• The Korean Journal of Physiology
• /
• v.14 no.1
• /
• pp.7-13
• /
• 1980

In the previous experiment, authors have shown that during the latter half of estrous cycle there was an increase in plasma testosterone level in the rats stimulated with hCG. To determine the physiologic significance of elevated plasma testosterone, changes of the plasma concentrations of TeBG and testosterone following hCG stimulation were analyzed in the rats having a regular 5 day cycle. The rats were divided into three groups; the control, the rats stimulated with single hCG on the day of proestrus and stimulated with hCG throughout the entire cycle. Blood samples were obtained once a day for an estrous cycle and analyzed for the binding capacity of TeBG using ammonium sulphate precipitation method and testosterone concentration by means of radioimmunoassay. Followings were the results; 1) There was no significant variation in the binding capacity of TeBG in peripheral blood during the estrous cycle of the control rats. 2) No cyclic variation in the binding capacity of TeBG was observed in the rats stimulated with single hCG on proestrus. although the levels tended to be higher in the rats with stimulation than in the control rats. 3) Continual stimulation of hCG produced a marked increase in the binding capacity of TeBG especially on the day of metaestrus. 4) The changes in the plasma level of testosterone followed the same basic pattern seen in the TeBG binding capacity. 5) From above results, the followings were suggested. a. hCG related increase of the binding capacity of TeBG is probably secondary to a modest increase in estrogen as well. b. hCG related increase of plasma testosterone in female rats is not entirely due to excess production rather in part due to decreased metabolism induced by the rise in TeBG. c. It seems likely that most of elevated testosterone shown in the rat stimulated with hCG is bound to TeBG and only small portion is unbound form which influence cellular activity. It is rather possible that an increase in TeBG could augment estrogen activity.

• New & Renewable Energy
• /
• v.10 no.1
• /
• pp.6-19
• /
• 2014

Organic Rankine cycle (ORC) has been widely used to convert renewable energy such as solar energy, geothermal energy, or waste energy etc., to electric power. For a small scale output power less than 10 kW, turbo-expander is not widely used than positive displacement expander. However, the turbo-expander has merits that it can operate well at off-design points. Usually, the available thermal energy for a small scale ORC is not supplied continuously. So, the mass flowrate should be adjusted in the expander to maintain the cycle. In this study, nozzles was adopted as stator to control the mass flowrate, and radial-type turbine was used as expander. The turbine operated at partial admission. R245fa was adopted as working fluid, and supersonic nozzle was designed to get the supersonic flow at the nozzle exit. When the inlet operating condition of the working fluid was varied corresponding to the fluctuation of the available thermal energy, optimal operating condition was investigated at off-design due to the variation of mass flowrate.

• KDI Journal of Economic Policy
• /
• v.31 no.2
• /
• pp.47-85
• /
• 2009

With a relatively simple quantitative method, this study comprehensively analyzes the characteristics related to business cycles represented by macroeconomic variables of Korea since 1970. This empirical analysis deals with roughly following three topics: How to identify cyclical component with respect to trend; with what characteristics and how the economic variables of each sector move with in the phases of business cycle, and; whether there are signs of a structural change in the phases of business cycle. Section 2 discusses how to identify trends and cycle components, the basis assumption for the analysis of business cycle. Like the Korean economy, where a relatively high growth rate has been maintained, it is appropriate to determine its economic recession based on the fall in the growth trend, not in the absolute level of real output. And, it is necessary to apply the concept of growth cycle against a traditional concept of business cycle. Accordingly the setting of growth trend is of preliminary importance in identifying cyclical fluctuations. The analysis of Korea's GDP data since 1970, the decomposition of trends and cycles through the Band-pass filter is found to appropriately identify the actual phases of busyness cycle. Section 3 analyzes what particular relationship various economic variables have with output fluctuations during the phases of economic cycle, using the corss-correlation coefficients and prediction contribution. Section 4 monitors the stability of the phases of Korea's business cycle and quantitatively verifies whether there is a structural break, and then reviews the characteristics of variations in each sector. And, stylized facts observed through these studies are summarized in the conclusion. The macroeconomic stability of Korea, in particular, is found to continue to improve since 1970, except for the financial crisis period. Not only that, it is found that its volatility of economic growth rate as well as inflation have been reduced gradually. Meanwhile, until recently since 2000, the volatility in domestic demand has remained stable, while that in exports and imports has been increased slightly. But, in an over all perspective, Korea's business cycle variation is on the decline due to shorter response period to shocks and the formation of complementary relationship among economic sectors.

