• The Transactions of the Korean Institute of Power Electronics
• /
• v.22 no.5
• /
• pp.397-403
• /
• 2017

This paper studies the voltage angle control of interior permanent magnet synchronous motors (IPMSMs). For voltage angle control, the optimum voltage angle trajectory according to the operating speed is researched while the voltage and current limit conditions are considered. Through research, two different optimum voltage angle trajectories that depend on the design of IPMSMs were found. The IPMSM drive based on a voltage angle control that follows such trajectory is proposed. Unlike the conventional voltage angle control method, which is applied only in the flux-weakening region, the proposed voltage angle control can be implemented in all operation ranges from low to high speed. The proposed method is verified by experiments using a DSC controller for 800 W IPMSM.

• The Journal of Korean Physical Therapy
• /
• v.16 no.1
• /
• pp.14-31
• /
• 2004

The Purpose of this study was to investigate the change of lumbar extensor strength according to lumbosacral angle on chronic lumbar back pain patients. For this investigation lumbar extensor strength was administered to 60 patients who were diagnosed chronic lumbar back pain The subjects was to investigate lumbosacral angle in standing position and it were calculated lumbar extensor strength by using Medex. The result of this study summarized are as follows ; 1. Total experimental group exhibited significantly higher difference than control group in lumbar extensor strength among all degree lumbosacral angle. 2. In the relationship between experimental group and control group in lumbar extensor strength among lumbosacral angle, all degree difference was revealed II, I, III order. 3. In the relationship between experimental group and control group in lumbar extensor strength among lumbosacral angle, I group difference was did not. 4. In the relationship between experimental group and control group in lumbar extensor strength among lumbosacral angle, all degree among II group was noted significantly difference except 24, 72 angle. 5. In the relationship between experimental group and control group in lumbar extensor strength among lumbosacral angle, control group was revealed higher muscle strength 48, 60, 72 angle, however no significantly difference was noted 0, 12, 24 angle. The study was objected difference of other group in both of experimental and control group. Because lumbar extensor weakness with bad position was gradually increased back pain, to Maintain normal lumbosacral angle befor exercising lumbar extensor strength was most important.

• Journal of the Korean Society for Industrial and Applied Mathematics
• /
• v.19 no.3
• /
• pp.235-252
• /
• 2015

Optimal impact angle control guidance law and its variants for intercepting a maneuvering target are introduced in this paper. The linear quadratic(LQ) optimal control theory is reviewed first to setup framework of guidance law derivation, called the sweep method. As an example, the inversely weighted time-to-go energy optimal control problem to obtain the optimal impact angle control guidance law for a fixed target is solved via the sweep method. Since this optimal guidance law is not applicable for a moving target due to the angle mismatch at the impact instant, the law is modified to three different biased proportional navigation(PN) laws: the flight path angle control law, the line-of-sight(LOS) angle control law, and the relative flight path angle control law. Effectiveness of the guidance laws are verified via numerical simulations.

• International Journal of Precision Engineering and Manufacturing
• /
• v.6 no.3
• /
• pp.37-44
• /
• 2005

Gait control capacity for most trans-femoral prostheses is significantly different from that of a normal person, and training is required for a long period of time in order for a patient to walk properly. People become easily tired when wearing a prosthesis or orthosis for a long period typically because the gait angle cannot be smoothly adjusted during wearing. Therefore, to improve the gait control problems of a trans-femoral prosthesis, the proper gait angle is estimated through surface EMG(electromyogram) signals on a normal leg, then the gait posture which the trans-femoral prosthesis should take is calculated in the neural network, which learns the gait kinetics on the basis of the normal leg's gait angle. Based on this predicted angle, a postural control method is proposed and tested adaptively following the patient's gait habit based on the predicted angle. In this study, the gait angle prediction showed accuracy of over $97\%$, and the posture control capacity of over $90\%$.

• Journal of Mechanical Science and Technology
• /
• v.19 no.4
• /
• pp.985-992
• /
• 2005

Vehicle Stability Control (VSC) system prevents vehicle from spinning or drifting out mainly by braking intervention. Although a control threshold of conventional VSC is designed by vehicle characteristics and centered on average drivers, it can be a redundancy to expert drivers in critical driving conditions. In this study, a manual adaptation of VSC is investigated by changing the control threshold. A control threshold can be determined by phase plane analysis of side slip angle and angular velocity which is established with various vehicle speeds and steering angles. Since vehicle side slip angle is impossible to be obtained by commercially available sensors, a side slip angle is designed and evaluated with test results. By using the estimated value, phase plane analysis is applied to determine control threshold. To evaluate an effect of control threshold, we applied a 23-DOF vehicle nonlinear model with a vehicle planar motion model based sliding controller. Controller gains are tuned as the control threshold changed. A VSC with various control thresholds makes VSC more flexible with respect to individual driver characteristics.

