• Journal of Satellite, Information and Communications
• /
• v.9 no.3
• /
• pp.86-90
• /
• 2014

A DC-DC Converter operates in CCM(Continuous Coundcution Mode), DCM(Discontinuous Conduction Mode), CRM(Critical Conduction Mode). The CRM is boundary between CCM and DCM. If a DC-DC converter is designed to operate in CRM, its inductor volume can decrease and power loss which caused by switch and diode can decrease. In this paper, the DC-DC converter which operates in CRM is applied to a solar array regulator(SAR) for the satellite. The switching frequency of the CRM boost SAR changes according to input and output condition. The switching frequency limit logic is applied to limit the maximum switching frequency. Meanwhile, the small signal transfer function of the CRM boost SAR is simple, so the controller design is also simple. In this paper, the small signal transfer function from control reference to solar array voltage is induced. And the voltage controller is designed based on the small signal transfer function. Finally, the CRM boost SAR is verified by simulation.

• Journal of Sensor Science and Technology
• /
• v.26 no.1
• /
• pp.15-23
• /
• 2017

In this study, bioelectrical impedance analysis, which has been used to assess an alteration in intracellular fluid (ICF) of the body, was applied to detect intravenous infiltration. The experimental results are described as follows. Firstly, when infiltration occurred, the resistance gradually decreased with time and frequency i.e., the resistance decreased with increasing time, proportional to the amount of infiltrated intravenous (IV) solution. At each frequency, the resistance gradually decreased with time, indicating the IV solution (also blood) accumulated in the extracellular fluid (ECF) (including interstitial fluid). Secondly, the resistance ratio started to increase at infiltration, showing the highest value after 1.4 min of infiltration, and gradually decreased thereafter. Thirdly, the impedance ($Z_C$) of cell membrane decreased significantly (especially at 50 kHz) during infiltration and gradually decreased thereafter. Fourthly, Cole-Cole plot indicated that the positions of (R, $X_C$) shifted toward left owing to infiltration, reflecting the IV solution accumulated in the ECF. The resistance ($R_0$) at zero frequency decreased continuously over time, indicating that it is a vital impedance parameter capable of detecting early infiltration during IV infusion. Finally, the mechanism of the current flowing through the ECF, cell membrane, and ICF in the subcutaneous tissues was analyzed as a function of time before and after infiltration, using an equivalent circuit model of the human cell. In conclusion, it was confirmed that the infiltration could be detected early using these impedance parameters during the infusion of IV solution.

• Particle and aerosol research
• /
• v.14 no.1
• /
• pp.17-24
• /
• 2018

Since the motion of the charged particle strongly depends on its charge characteristics, information on charge distributions of target particles is one of the important variables in aerosol research. In this study, charged distribution of atomized NaCl particles were measured using a Gerdien type ion counter. Two kinds of particle charging conditions were used in this study. First, atomized NaCl particles were passed through an aerosol neutralizer to have a Boltzmann charge distribution, and then its charge distribution was measured. In this case, the portion of uncharged particles was compared with the portion obtained from the Boltzmann charge distribution for verifying the suggested experimental method. Second, same experiment was conducted without the aerosol neutralizer to measure the charge distribution of atomized and un-neutralized NaCl particles. In the conclusion, the portion of uncharged, negatively charged and positively charged particles were 19%, 62% and 20%, respectively, for neutralized particles. The atomized particles, which was generated without the aerosol neutralizer, also had almost a zero charge state, but the standard deviation in charge distribution was larger than that of neutralized particles. The test method proposed in this study is expected to be used in various aerosol research fields because it can obtain simple information on the particle charge characteristics more easily and quickly than the existing test methods.

• Journal of the Korea Society of Computer and Information
• /
• v.6 no.2
• /
• pp.8-13
• /
• 2001

We demonstrate a pulsed CO$_2$laser with long pulse duration of millisecond order in the low pressure less than 30 Torr. A new power supply for our laser system switches the voltage of AC power line(60㎐) directly. The power supply doesn't need elements such as a rectified bridge, energy-storage capacitors. and a current-limiting resistor in the discharge circuit. In order to control the laser output power, the pulse repetition rate is adjusted up to 60㎐ and the firing angle of SCR gate is varied from 30˚ to 150˚. A ZCS(Zero Crossing Switch) circuit and a PIC one-chip microprocessor are used to control the gate signal of SCR precisely. The maximum laser output is 23W at the total pressure of 18 Torr, the pulse repetition rate of 60㎐, and SCR gate firing angle of 90˚. In addition, the obtained laser pulse width is approximately 3㎳(FWHM)

• Korean Journal of Human Ecology
• /
• v.19 no.1
• /
• pp.51-61
• /
• 2010

The purpose of the current study was to select vulnerable regions with insufficient child care services based on an in-depth investigation of diverse regional characteristics and to establish a practical goal for the expansion of public child care centers through identifying priority regions in foremost need of public child care centers out of the vulnerable regions. The vulnerable regions were selected from both urban and rural areas with particular criterions to determine their critical situation. First of all, the number of children aged zero to five, private and public child care centers, and capacity and enrolment of the regional child care center were selected from towns (Eup) and townships (Myeon) within rural areas and neighborhoods (Dong) within urban areas to calculate the capacity fulfillment. Specifically, a dense population of low-income families inhabited within urban areas defined the region's vulnerable status for the analysis, whereas poor accessibility of a child care center within rural areas correspond to the lack of child care services. The analytical result displayed that a total of 456 towns and townships did not acquire child care centers. Out of 456 towns and townships, 162 were selected as priority regions. On the other hand, 546 neighborhoods corresponding to upper 30 percentiles of urban area where children receive basic subsidy for low income families were selected as vulnerable regions. Out of 546 neighborhoods, 243 were selected as priority regions according to the analytical result.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.18 no.4
• /
• pp.49-61
• /
• 1981