• Journal of Applied Biological Chemistry
• /
• v.51 no.6
• /
• pp.262-271
• /
• 2008

Natural abundances of stable isotopes of nitrogen and carbon (${\delta}^{15}N$ and ${\delta}^{13}C$) are being widely used to study N and C cycle processes in plant and soil systems. Variations in ${\delta}^{15}N$ of the soil and the plant reflect the potentially variable isotope signature of the external N sources and the isotope fractionation during the N cycle process. $N_2$ fixation and N fertilizer supply the nitrogen, whose ${\delta}^{15}N$ is close to 0%o, whereas the compost as. an organic input generally provides the nitrogen enriched in $^{15}N$ compared to the atmospheric $N_2$. The isotope fractionation during the N cycle process decreases the ${\delta}^{15}N$ of the substrate and increases the ${\delta}^{15}N$ of the product. N transformations such as N mineralization, nitrification, denitrification, assimilation, and the $NH_3$ volatilization have a specific isotope fractionation factor (${\alpha}$) for each N process. Variation in the ${\delta}^{13}C$ of plants reflects the photosynthetic type of plant, which affects the isotope fractionation during photosynthesis. The ${\delta}^{13}C$ of C3 plant is significantly lower than, whereas the ${\delta}^{13}C$ of C4 plant is similar to that of the atmospheric $CO_2$. Variation in the isotope fractionation of carbon and nitrogen can be observed under different environmental conditions. The effect of environmental factors on the stomatal conductance and the carboxylation rate affects the carbon isotope fractionation during photosynthesis. Changes in the environmental factors such as temperature and salt concentration affect the nitrogen isotope fractionation during the N cycle processes; however, the mechanism of variation in the nitrogen isotope fractionation has not been studied as much as that in the carbon isotope fractionation. Isotope fractionation factors of carbon and nitrogen could be the integrated factors for interpreting the effects of the environmental factors on plants and soils.

• Journal of Ocean Engineering and Technology
• /
• v.13 no.4 s.35
• /
• pp.55-62
• /
• 1999

Cold rolled steel has much plastic strain in the material surface produced by manufacturing process. The strain causes the variation of surface residual stress, in which influences the fatigue behavior under repeated loading. As experimental results, it was confirmed that the behavior of residual stress ${\sigma}_r$, with cycle N consisted of three stages except stress amplitude near fatigue limit in SPCC steel. On the first stage compressive residual stress decreased rapidly, on the second stage gradually, and on the last stage slightly. The relation between ${\sigma}_r$, and log N appeared linear behavior except the early part of cycle ratio $N/N_f$. The average gradient of ${\sigma}_r$, with respect to log N seemed to take a constant value without initial cycle ratio. On the other hand, the $N_f$ line was regressed by the first-order polynomial equation on ${\sigma}_r-log\;N_f$ diagram. Therefore, this study showed that both the gradient of ${\sigma}_r$, with respect to log N and the $N_f$ line was useful in predicting the cycle ratio $N/N_f$.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.5 no.3
• /
• pp.198-206
• /
• 1993

Experimental results of two stage Gifford-McMahon cryorefrigerator are described. In-prototype experiments, drive mechanism is Scotch Yoke type driven by stepping motor, copper meshes and lead balls are used for regenerator's materials in the first stage and the second stage, respectively. To find optimal conditions of the cryopump, no load temperature and refrigeration capacity according to the variation of cycle frequency and operating pressure are measured, and the cool down and load characteristics at particular cycle frequencies are presented. In general, as the cycle frequency is lowered, no load temperature is dropped but refrigeration capacity is diminished. As the representative result, in a case that the cycle frequency is 70rpm and steady state pressure is 14 atm, no load temperature of second stage is lowered to 10.5K in 55 minuters, and in this situation the refrigeration capacity of the first stage is 42W at 80K, that of the second stage is 11 W at 20K.

• Development and Reproduction
• /
• v.21 no.3
• /
• pp.297-305
• /
• 2017

An experiment was conducted to investigate the annual reproductive cycle of a Korean endemic species, Acheilognathus majusculus, from Jeokseong-myeon located in Seomjin River. The reproductive cycle is examined histologically regarding water temperature and day length of the habitat, the gonadosomatic index (GSI), the female ovipositor length index (OLI), monthly variation in egg diameter distribution, and developmental characteristics of female and male gonads. The maximum GSI was found in $19.21{\pm}2.32$ and $6.90{\pm}0.53$ for female and male respectively when water temperature ($14^{\circ}C$) and day length (11.1hr) began to rise. On the other hand, the minimum level was reached during August ($1.87{\pm}0.67$ for female and $0.88{\pm}0.50$ for male). No samples represent with measurable ovipositor between September and November, while the longest ovipositor length index was in April ($79.68{\pm}4.69%$). We compared and calculated the stages of testis and ovary development process in order to determine the germ cell development characteristics and the reproductive cycle. According to the result, we classified the female Acheilognathus majusculus reproductive cycle into four stages: Ripe (April) and spawning phase (May to June), degenerative phase (July), growing phase (August to December), and mature phase (January to March). The annual reproductive cycle of male Acheilognathus majusculus was categorized into five stages viz. Ripe and spawning phase (May to June), degenerative phase (July to August), resting phase (September to November), growing phase (December to February), and mature phase (March to April).

