• Proceedings of the International Microelectronics And Packaging Society Conference
• /
• 2001.11a
• /
• pp.146-150
• /
• 2001

Microwave model and high-frequency measurement of the ACF flip-chip interconnection was investigated using a microwave network analysis. S-parameters of on-chip and substrate were separately measured in the frequency range of 200 MHz to 20 GHz using a microwave network analyzer HP8510 and cascade probe. And the cascade transmission matrix conversion was performed. The same measurements and conversion techniques were conducted on the assembled test chip and substrate at the same frequency range. Then impedance values in ACF flip-chip interconnection were extracted from cascade transmission matrix. ACF flip chip interconnection has only below 0.1nH, and very stable up to 13 GHz. Over the 13 GHz, there was significant loss because of epoxy capacitance of ACF. However, the addition of SiO$_2$filler to the ACF lowered the dielectric constant of the ACF materials resulting in an increase of resonance frequency up to 15 GHz. High frequency behavior of metal Au stud bumps was investigated. The resonance frequency of the metal stud bump interconnects is higher than that of ACF flip-chip interconnects and is not observed at the microwave frequency band. The extracted model parameters of adhesive flip chip interconnects were analyzed with the considerations of the characteristics of material and the design guideline of ACA flip chip for high frequency applications was provided.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.6
• /
• pp.2211-2220
• /
• 2015

This paper analyzes multiple active management (AM) techniques of active distribution network (ADN), and proposes an optimal coordination model of intermittent distributed generation (IDG) accommodation considering the timing characteristic of load and IDG. The objective of the model is to maximize the daily amount of IDG accommodation under the uncertainties of IDG and load. Various active management techniques such as IDG curtailment, on-load tap changer (OLTC) tap adjusting, voltage regulator (VR) tap adjusting, shunt capacitors compensation and so on are fully considered. Genetic algorithm and Primal-Dual Interior Point Method (PDIPM) is used for the model solving. Point estimate method is used to simulate the uncertainties. Different scenarios are selected for the IDG accommodation capability investigation under different active management schemes. Finally a modified IEEE 123 case is used to testify the proposed accommodation model, the results show that the active management can largely increase the IDG accommodation and penetration.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.26 no.2
• /
• pp.1-9
• /
• 1989

This paper deals with the simplification and the conversion time reduction for the 12-channel TDM/FDM transmultiplexing system using the polyphase network and the FDCT. The prototype filter required in the digital polyphase network is designed based on interpolated FIR (IFIR) properites of the IFIR coefficients, the multiplication rate required in its implementaion is shown to be $0.1640{\times}10^6$ multiplications/sec. channel which reduces about 25% of the result obtained in the previous work. The result of computer simulation indicates that the proposed conversion method is valid.

• Proceedings of the IEEK Conference
• /
• 2001.06d
• /
• pp.5-8
• /
• 2001

We propose a realtime numeric caption recognition algorithm that automatically recognizes the numeric caption generated by computer graphics (CG) and displays the modified caption using the recognized resource only when a valuable numeric caption appears in the aimed specific region of the live sportscast scene produced by other broadcasting stations. We extract the mesh feature from the enhanced binary image as a feature vector after acquiring the sports broadcast scenes using a frame grabber in realtime and then recover the valuable resource from just a numeric image by perceiving the character using the neural network. Finally, the result is verified by the knowledge-based rule set designed for more stable and reliable output and is displayed on a screen as the converted CC caption serving our purpose. At present, we have actually provided the realtime automatic mile-to-kilometer caption conversion system taking up our algorithm f3r the regular Major League Baseball (MLB) program being broadcasted live throughout Korea over our nationwide network. This caption conversion system is able to automatically convert the caption in mile universally used in the United States into that in kilometer in realtime, which is familiar to almost Koreans, and makes us get a favorable criticism from the TV audience.

• Journal of Electrical Engineering and Technology
• /
• v.13 no.2
• /
• pp.822-828
• /
• 2018

AC-DC conversion is a necessary for the systems that require DC source. This conversion has been done via rectifiers based on controlled or uncontrolled semiconductor switches. Advances in the power electronics and microprocessor technologies allowed the use of Pulse Width Modulation (PWM) rectifiers. In this paper, dq-axis current and DC link voltage of three-phase PWM rectifier are controlled by using type-2 fuzzy neural network (T2FNN) controller. For this aim, a simulation model is built by MATLAB/Simulink software. The model is tested under three different operating conditions. The parameters of T2FNN is updated online by using back-propagation algorithm. The results obtained from both T2FNN and Proportional + Integral + Derivate (PID) controller are given for three operating conditions. The results show that three-phase PWM rectifier using T2FNN provides a superior performance under all operating conditions when compared with PID controller.

