• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.2
• /
• pp.127-142
• /
• 2013

A dual-user multiplexing scheme for a pair of mobiles equipped with single antenna is proposed which incorporates time-delay diversity employing a rotation-based D-BLAST-like layered code. A low-dimension equivalent of the existing partial interference cancellation based group decoder is also proposed for the corresponding receiver. The BER performances of the proposed scheme and those of the ideal scheme are studied comparatively through Monte Carlo simulations.

• Journal of Advanced Navigation Technology
• /
• v.6 no.3
• /
• pp.241-250
• /
• 2002

This paper presents a way to maximize transmission efficiency and reception ability through transmission diversity technology, which can be adapted to wireless multimedia OFDM system. The presented method is a comparative analysis between a case where parameter ${\alpha}$ for time average is 0.3, 1 with consideration of channel presumption with two types of rms delayed spread, which is 50nsec, 150nsec, for the performance analysis of STTC(Space-Time Trellis Code) using time-space ciphering method appropriate for MIMO channel, and performance in the case where presumed channel value from long training column section is applied to according frame in a single frame. The result showed that BER brought SNR improvement of 1.0 dB in $10^{-3}$ when ${\alpha}$ was 0.3 than using only the long training column, and showed increase of general performance improvement for the sake of time average rather than the case without.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.7
• /
• pp.2972-2991
• /
• 2016

WLAN is the best choice in the place where complex network is hard to set up. Intelligent terminals are more and more assembled in some areas now. However, according to IEEE 802.11n/802.11ac, the access-point (AP) can only serve one user at a single frequency channel. The spectrum efficiency urgently needs to be improved. In theory, AP with multi-antenna can serve multiple users if these users do not interfere with each other. In this paper, we propose a user clustering scheme that could achieve multi-user selection through the mutual cooperation among users. We focus on two points, one is to achieve multi-user communication with multiple antennas technique at a single frequency channel, and the other one is to use a way of distributed users' collaboration to determine the multi-user selection for user clustering. Firstly, we use the CSMA/CA protocol to select the first user, and then we set this user as a source node using users' cooperation to search other proper users. With the help of the users' broadcast cooperation, we can search and select other appropriate user (while the number of access users is limited by the number of antennas in AP) to access AP with the first user simultaneously. In the network node searching, we propose a maximum degree energy routing searching algorithm, which uses the shortest time and traverses as many users as possible. We carried out the necessary analysis and simulation to prove the feasibility of the scheme. We hope this work may provide a new idea for the solution of the multiple access problem.

• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.2 no.2
• /
• pp.36-45
• /
• 2003

This paper presents a way to maximize transmission efficiency and reception ability through transmission diversity technology, which can be adapted to wireless multimedia OFDM (orthogonal FDM) system. The presented method gives a comparative analysis between a case where parameter a for time average is 0.3, i with consideration of channel presumption and two types of rms delayed proliferation, which is 50nsec, 150nsec, for the performance analysis of STTC (Space-Time Trellis Code) using time-space code method which is appropriate for MIMO channel, and performance, in the case, where presumed channel value from long training column section is applied to the according frame in a single frame. The result shows that BER brought SNR improvement of 1.0dB in $10^{-3}$ when a was 0.3 than using only the long training column, and shows an increasement of general performance improvement when the time average factor is used.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.10A
• /
• pp.1177-1188
• /
• 2004

This paper describes and analyzes the performance of MB-OFDM UWB system that is suggested as one of standards in IEEE 802.15 TG3a for UWB application. UMBchannel model that has been contributed in IEEE 802.15 SG3a is a wideband channel model of 6Ghz bandwidth, so we modify it to have 3 subband channels that are obtained by filtering conventional U Channel, considering center frequency hopping and system bandwidth. From simulations, we compare performances of MB-OFDM system in AWGN and WB channel and verify the frequency and time domain diversity gains from time End frequency spreading technique. We also compare and analyze the performance of proposed SFBC MB-OFDM with that of conventional MB-OFDM system. Simulation results show SFBC MB-OFDM system outperforms conventional MB-OFDM system about 1.5dB of Eb/No at target BER of 10$^{-m4}$./.

