company in ICT industry. Input factors include developer resource and development cost for the NPD reported after the project has been completed, the delay weeks for the schedule targeted at the project planning stage, and the number of quality issues due to development design faults during initial mass-production. The sales figure and the contribution margin of the product after one year from the start of mass production are defined as the output factors. In this paper, we analyze the efficiency of the projects by using data envelope analysis (DEA). As a result, we found out the reason of the inefficient project of DMUs according to the differences in the characteristics of the efficient and inefficient B2B markets based on the result of DEA of NPD projects. Thus, the goal of this paper is to identify strategies for improving sales performance of NPD projects in inefficient markets.