• Resources Recycling
• /
• v.21 no.1
• /
• pp.41-48
• /
• 2012

A study on the behavior of boron extraction by TMPD(2,2,4-trimethyl-1,3-pentanediol) was carried out to find the optimum conditions for the boron extraction from brine. In case of boron extraction from 0.736 g/L boron-containing brine, typical optimum extractive conditions would be confirmed to be 0.75 mol/L of extractant concentration at 3.0 pH of brine with 1 of phase ratio and 20 min. of shaking time at 298 K respectively. And 1 mol/L sodium hydroxide of stripping agent was shown above 99 % of boron extraction and stripping efficiencies. Also, extraction equilibrium equation were obtained through experiments as follows : log D = 1.7 log $[TMPD]_O$ + constant at pH < 6.

• Journal of Soil and Groundwater Environment
• /
• v.18 no.5
• /
• pp.1-6
• /
• 2013

This study was performed to develop a method for quantitative analysis obtaining the amount of calcium carbonate minerals formed when Ca salts biomimetically reacted with carbon dioxide. There were two methods compared; 1) volumetric calcimeter method that determining the amount of released carbon dioxide after calcium carbonate minerals were acidified by 4N HCl and 2) Thermogravimetry-Differential Thermal Analysis (TG-DTA) adopting differential decomposition temperature breaking-up the structural link within calcium carbonate minerals. The comparisons were made by batch experiment (i.e., biocalcification process) along with control (i.e., nominal concentration of $CaCO_3$ prepared). For the control, TG-DTA took a minor root mean square deviation (RMSD) of 1.1~5.9 mg, whereas volumetric calcimeter exposed a greater RMSD of 28.3 mg. For the biocalcification, the amount of $CaCO_3$ was more precisely obtained for TG-DTA rather than that of volumetric calcimeter. It was decided that TG-DTA was more successfully used for quantitative analysis to observe the amount of calcium carbonate minerals derived from biocalcification.

• Toxicological Research
• /
• v.21 no.1
• /
• pp.15-21
• /
• 2005

There is now a growing concern about the possible toxicity of heavy metals in cosmetics. Heavy metals can be used as cosmetic ingredients or may be present as low level impurities in some of the raw materials. Chromium derivatives are used as pigments in cosmetics. Chromium is essential and toxic trace elements. Chromium may cause skin allergy. However, the regulations related to cosmetic products give no limit values for Chromium. Hexavalent chromium is significantly more toxic than trivalent chromium. Hexavalent chromium may present a carcinogenic risk at high concentrations. Therefore, it is important to consider oxidation state of chromium when analyze chromium. The purpose of this study is to determine the concentrations of water-soluble trivalent and hexavalent chromium in samples of makeup products, and to assess the safety of cosmetics on the basis of animal sensitization tests using guinea pig. The present study of chromium in 48 makeup products of 12 manufacturers provides a basis for assessing safety of makeup products. Water-soluble hexavalent chromium was not detected in any product. Water-soluble trivalent chromium was detected in only 9 eye shadows out of 48 makeup products, and could not be quantified 3 out of 9 eye shadows. The highest level of water-soluble trivalent chromium was about 10 mg/kg in spite of 90,000 mg/kg of total chromium. The results of animal sensitization tests show that 200 mg/kg of trivalent chromium and 5 mg/kg of hexavalent chromium have no harmful effect. No cross-reaction among these metals was found. Accordingly, the concentrations of water-soluble chromium in makeup products seemed to be safe. The overall results indicate that chromium in cosmetics probably have no significant toxicological effects. However, It is necessary to set guidelines on the maximum permissible concentration of water-soluble chromium in cosmetics.

• Economic and Environmental Geology
• /
• v.53 no.3
• /
• pp.235-244
• /
• 2020

Copper (Cu), one of the main contaminants in the mine drainage from the closed mine area, needs to be removed before exposed to environment because of its toxicity even in the low concentration. In this study, passive treatment based field pilot experiments using limestone and compost media were conducted during 9 months for enhancing Cu removal efficiency of the mine water treatment facility of S mine located in Goseong, Gyeongsangnam-do in South Korea. The pH increase and Cu removal efficiency showed high value at Successive Alkalinity Producing System ( SAPS) > Reducing and Alkalinity Producing System (RAPS) > limestone reactor in a sequence. The compost media using in SAPS and RAPS contributed to raise pH by organic material decomposition with generating alkalinity, thus, Cu removal efficiency increased. Also, experimental results showed that Cu removal efficiency was proportional to pH increase, meaning that pH increase is the main mechanism for Cu removal. Moreover, Sulfate Reduction Bacteria (SRB) was identified to be most activated in SAPS. It is inferred that the sulfate reduction reaction also contributed to Cu removal. This study has the site significance in that the experiments were conducted at the place where the mine water generates. In the future, the results will be useful to select the more effective reactive media used in the treatment facility, which is most appropriate to remediate mine water from the S mine.

