• Journal of Energy Engineering
• /
• v.28 no.2
• /
• pp.47-54
• /
• 2019

As absorption type heat pump for waste heat recovery is installed in combined cycle power plant for Energy Service Company, performance test is implemented to confirm the operation data on partial load. The operation data changes according to the heat pump operation on partial load are as follows. Total heat output increases, because waste heat of closed cooling water and a portion of LP steam from HRSG is supplied. But electric power output of steam turbine is reduced, because LP steam to steam turbine is reduced. And heat output from HP district heater and LP district heater is reduced, because HP turbine exhaust steam to HP district heater and LP district heater is reduced. On partial load operation, turbine output reduction is higher than the base load operation. Therefore, on partial load, heat pump should be operated in consideration of the heat output increase and electric power output reduction.

• Corrosion Science and Technology
• /
• v.17 no.6
• /
• pp.287-291
• /
• 2018

In this study, corrosion behavior of a SA178-A alloy used in the boiler tube of a district heating system was investigated in different environments where it was exposed to pure water, district heating (DH) water, and filtered district heating (FDH) water. After the corrosion test, the surface morphology was examined for observation of the number of pitting sites and pitting area fraction, using a scanning electron microscope. The DH water and FDH water conditions resulted in a lower corrosion potential and pitting potential, and revealed a significantly higher corrosion rate than the pure water condition. The pitting sites in the DH water (pH 9.6) were approximately eighteen times larger than those in the pure water (pH 9.6). Compared to the DH water, the corrosion potential became more noble in the FDH water condition, where iron ions were reduced through filtration. However, the corrosion rate increased in the FDH water due to an increased concentration of chloride ions, which deteriorated the stability of passive film.

• Journal of Convergence for Information Technology
• /
• v.12 no.4
• /
• pp.345-353
• /
• 2022

The purpose of this study is to identify the types for open innovation of SMEs considering strategic- culture mixed typology and environmental dynamism. The analysis results of 182 SMEs classified into 4 groups are as follows. First, type PD had a positive effect on innovation performance in both in-bound and out-bound innovation and had improved performance through in-bound innovation in a dynamic technical environment. While DH had no significant effect on both innovations. Second, PH and DD, strategy-culture mismatched types, had a single effect of innovation that affected performance. No moderating effects of environmental dynamism had been shown in types PH, DD, DH. SMEs that aim for open innovation should strive to improve performance by aligning change-oriented strategy with creative and challenging culture.

• Restorative Dentistry and Endodontics
• /
• v.49 no.2
• /
• pp.15.1-15.11
• /
• 2024

Objectives: This study aimed to establish a single-session associative protocol for nonrestorative management of dentin hypersensitivity (DH). Materials and Methods: Twenty-four individuals with DH and a minimum sensitivity level of 4 on the visual analog scale (VAS) were selected. The study was conducted in a split-mouth design, with each participant (n = 20) having at least 1 affected tooth in all quadrants. The management protocols consisted of control group: universal adhesive, Neural Desensitizing Protocol group: 5% potassium nitrate, Mixed Desensitizing Protocol (PAM) group: 5% sodium fluoride and 5% potassium nitrate, Remineralizing Desensitizing Protocol (PDR) group: surface-partially reacted glass technology photopolymerizable varnish. Evaluations were performed immediately after application, at 1 week, 1 month, 2 months, and 12 months using the VAS sensitivity test. Results: The scores were subjected to statistical analysis using the Friedman test (p < 0.05), Durbin-Conover test (p < 0.05), and Wilcoxon test (p < 0.05). At the 12-month evaluation, all groups showed statistically significant differences compared to the initial assessment. For the evaluation after 12 months, there was a statistically significant difference between the PAM group, the control group, and the PDR group. Conclusions: It can be concluded that all groups were effective in controlling DH, but there were significant results in the control group and PDR group. The clinical relevance of this study is to demonstrate that the application of single-session desensitizing protocols can be effective in controlling DH for up to 12 months.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.11 no.3
• /
• pp.75-86
• /
• 2003

