• Journal of Korean Society for Atmospheric Environment
• /
• v.27 no.4
• /
• pp.405-415
• /
• 2011

The objective of this study was to compare greenhouse gas emissions from road transportation by calculation methods (Tier 1, Teir 2, and Tier 3). Tier 1 based on 2006 IPCC guidelines default emission factor and amount of fuel consumption. The Tier 2 approach is the same as Tier 1 except that country-specific carbon contents of the fuel sold in road transport are used. Tier 2 based on emission factor of guidelines for local government greenhouse gas inventories (Korea Environment Corporation), the fuel consumption per one vehicle, and the registered motor vehicles. The Tier 3 approach requires detailed, country-specific data to generate activity-based emission factors for vehicle subcategories (National Institute of Environmental Research) and may involve national models. Tier 3 calculates emissions by multiplying emission factors by vehicle activity levels (e.g., VKT) for each vehicle subcategory and possible road type. VKT was estimated by using GIS road map and traffic volume of the section. The GHG average emission rate by the Tier 1 was 728,857 $tonCO_2eq$/yr, while Tier 2 and Tier 3 were 864,757 $tonCO_2eq$/yr and 661,710 $tonCO_2eq$/yr, respectively. Tier 3 was underestimated by 10.1 and 20.7 percent for the GHG emission observed by Tier 1 and Tier 2, respectively. Based on this study, we conclude that Tier 2 is reasonable GHG emissions than Tier 1 or Tier 3. But, further study is still needed to accurate GHG emission from Tier 3 method by expanding the traffic survey area and developing the model of local road traffic.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.28 no.3
• /
• pp.451-458
• /
• 2022

In Korea, five major ports have been designated as sulfur oxide emission control areas to reduce air pollutant emissions, in accordance with Article 10 of the "Special Act on Port Air Quality" and Article 32 of the "Ship Pollution Prevention Regulations". As regulations against vessel-originated air pollutants (such as PM, CO2, NOx, and SOx) have been strengthened, the Ministry of Oceans and Fisheries(MOF) enacted rules that newly built public ships should adopt eco-friendly propulsion systems. However, particularly in diesel-electric hybrid propulsion systems,the demand for precise control schemes continues to grow as the fuel saving rate significantly varies depending on the control strategy applied. The conventional Power Take In-Power Take Off(PTI - PTO) mode control adopts a rule-based strategy, but this strategy is applied only in the low-load range and PTI mode; thus, an additional method is required to determine the optimal fuel consumption point. The proposed control method is designed to optimize fuel consumption by applying the equivalent consumption minimization strategy(ECMS) to the PTI - PTO mode by considering the characteristics of the specific fuel oil consumption(SFOC) of the engine in a diesel-electric hybrid propulsion system. To apply this method, a specific fishing vessel model operating on the Korean coast was selected to simulate the load operation environment of the ship. In this study, a 10.2% reduction was achieved in the MATLAB/SimDrive and SimElectric simulation by comparing the fuel consumption and CO2 emissions of the ship to which the conventional rule-based strategy was applied and that to which the ECMS was applied.

• Journal of Korean Society for Atmospheric Environment
• /
• v.13 no.2
• /
• pp.123-135
• /
• 1997

An air pollutant emission inventory system for the input preparations of photochemical dispersion model was developed. Using the system, anthropogenic emissions as well as biogenic emissions in the Seoul metropolitan area were calculated. Anthropogenic emission by fuel combustion using regional cosumption data, and the laundries and so forth was estimated. The biogenic emission was estimated based upon meteorological data and the distribution of land use type in the study area. The anthropogenic emission of pollutants was highest in Seoul, and the second highest in Inchon. TSP and $SO_2$ were found large quantities during the winter due to increased consumption of heating oil. NOx and THC were emitted without seasonal variation. Among biogenic emissions, PAR was very common while NO was the least common. PAR, OLE, and ALD2 were emitted in large volumes in coniferous forest areas, while ISOP was emitted in deciduous forest areas. Generally, most biogenic emissions increased during daytime, and peaked between oen and two o'clock. Because of strong solar radiation, emission during the summer was high. Biogenic NO emissions were found to be lower compared to anthropogenic emissons, and other VOC was indicated relatively high. In the study area, among biogenic emissions PAR was found to be 3 times, OLE 8 times,and ALD2 12 times more common than among anthropogenic emissions.