• Journal of the Korean Institute of Gas
• /
• v.15 no.2
• /
• pp.9-14
• /
• 2011

A set of test was conducted on a SA-372 steel for CNG storage tank to study the effect of hydrogen embrittlement. Tensile tests were carried out several conditions such as CNG, HCNG and H2 gas environment including air and Ar under the 35 MPa. Also, the test speed was set at 4*10^-4/s and 4*10^-5/s respectively. To maintain the high pressure for environmental gas during test process, we chose MTS which was installed autoclave. Test results showed that tensile stress, elongation rate and cross sectional contraction under Ar and CNG charging condition were similar to that of reference of air. And there was little bit change with test speed variations. However, hydrogen added conditions such as HCNG and H2 were revealed noticeable change in elongation rate and cross sectional contraction. Tensile stress was still uniform for all conditions. From the results, the effect of hydrogen embrittlement was confirmed on the hydrogen enriched conditions. Also its effect was showed more strong with much hydrogen concentration and slower test speed.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.23 no.4
• /
• pp.179-191
• /
• 2018

In order to determine the distribution characteristics of the heavy metals in surface sediments of the eastern Yellow Sea, heavy metal concentrations (Cu, Pb, Zn, Cd, Cr, Mn, As, Ni, Co, Li, Fe and Al) together with grain size and total organic carbon (TOC), were analyzed. The concentrations of all heavy metals, with the exception of Pb, Mn and As in some stations, were relatively high in the central area of the Yellow Sea and tended to decrease toward the Korean coast. A significant relationship between grain size and concentrations of heavy metals suggested that they were mostly controlled by quartz dilution effect. However, at some stations, Pb, Mn and As exhibited different distribution patterns. For Pb, the differences were caused by petrogenetic influences (feldspar) in coarse-grained sediments. In the case of Mn, biogenetic influences ($CaCO_3$) affected distribution patterns. As was distributed differently because of the existence of a heavy mineral (pyrite). A comparison with previous data (collected in 2000) shows that the heavy metal concentration in the eastern Yellow Sea has not increased over the past fifteen years. The sedimentary environment of dumping sites in the Yellow Sea has not been significantly improved during this period. The results of the pollution assessment revealed that the concentrations of heavy metals in the study area were lower than lower criteria (TEL, MSQ-1) in Korean and Chinese sediment quality guidelines. The enrichment factor (EF), geo-accumulation index ($I_{geo}$) and ecological risk index (ERI) of Cu, Pb, Zn and Cr were higher in the central area of the Yellow Sea.

• Korean Journal of Soil Science and Fertilizer
• /
• v.48 no.2
• /
• pp.138-145
• /
• 2015

Heavy metal pollution in agricultural field near the abandoned metal mines is a critical problem in Korea. General remediation technique is to apply chemical amendments and soil covering. However, there is no specific guidelines for conducting soil covering. Therefore, main objective of this research was to determine optimum soil covering technique with microcosm experiment. Three different chemical amendments, lime stone (LS), steel slag (SS), and acid mine drainage sludge (AMDS), were examined and varied soil covering depth, 20, 30, 40cm, was applied to determine optimum remediation technique. Bioavailable heavy metal concentration in soil and total concentration of heavy metals in crop were monitored. Result showed that average heavy metal concentration in varied soil covering depth was ordered as 40 cm ($14.5mg\;kg^{-1}$) < 20 cm ($14.6mg\;kg^{-1}$) < 30 cm ($16.0mg\;kg^{-1}$) and also heavy metal concentration in crop was ordered as 40 cm ($100{\mu}g\;kg^{-1}$) < 30 cm ($183{\mu}g\;kg^{-1}$) < 20 cm ($190{\mu}g\;kg^{-1}$). In terms of chemical amendments, average heavy metal concentration was decreased as AMDS ($150{\mu}g\;kg^{-1}$) < SS ($151{\mu}g\;kg^{-1}$) < LS ($154{\mu}g\;kg^{-1}$). Overall, depth of soil covering should be over 30 cm to minimize bioaccumulation of heavy metals and SS and LS could be applied in heavy metal contaminated soil for remediation purposes.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.66 no.1
• /
• pp.72-79
• /
• 2021