• Journal of the Korean Geotechnical Society
• /
• v.17 no.2
• /
• pp.73-83
• /
• 2001

본 연구에서는 전국 4개 지구의 화강암 풍화토를 연구대상으로 현장 및 실내시험을 수행하고 토량 변화율을 노상과 노체에 대하여 결정하였다. 그리고, 본 연구에서는 인공 신경망 중 오류 역전파 학습 알고리즘을 도입하여 토량 변화율 C 값을 추정하고 신경망의 적용성에 대한 검증을 수행하였다. 화강암 풍화토에 대한 실내 및 현장시험 결과에서 얻어진 토량 변화율 C 값은 노상과 노체 구분 없이 최소 0.7에서 최대 1.2정도의 넓은 범위로 나타났다. 토지공사에서 제안하는 C값의 산정식과 본 연구 결과를 비교한 결과, 토지공사의 산정식에 의한 결과가 과대 평가될 가능성이 큰 것으로 나타났다. 비중, 자연 함수비, 자연상태의 습윤단위중량, #200 통과율 그리고 균등계수의 입력변수를 갖는 $I_{5-1}$$H_{30-30}$$O_1$의 신경망에서 다른 신경망 구조들보다 잦은 지역 최소점에 수렴하는 결과를 보였다. 본 연구에서 사용한 모든 신경망 구조에서 시험결과와 신경망 결과의 상관계수는 0.9이상으로 나타나 높은 상관성을 나타내었다. 특히, 인공 신경망에 의한 예측결과는 다양한 영향인자들 중에서 비중, 자연 함수비, 자연상태의 습윤단위중량 그리고 #200 통과율의 4개 변수만으로도 C값을 예측할 수 있었으며, 상관계수는 0.96으로 나타났다.다.

• KEPCO Journal on Electric Power and Energy
• /
• v.6 no.4
• /
• pp.419-425
• /
• 2020

DC distribution system has been evaluated as an excellent one in comparison with existing AC distribution network because it needs fewer power conversion stages and the full capacity of the equipment can be used without consideration for power factor. Recently, research and development on the implementation of DC distribution networks have been progressed globally based on the rapid advancement in power-electronics technology, and the technological developments from the viewpoint of infrastructure are also in progress. However, to configure a distribution network which is a distribution line for DC, more accurate and rapid introduction of analysis technology is needed for the monitoring, control and operation of the system, which ensure the system run flexible and efficiently. However, in case of a bipolar DC distribution network, there are two buses acting as slack buses, so the Jacobian matrix cannot be configured. Without solving this problem, DC distribution network cannot be operated when the network is unbalanced. Therefore, this paper presented a comprehensive method of analysis with consideration of operating elements which are directly connected between neutral electric potential caused by the unbalanced of load in DC distribution network with bipolar structure.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.38 no.8
• /
• pp.43-53
• /
• 2001

Wavelength conversion devices are essential to build an expanding all-optical network, and various types of wavelength conversion techniques are being researched. Among them, wavelength conversion based on the cross phase modulation in a directionally coupled semiconductor optical amplifier has been introduced and the concept has been experimentally proved. In this paper, a split-step method is applied to properly model the mentioned wavelength converter in the time-domain and various characteristics have been analyzed. It is shown that the present modeling approach can explain the results of the reported experimental results. Furthermore the wavelength conversion is shown to be well performed when the input signal wave and the converted wave travels in the opposite direction. The simulation shows that the positive and negative chirping appear simultaneously at both the leading and trailing of edges of the optical pulse.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.1 s.116
• /
• pp.15-23
• /
• 2007

A simple six-port direct conversion QPSK receiver which is made up of a six-port phase correlator, a signal power detector, and I/Q channel signal de-modulator is designed and implemented in this paper. The output phase signals of six-port phase correlator are also analysed. On the basis of $90^{\circ}C$ phase relation among the six-port phase correlator output signals, the QPSK de-modulation circuit is designed by a simple circuit. The six-port phase correlator is made up of $90^{\circ}$ hybrid branch line and power detector. The six-port phase correlator, which is designed in frequency range of 11.7 to 12.0 GHz, gets the phase error characteristics less than $5^{\circ}$. By considering matching network and amplitude balance in the designed fiequency range, the designed six-port direct conversion QPSK receiver demodulates the I and Q signals with performance less than $5^{\circ}$ phase error.

• International Journal of Advanced Culture Technology
• /
• v.8 no.3
• /
• pp.223-230
• /
• 2020

Companies have made an investment of cost and time to optimize processing of a new business model in a cloud environment, applying collaboration technology utilizing business processes in a social network. The collaborative processing method changed from traditional BPM to the cloud and a mobile cloud environment. We proposed a collaborative system for operating processes in social networks using MOXMDR-DAI+ (eXtended Metadata Registry-Data Access & Integration based multimedia ontology). The system operating cloud-based collaborative processes in application of MOXMDR-DAI+, which was suitable for data interoperation. MOXMDR-DAI+ applied to this system was an agent effectively supporting access and integration between multimedia content metadata schema and instance, which were necessary for data interoperation, of individual local system in the cloud environment, operating collaborative processes in the social network. In operating the social network-based collaborative processes, there occurred heterogeneousness such as schema structure and semantic collision due to queries in the processes and unit conversion between instances. It aimed to solve the occurrence of heterogeneousness in the process of metadata mapping using MOXMDR-DAI+ in the system. The system proposed in this study can visualize business processes. And it makes it easier to operate the collaboration process through mobile support. Real-time status monitoring of the operation process is possible through the dashboard, and it is possible to perform a collaborative process through expert search using a community in a social network environment.