• 대한조선학회지
• /
• 제21권4호
• /
• pp.29-39
• /
• 1984

In this paper, the membrane and buckling analysis of beams with various shaped brackets is performed by using the finite element method. From the viewpoint of minimum structural weight, a optimum design method to determine the optimal shapes and scantling of brackets under design load is proposed by investigating the effects of beam depth, bracket length and aspect ratio on the structural weight. Also optimal design data and charts for the brackets to support transverse girders or web frames of actual ships are provided. By the present design method, it is possible to perform optimum design of brackets used in actual ships, which could result in considerable reduction of structural weight or cost, increase of dead weight and service speed of ships.

• Asian-Australasian Journal of Animal Sciences
• /
• 제12권4호
• /
• pp.554-557
• /
• 1999

Hatchery waste including infertile eggs, dead embryos in shell, dead or low grade chicks was cooked at $100^{\circ}C$ for 15 minutes and then oven dried and ground. Hatchery waste meal (HWM) thus prepared contained 44.25% protein, 4,573 kcal/kg gross energy, 3,600 kcal/kg metabolizable energy, 30% ether extract, 1.9% fibre, 14% ash, 9.8% nitrogen free extract, 7.26% Ca, 0.84%P, 1.86% lysine and 0.66% methionine with no Salmonella and E. coli. In biological evaluation trial, significantly higher weight gain was observed in ration containing 12% HWM compared with that containing similar amount of fish meal. Protein efficiency ratio on the two rations was 3.96 vs 2.85; protein digestibility, 86.02 vs 71.9; net protein utilization, 64.9 vs 42.37 and biological value, 75.37 vs 58.84, respectively, indicating better balance of amino acids in HWM compared with fish meal. Growth performance trial on broiler chicks also revealed better weight gain and feed efficiency on ration containing 12% HWM than that containing similar level of fish meal.

• 한국기계가공학회지
• /
• 제15권3호
• /
• pp.21-27
• /
• 2016

The static and dynamic structural integrity qualification was performed through the seismic analysis of a small-size Savonius-type vertical wind turbine at dead weight plus wind load and seismic loads. The ANSYS finite element program was used to develop the FEM model of the wind turbine and to accomplish static, modal, and dynamic frequency response analyses. The stress of the wind turbine structure for each wind load and dead weight was calculated and combined by taking the square root of the sum of the squares (SRSS) to obtain static stresses. Seismic response spectrum analysis was also carried out in the horizontal (X and Y) and vertical (Z) directions to determine the response stress distribution for the required response spectrum (RRS) at safe-shutdown earthquake with a 5% damping (SSE-5%) condition. The stress resulting from the seismic analysis in each of the three directions was combined with the SRSS to yield dynamic stresses. These static and dynamic stresses were summed by using the same SRSS. Finally, this total stress was compared with the allowable stress design, which was calculated based on the requirements of the KBC 2009, KS C IEC 61400-1, and KS C IEC 61400-2 codes.

• 한국작물학회지
• /
• 제48권4호
• /
• pp.339-344
• /
• 2003

To identify the new source of breeding materials for rice salt tolerance, the salinity tolerance of thirty-four varieties was evaluated under 0.5% saline condition at seedling stage. The salinity score showed highly significant correlations to dry weight and dead leaf ratio. The tested varieties were classified into three groups by visual score, reduction ratio of dry weight, and dead leaf ratio. Eighteen varieties were classified as the highly tolerant group (salinity scores of 1.3-3.7), seven varieties were fallen into the tolerant group (salinity scores of 4.2-5.8), and others were susceptible (salinity scores of 6.7-9.0). In highly tolerant group, most indica varieties including Getu, Dikwee and Kuatic Putic, didn't exsert a panicle under the Korean climate. But six varieties, Xiangcho V, Annapuruna, HP 3319-2wx-6-3-1, Giza 175, and GZ 2447-S-17, GZ 4255-6-3 were suitable to the Korean climate, and their heading date (6-16, August) and culm length (65-78㎝) were similar to the Korean varieties. Accordingly, these varieties can be utilized as crossing materials for the salt tolerance in japonica rice.

• Toxicological Research
• /
• 제21권1호
• /
• pp.63-70
• /
• 2005

Gami-Honghwa-Tang (KH-19), a herbal prescription for reducing the side effect of radiotherapy, is composed of eight crude herbs such as Rehmanniae Radix Preparata, Angelicae Gigantis Radix, Cnidii Rhizoma, Paeoniae Radix, Corni Fructus, Moutan Cortex Radicis, Lycii Fructus, Carthami Flos, and Glycyrrhizae Radix. In this study, marker substances in KH-19 were analyzed by high performance liquid chromatography-diode array detector (HPLC-DAD) and safety evaluation of standardized KH-19 was evaluated by good laboratory practices (GLP) guideline of Korea Food and Drug Administration. HPLC-DAD was employed to determine the quantities and the qualities of several marker substances such as 5-hydroxymethyl-2-furaldehyde (5-HMF), paeonol, loganin, paeoniflorin, glycyrrhizin, and decursin in the KH-19. In acute oral toxicity study on rat, transient inhibition of body weight was shown, but change in general symptom was not detected. No dead animal was observed up to 5,000 mg/kg in both male and female animals. In acute oral toxicity study on Beagle dog, transient vomiting, diarrhea, anorexia, and body weight reduction were observed, However, no dead animal was observed up to 2,000 mg/kg in both male and female animals.