In the near future, the capacity of conventional anaerobic digester is thought to be insufficient because of the increase of the total solids from expansion of intercepting sewer, sewage quantity and direct input of night soil from near apartment districts. The objectives of this study was to investigate the improvement of digestion efficiency using microbial agent(Bio-dh). The system was a pilot-scale, two-staged, anaerobic sludge digestion system. The first-stage digester was heated and mixed. The agitation velocity of the first-stage digester was 120rpm. The second-stage digester was neither heated nor mixed. The Digestion temperature was kept at $35{\pm}1^{\circ}C$ The detention time of digester was 19 days. The dosage of sewage sludge and microbial agent were $0.65m^3/day$ and $0.5{\ell}/day$, respectively. The experiments was run for 25days. Three times a week, $COD_{Mn}$ and SS of effluent, TS, VS, and biogas production rate were measured. Temperature, pH, and alkalinity were measured daily. The results were as follows ; Without microbial agent, digestion efficiencies ranged 46.0%~50.9%(mean=48.6%), with microbial agent(Bio-dh), digestion efficiencies ranged 52.8%~57.3%(mean=54.2%). Consequently, microbial agent(Bio-dh) increased the sludge digestion efficiency about 12%. Also, Without microbial agent, the mean concentration of $COD_{Mn}$ and SS of second-stage digester effluent were 1,639mg/L, 4,888mg/L respectively. With microbial agent, the mean concentration of $COD_{Mn}$ and SS of second-stage digester effluent were 859mg/L, 2,405mg/L respectively. Consequently, microbial agent(Bio-dh) increased the removal efficiency of $COD_{Mn}$ and SS about 47.6% and 50.8%, respectively.

• Applied Biological Chemistry
• /
• v.39 no.6
• /
• pp.430-436
• /
• 1996

The induction by xylose and repression by glucose of xylose isomerase(XI) were investigated to elucidate the regulation for production of XI in Escherichia coli. Regulation for expression of xyIA gene which codes XI is under control of xylR which is a regulatory gene for xylose catabolism. When xyIR gene was resided in chromosome, the inductions of XI by the addition of 0.4% xylose were increased to 1.9 and 1.7-fold in case of locating on multicopy(pEX202/DH77) and low copy Plasmid(pEX102/DH77), respectively, as compared with that of xylA gene which was resided in chromosome(JM109). xyIR gene product derived from xyIR gene on chromosome might react to xylA gene on the plasmid as same as xylA gene on chromosome. In JM109 and xylA transformant; pEX202/DH77 and pEX102/DH77, the inductions of XI were completely repressed by the addition of 0.2% glucose and these catabolite repressions were derepressed by the addition of 1 mM cAMP In comparison with the addition of 0.4% xylose only for the induction XI was inductively produced 1.7 to 2-fold with the addition of xylose plus 1 mM cAMP in DM minimal media. pEX13/TP2010, xylA transformant of the deficient mutant($xyl^-,\;cya^-$; TP2010) of XI and cAMP production, did not induce XI by the addition of xylose only but induced in case of simultaneous addition of xylose and cAMP. These results show that cAMP and xylose are the indispensable effectors for the induction and derepression of Xl in E. coli.

