• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 학술대회 논문집 전문대학교육위원
• /
• pp.98-101
• /
• 2002

The switching-mode power converter has been widely used because of its features of high efficiency and small weight and size. These features are brought by the ON-OFF operation of semiconductor switching devices. However, this switching operation causes the surge and EMI(Electromagnetic Interference) which deteriorate the reliability of the converter themselves and entire electronic systems. This problem on the surge and noise is one of the most serious difficulties in AC-to-DC converter. In the case of carrier frequency selection, output-voltage of steady state and transient state is fully regulated. A RPWM control method was proposed in order to smooth the switching noise spectrum and reduce it's level. Experimental results are verified by converter operating at 300V/1kW with 5%${\sim}$30% white noise input. Spectrum analysis is performed on the Phase current and the CM noise voltage. The former is measured with Current Probe and the latter is achieved with USN. which are connected to the spectrum analyzer respectively.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2015년도 전력전자학술대회 논문집
• /
• pp.319-320
• /
• 2015

A hybrid converter for the on-board charger consisting of a soft switching full bridge (SSFB) and a half bridge (HB) LLC resonant converter is proposed. The proposed topology adopts an additional switch and a diode at the secondary side of SSFB converter to guarantee the wide ZVS range of primary side switches and to eliminate the circulating current. The output voltage is regulated by controlling the duty cycle of secondary side switch. The effectiveness of the proposed converter was experimentally verified using a 10-kW prototype circuit. The experimental results show 96.8% peak efficiency.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 하계학술대회 논문집 A
• /
• pp.365-367
• /
• 1995

This paper is concerned on developing low-voltage high-current DC-DC converter using FB-ZVS PWM Converter. The converter output is 28V, 100A and regulated by phase-shift control method. IGBT is used by the main switching device and high frequency transformer is made for operating at 30kHz switching frequency. When the load vary widely, converter's ZVS characteristic is expressed by experiment result.

• 전력전자학회논문지
• /
• 제12권6호
• /
• pp.465-471
• /
• 2007

본 논문에서는 새로운 소프트 스위칭형 PFC 벅-부스트 AC-DC 컨버터에 대해 연구된다. 제안된 컨버터에 사용된 제어스위치의 턴-온과 턴-오프는 부분공진 동작에 의해 소프트 스위칭으로 되어 스위칭 손실을 줄이고, 입력전류는 듀티율 일정제어에 의한 교류 입력전압의 크기에 비례된 불연속적 유사 펄스열의 정현파 형태를 가진다. 그 결과 컨버터는 효율이 증대되고 입력역률이 증대되는 효과를 가진다. 또한 제안된 컨버터의 출력전압은 제어스위치의 PWM 제어에 의해 조정되고 벅-부스트용 인덕터에 흐르는 전류는 불연속모드로 제어되어 제어회로와 제어기법이 간단한 장점이 주어진다. 제안된 PFC 벅-부스트 컨버터는 기존의 PFC 벅-부스트 컨버터와 비교되어 해석되고 컴퓨터 시뮬레이션과 실험을 통해 그 해석적 타당성이 입증된다.

• 전기학회논문지P
• /
• 제61권4호
• /
• pp.206-213
• /
• 2012

This paper propose a improved speed control system for five-phase squirrel-cage induction motor(IM) considering effects of 3rd. harmonic current components with field oriented control(FOC) A five-phase IM drives present unique characteristics due to the additional degrees of freedom and also drives possess many others advantage compared with the traditional three-phase motor drive system, such as reducing a amplitude of torque pulsation at low frequency and increasing the reliability. In order to maximize the torque per ampere, the proposed motor has concentrated windings. The produced back-electromotive force is almost trapezoidal, and the motor is supplied with the combined sinusoidal plus third harmonic of currents. There is necessary to controlled 3rd harmonic current. For presenting the superior performance of the proposed the speed control system, experimental results are presented using a 32-bit fixed point TMS320F2812 DSP with 1.5[KW] induction motor.