• Journal of Biosystems Engineering
• /
• 제35권1호
• /
• pp.31-36
• /
• 2010

A small unmanned helicopter was suggested to replace the conventional spray system. Aerial application using an agricultural helicopter helps precise and timely spraying, and reduces labor intensity and environmental pollution. In this research, a rotor system (SW05) was developed and its lift capability was evaluated. Lift force for the dead weight of the helicopter was obtained at the grip pitch angle of $12^{\circ}$. As the pitch angle increased to $14^{\circ}$ and $16^{\circ}$, the payload increased to 176 N and 216 N, respectively. Compared with SW04 airfoil performance in the total lift, the SW05 airfoil showed nearly the same capacity, but the payload of the SW05 was reduced because of the increased dead weight. A rated flight condition was defined as lifting mean payload of 294 N with the grip pitch angles of $16{\sim}17^{\circ}$ at the rotor rotating speed of 850~950 rpm for the adjusted engine power. The fuel consumption would be 4.8~6.0 L/hr, and the air temperature of cooling fan should be kept below $160^{\circ}C$.

• 한국전산구조공학회:학술대회논문집
• /
• 한국전산구조공학회 2003년도 가을 학술발표회 논문집
• /
• pp.333-339
• /
• 2003

Recently, the bridges become greater according to development of a construction technology. This phenomenon requires long span bridge, so that increases the dead weight. The orthotropic steel deck bridges have much advantages such as the light dead weight and the reduction of construction period. And almost whole process of carried out is manufactured at factory, so it can cause the increase of quality authoritativeness. But orthotropic steel deck bridge is consist of structure by welding, it can not avoid a lot of welding jobs, defects and transformation by welding are becoming problem accordingly. Specially, topical stress concentration phenomenon in cross connection area of longitudinal and transverse rib causes fatigue failure. The Bulkhead Plate for prevention of this stress concentration phenomenon was applied by changing the orthotropic steel deck of Williamsburg bridge in USA. But, it is principle that a Bulkhead Plate is not established in the domestic design standard. Therefore, it is estimated that the study for installation of Bulkhead Plate is needed. This treatise with considering these circumstances proves efficiency of Bulkhead Plate and will be presented optimal design details through finite element analysis according to change the geometrical of Bulkhead Plate and tile cross-connection area of longitudinal and transverse rib.

• 대한토목학회논문집
• /
• 제29권3B호
• /
• pp.281-287
• /
• 2009

본 연구에서는 우리나라 인천 남구 시화호 연안의 퇴적토를 가토제(containment dyke)내에 펌핑 매립한 인천 LNG 인수기지 조성부지 내의 준설지반과 인근 시화호 조성공사 지역의 해성퇴적토에 대해 토질시험을 실시하여 토질정수를 산정하고, 돌핀 기초말뚝의 배열 조건을 달리하여 태풍 내습 시 돌핀에 작용하는 최대 파고에 의한 돌핀 기초말뚝의 변위, 전단력과 모멘트에 대한 거동 특성을 해석하였다. 수치해석 결과, 최대 심해설계파와 만내발생파의 파력에 의한 돌핀구조물의 거동은 일반적으로 준설토와 퇴적토의 지반반력계수 보다는 말뚝 직경의 크기에 더 큰 영향을 받는 것으로 나타나고 있다. 또한 돌핀구조물 기초말뚝을 직항으로 모델링한 경우와 경사말뚝을 조항으로 모델링한 경우, 조항이 직항보다 돌핀에 작용하는 외력에 대해 수십 배 이상의 저항효과가 있는 것으로 나타나고 있다.

• 한국환경과학회지
• /
• 제22권11호
• /
• pp.1465-1471
• /
• 2013

To develop the protein materials by the reutilization of dead flatfish from fish farms in Jeju island, the physicochemical characteristics and the functional activities of collagen peptide extracts were investigated. Flatfish skin collagen peptide (FSCP) and flatfish protein hydrolysate (FPH) were manufactured from dead flatfish. The differences of pH, moisture and fat contents between FSCP and FPH were not significant, fat contents were analyzed less than 0.3%, and trans-fat, saturated fat and cholesterol were not detected in both samples. Protein contents of FSCP and FPH showed about 92% and 95%, respectively. In the analysis of amino acids, glycine and hydroxy proline content in FSCP was 24.22% and 6.15%, respectively, showed a typical characteristics of the collagen protein, but essential amino acids contents such as threonine, valine, methionine, isoleusine, leusine and phenylalanine were relatively higher than those of FPH. Average molecular weight of FSCP was measured as 1,102 which was almost equal value with that of tuna collagen peptide. The antioxidant activities and functional properties showed high but did not show significant difference between two samples.

• 멤브레인
• /
• 제12권3호
• /
• pp.165-170
• /
• 2002

씻어나온 쌀(무세미) 생산공정 중 발생하는 쌀뜨물 중 함유된 유효성분, 특히 단백질 회수를 위한 분리막 공정에 관하여 검토하였다. 먼저 dead-end형 Amicon 여과셀을 이용하여 단백질 농축에 적절한 분리막을 선정하였으며 이를 토대로 중공사형 한외여과 모듈 또는 가정용 정수기에 사용되는 나권형 나노여과 및 역삼투 모듈을 이용한 투과실험을 행하였다. 그 결과, 분획분자량이 10,000 dalton인 한외여과막은 쌀뜨물내 유효성분 내지는 단백q질을 농축하기에 적절하지 않았다. 그러나 역삼투 또는 나노여과 모듈에 9% 가량의 단백질이 함유된 원료용액을 250%까지 농축할 경우, 역삼투 모듈 농축액중에 단백질의 농도는 22%로서 약 2.4배가 농축되었으며 나노여과 모듈의 경우는 약 2배까지 단백질을 농축할 수 있었다.