• 공업화학
• /
• 제32권5호
• /
• pp.581-588
• /
• 2021

In this study, soil slurry bioreactors were used to treat soils containing 16 polycyclic aromatic hydrocarbons (PAHs) for 35 days. Five different soil samples were taken from manufactured gas plant (MGP) and coal tar disposal sites. Soil properties, such as carbon content and particle distribution, were measured. These properties were significantly correlated with percent biodegradation and degradation rate. The cumulative amount of PAH degraded (P), degradation rate (K_m), and lag phase (𝜆) constants of PAHs in different MGP soils for 16 PAHs were successfully obtained from nonlinear regression analysis using the Gompertz equation, but only those of naphthalene, anthracene, acenaphthene, fluoranthene, chrysene, benzo[k]fluoranthene, benzo(a)pyrene, and benzo(g,h,i)perylene are presented in this study. A comparison between total non-carcinogenic and carcinogenic PAHs indicated higher maximum amounts of PAH degraded in the former than that in the latter owing to lower partition coefficients and higher water solubilities (S). The degradation rates of total non-carcinogenic compounds for all soils were more than four times higher than those of total carcinogenic compounds. Carcinogenic PAHs have the highest partitioning coefficients (K_oc), resulting in lower bioavailability as the molecular weight (MW) increases. Good linear relationships of K_m, 𝜆, and P with the octanol-water partitioning coefficient (K_ow), MW, and S were used to estimate PAH remaining, lag time, and biodegradation rate for other PAHs.

• 약학회지
• /
• 제46권3호
• /
• pp.168-173
• /
• 2002

The physicochemical properties of aloesin, which has been recently found to reduce renal toxicity induced by cis-platin, were studied including solubility, partition coefficient ( $P_{c}$ ), osmolality, and stability. The solubility of aloesin was about 500 mg/mι, and the $P_{c}$ value for n-octanol/water was 1.01 $\pm$ 0.03. The degradation of aloesin followed the pseudo-first-order kinetics and was dependent on temperature, pH and ionic strength. From the pH-rate profile, the optimal pH was found to be 2.0~3.0. Some metal ions increased the degradation rate in the rank order of M $n^{2+}$ ＞ F $e^{3+}$ ＞ C $u^{2+}$ ＞ F $e^{2+}$. On the other hand, other metal ions such as B $i^{3+}$, $Ba^{2+}$, Z $n^{2+}$, N $i^{2+}$, $Co^{2+}$ and $Mg^{2+}$ did not show the unfavorable effects. After autoclaving, aloesin contents remaining were 81.8~98.8% of initial concentrations depending on pH. The most stable pH was 3.98 in the autoclaving. Osmolality increased linearly as concentration increased.sed.creased.sed.

• Journal of Photoscience
• /
• 제8권2호
• /
• pp.43-53
• /
• 2001

a, a parameter that describes how effectively photoinactivated PS II units protect their functional neighbours; car, carotenoids; ΔpH, transthylakoid pH difference; D1 protein, psbA gene product in the PS II reaction centre; f, functional fraction of PS II: F$\_$v//F$\_$m/, the ratio of variable to maximum chlorophyll a fluorescence; k$\_$d/, rate coefficient for degradation of D1 protein; k$\_$i/ and k$\_$r/, rate coefficient for photoinactivation and repair of PS II, respectively; NADP+, oxidized nicontinamide adenine dinucleotide phosphate; P680, the primary electron donor in the PSII reaction centre; Ph, pheophytin; PS, photosystem; Q$\_$A/, first quinone acceptor of an electron in PS II; R$\_$s/, the gross rate of D1 protein synthesis.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 추계학술대회 논문집 Vol.19
• /
• pp.203-204
• /
• 2006

Nano-Varistors fabricated with ZnO 30nm and 80nm powders were studied about the electrical characteristics with AC accelerated degradation in this paper Especially, ZnO nano-powder varistors were sintered m air at $1050^{\circ}C$ and analyzed the phenomenons of before and after AC degradation test. The stress conditions of AC degradation test were $1.0V_{1mA}$ $115{\pm}2^{\circ}C$ for 24h. 80nm-varistor was exhibited better performance than 30nm-varistor m the electrical stabilities. And then 80nm-varistor resulted m the degradation characteristics that the variation rate of operating voltage, nonlinear coefficient and leakage current was -0 3%, -0 4% and -3 3%, respectively.

