• Nuclear Engineering and Technology
• /
• 제36권3호
• /
• pp.237-247
• /
• 2004

To investigate the applicability of automated ball indentation (ABI) tests in the evaluation of the tensile properties of cast stainless steel (CSS), ABI tests were performed on four types of unaged CSS and on 316 stainless steel, all of which had a different microstructure and strength. The reliability of ABI test data was analyzed by evaluating the data scattering of the ABI test and by comparing tensile properties obtained from the ABI test and the tensile test. The results show that the degree of scattering of the ABI test data is reasonably acceptable in comparison with that of standard tensile data, when two points data that exhibit out-of-trend are excluded from five to seven points data tested on a specimen. In addition, the scattering decreases slightly as the content of ${\delta}-ferrite$ in CSS increases. Moreover, the ABI test can directly measure the flow parameters of CSS with error bounds of about ${\pm}10\%$ for the ultimate tensile stress and the strength coefficient, and about ${\pm}15\%$ for the yield stress and the strain hardening exponent. The accuracy of the ABI test data is independent of the amount of ${\delta}-ferrite$ in the CSS.

• 전자공학회논문지A
• /
• 제31A권8호
• /
• pp.34-45
• /
• 1994

We studied threshold voltages and I-V characteristics. considering short channel effect of the fully depleted thin film n-channel SOI MOSFET. We presented a charge sharing model when the back surface of short channel shows accumulation depletion and inversion state respectively. A degree of charge sharing can be compared according to each of back-surface conditions. Mobility is not assumed as constant and besides bulk mobility both the mobility defined by acoustic phonon scattering and the mobility by surface roughness scattering are taken into consideration. I-V characteristics is then implemented by the mobility including vertical and parallel electric field. kThe validity of the model is proved with the 2-dimensional device simulation (MEDICI) and experimental results. The threshold voltage and charge sharing region controlled by source or drain reduced with increasing back gate voltage. The mobility is dependent upon scattering effect and electric field. so it has a strong influence on I-V characteristics.

• 한국광학회지
• /
• 제25권1호
• /
• pp.1-7
• /
• 2014

구름에서의 다중산란 효과는 Mie 산란현상을 이용하는 탄성산란 라이다에서 그 해를 구하는데 있어서, 매우 중요한 오차요인으로 작용하기 때문에 이 효과를 보정하는 것은 그 자체만으로도 매우 중요하다. 이를 위하여 구름에서 다중산란되는 현상을 Monte Carlo 방법으로 계산하였으며, 이 결과를 적용하여 물방울 구름의 총량과 유효입자크기를 추출하는 방법을 제안하였다. 구름의 유효입자 크기가 $2.5{\mu}m$ 이하일 경우엔 355 nm나 1064 nm에서 얻은 두 파장의 소광계수로 쉽게 그 값들을 구할 수 있음을 알 수 있었다. 크기가 큰 경우엔 라이다 신호의 안정화된 선형편광도가 유효입자크기, 총량, 그리고 소광계수와 관련이 있음을 알 수 있었으며, 이 관계를 통하여 큰 입자의 경우에도 라만 라이다와 편광 라이다를 이용한다면 유효입자크기와 총량을 구할 수 있다는 것을 알 수 있었다.

• 한국지진공학회논문집
• /
• 제26권6호
• /
• pp.237-246
• /
• 2022

Based on the random-vibration-theory methodology, dynamic responses of nuclear facilities subjected to obliquely incidental and incoherent earthquake ground motions are calculated. The spectral power density functions of the 6-degree-of-freedom motions of a rigid foundation due to the incoherent ground motions are obtained with the local wave scattering and wave passage effects taken into consideration. The spectral power density function for the pseudo-acceleration of equipment installed on a structural floor is derived. The spectral acceleration of the equipment or the in-structure response spectrum is then estimated using the peak factors of random vibration. The approach is applied to nuclear power plant structures installed on half-spaces, and the reduction of high-frequency earthquake responses due to obliquely incident incoherent earthquake ground motions is examined. The influences of local wave scattering and wave passage effects are investigated for three half-spaces with different shear-wave velocities. When the shear-wave velocity is sufficiently large like hard rock, the local wave scattering significantly affects the reduction of the earthquake responses. In the cases of rock or soft rock, the earthquake responses of structures are further affected by the incident angles of seismic waves or the wave passage effects.

• Journal of Radiation Protection and Research
• /
• 제41권2호
• /
• pp.111-115
• /
• 2016

Background: The scattered photons cause reduction of the contrast of radiographic image and it results in the degradation of the quality of the image. In order to acquire better quality image, an anti-scattering x-ray gird should be equipped in radiography system. Materials and Methods: The X-ray anti-scattering grid of the inclined type based on the hybrid concept for that of parallel and focused type was tested by MCNP code. The MCNPX 2.7.0 was used for the simulation based test. The geometry for the test was based on the IEC 60627 which was an international standard for diagnostic X-ray imaging equipment-Characteristics of general purpose and mammographic anti-scatter grids. Results and Discussion: The performance of grids with four inclined shielding material types was compared with that of the parallel type. The grid with completely tapered type the best performance where there were little performance difference according to the degree of inclination. Conclusion: It was shown that the grid of inclined type had better performance than that of parallel one.

