• 한국멀티미디어학회논문지
• /
• 제8권9호
• /
• pp.1208-1215
• /
• 2005

멀티캐스트를 이용한 멀티미디어 응용에서는 다수의 수신자들로부터 피드백을 수신할 경우 폭주로 인한 혼잡이 발생하여 전송률이 낮아지는 문제가 발생한다. 이를 위해 계층적 대표자 기법이 제안되었다. 그러나 수신자 전체를 고려한 전송률 조절로 인하여 혼잡이 없는 지역의 전송률도 같이 낮아지는 문제가 발생한다. 본 논문에서는 이러한 문제를 해결하기 위해 지역대표자를 두었다. 지역대표자는 해당 그룹의 전송률이 최소 유지임계치 미만일 경우, 혼잡 수신자를 전송률 계산에서 제외시켜 다시 계산한다. 이렇게 함으로써 혼잡이 발생하지 않는 지역의 전송률이 같이 낮아지는 문제를 개선하였다. 실험을 통한 결과를 볼 때 기존의 기법보다 더 안정적인 전송률로 조절됨을 보였다.

• Asian-Australasian Journal of Animal Sciences
• /
• 제5권1호
• /
• pp.81-90
• /
• 1992

Five buffaloes kept in normal ambient temperature ($30^{\circ}C$) showed no significant changes in the heart rate, respiratory rate, packed cell volume, plasma constituents and renal hemodymics during intravenous infusion of urea for 4 h. The rate of urine flow, fractional urea excretion, urinary potassium excretion and osmolar clearance significantly decreased while the renal urea reabsorption markedly increased during urea infusion. The decrease of fractional potassium excretion was concomitant with the reduction of the rate of urine flow and urine pH. In animals exposed to heat ($40^{\circ}C$) the rectal temperature heart rate and respiratory rate significantly increased while no significant changes in GFR and ERPF were observed. An intravenous infusion of urea in heat exposed animals caused the reduction of the rate of urine flow with no changes in renal urea reabsorption, urine pH and fractional electrolyte excretions. During heat exposure, there were marked increases in concentrations of total plasma protein and plasma creatinine whereas plasma inorganic phosphorus concentration significantly decreased. It is concluded that an increase in renal urea reabsorption during urea infusion in buffaloes kept in normal ambient temperature depends on the rate of urine flow which affect by an osmotic diuretic effect of electrolytes. The limitation of renal urea reabsorption in heat stressed animals would be attributed to an increases in either plasma pool size of nitrogenous substance or body metabolism.

• Journal of Biosystems Engineering
• /
• 제19권2호
• /
• pp.112-123
• /
• 1994

At present, no appropriate drying conditions can be found for the heated-air drying of mushroom in Korea. Usually, mushroom is being dried at the temperature range of 40 to $50^{\circ}C$ until the moisture content reaches 10~13% (wb). However, drying characteristics of the mushroom should be investigated for quality improvement and efficient drying operation of the mushroom. The results of this study may be summarized as follows ; 1. The effect of air temperature on the rate of drying was greater than that of relative humidity for drying of mushroom, and the rate of drying was increased with increase in the air temperature. 2. Drying rate for Shiitake mushroom showed falling-rate period of drying without constant-rate period of drying. Drying rate for Oyster mushroom showed a short constant-rate period at the initial stage of drying process, and followed by falling-rate period of drying. 3. Exponential and App.-Diffusion models were found to describe well the drying process of Shiitake mushroom. Exponential and Thompson models for Oyster mushroom in which Thompson model was the most suitable for Oyster mushroom. 4. The equilibrium moisture content of the mushroom decreased with decrease in the air temperature and increase in the relative humidity. In room condition($20^{\circ}C$, 54% RH), the calculated values of the equilibrium moisture content showed 11.17% for Shiitake mushroom and 13.19% for Oyster mushroom, respectively.