The increasing use of deicing salts has caused various environmental problems, including crop damage along the motorway where deicing salts are sprayed during winter. Deicing salts used on roads have been reported to negatively affect crops, but little information is known about their impact on crops. A seedling emergence assay was conducted to evaluate the effects of deicing salts on crops using oilseed rape (Brassica napus) as a model plant. We tested five chloride deicing salts consisting of NaCl, CaCl2, or MgCl2 and 1 non-chloride deicing salt (SM-3) at a range of concentrations (25, 50, 100, 200, and 400 mM), and untreated control. Regardless of deicing salts, they significantly delayed and reduced seedling emergence of oilseed rape with increasing salt concentration. Non-linear regression analysis of seedling emergence with a range of salt concentrations by fitting to the log-logistic model revealed that the chloride deicing salts reduced seedling emergence more than the non-chloride deicing salt SM-3. The GR50 value, the concentration causing 50% seedling emergence, of SM-3 was 47.1 mM, while those of the chloride deicing salts ranged from 30.7 mM (PC-10) to 37.5 mM (ES-1), showing approximately 10 mM difference between non-chloride and chloride deicing salts. Our findings suggest that seedling emergence assay is a useful tool to estimate the potential damage caused by deicing salts on crops.

• Journal of Microbiology
• /
• v.42 no.1
• /
• pp.25-31
• /
• 2004

Sf9 cells have obvious advantages for the conventional production technology of vaccine. They are useful tools for high concentration and large-scale cultures. Sf9 cells were grown to maximal concentration, 8${\times}$l0$\^$6/ cells/$m\ell$ in a 500$m\ell$ spinner flask, with a doubling time at the exponentially growing phase of 24.5 hours, using serum-free media. To explore the ability of Sf9 cells to be infected by the Japanese encephalitis (JE) virus Beijing-l strain, Sf9 cells were infected with the virus. By 4-5 days post-infection, 10-15 % of the Sf9 cells showed cytopathic effect (CPE), from granularity to the formation of syncytia and multinucleated giant cells continuously observed over a period of 35 days. Positive fluorescent reactions were detected in 30-40% of cells infected with the JE virus Beijing-l strain, and the uninfected Sf9 cells were completely negative. Virus particles, propagated in Sf9 and Vero cells, were concentrated by sedimentation on 40% trehalose cushions by ultracentrifugation, and showed identical patterns of viral morphogenesis. Complete virus particles, 40 to 50 nm in diameter, were observed, and JE virus envelope (E) proteins, at 53 kDa, were found in the western blot analysis to the anti-JE virus E protein monoclonal antibody and reacted as a magenta band in the same position to the glycoprotein staining. To evaluate whether the infectious virus was produced in Sf9 cells inoculated with the JE virus Beijing-l stain, Sf9 cells were inoculated with the virus, and sample harvested every 5 days. The titers of the JE virus Beijing-l strain rose from 1.0${\times}$l0$\^$5/ to 1.5${\times}$l0$\^$6/ pfu/$m\ell$. The infected Sf9 cells could be subcultured in serum-free medium, with no change in the plaque sizes formed by the JE virus Beijing-l strain in the plaque assay. It is suggested that the ability of the JE virus Beijing-l strain to infect Sf9 cells in serum-free media will provide a useful insect cell system, where the JE virus replication, cytopathogenicity and vaccine immunogen can be studied.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.15 no.2
• /
• pp.91-98
• /
• 2009

The long-term water-quality change of Asan Bay by the influx of polluted disposal water was predicted through a simulation with an Eco-hydrodynamic model. Eco-hydrodynamic model is composed of a multi-level hydrodynamic model to simulate the water flow and an ecosystem model to simulate water quality. The water quality simulation revealed that the COD(Chemical Oxygen Demand), dissolved inorganic nitrogen(DIN) and dissolved inorganic phosphorus(DIP) are increased at 5 stations for the subsequent 6 months after the influx of the effluent. COD, DIN and DIP showed gradual decreases in concentration during the period of one to two years after the increase of last 6 months and reached steady state for next three to ten years. Concentration levels of COD, DIN, and DIP showed the increase by the ranges of $11{\sim}67%$, $10{\sim}67%$, and $0.5{\sim}7%$, respectively, which represents that the COD and DIN are the most prevalent pollutants among substances in the effluent through the sewage treatment plant. The current water quality of Asan Bay based on the observed COD, TN and TP concentrations ranks into the class II of the Korean standards for marine water quality but the water quality would deteriorate into class III in case that the disposal water by the sewage plant is discharged into the Bay.