• 한국원자력학회:학술대회논문집
• /
• 한국원자력학회 2004년도 요약집 춘계학술발표대회
• /
• pp.391-391
• /
• 2004

• East Asian mathematical journal
• /
• 제39권2호
• /
• pp.141-166
• /
• 2023

The purpose of this study is to confirm the MKT(Mathematical Knowledge for Teaching) of the in-service mathematics teachers on the statistics(Representative value, Degree of scattering) through the comparative analysis between the sub-elements of the MKT. In addition, it is to examine the factors that cause the difference of the subjects' MKT. To accomplish this, by the subject of 12 secondary in-service mathematics teachers, in this study the test items of the MKT on the statistics were developed and data were collected and analyzed. As a result of the analysis of the MKT test sheet, the CCK(Common Content Knowledge) and SCK(Specialized Content Knowledge) of the mathematics teacher was confirmed as a high score, whereas the and KCS(Knowledge of Content and Students) and KCT(Knowldge of Curriculum and teaching) were confirmed as low scores. In addition, through these results, it was shown that the difference in MKT's elements the middle school and high school teachers obtain occurred slightly.

• Journal of Magnetics
• /
• 제19권4호
• /
• pp.333-339
• /
• 2014

Single crystal growth of $BaFe_{12}O_{19}$ by the solid state crystal growth method was attempted. Seed crystals of ${\alpha}-Fe_2O_3$ were pressed into pellets of $BaFe_{12}O_{19}$ + 2 wt% $BaCO_3$ and heat-treated at temperatures between $1150^{\circ}C$ and $1250^{\circ}C$ for up to 100 hours. Instead of single crystal growth taking place on the seed crystal, BaO diffused into the seed crystal and reacted with it to form a polycrystalline reaction layer of $BaFe_{12}O_{19}$. The microstructure, chemical composition and structure of the reaction layer were studied using scanning electron microscopy-energy dispersive spectroscopy (SEM-EDS), x-ray Diffraction (XRD) and micro-Raman scattering and confirmed to be that of $BaFe_{12}O_{19}$. XRD showed that the reaction layer shows a strong degree of orientation in the (h00)/(hk0) planes in the sample sintered at $1200^{\circ}C$. $BaFe_{12}O_{19}$ layers with a degree of orientation in the (hk0) planes could also be grown by heat-treating an ${\alpha}-Fe_2O_3$ seed crystal buried in $BaCO_3$ powder.

• 천문학회보
• /
• 제37권2호
• /
• pp.106.1-106.1
• /
• 2012

The Gegenschein is a faint glow around the anti-solar point caused by the interplanetary dust particle(IDP)'s back-scattering enhancement. From the previous low resolution observations, the overall morphology of the Gegenschein has been intensively studied. However, sub-degree scale fine structure of the Gegenschein is still not well known, even though the detailed morphology of the Gegenschein within a few degree from the anti-solar point may supply pivotal information about the property of the IDPs. We made optical CCD observations of the Gegenschein between 2003 March and 2006 November. From the observations, we succeeded in making high resolution images of the Gegenschein, with unprecedented 1.'4 resolution. Our results concur with IDP cloud model based on the infrared observations combined with scattering phase function derived from low resolution data. The only exception is the anti-solar point. We found a steep additional brightness enhancement existing at the exact anti-solar point. Plausible explanation of the finding is that the IDPs are significantly larger than observing wavelength, and have irregular morphology or inhomogeneous internal structure. Furthermore, we measured average geometric albedo of the IDPs from the optical brightness of the anti-solar point. The geometric albedo was $0.06{\pm}0.01$, similar to those of comets or C-type asteroids.

• 한국분무공학회지
• /
• 제26권4호
• /
• pp.189-196
• /
• 2021

Spray drift of agricultural nozzles has become a big issue because it causes low precision targeting and environmental pollution. In order to reduce the spray drift, study spray characteristics of agricultural nozzles is virtually important. In this study, shadowgraph and Mie-scattering visualization techniques were used to study the macroscopic spray and atomization characteristics of an agricultural nozzle. PDPA was used to measure the atomization characteristics of spray. The injection pressure is set to 1 bar, 3 bar and 5 bar, which covers the working range of the nozzle. For the PDPA experiment, 75 points were measured in an area of 160 mm × 120 mm at 10 mm intervals directly below the nozzle to grasp the overall atomization characteristics of the spray. It was found that the spray width and sheet width showed a linear correlation. As the injection pressure increased, the sheet expansion in the 0-degree direction and the sheet swing in the 90-degree direction jointly promoted the breakup of the sheet. In addition, the area close to the central axis had a large droplet velocity, and since a large droplet velocity promoted atomization of spray, the area close to the central axis had a smaller spray droplet diameter than the left and right regions.