• Journal of Power Electronics
• /
• 제17권3호
• /
• pp.653-663
• /
• 2017

Multilevel active neutral-point-clamped (ANPC) converter combines the advantages of three-level ANPC converter and multilevel flying capacitor (FC) converter. However, multilevel ANPC converter often suffers from capacitor voltage balancing problems. In order to solve the capacitor voltage balancing problems for five-level ANPC converter, phase-shifted pulse width modulation (PS-PWM) is used, which generally provides natural voltage balancing ability. However, the natural voltage balancing ability depends on the load conditions and converter parameters. In order to eliminate voltage deviations under steady-state and dynamic conditions, the active voltage-balancing control (AVBC) methods of floating capacitors and dc-link capacitors based on PS-PWM are proposed. First, the neutral-point current is regulated to balance the neutral-point voltage by injecting zero-sequence voltage. After that, the duty cycles of the redundant switch combinations are adjusted to balance the floating-capacitor voltages by introducing moderating variables for each of the phases. Finally, the effectiveness of the proposed AVBC methods is verified by experimental results.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 제37회 하계학술대회 논문집 B
• /
• pp.781-782
• /
• 2006

This paper presents a drive strategy to reduce torque ripple of a permanent magnet Brushless DC Motor(BLDCM) with short $120^{\circ}$ flat top Back Electromotive Force(Back-EMF). In this strategy, the phase Back-EMF is divided into four sections. Then, in each section the phase current is regulated by corresponding PWM duty ratio to compensatethe torque ripple caused by imperfect Back-EMF. A program based on this strategy has been implemented in MATLAB@Simulink. The validity of the presented method is verified by simulation results.

• 전력전자학회논문지
• /
• 제12권5호
• /
• pp.394-399
• /
• 2007

본 논문에서는 소프트 스위칭에 의한 새로운 고효율의 벅-부스트 DC-DC 컨버터에 대해 연구된다. 제안된 벅-부스트 컨버터는 기존의 벅-부스트 DC-DC 컨버터에서 문제가 되는 제어용 스위치의 스위칭 손실증대를 해결하기 위해 새로운 소프트 스위칭 기법이 적용된다. 소프트 스위칭 회로는 구조적으로 기존의 컨버터에 사용되는 벅-부스트용 인덕터와 스너버 회로를 변형 설계한 구조로써 회로구성이 간단하다. 제안된 컨버터에 사용된 제어스위치들은 부분공진의 동작에 의해 소프트 스위칭을 이룬다. 또한 컨버터의 출력전압은 제어스위치의 PWM 제어에 의해 조정되고 벅-부스트용 인덕터에 흐르는 전류는 불연속모드로 제어되어 제어회로와 제어기법이 간단한 장점이 주어진다. 제안된 벅-부스트 컨버터는 기존의 벅-부스트 컨버터와 비교되어 해석되고 컴퓨터 시뮬레이션과 실험을 통해 그 해석적 타당성이 입증된다.

• 전기학회논문지P
• /
• 제51권3호
• /
• pp.120-125
• /
• 2002

The switching-mode power converter has been widely used because of its features of high efficiency and small weight and size. These features are brought by the ON-OFF operation of semiconductor switching devices. However, this switching operation causes the surge and EMI(Electromagnetic Interference) which deteriorate the reliability of the converter themselves and entire electronic systems. This problem on the surge and noise is one of the most serious difficulties in AC-to-DC converter. In the switching-mode power converter, the output voltage is generally controlled by varying the duty ratio of main switch. When a converter operates in steady state, duty ratio of the converter is kept constant. So the power of switching noise is concentrated in specific frequencies. Generally, to reduce the EMI and improve the immunity of converter system, the switching frequency of converter needs to be properly modulated during a rectified line period instead of being kept constant. Random Pulse Width Modulation (RPWM) is performed by adding a random perturbation to switching instant while output-voltage regulation of converter is performed. RPWM method for reducing conducted EMI in single switch three phase discontinuous conduction mode boost converter is presented. The more white noise is injected, the more conducted EMI is reduced. But output-voltage is not sufficiently regulated. This is the reason why carrier frequency selection topology is proposed. In the case of carrier frequency selection, output-voltage of steady state and transient state is fully regulated. A RPWM control method was proposed in order to smooth the switching noise spectrum and reduce it's level. Experimental results are verified by converter operating at 300V/1kW with 5%~30% white noise input. Spectrum analysis is performed on the Phase current and the CM noise voltage. The former is measured with Current Probe and the latter is achieved with LISN, which are connected to the spectrum analyzer respectively.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2007년도 추계학술대회 논문집
• /
• pp.225-229
• /
• 2007

The output voltage of a synchronous generator is regulated constantly by field current control of excitation system. Synchronous generator exciter has two type, first one is Drop control type by thyristor and second one is exciter current control type through power output by PWM control. Control method of the second one prevails, but when the power devices have a breakdown, output voltage of the generator rises rapidly. This exciter must have a protection circuit and system is complicated, so reliability is poor Excitation control type which is drop control type control only 10% of the power, so it can be improved precision. When a trouble come to the controller, output voltage of a generator don't rise excessively and the voltage rise about 10%, so it has a excellent reliability. This paper prove stability of the digital AVR.