• Geomechanics and Engineering
• /
• v.22 no.3
• /
• pp.219-226
• /
• 2020

Unconfined compression test (UCT) is widely conducted in laboratories to evaluate the mechanical behavior of frozen soils. However, its results are sensitive to the initial conditions of sample creation by freezing as well as the end-surface conditions during loading of the specimen into the apparatus for testing. This work compared ice samples prepared by three-dimensional and one-dimensional freezing. The latter created more-homogenous ice samples containing fewer entrapped air bubbles or air nuclei, leading to relatively stable UCT results. Three end-surface conditions were compared for UCT on ice specimens made by one-dimensional freezing. Steel disc cap with embedded rubber was found most appropriate for UCT. Three frozen materials (ice, frozen sand, and frozen silt) showed different failure patterns, which were classified as brittle failure and ductile failure. Ice and frozen sand showed strain-softening, while frozen silt showed strain-hardening. Subsequent investigation considered the influence of fines content on the unconfined compression behavior of frozen soil mixtures with fines contents of 0-100%. The mixtures showed a brittle-to-ductile transition of failure patterns at 10%-20% fines content.

• Steel and Composite Structures
• /
• v.12 no.2
• /
• pp.117-127
• /
• 2012

This paper deals with an experimental investigation to study the effect of fibre content on the stability of composite plates with various aspect ratios. Epoxy based glass fibre reinforced composite plates with aspect ratio varying from 0.4 to 1 and with volume fractions of 0.36, 0.4, 0.46, 0.49 and 0.55 are used for the investigation. From the study it is observed that for plate with aspect ratio of 0.5 and 0.4 there is no buckling and the plate got crushed at the middle. As the volume fraction increases the buckling load also increases to a limit and then began to reduce with further increase in fibre content. The optimum range of fibre content for maximum stability is found between 0.49 and 0.55. Polynomial expressions are developed for the study of buckling behaviour of composite plates with different volume fractions in terms of load and aspect ratio.

• Journal of Electrochemical Science and Technology
• /
• v.14 no.3
• /
• pp.205-214
• /
• 2023

Soil salinity is becoming one of the most devastating environmental hazards over the years. Soil investigation involves fast, low cost and non disturbing methods to measure soil characteristics for both construction projects as well as for agricultural use. The electrical resistivity of saline soils is greatly governed by salt concentration and the presence of moisture in soil matrix. Experimental results of this investigation highlight that there is a significant relationship between the electrical resistivity of soil samples mixed with chloride solutions (NaCl, KCl, and MgCl₂) at various concentrations, and soil physical properties. Correlations represented by quadratic functions were obtained between electrical resistivity and soil characteristics, namely, water content, degree of saturation and salt concentration. This research reveals that the obtained correlations between electrical resistivity, salt concentration, water content and degree of saturation are effective for predicting the characteristics of salt affected soils in practice, which constitute a governing element in the assessment of saline lands sustaining infrastructure.

• International Journal of Internet, Broadcasting and Communication
• /
• v.16 no.3
• /
• pp.242-252
• /
• 2024

This study introduces a prototype for a virtual zoo initiative, aimed at optimizing resource utilization and minimizing animal displacement from their natural habitats. The prototype features a thoughtfully developed three-dimensional representation of an emperor penguin, with animations designed to emulate real-life behaviors. An investigation into file format distinctions for scientific research, encompassing Wavefront(OBJ), Collada(DAE), and Filmbox(FBX) formats, was conducted. The research utilized the Hololens 2 device for visualization, Unity for environment development, Blender for modeling, and C# for programming, with deployment facilitated through Visual Studio 2019 and the Mixed Reality Toolkit. Empirical examination revealed the OBJ format's suitability for simple geometric shapes, while DAE and FBX formats were preferred for intricate models and animations. DAE files offer detailed preservation of object structure and animations albeit with larger file sizes, whereas FBX files provide compactness but may face scalability constraints due to extensive data integration. This investigation underscores the potential of virtual zoos for conservation and education, advocating for further exploration and context-specific implementation.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2006.11a
• /
• pp.401-404
• /
• 2006

This study is the part of the investigation of the state of the art in ultra high flowing concrete (UHFC), applied in practical field construction, in order to develop the technology for improving workability. This paper includes a brief introduction of water content variance properties in UHFC before and after the pumping operation. Test showed that water content in all parameters decreased after the pumping. This is due to the increase of an absorption ratio of coarse aggregate by the pressure of the pumping operation. thus decreasing the water content. Therefore it should be considered to find out the possibility, which can improve the workability, suffering from over viscosity by the lower water content, in field construction.

• Journal of Apiculture
• /
• v.32 no.4
• /
• pp.327-332
• /
• 2017

In this study, we studied the changes in antioxidant activity of Actinidia arguta fruit of Autumn Sense cultivar during fruit ripening. The aim of this investigation was to find the knowledge of the changes of physiochemicals associated with fruit quality, antioxidant properties (free-radical scavenging activity and reducing power), total phenolics and vitamin C during fruit ripening. The highest free-radical scavenging activity (at $100{\mu}g/ml$) and reducing power (at $100{\mu}g/ml$) in A. arguta fruit were 78.57% and 0.22, respectively. Total phenolic content and vitamin C content in fruit of 10 days after fruit set were $639.48{\mu}g/g$ and $1052.2{\mu}g/g$, respectively. In general, the antioxidant activity and the related parameters, including total phenolic content and vitamin C content decreased during fruit ripening. These results improve knowledge of the effect of ripening on the antioxidant activity and related compounds contents that could help to establish the optimum A. arguta fruit harvest data for various usages.