• Corrosion Science and Technology
• /
• v.14 no.3
• /
• pp.113-119
• /
• 2015

Alloy 82/182 weld metals had been extensively used in joining the components of the PWR primary system. Unfortunately, there have been a number of incidents of cracking caused by PWSCC in Alloy 82/182 welds during the operation of PWR worldwide. To mitigate PWSCC, optimization of water-chemistry conditions, especially dissolved hydrogen (DH) and Zn contents, is considered as the most promising and effective remedial method. In this study, the PWSCC behaviours of Alloy 182 weld were investigated in simulated PWR environments with various DH content. Both in-situ and ex-situ oxide characterizations as well as PWSCC initiation tests were performed. The results showed that PWSCC crack initiation time was shortest in PWR water (DH: 30cc/kg). Also, high stress reduced crack initiation time. Oxide layer showed multi-layered structures consisted of the outer needle-like Ni-rich oxide layer, Fe-rich crystalline oxide, and inner Cr-rich inner oxide layers, which was not altered by the level of applied stress. To analyse the multi-layer structure of oxides, EIS measurement were fitted into an equivalent circuit model. Further analyses including TEM and EDS are underway to verify appropriateness of the equivalent circuit model.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.27 no.6
• /
• pp.1110-1116
• /
• 1998

To determine the optimum conditions for the enzymic hydrolysis against wheat gluten of high con centrations (6~14%, w/w, protein), a hydrolysis system combining weak acid pretreatment and enzymic hydrolysis was investigated. Alcalase showed the highest DH(degree of hydrolysis) of the tested proteases. After hydrolysis by alcalase, subsequently peptidases were applied for the better DH of the wheat gluten hydrolyzate. Peptidase NP2 showed the highest DH of the tested peptidases, but flavour zyme was shown for the lowest bitter taste of the resulting hydrolyzate. In order to minimize aggregation or gelling at higher initial substrate concentration during heat treatment, wheat gluten suspension was pretreated with possibly low concentrations of hydrochloric acid at 105oC for 1 hour, and then enzy matically hydrolysed with alcalase and subsequently with flavourzyme. Each required minimum concen tration of hydrochloric acid in the wheat gluten suspension of 6, 8, 10, 12, and 14%(w/w, protein) was 0.10, 0.15, 0.20, 0.225, and 0.275N, respectively. After the subsequent enzymic treatment by alcalase and peptidase NP2 for 24 hrs, the nitrogen solubility in the final wheat gluten hydrolysates was increased to 94.9, 86.4, 85.3, 89.3 and 95.0%, and their amino nitrogen content was increased to 2.87, 5.68, 7.34, 9.71 and 12.50mg/m, respectively.

• Journal of Microbiology
• /
• v.42 no.3
• /
• pp.174-180
• /
• 2004

A halophilic bacterium was isolated from fermented seafood. The 16S rDNA sequence identity between the isolate and Halomonas subglaciescola AJ306801 was above 95％. The isolate that did not grow in the condition without NaCl or in the condition with other sodium (Na$\^$+/) or chloride ions (Cl$\^$-/) instead of NaCl was named H. subglaciescola DH-l. Two mutants capable of growing without NaCl were obtained by random mutagenesis, of which their total soluble protein profiles were compared with those of the wild type by two-dimensional electrophoresis. The external compatible solutes (betaine and choline) and cell extract of the wild type did not function as osmoprotectants, and these parameters within the mutants did not enhance their growth in the saline environment. In the proton translocation test, rapid acidification of the reactant was not detected for the wild type, but it was detected for the mutant in the condition without NaCl. From these results, we derived the hypothesis that NaCl may be absolutely required for the energy metabolism of H. subglaciescola DH-l but not for its osmoregulation, and the mutants may have another modified proton translocation system that is independent of NaCl, except for those mutants with an NaCl-dependent system.

• Korean Journal of Microbiology
• /
• v.28 no.1
• /
• pp.27-34
• /
• 1990

Two macrolide-lincosamide-streptogramin B (MLS) antibiotic resistance genes, one expressed inducibly and the other expressed constitutively were recognized from a single Staphylococcus aureus DH1 strain. The inducible MLS resistance gene was isolated and cloned from the R-plasmid pDE1(7.4kb) and the constitutive gene was from chromosomal DNA. Base sequence of the inducible MLS resistance gene (1.2kb) was determined and found as same that of pE194. The restriction map of the cloned constitutive MLS resistance gene was compared with that of the inducible gene. Two genes have same restriction map except leader region. In the constitutive gene there is no leader region which is doing major role in inducible expression.