• 한국환경과학회지
• /
• 제24권7호
• /
• pp.947-954
• /
• 2015

Dielectric barrier discharge plasma is a new technique in water pollutant degradation, which that is characterized by the production of chemically active species such as hydroxyl radicals, ozone, hydrogen peroxide, etc. If dissolving of plasma gas generated in the plasma reaction has increased, it is possible to increase the contaminant removal capacity. In this study, the improvement on the dissolving performance of plasma gas was evaluated by the indirect method measuring the overall oxygen transfer coefficient. Experiments were conducted to examine the effects of nozzle type, distance from water surface, air supply rate and liquid circulation rate. The experimental results showed that the $K_{La}$ value of the 3-prong nozzle is 2.67 times higher than the diffuser. The order of $K_{La}$ value with nozzle type ranked in the following order: 3-prong nozzle (inner diameter, less 1 mm) > circular nozzle (inner diameter, 1.5 mm) > ellipse nozzle (short diameter 1 mm, long diameter 2.5 mm) > circular nozzle (inner diameter, 3 mm). Optimal liquid circulation rate was appeared to be 1.7 L/min, the value of $K_{La}$ was 0.510 1/min. The value of $K_{La}$ with increasing air supply rate was revealed in the form of an exponential such as $K_{La}=0.3581e^{0.2919^*air\;flow\;rate}$.

• Journal of information and communication convergence engineering
• /
• 제7권4호
• /
• pp.496-500
• /
• 2009

In EBCOT, the context modeling process takes excessive calculation time and this paper proposed a method to reduce this calculation time. That is, if the finest resolution coefficient is less than a pre-defined transfer factor the coefficient and its descendents skip the context modeling process. There is a trade-off relationship between the calculation time and the image quality or the amount of output data such that as this threshold value increases, the calculation time and the amount of output data decreases, but the image degradation increases. The experimental results showed that in this range the resulting reduction rate in calculation time was from 3% to 64% in average, the reduction rate in output data was from 32% to 73% in average.

• 설비공학논문집
• /
• 제4권4호
• /
• pp.360-369
• /
• 1992

A heat pump system is constructed to evaluate its performance and heat transfer characteristics with mixtures of R22/R142b as working fluids. The heat transfer in the evaporator and the overall performance are measured and analyzed in terms of the compositions and relevant variables. Possibility of capacity modulation by changing composition is observed without degradation of heat transfer coefficients and coefficient of performance. The cooling capacity is varied continuously within 200 percent based on minimum capacity at constant compressor speed. For similar cooling capacity, COP is improved by mixing two refrigerants and shows maximum value at 60％ mass fraction of R22. Average heat transfer coefficients of mixtures decrease in comparison with pure refrigerants at similar cooling capacity and mass flow rate. However, the overall heat transfer coefficients decrease moderately. A cycle simulation is performed in order to manifest the advantages of using refrigerant mixtures, considering experimentally observed heat transfer characteristics.

• 한국지하수토양환경학회지:지하수토양환경
• /
• 제21권5호
• /
• pp.8-15
• /
• 2016

Bioremediation, which uses microbes to degrade most organic pollutants in soil and groundwater, can be used in solving environmental issues in various polluted sites. In this research, a wind-driven bioventing system is built to degrade about 20,000 mg/kg of high concentration diesel pollutants in soil-pollution mode. The wind-driven bioventing test was proceeded by the bioaugmentation method, and the indigenous microbes used were Bacillus cereus, Achromobacter xylosoxidans, and Pseudomonas putida. The phenomenon of two-stage diesel degradation of different rates was noted in the test. In order to interpret the results of the mode test, three microbes were used to degrade diesel pollutants of same high concentration in separated aerated batch-mixing vessels. The data derived thereof was input into the Haldane equation and calculated by non-linear regression analysis and trial-and-error methods to establish the kinetic parameters of these three microbes in bioventing diesel degradation. The results show that in the derivation of μ_m (maximum specific growth rate) in biodegradation kinetics parameters, K_s (half-saturation constant) for diesel substance affinity, and K_i (inhibition coefficient) for the adaptability of high concentration diesel degradation. The K_s is the lowest in the trend of the first stage degradation of Bacillus cereus in a high diesel concentration, whereas K_i is the highest, denoting that Bacillus cereus has the best adaptability in a high diesel concentration and is the most efficient in diesel substance affinity. All three microbes have a degradation rate of over 50% with regards to Pristane and Phytane, which are branched alkanes and the most important biological markers.