• Journal of Advanced Navigation Technology
• /
• v.20 no.4
• /
• pp.344-351
• /
• 2016

In the present study, a dual-band multiple-input-multiple-output (MIMO) antenna covering WLAN frequency bands of 2.4 GHz (2.4 ~ 2.484 GHz) and 5 GHz (5.15 ~ 5.825 GHz) is newly presented to avoid use of decoupling structure for increasing isolation. The antenna consists of two L-shaped slots with n-shaped slots etched on the floating ground plane surrounded by open ended L-shaped slots which are placed in the left and right corner of PCB respectively. The proposed antenna is designed and fabricated on one side of FR4 substrate with dielectric constant of 4.3, thickness of 1.6 mm, and size of $50{\times}50mm2$. It has been observed that the measured impedance bandwidths ($S_{11}{\leq}-10dB$) are 0.3 GHz (2.28 ~ 2.58 GHz) in 2.4 GHz frequency band and 0.89 GHz (5.11 ~ 6 GHz) in 5 GHz frequency band respectively. In addition, It has been observed that the whole efficiency are more than 80 % in the whole operating frequency band and envelope correlation coefficient of the antenna is less than 0.05 as a very small value in spite of nothing of the decoupling structure.

• Journal of Advanced Navigation Technology
• /
• v.15 no.6
• /
• pp.1068-1074
• /
• 2011

In this paper, the proposed scheme is STBC(space-time block codes) system combined with convolution code which is the most popular channel coding to ensure the reliability of data transmission for a high data rate wireless communication. The STBC is one of MIMO(multi-input multi-output) techniques. In addition, this scheme uses a modified viterbi algorithm in order to get a high system gain when data is transmitted. Because we combine STBC and convolution code, the proposed scheme has a little high quantity of computation but it can get a maximal diversity gain of STBC and a high coding gain of convolution code at the same time. Unlike existing viterbi docoding algorithm using Hamming distance in order to calculate branch matrix, the modified viterbi algorithm uses Euclidean distance value between received symbol and reference symbol. Simulation results show that the modified viterbi algorithm improved gain 7.5 dB on STBC 2Tx-2Rx at $BER=10^{-2}$. Therefore the proposed scheme using STBC combined with convolution code can improve the transmission reliability and transmission efficiency.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.12 no.6
• /
• pp.636-642
• /
• 2019

In this paper, we analyzed BER (Bit Error Rate) communication performance according to the detection order of MMSE (Minimum Mean Square Error) based soft decision interference cancellation. As the detection order method, antenna index order method, absolute value magnitude order method of channel elements, absolute value sum order method of channel elements, and SNR (Signal Noise Ratio) order method are proposed. BER performance for the scheme was measured and analyzed. As a simulation environment, 16-QAM (Quadrature Amplitude Modulation) modulation is used in an uncoded environment of an M×M multiple-input multiple-output system, and an independent Rayleigh attenuation channel is considered. The simulation results show that the performance gain is about 1.5dB when the SNR-based detection order method is M=4, and the performance gain is about 3.5dB when M=8 and about 3.5dB when M=16. The more BER performance was confirmed, the more the detection order method of the received signal prevented the interference and error spreading occurring in the detection process.

• ETRI Journal
• /
• v.39 no.4
• /
• pp.514-524
• /
• 2017

In this paper, we propose a spatial modulation (SM) scheme referred to as complex quadrature SM (CQSM). In contrast to quadrature SM (QSM), CQSM transmits two complex signal constellation symbols on the real and quadrature spatial dimensions at each channel use, increasing the spectral efficiency. To achieve that, signal symbols transmitted at any given time instant are drawn from two different modulation sets. The first modulation set is any of the conventional QAM/PSK alphabets, while the second is a rotated version of it. The optimal rotation angle is obtained through simulations for several modulation schemes and analytically proven for the case of QPSK, where both results coincide. Simulation results showed that CQSM outperformed QSM and generalized SM by approximately 5 dB and 4.5 dB, respectively, for the same transmission rate. Its performance was similar to that of QSM; however, it achieved higher transmission rates. It was additionally shown numerically and analytically that CQSM outperformed QSM for a relatively large number of transmit antennas.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2005.06a
• /
• pp.1901-1905
• /
• 2005

This Paper describes the mathematical modeling and control of the tension and the speed of moving Bio-wrap in a wrap winding machine. In winding process, important control specifications include the regulation of wrap tension and velocity. In this research, a tension and velocity model has been developed for winding processes. A prototype winding system has been constructed, and the controller has been implemented in a real time PC-based environment. The tension control system is modeled a MIMO of the two-input and four-output system. The performance of the modeled system has been evaluated via simulation using MATLAB and experiments.