• Proceedings of the KIPE Conference
• /
• 2016.07a
• /
• pp.293-294
• /
• 2016

태양광 발전 시스템은 그 필요성이 늘어남에 따라 다양한 연구가 진행되고 있다. 기존에 태양광 발전 제어 방식인 스트링 방식이나, 마이크로 컨버터 같은 방식 이외에도 그늘짐 등으로 인해 발생한 태양광 모듈의 전력 차이만을 부담하는 컨버터를 이용한 차동 전력 조절 방식도 연구가 되고 있다. 차동 전력조절기는 담당하는 전력이 적고, 스트링 컨버터를 통해 많은 전력이 전달이 되어 기존의 방식 보다 효율이 높다. 하지만, 태양광 모듈 MPPT 전압으로 부터 DC_link 전압만큼의 승압이 필요하다. 따라서, 고승압, 고효율 컨버터를 차동 전력 조절기로 사용을 하면 기존의 차동 전력 방식보다 더 나은 동작 특성을 가질 수 있다. 따라서 본 논문에서는 차동 전력 조절기로 고승압의 컨버터 토폴로지를 사용하여, 기존의 방식보다 고효율을 유지하면서 차동 전력 조절기의 기능을 수행하는 구조를 제안한다.

• Proceedings of the KIPE Conference
• /
• 2016.07a
• /
• pp.151-152
• /
• 2016

This paper presents a neutral point deviation compensating control algorithm applied to a 3-level NPC converter under generalized unbalanced ac input conditions. The neutral point deviation is analyzed with a focus on the current flowing out of or into the neutral point of the dc-link in 3-level NPC converter. The model of neutral point deviation and neutral current are also constructed. The positive and negative sequence components of the pole voltages and ac input currents are employed to accurately explain the behavior of 3-level NPC converter and its impact on neutral point deviation. This paper includes the harmonic characteristic of neutral point current under various imbalance AC operating conditions.

• Proceedings of the KIPE Conference
• /
• 2016.07a
• /
• pp.173-174
• /
• 2016

This paper proposes a comparison of Voltage Oriented Control (VOC) and Direct Power Control (DPC) under command mode transition for PMSG Wind Turbines (WT). Based on a neutral point clamped three level back to back type Voltage Source Converter (VSC), proposed control scheme automatically control the generated output power to satisfy a grid requirement from the hierarchical wind farm controller. Automatic command mode transition based on the dc-link voltage error provides a command mode changing between grid command and MPPT mode. It is confirmed through PLECS simulations in Matlab. Simulation result shows that proposed control scheme of VOC and DPC achieves a much shorter transient time of generated output power than the conventional control scheme of MPPT with optimal torque control and VOC under a step response. The proposed control scheme makes it possible to provide a good dynamic performance for PMSG wind turbines in order to generate a high quality output power.

• Proceedings of the KIPE Conference
• /
• 2011.11a
• /
• pp.297-298
• /
• 2011

최근 계통연계형 인버터 시스템에서 고 신뢰 운전이 매우 중요한 과제로 대두되고 있다. 특히 인버터의 고장에 관한 많은 연구가 진행되고 있다. 본 논문에서는 계통연계형 인버터에서 직류단 전압 센서의 고장 허용 제어 알고리즘을 제안한다. 직류단 전압의 추정값으로 고장의 발생 시에 허용 제어를 수행한다. 매우 빠른 동특성을 가진 제어기가 요구되는 제안된 알고리즘의 적용을 위해 데드비트 전류제어기를 사용한다. 시뮬레이션을 통해 제안된 알고리즘을 검증한다.

• Proceedings of the KIPE Conference
• /
• 2011.11a
• /
• pp.14-15
• /
• 2011

본 논문에서는 단상입력을 가지고, 직류단에 소형 캐패시터를 사용하는 인버터를 사용해 3상 전동기 가변속 구동을 한다. 이때 주기적으로 크게 맥동하는 직류단 전압 조건에서 어떻게 전동기를 제어하는가에 대해 언급한다. 평균 전압 제한원을 전류 영역에 표현하고, 새로운 약자속 영역을 정의한다. 이를 바탕으로 전류 지령을 생성하는 제어기를 구성하여 전동기를 제어할 수 있는 기법을 제안하고 이를 실험을 통해 검증한다. 이를 통해 입력 전류의 고조파를 줄여 역율도 개선할 수 있다.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.4 no.5
• /
• pp.413-422
• /
• 1999

Auto-connected multipulse(12/24pulse) rectifier schemes are cost effective methods for reducing line current hamonics in PWM drive systems. Employing these schemes to enhance utility power quality requires careful attention to several design considerations In particular, excursion of dc-link voltage at no load, effect of pre-existing voltage distortion, impedance mismatches, unequal diode drops on rectifier current sharing and performance, are fully analyzed, Several corrective measures to improve the performance of 12/24­pulse rectifier systems are also discussed. Finally, experimental results on a 460V, 60Hz 400kVA commercial ASD, retrofitted with 12/24pulse rectifier systems are discussed in detail.

• Proceedings of the KIEE Conference
• /
• 1991.11a
• /
• pp.164-166
• /
• 1991

This paper achieved by Pulse-Withed Modulation of the inverter switchs. But Conventional PWM inverter is employed hard switching by means a switching device. Moreover, this paper presents resonant DC link Voltage type inverter thet it was not necessary snubber circuit and dead time and modeling of motor drive control system and simulating analysis are discussed.

• Proceedings of the KIEE Conference
• /
• 1990.11a
• /
• pp.295-300
• /
• 1990

This paper describes a new method to increase the fundamental output of PWM inverter by adding all triplen-harmonics to sinusoidal reference wave. As a result, the amplitude of the fundamental component is increased upto 21 percent compared with the conventional SPWM method, and hence the conversion efficiency of dc link is higher. Also as the commutation number of the inverter is decreased to two-thirds, the heating of the switch devices is reduced. In addition random carrier modulation is adopted to lower the acoustic noise at given frequency modulation index.

• Proceedings of the KIEE Conference
• /
• 1996.07a
• /
• pp.550-552
• /
• 1996

In order to develop a noble Uninterruptible Power Supply(UPS), we designed and manufactured the UPS using the PWM converter and the Resonant DC Link Inverter. This paper describes the power circuits, the key techniques, the control and monitoring unit of the developed UPS. Finally, using the UPS we verified the superiority through the type test.

• Proceedings of the KIEE Conference
• /
• 1996.07a
• /
• pp.501-503
• /
• 1996

In this paper, a novel control strategy for PWM current source converter and inverter is proposed, applying a multivariable state feedback control. The PWM converter controls line current to be sinusoidal and make input power factor unity. In addition, the modulation index control of dc link current is carried out, which produces lower loss of switching devices. Since the voltage control of inverter output filter capacitor is performed a decoupling of the d-q current of the induction motor is well retained. With the proposed algorithm, both high dynamic responses and satisfactory static performance can obtained.