• Archives of Pharmacal Research
• /
• 제24권6호
• /
• pp.572-577
• /
• 2001

The feasibility of skin penetration was studied for aspalatone (AM, acetylsalicylic acid maltol ester), a novel antithrombotic agent. In this studys hairless mouse dorsal skins were used as a model to select composition of vehicle and AM. Based on measurements of solubility and partition coefficient, the concentration of PC that showed the highest flux for AM across the hairless mouse skin was found to be 40%. The cumulative amount permeated at 48 h, however, appear inadequate, even when the PC concentration was employed. To identify a suitable absorption enhancer and its optimal concentration for AM, a number of absorption enhancers and a variety of concentration were screened for the increase in transdermal flux of AM. Amongst these, linoleic acid (LOA) at the concentration of 5% was found to have the largest enhancement factor (i.e., 132). However, a further increase in AM flux was not found in the fatty acid concentration greater than 5%, indicating the enhancement effect is in a bell-shaped currie. In a study of the effect of AM concentration on the permeation, there was no difference in the permeation rate between 0.5 and 1% for AM, below its saturated concentration. At the donor concentration of 2%, over the saturated condition, the flux of AM was markedly increased. A considerable degradation of AM was found during permeation studies, and the extent was correlated with protein concentrations in the epidermal and serosal extracts, and skin homogenates. In rat dorsal skins, the protein concentration decreased in the rank order of skin homogenate > serosal extract > epidermal extract. Estimated first order degradation rate constants were $6.15{\pm}0.14,{\;}0.57{\pm}0.02{\;}and{\;}0.011{\pm}{\;}0.004{\;}h^{-1}$ for skin homogenate, serosal extract and epidermal extract, respectively. Therefore, it appeared that AM was hydrolyzed to some extent into salicylmaltol by esterases in the dermal and subcutaneous tissues of skin. taken together, our data indicated that transdermal delivery of AM is feasible when the combination of PC and LOA is used as a vehicle. However, since AM is not metabolically stable, acceptable degradation inhibitors may be nervessary to fully realize the transdermal delivery of the drug.

• 약학회지
• /
• 제39권2호
• /
• pp.175-184
• /
• 1995

The interaction of omeprazole(OMP) with $\gamma$-cyclodextrin($\gamma$-CyD) was investigated by solubility study and the complexation was confirmed by means of UV/VIS spectrophotometer, circular dichroism, differential scanning calorimeter, and $^{1}$H nuclear magnetic resonance spectra. The stability, dissolution rate, and partition coefficient of the complex were measured. The results present that the benzimidazole moiety and a part of pyridine ring containing sulfur atom of OMP might be included into the cavity of $\gamma$-CyD and the formation type of inclusion complex appeared to be B$_{s}$. The stoichiometric ratio of OMP to $\gamma$-CyD in the complex was found to be 1:1 and the stability constant of the complex found to be 97.1 M$^{-1}$. And the dissolution rate of OMP was markedly increased by inclusion complex formation with $\gamma$-CyD, and so it was above 90% in 5 min. from solid complex. Oil to water partition coefficient of OMP-$\gamma$-CyD complex was 60, which is significantly higher than that of OMP itself, 36.4. The degradation rate constant of OMP were greater than OMP-$\gamma$-CyD complex in aqueous solutions of various pHs, and the half lives of OMP and OMP-$\gamma$-CyD at pH 9 were 279.2 and 509.9 days, respectively, showing that the complex was more stable than OMP, therefore it was thought that OMP was stabilized by inclusion formation with $\gamma$-CyD.