• Journal of Korean Institute of Industrial Engineers
• /
• v.34 no.1
• /
• pp.23-31
• /
• 2008

This paper presents accelerated degradation test plans considering adoption of tightened critical values. Under arandom coefficient degradation rate and log-linear acceleration models, the asymptotic variance of an estimatorfor a lifetime quantile at the use condition as the optimization criterion is derived where the degradation ratefollows a lognormal and Reciprocal Weibull distributions, respectively and then the low stress level andproportions ofunits allocated to each stress level are determined. We also show that the developed test plans canbe applied to the multiplicative model with measurement error.

• Journal of Korean Society for Quality Management
• /
• v.34 no.3
• /
• pp.19-30
• /
• 2006

For highly reliable products, it is difficult to assess the lifetime of the products with traditional life tests. Accordingly, a recent approach is to observe the performance degradation of product during the test rather than regular failure time. This study compares performances of three methods(i.e. the approximation, analytical and numerical methods) to estimate the parameters and quantiles of the lifetime when the time-to-failure distribution follows Weibull and lognormal distributions under a random coefficient degradation rate model. Numerical experiments are also conducted to investigate the effects of model error such as measurements in a random coefficient model.

• Journal of Korean Society for Quality Management
• /
• v.32 no.1
• /
• pp.113-129
• /
• 2004

The reliability of the product can be improved by making the product less sensitive to noises. Especially, it Is important to make products robust against various noise factors encountered in production and field environments. In this paper, the phenomenon of degradation assumes a simple random coefficient degradation model to present analysis procedures of degradation data for robust experimental design. To alleviate weak points of previous studies, such as Taguchi's, Wasserman's, and pseudo failure time methods, novel techniques for analysis of degradation data using the cross array that regards amount of degradation as a dynamic characteristic for time are proposed. Analysis approach for degradation data using robust experimental design are classified by assumptions on parametric or nonparametric degradation rate(or slope). Also, a simulation study demonstrates the superiority of proposed methods over some previous works.

• Biomolecules & Therapeutics
• /
• v.8 no.4
• /
• pp.332-337
• /
• 2000

Physicochemical properties of aspalatone (acetylsalicylic acid maltol ester, AM), which has been recently found to have an antithrombotic effect, were studied in terms of solubility, dissolution, partition coefficient (Pc) and stability. The solubility of AM at 37$^{\circ}C$ was about 1.2 mg/ml and the P$_{c}$ value for n-octanol/water and chloroform/water was 11.4 and 382.6, respectively. Dissolution rates of AM at pH 1.2 and 6.8 were more than 80% within 30 min. The degradation of AM followed apparent first-order kinetics, and was dependent on temperature, pH and ionic strength. From the pH-rate profile, the optimal pH was found to be at around 4.0. Half-lives at pH 1.2 and 6.8 were 33.5 and 44.4 hr, respectively. The degradation rate of AM at pH 1.2 was somewhat faster than that of aspirin, but at pH 7.0, the degradation rate of AM was slower than that of aspirin.n.

• Journal of Environmental Health Sciences
• /
• v.22 no.2
• /
• pp.90-95
• /
• 1996

This study was performed to calculate the degration rate coefficient, operating parameters to meet the effluent standards, and the temperature adjustment coefficients to each parameter of pollution by seasonal variation of concentration and temperature of influent in livestock wastewater treatment by sequencing batch reactor process in field scale. The followings are the conclusions that were derived from this study. 1. In the field, temperature of livestock wastewater in reactor was 20.3$\circ$C in summer and 6.0$\circ$C in winter. The ratio of BOD:TKN: T-P in influent was 100:80:7. BOD loadings in winter and spring were 0.26 and 0.43 kg $BOD/m^3$ day, respectively. Those in summer and fall were 0.25 and 0.13 kg $BOD/m^3$ day, respectively. 2. The degradation rate coefficient for TKN was larger in summer and fall in which temperature was high than that in which temperature was high than that in winter and spring in which concentration was high. On the contrary, the phosphorus uptake rate was larger in winter and spring than that in summer and fall. 3. The hydraulic retention time in winter and spring was longer than that in summer and fall. Especially, in order to meet the standard for TKN of 120 mg/l in winter in which temperature of wastewater was 6.0$\circ$C, as the MLSS concentration was increased from 4, 000 to 7, 000 mg/l, the hydraulic retention time was increased from 212 to 121 hours. But, in order to shorten that less than 121 hours for the economical wastewater treatment, countermeasure to increase temperature of wastewater in the reactor should be considered. 4. the temperature adjustment coefficients for BOD, $COD_{Mn}$, TKN and T-P were 1.0241, 1.0225, 1.0541 and 1.0495, respectively. Namely, the treatment of TKN was most sensitively affected by temperature. For the purpose of the effective removal of nitrogen and phosphorus which are sensitive to temperature, it is necessary to keep the temperature of livestock wastewater more than 20$\circ$C which is the temperature of it in summer.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.427-430
• /
• 2001

The degradation characteristics versus MgO Additive for the ZnO ceramic devices fabricated by the standard ceramic techniques is investigated in this study. It were made these devices be basic Matsuoka's composition. Especially, MgO were added to analyze the degradation characteristics and sintered in air at 1300$^{\circ}C$. The conditions of DC degradation test were 115${\pm}$2$^{\circ}C$ for 12h. Using XRD and SEM, the phase and microstructure of samples were analyzed respectively. The elemental analysis in the microstructures was used by EDS, E-J analysis was used to determine ${\alpha}$ . Frequency analysis was accomplished to understand the relationship between R$\sub$g/ and $R_{b}$ with the electric stress at the equivalent circuit.

