• Journal of the Korean Wood Science and Technology
• /
• v.2 no.2
• /
• pp.5-7
• /
• 1974

1. This study indicates that above the fiber saturation point the drying rate can be increased with increasing the velocity of the air circutation, i.e., the drying rate of sample boards is proportional to the air velocity, but below the fiber saturation point, the effect of the velocity of air circulation is very low as shown in Figs. 1 and 2. 2. Under the controlled temperature and humidity in the kiln, the more the sample boards have moisture, the higher drying rate of it can be obtained. In other words, this means that even though in the case of drying various moisture content of wood, at the final drying stage, approximately the same percentage of moisture content of wood can be secured by employing the higher velocity of air circulation. 3. This study shows that the rate of drying in kiln changes distinctly at the fiber saturation point, i, e., above the fiber saturation point, the drying curve shows concave aginst the X axsis, but below the fiber saturation point, in the range from 30 percent of moisture content to 20 percent of moisture content, the curve shows convex as shown in Fig. 3. As the drying progresses, however, the drying curve shows concave again below 20 percent of moisture content. This means that inflection point of drying curve may be located clearly at the fiber saturation point, i.e., 30 percent of moisture content. As mentioned above, the 30 percent of moisture content of wood at which the inflectional point appears can be recognized as a critical point, i. e., the fiber saturation point at which all free water was removed from wood. The existence of inflectional point indicates that the evaporation of hygroscopic water in a cell wall is more difficult than the evaporation of free water in a cell cavity and the minor space of cell wall. The convex curve in the range of moisture content from 30 percent to 20 percent means that the evaporation of capillary condensed water has a tendency of the same rates of drying approximately, but as approaching to the 20 percent of moisture, the transfusion of moisture from wood becomes difficult because of having less moisture in cell wall. Below 20 percent of moisture content, the drying curve shows concave again, which means that it is difficult to remove the moisture located nearer to the surface of cellulose molecules and the surface bound water. These relations were revealed in Fig. 4. In comparison AC curve which does not have the two inflection points with BD curve which has two inflection points, i.e., Band D, they are mentioned already, by existence of the inflection points, the curve BD shows that the change of drying rate in the interval from 20 percent of moisture content to 30 percent of moisture content is not greater than in the case of the curve AC in the same interval. At the inflection point of 30 percent of moisture content, it can be noticed that the changing of the drying rate is very conspicuous. This phenomenon also can be recognized, as it is noticed by the Fig. 3, the drying rate from green to 30 percent of moisture content is very great. But the inclination of the curve is very slow from 30 percent of moisture content to 20 percent of moisture content, i.e., the inclination of the curve becomes almost horizontal lines. Acknowledgments Gratitude is expressed to Fred E. Dickinson, Professor of 'Wood Technology, School of Natural Resources, University of Michigan, USA for his suggestion to carry out this study.

• Proceedings of the SAREK Conference
• /
• 2009.06a
• /
• pp.236-241
• /
• 2009

After analyzing the characteristics of the cooling dryer, the mixed cooling dryer was developed by adding the desiccant dryer which supplement the cooling dryer's demerits. Also, the hybrid desiccant cooling dryer was developed to use effectively the exhaust heat energy of the cooling dryer. It could make a more that 20 percent reduction in energy compared with the mixed desiccant cooling dryer. It has become essential to supply this equipment and search the suitable drying product.

• Korean Journal of Food Science and Technology
• /
• v.31 no.1
• /
• pp.164-170
• /
• 1999

Cracking of rice caused by moisture migration during storage under different relative humidity conditions was investigated for the establishment of safe storage condition of rice. Rice was cracked when a large difference in equilibrium relative humidity $({\Delta}ERH)$ between the rice and the environment was present. External and internal cracks were generated as the results of moisture desorption and adsorption, respectively. The external cracks by moisture desorption generated in all directions and shaped irregularly, while the internal cracks by moisture adsorption did in radial direction and showed a typical shape. The cracking trend could be analyzed by the Weibull function, and the cracking constant increased with ${\Delta}ERH$. The frequency of cracked rice increased linearly with In $({\Delta}ERH)$. The critical crack-inducing ${\Delta}ERH$ was $11.3{\sim}16.4%$ during desorption and $10.8{\sim}17.1%$ during adsorption. A diagram for the safe storage of rice was developed with respect to the initial moisture content and the water activity of rice.