• Bulletin of the Korean Chemical Society
• /
• 제30권7호
• /
• pp.1598-1602
• /
• 2009

The particle size of Li[$Ni_{0.2}Li_{0.2}Mn_{0.6}]O_2$ cathode powder was controlled effectively by dispersion using lauric acid as a surfactant. The samples treated by lauric acid showed smaller particles of approximately half the original size compared to the particles of a pristine sample. A structural change due to the dispersion of Li[$Ni_{0.2}Li_{0.2}Mn_{0.6}]O_2$ powder was not detected. The rate performance of the Li[$Ni_{0.2}Li_{0.2}Mn_{0.6}]O_2$ cathode was improved by dispersion using lauric acid, which was likely due to the decrease of the particle size. In particular, a sample dispersed pristine powder using lauric acid (L2) presented a greatly enhanced discharge capacity and capacity retention at a high C rate. The discharge capacity of a pristine sample was only 133 m$Ahg^{-1}$ (3C rate) and 96 m$Ahg^{-1}$ (12C rate) at the tenth cycle. In contrast, the L2 electrode delivered higher discharge capacities of 160 m$Ahg^{-1}$ (3C rate) and 129 m$Ahg^{-1}$ (12C rate) at the tenth cycle. The capacity retention at a rate of 12C/2C was also enhanced from ~ 45% (pristine sample) to 57% (L2) by treatment with lauric acid.

• 한국대기환경학회지
• /
• 제24권1호
• /
• pp.83-90
• /
• 2008

In order to clarify the urbanization intensity of Daegu Metropolitan and its characteristics, comparative study on the variation of the cooling rate of two different sites was carried out using observation data for 40 years by Korea Meteorological Adminstration. Daegu Metropolitan and Chupungnyung represent well urbanized and rural areas, respectively. In comparison with Chupungnyung, yearly mean temperature at Daegu Metropolitan increases rapidly and especially the differences of minimum temperature increasing rate during 40 years becomes greater. These differences of regional warming are caused by the different urbanization intensity between two sites. And the impact of anthropogenic heat due to urbanization should be stronger in nighttime than in daytime. Sensible heat advection by regional wind during 6 hours from 18 LST contributes to atmospheric cooling. For this reason wind speed is in proportion to cooling rate of atmosphere. However, wind after 24 LST induces the warm air advection and makes decrease the cooling rate in urban area. Although the cooling rates between Daegu Metropolitan and Chupungnyung are some different, the variation tendencies of cooling rate of two site are almost same. Therefore atmospheric cooling rate in nighttime tends to be associated with the intensity of wind speed.

• 한국재료학회지
• /
• 제30권12호
• /
• pp.693-700
• /
• 2020

Direct water quenching technique can be used in hot stamping process to obtain higher cooling rate compared to that of the normal die cooling method. In the direct water quenching process, setting proper water flow rate in consideration of material thickness and the size of the area directly cooled in the component is important to ensure uniform microstructure and mechanical properties. In this study, to derive proper water flow rate conditions that can achieve uniform microstructure and mechanical properties, microstructure and hardness distribution in various water flow rate conditions are measured for 3.2 mm thick boron steel sheet. Hardness distribution is uniform under the flow condition of 1.5 L/min or higher. However, due to the lower cooling rate in that area, the lower flow conditions result in a drastic decrease in hardness in some areas in the hot-stamped part, resulting in low martensite fraction. From these results, it is found that the selection of proper water flow rate is an important factor in hot stamping with direct water quenching process to ensure uniform mechanical properties.

• Journal of the Korean Wood Science and Technology
• /
• 제51권2호
• /
• pp.98-108
• /
• 2023

In this study, the boards were manufactured according to the mandarin peels addition rate using sawdust and mandarin orange peel. After that, the mechanical properties and density profile of ceramics prepared by conditions through resin impregnation process and carbonization process were investigated. The bending and compression strengths of ceramics tended to increase as the resin impregnation rate increased. When the resin impregnation rate was 70%, the highest values were 8.58 MPa and 14.77 MPa, respectively. Also, the mechanical properties of ceramics according to carbonization temperature showed the highest values at 1,200℃ for bending strength of 11.09 MPa and compression strength of 17.20 MPa. The bending strength and compression strength according to the mandarin peels addition rate showed the highest values at 8.62 MPa and 14.16 MPa, respectively, when the mandarin orange peel addition rate was 5%. The mechanical properties tended to decrease when the addition rate of mandarin orange was increased. The density profile of ceramics showed a similar tendency to the mechanical properties. It can be seen that the density distribution from the surface layer to the center layer is more uniform as the resin impregnation rate and carbonization temperature increase and the mandarin peels addition rate decreases.