• Composites Research
• /
• v.16 no.6
• /
• pp.33-40
• /
• 2003

The initial thermal degradation of polymer matrix composite is not observed easily. At the beginning of thermal degradation of polymer matrix composites, phase transformation such as chain scission, oxidation occur, and then micro delamination is produced in matrix and interface between matrix and fiber before blistering. Initial heat damage deteriorate mechanical properties of composites. We presented the detection method of the initial heat damage of composites conveniently using ultrasonic technique. Absorption coefficient and material velocity was measured with thermal degradation and degree of cure. The more thermal degradation was progressed, the more absorption coefficient was increased. When the cure temperature is more high, the absorption coefficient of cured composite is increased and material velocity is decreased. We concluded that cure temperature is more high, the defects such as void is increased and molecular structure cured at high temperature has cross-linking structure which is more absorb the ultrasonic waves.

• Proceedings of the KIEE Conference
• /
• 1999.11d
• /
• pp.978-980
• /
• 1999

In this paper, DC degradation of ZnO varistor sintered in the atmospheres of nitrogen and oxygen was investigated. The content of $SiO_2$ containing 0.0, 0.2, 0.5 mol% respectively was addicted for the improvement of degradation property. ZnO varistor was fabricated in the special electrical furnace which had the vacuum system. The temperature and the voltage for the DC degradation test were $115{\pm}2^{\circ}C$, $0.85V_{1mA/cm^2}$. The time conditions for this test were 0, 2, 4, 8 hours and Current-voltage analysis is used to determine nonlinear coefficients($\alpha$). Frequency analysis are accomplished for the understanding of electrical properties as DC degradation test. In this experiment, We concluded that nonlinear coefficient decreased as the amount of $SiO_2$ addition increased, but degradation rate coefficient increased as the amount of $SiO_2$ addition increased. Also, degradation test with the analysis of equivalent circuit showed that the degradation phenomenon of ZnO varistor wasn't linearity.

• Journal of Microbiology and Biotechnology
• /
• v.33 no.10
• /
• pp.1390-1401
• /
• 2023

In this study, a 12-week feeding experiment was conducted to characterize the effects of exogenous α-amylase on the growth, feed utilization, digestibility, plasma α-amylase activity, feed degradation rate, and fecal particle size of olive flounder (Paralichthys olivaceus). Diet was supplemented with 0 (AA₀; control), 100 (AA₁₀₀), 200 (AA₂₀₀), or 400 (AA₄₀₀) mg/kg of α-amylase, respectively. Fish (273.1 ± 2.3 g) were stocked into 12 tanks (25 fish/1,000-L tank) and 3 tanks were randomly selected for each diet group. As a result, α-amylase was found to have no significant effects (p ≥ 0.05) on the growth, feed utilization parameters, and whole-body proximate compositions. α-Amylase-treated fish exhibited only a significant increase in the apparent digestibility coefficient of carbohydrates compared to the controls. In addition, in vitro analyses revealed that α-amylase dose-dependently increased (p < 0.05) the feed degradation rate, while photographs of the intestinal content after 2, 4, and 8 h of feeding demonstrated an improved degradation rate in the α-amylase-treated groups. Plasma α-amylase content was higher in the AA₂₀₀ and AA₄₀₀ groups, whereas the control group produced significantly larger-sized fecal particles (90% size class) than these two groups. In the intestine, no changes were observed in the expression levels of the immune-related TNF-α, IL-1β, IL-2, immunoglobulin-M, HSP-70, lysozyme, and amylase alpha-2A. However, growth-related genes IGF-1, IGF-2, TGF-β3, and growth hormone genes were upregulated in muscle tissues. Collectively, exogenous α-amylase has positive roles in the modulation of the digestibility coefficient, blood α-amylase concentration, growth-related gene expression, and diet degradation for improved digestion in olive flounder.

• Journal of Welding and Joining
• /
• v.32 no.3
• /
• pp.74-80
• /
• 2014

Due to environmental regulations (RoHS, WEEE and ELV) of the European Union, electronics and automotive electronics have to eliminate toxic substance from their devices and system. Especially, reliability issue of lead-free solder joint is increasing in car electronics due to ELV (End-of-Life Vehicle) banning from 2016. We have prepared engine control unit (ECU) modules soldered with Sn-40Pb and Sn-3.0Ag-0.5Cu (SAC305) solders, respectively. Degradation characteristics of solder joint strength were compared with various conditions of automobile environment such as cabin and engine room. Thermal cycle test (TC, $-40^{\circ}C$ ~ ($85^{\circ}C$ and $125^{\circ}C$), 1500 cycles) were conducted with automotive company standard. To compare shear strength degradation rate with eutectic and Pb-free solder alloy, we measured shear strength of chip components and its size from cabin and engine ECU modules. Based on the TC test results, finally, we have known the difference of degradation level with solder alloys and use environmental conditions. Solder joints degradation rate of engine room ECU is superior to cabin ECU due to large CTE (coefficient of thermal expansion) mismatch in field condition. Degradation rate of engine room ECU is 50~60% larger than cabin room electronics.