• Journal of Institute of Control, Robotics and Systems
• /
• v.19 no.3
• /
• pp.275-280
• /
• 2013

Conventional proportional navigation guidance law is not adequate for missiles with a strapdown seeker, because the strapdown seeker cannot measure line-of-sight rate directly. This paper suggests a guidance loop design method, in which the look angle, measured by the strapdown seeker directly, is controlled to deliver a missile to a target. Basically, the look angle control loop is regarded as an attitude control loop. By using the proposed method, it is possible to shape the midcourse trajectory by choosing the reference look angle properly. The look angle control loop can robustly maintain target lock-on against disturbances because the target is always captured in the field of view of the seeker. The performance of the proposed method is verified via 6-DOF simulations of a true short range tactical missile model.

• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.37 no.12
• /
• pp.854-861
• /
• 1988

The current source inverter-fed induction motor(CSIM) drive is widely used in industry because of its four quadrant operation, fuseless protection, fuseless protection, and ruggedness. the CSIM drive system, however, has shortcomins such as slow response and dynamic stability to load torque disturbance and reference speed change. Such a disadvantages can be compensated considerably by means of introducing additional angle angle control loop. The angle control method is dependent upon the inverter type. In this paper, simultaneus recovery and commutation inverter(SRCI) which is developed recently is considered.

• Korean Journal of Applied Biomechanics
• /
• v.14 no.3
• /
• pp.17-35
• /
• 2004

The purpose of this study is to explain developmental process of gait via angle-angle diagram to understand how coordinated relationships and control change with age. Twenty four female children, from one to five years of age were the test subjects for this study, and their results were compared to a control group consisting of twenty one adult females. The Vicon 370 CCD camera, VCR, video timer, monitor, and audio visual mixer was utilized to graph the gait cycle for all test subjects. Both coordinated Intra-limb relationships, and range of motion and timing according to quadrant were explained through the angle angle diagram. Movement in the sagittal plane showed both coordinated relationships and control earlier than movement in the coronal or transverse plane. In the sagittal plane, hip and Knee coordinated relationships developed first (from one year of age.) Coordinated relationships in the Knee and ankle and hip and ankle developed next, respectively. Both hip and ankle and knee and ankle development were inhibited by the inability of children to completely perform plantar flexion during the swing and initial double limb support phases. Children appeared to compensate for this by extending at their hip joint more than adults during the third phase, final double limb support. In many cases the angle angle diagram for children had a similar shape as adult's angle angle diagram. This shows that children can coordinate their movements at an early age. However, the magnitudes and timing of children's angle angle diagrams still varied greatly from adults, even at five years of age. This indicates that even at this age, children still do not possess full control of their movements.

• Journal of Electrical Engineering and Technology
• /
• v.12 no.2
• /
• pp.674-682
• /
• 2017

This paper presents an optimal initial firing angle control based on the energy consumption and regenerative energy of a parallel multi-pulse thyristor dual converter for urban railway power substations. To prevent short circuiting the thyristor dual converter, a hysteresis band for maintaining a zero-current discontinuous section (ZCDS) is essential during mode changes. During conversion from the ZCDS to forward or reverse mode, the DC trolley voltage can be stabilized by selecting the optimal initial firing angle without an overshoot and slow response. However, the optimal initial firing angle is different depending on the line impedance of each converter. Therefore, the control algorithm for tracking the optimal initial firing angle is proposed to eliminate the overshoot and slow response of DC trolley voltage. Simulations and experiments show that the proposed algorithm yields the fastest DC voltage control performance in the transient state by tracking the optimal firing angle.

• Journal of Power Electronics
• /
• v.7 no.1
• /
• pp.81-88
• /
• 2007

This paper presents a new approach to the automatic control of the turn-off angle used to excite the Switched Reluctance Motor (SRM) employed in electric vehicles (EV). The controller selects the turn-off angle that supports and improves the performance of the motor drive system. This control scheme consisting of classical current control and speed control depends on a lookup table to take the best result of the motor. The turn-on angle of the main switches of the inverter is fixed at $0^{\circ}C$ and the turn-off angle is variable depending on the reference speed. The motor, inverter and control system are modeled in Simulink to demonstrate the operation of the system.