• Culinary science and hospitality research
• /
• v.2
• /
• pp.59-87
• /
• 1996

This study has been done by giving the guide when development of menu or doing marketing strategy in Hotel Restaurant. All products and service has a regular course from induction in market to disappear, so it shall be come out Products Life Cycle theory. In eating business, under the tendency and existing cycle to change menu by taste of customers, liking variation, change of periodic status (environment), MLC(Menu Life Cycle) shall be advised by application PLC(Products Life Cycle) in the process of induction of some menu first and spreading the same business field and then deletion (disappearance) from menu because of no popular. In Emergence Stage, it shall be tried to inform new menu through Cooking Contest, presentation of new menu, free sampling party and others. In Growth Stage, it shall be changed package menu or set menu. In Maturity Stage, it shall be provided complimentary ticket, gift coupon or discount for the customers with some degree of selling record in order to increase using frequency and selling amount after insure new customers. In Decline Stage, it shall be groped for entry underdeveloped country or less advance nation, but there is no possibility to devote in enterprise, it shall be planned substitute menu development in order to withdraw. By inducting MLC concept, it shall be provided the available informations such as“how could some menu be circulate in some restaurant”“Accordingly do strengthen promotion activities or go to low developed area or overseas, or delete it from menuitems and so on”. In the time of decline some menu, it is judged to the time of plan(preparation) of new menu development. In the broad view, when consideration of the concept of menu life cycle, it shall be possible to know which menu is decayed and which menu is developed newly or grown-up, so it shall be provided the important information to estimate the tendency of changing menu and set-up a menu development plan.

• Journal of Advanced Marine Engineering and Technology
• /
• v.18 no.1
• /
• pp.114-122
• /
• 1994

A cold temperature control system for the BAF(batch annealing furnace) has been established in order to reduce energy consumption to imrpove productivity and stabilize the properties of products. Therefore we confirmed a relation between annealing cycle time and atmospheric gas, changing annealing cycle time according to BAF temperature with time during heating and actual temperature measurements cold spot during soaking. The results of the temperature variation effect on the batch annealing are as follows. 1) Cooling rate is increasing gradually with increasing atmospheric gas flow, but heating rate is hardly increasing without atmospheric gas component. Heating time is reduced to one half with increasing atmospheric gas flow rate and changing of atmospheric gas component from HNx to Ax gas and annealing cycle time is reduce to 2.7 times. 2) With enlarging the difference between furnace temperature and soaking temperature at the HNx BAF, heating time becomes short, but cooling time is indifferent. 3) If temperature difference of 300.deg. C in the temperature change of cold spot according to the annealing cycle control temperature, Hi-CON/H2BAF is interchanging at each other at 26hours, but HNxBAF at 50 hours. 4) Soaking time at batch annealing cycle determination is made a decision by the input coil width, and soaking time for quality homogenization of 1219 mm width coil must be 2.5 hours longer then that of 914mm width coil for the same coil weight at Hi-CON/H2BAF. But, it is necessary to make 2 hours longer at HNxBAF.

• Environmental Engineering Research
• /
• v.22 no.3
• /
• pp.266-276
• /
• 2017

A life cycle impact assessment was applied in an industrial waste incineration plant to evaluate the direct and indirect environmental impacts based on toxicity and non-toxicity categories. The detailed life cycle inventory of material and energy inputs and emission outputs was compiled based on the realistic data collected from a local industrial waste incineration plant, and the Korean life cycle inventory and ecoinvent database. The functional unit was the treatment of 1 tonne of industrial waste by incineration and the system boundary included the incineration plant and landfilling of ash. The result on the variation of the impact by the unit processes showed that the direct impact was decreased by 79.3, 71.6, and 90.1% for the processes in a semi dry reactor, bag filter, and wet scrubber, respectively. Considering the final impact produced from stack, the toxicity categories comprised 91.7% of the total impact. Among the toxicity impact categories, the impact in the eco-toxicity category was most significant. A separate estimation of the impact due to direct and indirect emissions showed that the direct impact was 97.7% of the total impact. The steam recovered from the waste heat of the incineration plant resulted in a negative environmental burden.