• Journal of the Korean Society of Tobacco Science
• /
• v.8 no.1
• /
• pp.23-31
• /
• 1986

The water content, physical property and sensory of cigarette brands lave been studied from the view point of the individual and inner packages. It was found that the cigarettes had absorbed the moisture from alto more than 56% of a relative humidity (RH) and lost it under RH, 56%. The critical moisture contents for the optimum quality of cigarette maintenance were 7.7% through 14.595 in the range of equilibrium relative humidity (ERH) 52.2%-63.5%. The ERH at the initial moisture content of 12.1% showed 58.8% When cigarettes were storaged in 9095 of RH and 4$0^{\circ}C$, the shelf life of the Inner package was respectively shown 18.8 days In cellophane, 33.3 days In PET(25u), 69.8 days in OPP and 73.5 days in OPP film coated with PVDC. As shown above, the longest life time was found in the OPP film coated with PVDC. In the individual packages, the shelf life of packaging materials used above was significantly short in the same conditions as of the inner packages. Each shelf life of the individual packages was same In order comparing with that of the inner Packages.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.28 no.1
• /
• pp.47-52
• /
• 1999

Comparative effects of phosphine fumigation and gamma irradiation were evaluated on the qualities of white ginseng prepacked in a commercial laminated film in terms of water absorption, Hunter color parameters(L, a, b) and organoleptic properties(overall color/appearance, flavor) during 6 months of storage at ambient(20oC, 70% RH) and accelerated(40oC, 90% RH) conditions. Moisture content of packed white ginseng(initial 8.44%) linearly increased with storage period, thereby reaching to about 10% (r=0.9966) in ambient and more than 15%(r=0.9886) in accelerated conditions, respectively, at the 6th month of storage. The storage at severe conditions resulted in remarkable changes in Hunter's color values, decrease in whiteness(L) and increase in redness(a) and yellowness(b), while both treatments, phosphine and irradiation less than 5kGy, did not cause any significant changes in color parameters. Phosphine fumigation was shown detrimental to overall flavor of white ginseng(p<0.01), however or ganoleptic qualities of stored samples were effectively maintained by irradiation less than 5kGy(p< 0.05). As the index on the guality of white ginseng stored at severe conditions its organoleptic quality was highly correlated with moisture content(r= 0.9777) and Hunter color values(over 0.9), suggesting the critical values of 15.5% moisture and 72.56, 7.15, 21.45 in Hunter's L, a, b values, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.6
• /
• pp.644-653
• /
• 2013

In this paper, a formulation for obliquely incident electromagnetic wave has been presented for an analysis of highpower electromagnetic pulse penetration into multilayered dispersive media. Based on generalized models of measured dielectric constants and propagation channels reflecting the Earth's general features, the propagation phenomenon of the obliquely incident early-time(E1) high altitude electromagnetic pulse(HEMP) is analyzed. In addition, the polarization and critical angle are also considered. It is found that the total reflection occurs at an incident angle of about 38 degrees at the soil-rock interface, and that the parallel-polarized E1 HEMP penetrates better than the perpendicular-polarized one. The peak level of the penetrating electric field is found to be 5.6 kV/m at normal incidence, regardless of the type of polarization, and E1 HEMP is greatly reduced near the critical angle. Moreover, the penetrating E1 HEMP is analyzed as a variation of moisture content and depth of materials, resulting E1 HEMP could be useful in determining the levels of shielding required for buried facilities.

• Korean Journal of Remote Sensing
• /
• v.19 no.2
• /
• pp.117-133
• /
• 2003

A field survey and Landsat ETM+ image acquisition carried out simultaneously. Using these data, we attempted to establish relationships between tidal flat environmental factors and reflectance observed by ETM+, and to set up a new critical grain size useful for optical remote sensing. Although the grain size of 4 $\Phi$ has been conventionally used as a critical size by sedimentologists, the correlation with optical reflectance was very low. Instead, the grain size of 2 $\Phi$ showed a relatively high correlation coefficient, 0.699, with ETM+ band 4, except near tidal channels in upper tidal flat. We concluded that the grain size of 2 $\Phi$ would be better to use for a critical grain size in Gomso Bay. The grain size also correlated well with moisture content having a correlation coefficient of -0.811 when the 2 $\Phi$ criterion was used. The results of factor analysis showed moisture content was more important parameter than topographic relief, and they were different from German tidal flats in which topographic relief was the prior factor This can be explained by finer grain composition of the Gomso bay tidal flat. In short, moisture content and topography as well as grain size should be considered in tidal flat remote sensing.