• International Journal of Automotive Technology
• /
• v.6 no.1
• /
• pp.15-21
• /
• 2005

The purpose of this paper is to experimentally investigate the engine pollutant emissions and combustion characteristics of diesel engine fueled with ethanol-diesel blended fuel (bio-diesohol). The experiments were performed on a single-cylinder DI diesel engine. Two blend fuels were consisted of $15\%$ ethanol, $83.5\%$ diesel and $1.5\%$ solublizer (by volume) were evaluated: one without cetane improver (E15-D) and one with a cetane improver (E15-D+CN improver). The engine performance parameters and emissions including fuel consumption, exhaust temperature, lubricating oil temperature, Bosch smoke number, CO, NOx, and THC were measured, and compared to the baseline diesel fuel. In order to gain insight into the combustion characteristics of bio-diesohol blends, the engine combustion processes for blended fuels and diesel fuel were observed using an Engine Video System (AVL 513). The results showed that the brake specific fuel consumption (BSFC) increased at overall engine operating conditions, but it is worth noting that the brake thermal efficiency (BTE) increased by up to $1-2.3\%$ with two blends when compared to diesel fuel. It is found that the engine fueled with ethanol-diesel blend fuels has higher emissions of THC, lower emissions of CO, NOx, and smoke. And the results also indicated that the cetane improver has positive effects on CO and NOx emissions, but negative effect on THC emission. Based on engine combustion visualization, it is found that ignition delay increased, combustion duration and the luminosity of flame decreased for the diesohol blends. The combustion is improved when the CN improver was added to the blend fuel.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.12 no.1
• /
• pp.61-65
• /
• 2004

This paper presents the effect of methanol blended fuel on the engine performance and the reduction of exhaust emissions. In this wort, the combustion effects of methanol blended fuel in the engine was investigated for the conditions of three kinds of mixing ratios. Based on the experimental results, the output characteristics of the engine show the improvement of output performance due to the blended fuel of methanol. Also, the unburned hydrocarbon and carbon monoxide emissions are decreased in accordance with the increase of methanol blended ratio.

• Asian Journal of Atmospheric Environment
• /
• v.8 no.1
• /
• pp.48-58
• /
• 2014

Energy efficiency is vital to improve energy security, environmental and social sustainability, and economic performance. Improved energy efficiency also mitigates climate change by lowering greenhouse gas (GHG) emissions. Buildings are the single largest industrial consumer of energy and are therefore key to understanding and analyzing energy consumption patterns and the opportunities for saving energy at the district level in urban environments. This study focused on two representative boroughs in the major metropolitan area of Seoul, South Korea as a case study: Gandong-gu, a typical residential district, and Jung-gu, a typical commercial district. The sources of the energy supplied to the boroughs were determined and consumption patterns in different industry sectors in Seoul used to identify current patterns of energy consumption. The study analyzed the energy consumption patterns for five different building categories and four different sectors in the building using a bottom-up energy modeling approach. Electricity and gas consumption patterns were recorded for different building categories and monthly ambient temperatures in the two boroughs. Finally, a logarithmic equation was developed to describe the correlation between commercial activity and cooling energy intensity in Jung-gu, the commercial district. Based on these results, recommendations are made regarding the current energy consumption patterns at the district level and government energy policies are suggested to reduce energy consumption and, hence, greenhouse gas emissions, in both commercial and residential buildings.