A generally applicable computer simulation program for diffused silicon solar cells has been developed on the basis of the experimental results. The program can be easily used to obtain the spectral response and I-V characteristics for N+P, P+N N+PP+, P+NN+cells by changing various input parameters. The insolated spectra can be taken from AMI and constant intensity and GE - ELH lamp light sources. The options for AR coating are Si3N4 film and materials with constant reflectance including zero reflectance for ideal case. The computer simulation demonstrates successful results compared with the measured values for the short circuit current, open circuit voltage, efficiency, spectral response, quantum efficiency, I-V characteristics, etc. This program was used to optimize doping concentration, cell thickness, light concentration, junction depth, and to obtain the limit values for front surface recornbination velocity, effective carrier life time in the depletion regions and shunt resistance, and also to drive the changing rate in conversion efficiency depending on operation temperature, series resistance and electric field strength in N+P+ bulk regions.

• Journal of Hydrogen and New Energy
• /
• v.28 no.1
• /
• pp.56-62
• /
• 2017

Although most electricity production contributes to air pollution, the vehicle organizations and environmental agency categorizes all EVs as zero-emission vehicles because they produce no direct exhaust or emissions. Currently available EVs have a shorter range per charge than most conventional vehicles have per tank of gas. EVs manufacturers typically target a range of 160 km over on a fully charged battery. The energy efficiency and driving range of EVs varies substantially based on driving conditions and driving habits. Extreme outside temperatures tend to reduce range, because more energy must be used to heat or cool the cabin. High driving speeds reduce range because of the energy required to overcome increased drag. Compared with gradual acceleration, rapid acceleration reduces range. Additional devices significant inclines also reduces range. Based on these driving modes and climate conditions, this paper discusses the performance characteristics of EVs on energy efficiency and driving range. Test vehicles were divided by low / high-speed EVs. The difference of test vehicles are on the vehicle speed and size. Low-speed EVs is a denomination for battery EVs that are legally limited to roads with posted speed limits as high as 72 km/h depending on the particular laws, usually are built to have a top speed of 60 km/h, and have a maximum loaded weight of 1,400 kg. Each vehicle test was performed according to the driving modes and test temperature ($-25^{\circ}C{\sim}35^{\circ}C$). It has a great influence on fuel efficiency amd driving distance according to test temperature conditions.

• Current Industrial and Technological Trends in Aerospace
• /
• v.7 no.2
• /
• pp.95-105
• /
• 2009

Fuel cells are applied to the propulsion system of aircraft based on environmental-friendly characteristics with low noise and zero emission of CO2, currently many kinds of UAV and small manned aircraft equipped with fuel cells are being developed. Fuel cells for aircraft typically classified into PEMFC(Proton Exchange Membrane Fuel Cell) type and SOFC(Solid Oxide Fuel Cell) type and the system is developed to adapt missions and operational conditions of aircraft. For UAV, various types of aircraft mostly based on PEM fuel cell technology are investigated for military or commercial uses, and the stability and endurance of system will be improved. For small manned aircraft, many researches are carried out to substitute the propulsion system by fuel cell, also some developments for the higher performance of APU of large commercial aircraft to apply fuel cells are in progress. In the future, a fuel cell aircraft will be expected to improve the reliability and efficiency with higher power density.

• Current Research on Agriculture and Life Sciences
• /
• v.7
• /
• pp.175-184
• /
• 1989

Kinetics of ascorbic acid and browning that may use on the optimization of food dehydration were evaluated. Banana was chosen for this as the representative test material. We have described the destruction of ascorbic acid and browning as first and zero order reactions. The temperature dependence between two reactions were conducted with Arrhenius equation. Finally we have operated SPSS computer programs reapeatedly that we found very dose value of the parameter between result of ascorbic acid and browning. The attained Kinetic models were well prepared for the value of result experiments and the models may use on optimization for dehydration progress. Destruction rate of ascorbic acid and browning rate were low at initiation of progress, increased to show maximum at the low moisture on mid-progress and then decreased gradually. Freeze drying showed the most constant quality of product in this case.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.1
• /
• pp.321-340
• /
• 2016

The Compressive Video Sensing (CVS) is a useful technology for wireless systems requiring simple encoders but handling more complex decoders, and its rate-distortion performance is highly affected by the quantization of measurements and reconstruction of video frame, which motivates us to presents the Space-Time Quantization (ST-Q) and Motion-Aligned Reconstruction (MA-R) in this paper to both improve the performance of CVS system. The ST-Q removes the space-time redundancy in the measurement vector to reduce the amount of bits required to encode the video frame, and it also guarantees a low quantization error due to the fact that the high frequency of small values close to zero in the predictive residuals limits the intensity of quantizing noise. The MA-R constructs the Multi-Hypothesis (MH) matrix by selecting the temporal neighbors along the motion trajectory of current to-be-reconstructed block to improve the accuracy of prediction, and besides it reduces the computational complexity of motion estimation by the extraction of static area and 3-D Recursive Search (3DRS). Extensive experiments validate that the significant improvements is achieved by ST-Q in the rate-distortion as compared with the existing quantization methods, and the MA-R improves both the objective and the subjective quality of the reconstructed video frame. Combined with ST-Q and MA-R, the CVS system obtains a significant rate-distortion performance gain when compared with the existing CS-based video codecs.