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.38 no.3
• /
• pp.196-201
• /
• 2018

Soil is the main nitrogen (N) provider for plants but N in soil is not all available to advanced plants. Mineralization is a critical biological process for transferring organic N to inorganic N that can be used by plants directly. To investigate the effect of different levels of soil temperature and water content to soil mineralization, a field experiment was established on three different sites (A, B and C). We measured soil temperature, moisture and electrical conductivity once daily after swine slurry application. Average soil moisture and temperature in site A is the highest among three sites (40.9% and $9.7^{\circ}C$, respectively). Following is in site C (37.3% and $9.6^{\circ}C$) and the lowest is in site B (28.0% and $9.0^{\circ}C$). Ammonium N (NH4+-N) and nitrate N (NO3--N) were determined on the first and fifth day after treatment. Compared with site B and C, site A always had the highest soil total N content (1.54 g N kg-1 on day one; 1.22 g N kg-1 on day five) and highest NO3-- N content (93.18 mg N kg-1 on day one; 16.22 mg N kg-1 on day five) and a significant decrease on day five. Content of NH4+-N in site B and C reduced while in site A, it increased by 6.7%. Results revealed that net N mineralization positively correlated with soil temperature (P<0.5, $r=0.675^*$) and moisture (P<0.01, $r=0.770^{**}$), suggesting that to some extent, higher soil moisture and temperature contribute more to inorganic N that can be used by plants.

• Applied Biological Chemistry
• /
• v.19 no.3
• /
• pp.145-154
• /
• 1976

Studies have been carried out to design a suitable consumer size package from flexible packaging material to hold 100 grams of Chilli powder and 250 grams of whole chilli which are moisture and color sensitive. 1. Sorption characteristics of the chilli powder has revealed that moisture sorption is rapid above 55 per cent R.H., and the product is fairly hygroscopic. Further, an equilibrium moisture content of about 15 per cent at 70 per cent R.H., appears to be critical from the point of microbial spoilage of chilli powder. 2. Studies on the colour (Capsanthin) changes of chilli powder equilibriated to different moisture content, have revealed that colour changes during storage is greatly influenced by the moisture content and temperature decreases the capsanthin content of chilli during storage. 3. From the studies, it can be inferred that the sunlight exhibits pronounced effect in bleaching of colour and brings about maximum discolouration of the red pigment in chilli. 4. From the packaging and storage studies of chilli powder in different flexible films, it can be concluded that for long-term storage, the aluminium foil laminate is unique in offering maximum protection from various physico-chemical changes. For short-term storage and for fairly good moisture and colour protection, amber or black polyethylene, high-density polyethylene and Saran/Cello/Saran poly laminate pouches appear to be suitable alternatives.

• Korean Journal of Soil Science and Fertilizer
• /
• v.50 no.5
• /
• pp.369-382
• /
• 2017

Accurate and optimal water supply to cereal crop is critical in growing stalks and producing maximum yields. Recently, upland crops are cultivated in paddy field soils to reduce overproduced rice in Korea. In order to increase productivity of cereal crops in paddy fields which have poor percolation and drainage properties, it is necessary to fully understand crop response to excessive soil water condition and management of soil drainage system in paddy field. The objectives of this study were to investigate effects of excessive soil water to sesame growth and to quantify stress response using groundwater levels. Two cultivars of sesame were selected to investigate; Gunbak and Areum. These sesames were planted in paddy fields located in Miryang, Gyeongnam with different soil drainage levels and drainage systems. The experiment site was divided into two plots by drainage class; very poorly and somewhat poorly drained. Two different drainage systems were applied to alleviate excessive soil water in each plot: open ditch and pipe drainage system. Soil water contents and groundwater levels were measured every hour during growing season. Pipe drainage system was significantly effective to alleviate wet injury for sesame in paddy fields. Pipe drainage system decreased average soil moisture content and groundwater level during sesame cultivation. This resulted in greater yield and lignan contetns in sesame seeds than ones from open ditch system. Comparison between two cultivars, Gunbak had greater decrease in growth and yield by excessive soil water and high groundwater level than Areum. Seed components (lignan) showed decrease in seeds as soil water increased. When soil moisture content was greater than 40%, lignan content tended to decrease than ones from less soil moisture content. Based on these results, pipe drainage system would be more effective to reduce wet injury to sesame and increase lignan component in paddy field cultivation.