• Proceedings of the KSR Conference
• /
• 2011.10a
• /
• pp.861-864
• /
• 2011

Since national GHG reduction target by 2020 has been presented in Korea, the role of railroad has been reinforced within transport system due to the allocation of reduction target into sector. So, it is necessary to manage activity data systematically for the calculation of GHG emission in railroad. Now, the activity data of diesel consumption for NIR(National Inventory Report) are provided from oil supply and demand statistics. On the other hands, the activity data collected directly from railroad operating companies are used for GHG & Energy Target Management Act. This study aimed to assess the GHG emissions using two kinds of activity data related to the diesel consumption of railroad in 2009 and 2010. As a result, GHG emissions based on oil supply and demand statistics was 636 thousands ton $CO_{2e}$, but the activity data collected from railroad operating companies showed 649 thousands ton $CO_{2e}$ in 2009. Also, the gap of $CO_{2e}$ emission was increased in 2010. These trends were caused because oil supply and demand statistics included total diesel sales volume during 1 year and the activity data collected from railroad operating companies were the amount of diesel consumption only at railcar operation and maintenance step. In conclusion, it is important to develop the management and verification system of activity data with high reliability to substitute oil supply and demand statistics in railroad sector.

• Journal of Advanced Marine Engineering and Technology
• /
• v.35 no.8
• /
• pp.1035-1040
• /
• 2011

In this study, many researches have been carried out against Energy Efficiency Operational Indicator(EEOI) of existing ships under discussion by IMO. This research is examined the method for the polices about IMO's greenhouse gas reducing emissions among them, we were analyzed the EEOI for existing ships. we have analyzed the result about applying EEOI using the calculation method of the rate of fuel consumption for cargo quantities to the actual existing ships and raised the problem. Based on this research, we were presented the improved EEOI about the engine load using fuel consumption and applied the existing ships. As a result, we concluded that the improved EEOI can define a resonable rate of $CO_2$ emissions.

• Environmental and Resource Economics Review
• /
• v.21 no.4
• /
• pp.809-850
• /
• 2012

A linkage of emissions trading schemes among Korea, China and Japan demonstrates overall increase in gross domestic product (GDP). However, it also demonstrates reductions in household consumption, and the impact of integration could be very unbalanced between the countries. In particular, the reductions in domestic marginal costs are high in both Korea and Japan. Therefore, household consumptions in the two countries decrease despite increases in GDP because Korea and Japan will be purchasers of emissions rights. China, on the other hand, will experience the opposite. The unbalanced impacts on real household consumptions are intensified when emission credits are allocated via paid auctions instead of free allocation. This was demonstrated to be the case because the circumstances of three countries are intensified when using a paid emissions credit allocation scheme, and their differences could potentially hinder the cooperation between the three countries. Under the free allocation scheme, the emission trading schemes' unbalanced impacts on consumption could be mitigated, but unavoidable negative impacts of free allocation schemes are also serious. Based on the analysis results, Korea, China, and Japan will individually face complicated impacts if their carbon markets are integrated. Although the GDP of three countries will increase as a result of carbon market integration, the benefits of integration will surely be unbalanced, and the three countries will experience negative impacts in terms of actual consumption or employment. In particular, increases in income and consumption, reductions in employment, and energy dependence by credit purchasers (Japan and Korea) and production reduction and possibility of offshoring faced by revenue producing countries (China) could serve as a barrier to carbon market integration. To maximize the positive influences of carbon market integration while reducing the risks of negative side effects, the development and application of complimentary policy tools, such as import duties or discounts for emissions credits, are required.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.14 no.1
• /
• pp.77-84
• /
• 2015

In 2011, greenhouse gas emissions of transport sector were 85.04 million $tonCO_2eq$ and road emissions accounted for 95% of total emissions in the transport sector. There are few innovative technologies to reduce greenhouse gas emissions aside from eco-driving education and public relation program. Therefore, this paper focused on analyzing optimal acceleration by certain road grades and suggested fuel-efficient driving method for various uphill sections. Scenarios were established by driving modes. Speed profiles were generated by scenarios and speed variations. Each speed profile applied to Comprehensive Modal Emission Model and then each fuel consumption was estimated. Driving mode and speed variation that minimized fuel consumption were driven according to grade percent and uphill distance. When driving in the eco-friendly mode of the driving and speed variation, reduction rate of fuel consumption was evaluated by comparison between eco-driving and cruise control mode. When a vehicle drove under eco-driving mode at 100kph, 90kph and 80kph on uphill road, fuel consumptions were reduced by 33.9%, 30.8% and 5.3%, respectively.