• 한국수정란이식학회지
• /
• 제33권3호
• /
• pp.169-175
• /
• 2018

It has been claimed that artificial insemination (AI) of cows with frozen-thawed semen treated with commercially produced kits, Wholemom (in favour of female gender) increases the birth chance of calves with desired sex ratio by approximately 85% without decrease of pregnancy rates. Hence, this study was conducted to investigate the efficacy of wholemom kits as combined with frozen-thawed bovine semen during in vitro fertilization on the in vitro fertilization and developmental efficiency and sex ratios such as some reproductive parameters in bovine. For this, 1,737 oocytes were in vitro fertilized and developed. Agglutination effects on bovine after treatment of Wholemom kit were observed by time passage and dose respectively. To determine sex of embryos, Bovine embryo Y-specific gene primers(ConEY) and Bovine specific universal primer(ConBV) were used as multiple PCR method. Fertilization rate of wholemom-treated group was significantly lower than its of control group[66.9% (1,156/1,737) in Wholemom-treated group; 75.0% (610/813) in control group]. However, developmental rate after fertilization of both wholemom-treated and control groups were not significantly different [26.1% (404/1,156) in Wholemom-treated group; 27.4% (224/610) in control group]. Sex ratio of in vitro fertilized embryo with frozen-thawed semen treated with wholemom kit was determined by multi PCR. Female ratio in wholemom-treated group [85.4% (173/201)] was significantly higher than its of control group [47.2% (66/141)]. In conclusion, wholemom treatments of semen used in the in vitro fertilization and development of bovine oocytes provided increase in female ratio with decrease of fertilization rate.

• 동의생리병리학회지
• /
• 제16권2호
• /
• pp.353-358
• /
• 2002

To test the protective effect of herbal medicine against oxygen free radical-induced myocardiotoxicity, cytotoxicity of xanthine oxidase/hypoxanthine (XO/HX) was examined using MTT, TBARS, and beating rate assay in the presence of water extract of Sujeom-san(SJS) or single consituents of its prescription. Myocardial toxicity was evaluated in neonatal rat myocardiocytes in cultures. In the present paper, XO/HX resulted in a decrease in viability and beating rate and increases in lipid peroxidation in cultured myocardial cells. In the effect of SJS water extract, it showed effects from the cardiocytotoxicity induced by XO/HX treatment such as increases in beating rate and decreases in lipid peroxidation. In the effect of Rhizoma Corydalis (RC), Faeces Trogopterori (FT), Fructus Amomi Tsaoko (FAT) and Myrrha on the cardiocytotoxicity, they were significantly effective in blocking the XO/HX-induced cardiocytotoxicity by increase of beating rate in FAT and FT group as well as decrease of lipid peroxidation in FT and RC group. These results show that oxygen free radical elicits toxic effects in cultured myocardial cells derived from neonatal rat, and suggest that water extract of Sujeomsan, Rhizoma Corydalis, Faeces Trogopterori, Fructus Amomi Tsaoko or Myrrha is very effective in the prevention of xanthine oxidase/hypoxanthine- induced cardiotoxicity.

• 한국약용작물학회지
• /
• 제19권6호
• /
• pp.441-445
• /
• 2011

This research was conducted to investigate the influence of variouis organic substrates on growth and yield of organically grown ginseng seedlings in a shaded plastic house. In the investigation of optimal substrate, the eight substrate were formulated by adjusting blending rate of peatmoss, perlite, coir dust(coco peat), and vermiculite. Then, the changes in physico chemical properties of root substrates as well as their influences on the growth characteristics and yield were determined at six months after sowing. The elevation of the blending rate of peatmoss from 50% to 70% with decrease in the rate of inorganic component (mixture of perlite and vermiculite) from 50 to 30% resulted in the increase in container capacities and decrease in total porosities and air-filled capacities. The concentrations of $NH_4-N$, $P_2O_5$ and K increased as the incorporation rate of castor seed meal, phosphate ore, and langbenite, respectively, were elevated during the root medium formulations. The PPV-1 and PPV-4 substrates produced high stem length, stem diameter, shoot fresh weight, leaf area and root length among eight substrate. Root fresh weight was heaviest in PPV-4 compound nursery media. The results of this experiment will be utilized in the new substrate application for ginseng organic culture in shaded vinyl house.