• Computers and Concrete
• /
• v.11 no.1
• /
• pp.21-37
• /
• 2013

High-performance concrete (HPC) usually has higher paste and lower coarse aggregate volumes than normal concrete. The lower aggregate content of HPC can affect the shear capacity of concrete members due to the formation of smooth fractured surfaces and the subsequent development of weak interface shear transfer. Therefore, an experimental investigation was conducted to study the shear strength and cracking behavior of full-scale reinforced beams made with low-cement-content high-performance concrete (LcHPC) as well as conventional HPC. A total of fourteen flexural reinforced concrete (RC) beams without shear reinforcements were tested under a two-point load until shear failure occurred. The primary design variables included the cement content, the shear span to effective depth ratio (a/d), and the tensile steel ratio (${\rho}_w$). The results indicate that LcHPC beams show comparable behaviors in crack and ultimate shear strength as compared with conventional HPC beams. Overall, the shear strength of LcHPC beams was found to be larger than that of corresponding HPC beams, particularly for an a/d value of 1.5. In addition, the crack and ultimate shear strength increased as a/d decreased or ${\rho}_w$ increased for both LcHPC beams and HPC beams. This investigation established that LcHPC is recommendable for structural concrete applications.

• KIEAE Journal
• /
• v.15 no.4
• /
• pp.45-52
• /
• 2015

Purpose: Foam concrete is the concrete that contains large amount of air voids inside. In general, the density of foam concrete depends on parameters like water/binder ratio, foam volume, aggregate and pozzolan content, etc. Method: In this study, the effect of foam volume and fly ash content on dry density is investigated intensively in order to find the relationship between each parameter and their abilities to counteract with each other. According to the above information, though there are quite a number of studies on the effect micro fiber on foam concrete at low volume fractions, there is still lack of information especially on the high fiber content side. The objective of the second study is to investigate further on the use of micro fiber at higher volume fraction and fill in the lacking information. Beside from this study, the investigation of the effect of micro-fiber (polypropylene) to enhance the properties of foam concrete is also carried out. Result: Of the two variables that are investigated in this study, the foam volume and the fly ash content, show significant effect on the properties of foam concrete. The foam volume tends to decrease the density and strength of foam concrete. In the second part of our study, a large fibre volume fraction is proved to be able to evidently increase the flexural strength of foam concrete up to about 40% due to the effect of fibre bridging over the crack and a significant number of fibres that intercepts the crack surfaces. However, the compressive strength is found to decrease severely due to the occurrence of large pores as the result of fibre being added into concrete mixture.

• International Journal of Concrete Structures and Materials
• /
• v.8 no.4
• /
• pp.279-287
• /
• 2014

This paper presents the findings of an investigation of the fiber content variations in concrete being discharged from a ready-mix truck at the construction site. Concrete samples were extracted from the truck drums at the beginning, middle and end of discharge. Subsequently, fibers in each sample were separated from the concrete, and weighed. Presumably, synthetic macro fibers will float towards the top, i.e. towards the drum opening, of the inclined, revolving truck-drum, while, on the other hand, steel fibers will tend to gravitate towards the lower parts of the mixer drum. Accordingly, the discharge batch, containing synthetic macro fibers, will contain a higher amount of synthetic fibers per unit volume at the start of discharge than the average unit volume fiber content of the mix, and the content will gradually decrease further down the batch. The discharge batch of steel fiber concrete will contain fewer fibers per unit volume at the start of discharge than the average unit volume fiber content of the mix, and the content should gradually increase further down the batch. The correctness of the foregoing is partly confirmed. A certain percentage of the truck loads did not comply with the proposed requirements, mainly steel fiber reinforced batches, indicating the necessity of a code or guideline amendment. A change in the Norwegian shotcrete directive was made in 2011, based upon experimental research work (2010), which, in combination with the subsequent University of Life Sciences report (2012), constitutes the foundation of this article.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.26 no.3
• /
• pp.226-232
• /
• 1981

To clarify the relationship between rice cool injury and the contents of silica and phosphorus in the soils and the rice plant, the investigation was carried out at ripening stage of rice from the different altitudes with different varieties throughout Yeongnam area. The rate of fertilized spikelets were decreased with elevation increase and the situation was distincted in the Japonica cross Indica hybrid varieties. The higher rates of $SiO_2/P_2 O_5$ content in the leaves and stems or lower rates of that in the soils show the higher fertilization rates. The result seems to be caused by the different solubility and uptakes of silica and by the different availability and transformation of phosphorus. A positive correlation was observed between the content of silica in rice plant and the fertilization rates. The fertilization rate in Japonica varieties was higher than that of Indica cross Japonica hybrid varieties in the case of the same content of silica in plant as far as observed, but the increasing rate of fertilized grains due to increase of silica content was prominented in the hybrid varieties which probably demand more silica. Within the certain limit of silica and phosphorus content in rice plant, the more uptaking of silica might lessen the cool injury.